岩石破坏前后曲线分类及脆-延转换围压研究——蚀变岩常规三轴压缩试验Ⅰ   总被引：2，自引：0，他引：2  

杨根兰  黄润秋  蔡国军  付小敏  林锋  徐德敏 《岩土力学》2008,29(10):2759-2763

蚀变岩是工程中少见的软弱岩类,在西南某重大水电工程中,蚀变岩处于工程的重要部位,为保证工程的长期稳定性,对蚀变岩力学特性进行了深入全面的试验研究.通过对孔隙度不同的饱水蚀变岩进行系统的常规三轴压缩试验和总结分析,提出了蚀变岩三轴压缩下破坏前应力.应变曲线可分为3大类,破坏后应力-应变曲线亦可分为3大类的形态模式.并得出结论:蚀变岩的破坏类型受围压与孔隙度的共同影响,在给定的12 MPa围压下蚀变岩以脆性破坏为主,只有孔隙度大于16%且围压大于4 MPa时才有可能进入脆-延转换状态,且脆-延转换围压随孔隙度增加而降低,临界状态应力比随孔隙度增大而增加.  相似文献   

Effect of Cyclic Loading Frequency on Undrained Behaviors of Undisturbed Marine Clay   总被引：2，自引：0，他引：2  

陈云敏  姬美秀黄博 《中国海洋工程》2004,18(4):643-651

Based on a series of cyclic triaxial tests, the effect of cyclic frequency on the undrained behaviors of undisturbed marine clay is investigated. For a given dynamic stress ratio, the accumulated pore water pressure and dynamic strain increase with the number of cycles. There exists a threshold value for beth the accumulated pore water pressure and dynamic strain, below which the effect of cyclic frequency is very small, but above which the accumulated pore water pressure and dynamic strain increase intensely with the decrease of cyclic frequency for a given number of cycles. The dynamic strength increases with the increase of cyclic frequency, whereas the effect of cyclic frequency on it gradually diminishes to zero when the number of cycles is large enough, and the dynamic strengths at different frequencies tend to the same limiting minimum dynamic strength. The test results demonstrate that the reasons for the frequency effect on the undrained soil behaviors are beth the creep effect induced by the loading rate and the decrease of sample effective confining pressure caused by the accumulated pore water pressure.  相似文献   

Control strategies for the Clam Wave Energy Device   总被引：1，自引：0，他引：1  

Martin Greenhow  Jay H. Rosen  Mark Reed 《Applied Ocean Research》1984,6(4):197-206

A promising wave energy device being currently investigated is the ‘clam’. The clam extracts energy by pumping air through a specially designed (Wells) turbine. Although operation of the Wells turbine does not require a rectified air flow, some additional control will be necessary to optimize the phase of the clam motion for good efficiencies. An examination of the equation of motion in the time domain suggests the possibility of phase control by mechanical, power take-off, or pneumatic latching. Latching can be shown to increase the efficiency of the device in the longer wavelengths of the wave spectrum, i.e. those of high incident wave power. Equivalently latching could be used to keep the device efficiency high while reducing its size, possibly resulting in cheaper power extraction.  相似文献   

Long-Term Effect of TMD on Vibration Control of An MDOF Offshore Fixed Platform     

SHI  Xiang 《中国海洋工程》2003,17(4):481-494

A three-dimensional fixed offshore platform in deep water modeled by the finite element method is studied in this paper. Analysis of the dynamic response of the MDOF structure is realized taking the non-linearity of the wave drag force and the wave-structure interaction into account. The structural response statistics, which have Gaussian distributions, are used to evaluate the vibration effect of the structure without TMD and with TMD. And an optimal method to design TMD controlling the first mode of the multi-mode structure is proposed. Moreover, the probabilities of occurrence of sea states at the platform site are considered for prediction of the long-term effect of a TMD. Simulation results demonstrate that the long-term effect of a well-designed TMD is good and the practical use is possible due to the good stability of its optimal parameters under different sea states.  相似文献   

Spatial patterns and environmental risks of ringnet fishing along the Kenyan coast     

P Thoya  S Pérez-Jorge  GM Okemwa  H Mwamlavya  A Tuda  N Wambiji 《African Journal of Marine Science》2020,42(1):23-33

Ringnet fishing began in the early 20th century and is practised worldwide, mainly to target nearshore pelagic species. The method was introduced to Kenya’s coastal waters by migrant fishers from Tanzania. However, the impacts of this fishing gear remain poorly assessed. We assessed the spatial distribution of ringnet fishing effort and its possible effects on ecosystem components, such as coral reefs, marine megafauna and marine protected areas, on the south coast of Kenya. We tracked 89 ringnet fishing trips made from December 2015 to January 2016 and used spatial multicriteria analysis to determine hotspots of possible environmental risks. The results showed that habitat type and bathymetric profile influenced the spatial distribution of ringnet fishing effort. Mixed seagrass and coral habitats had the highest concentration of the effort. Most of the habitats in the study area were moderately exposed to the impacts of the ringnet fishery. The study identifies high-risk areas that require spatial measures to minimise possible environmental risks of the gear both to habitats and to endangered sea turtles.  相似文献   

