Texture and mineralogy of sediments from the Ganges-Brahmaputra-Meghna river system in the Bengal Basin, Bangladesh and their environmental implications   总被引：3，自引：0，他引：3  

D. K. Datta  V. Subramanian 《Environmental Geology》1997,30(3-4):181-188

 The Bengal basin, Bangladesh, represents one of the most densely populated recent floodplains of the world. The sediment flux through the basin is one of the highest on a global scale. A significant portion of this sediment load find its sink in the basin itself because of its lower elevation and frequent flooding. The textural, mineralogical and chemical nature of the sediments thus have an important bearing on the environmental quality of the basin as well as for the Bay of Bengal. The sediment load of the Ganges-Brahmaputra-Meghna (GBM) river system consists exclusively of fine sand, silt and clay at their lower reaches within the Bengal basin, Bangladesh, and is deposited under uniformly fluctuating, unidirectional energy conditions. The sediments have a close simitarity in grain size with the sediments of the surrounding floodplain. The mineral assemblage is dominated by quartz and feldspars. Illite and kaolinite are the major clay minerals, and occur in almost equal proportion in bed sediments. The heavy mineral assemblage is dominated by unstable minerals which are mostly derived from high-rank metamorphic rocks. The characteristic smaller grain-size, i.e. having large surface-to-mass ratios, and the mineralogy of sediments suggests that they are susceptible to large chemical adsorptive reactions and thus could serve as a potential trap for contaminants. However, the sediments of the GBM river system in the Bengal basin, Bangladesh, shows lower concentration of Pb, Hg and As, and a marginally higher value for Cd as compared to that of standard shale. Considering population density