The optimum control of thruster system for dynamically positioned vessels     

C. C. Liang  W. H. Cheng 《Ocean Engineering》2004,31(1):97-110

An offshore vessel with a dynamic positioning system (DP system) needs fast response to produce thrust to counteract the environmental forces acting on it for the purpose of maintaining its position and heading as close as possible to the working position. Therefore, quick and effective modulation of the thrust is the problem to determine the thrust and the rotation angle of the thruster devices of the ship. This paper presents an effective optimum control for a thruster system, using the sequential quadratic method to achieve economical and effective modulation of the thrust and the direction of the thruster. An optimum control study of a 2280 tons DP coring vessel with five rotary azimuth thruster marine positioning is studied in detail, which can quickly and exactly estimate the thrusts and angles of direction of all the thrusters. The results can provide a valuable thruster system for a dynamically positioned vessel.  相似文献   

Dynamic analysis of a vertical plate exposed to breaking wave impact     

M. Salih Kirkgoz  A. Kamil Tanrikulu  Cengiz Dündar 《Ocean Engineering》2004,31(13):2308-1635

From the experimental studies in recent years, it has become known that when a wave breaks directly on a vertical faced coastal structure, high magnitude impact pressures are produced. The theoretical and experimental studies show that the dynamic response of such structures under wave impact loading is closely dependent on the magnitude and duration of the load history. The dynamic analysis and design of a coastal structure can be succeeded provided the design load history for the wave impact is available. Since these types of data are very scarce, it is much more convenient to follow a method which is based on static analysis for the dynamic design procedure. Therefore, to facilitate the dynamic design of a vertical plate that is exposed to breaking wave impact, a multiplication factor called “dynamic magnification factor” is herein presented which is defined as the ratio of the maximum value of the dynamic response to that found by static analysis. The computational results of the present study show that the dynamic magnification factor is a useful ratio to transfer the results of static analysis to the dynamic design of a coastal plate for the maximum impact pressure conditions of p_max/γH₀≤18.  相似文献   

Neural Network-Based Active Control for Offshore Platforms     

周亚军  赵德有 《中国海洋工程》2003,17(3)

1 .IntroductionWiththedevelopmentofoceantechnology ,moreandmoreextremelylargeandlongflexibleoff shoreplatformsusedforoilexplorationanddrillingoperationarebuiltinhostileoceanenvironments .Ingeneral,thiskindofplatformsisanonlineardistributedparametersystemanditsnaturalfrequencyfallsclosertothedominantwavefrequencieswiththeincreaseofwaterdepth .Besides ,itsstructureisverycomplexandtheexternalwaveforceontheplatformisuncertain .Thus ,theseplatformsarepronetoexcessivewave inducedoscillationsunderbot…  相似文献   

基于EOF分析对南海西北海域水体光谱特性的研究   总被引：1，自引：0，他引：1  

付东洋  黄宇业  刘大召  廖珊  余果  张小龙 《海洋学报(英文版)》2020,39(7):107-114

This study presents an analysis of the spectral characteristics of remote sensing reflectance(R_(rs)) in northwestern South China Sea based on the in situ optical and water quality data for August 2018.R_(rs)was initially divided into four classes,classes A to D,using the max-classification algorithm,and the spectral properties of whole R_(rs) were characterized using the empirical orthogonal function(EOF) analysis.Subsequently,the dominant factors in each EOF mode were determined.The results indicated that more than 95% of the variances of R_(rs) are partly driven by the back-scattering characteristics of the suspended matter.The initial two EOF modes were well correlated with the total suspended matter and back-scattering coefficient.Furthermore,the first EOF modes of the four classes of R_(rs)(A-D R_(rs)-EOF_1) significantly contributed to the total variances of each R_(rs) class.In addition,the correlation coefficients between the amplitude factors of class A-D R_(rs)-EOF_1 and the variances of the relevant water quality and optical parameters were better than those of the unclassified ones.The spectral shape of class AR_(rs)-EOF_1 was governed by the absorption characteristic of chlorophyll a and colored dissolved organic matter(CDOM).The spectral shape of class B R_(rs)-EOF_1 was governed by the absorption characteristic of CDOM since it exhibited a high correlation with the absorption coefficient of CDOM(a_g(λ)),whereas the spectral shape of class C R_(rs)-EOF_1 was governed by the back-scattering characteristics but not affected by the suspended matter.The spectral shape of class D R_(rs)-EOF_1 exhibited a relatively good correlation with all the water quality parameters,which played a significant role in deciding its spectral shape.  相似文献   

Seismic Response Control of Offshore Platform Structures with Shape Memory Alloy Dampers     

李宏男何晓宇  霍林生 《中国海洋工程》2005,19(2):185-194

In this study, the seismic response control of offshore platform structures with Shape Memory Alloy (SMA) dampers is investigated. A new SMA damper and its restoring force medel are introduced for the calculation of seismic response reduction. Based on an actual platform structure and its mechanical medel, the parameters which may affect the rate of shock absorption are analyzed, such as the number, position and characteristics of the SMA dampers and the condition of the site where the platform is located. The results show that the SMA damper is an effective control device for offshore platforms and satisfactory control can be achieved by proper selection of the parameters.  相似文献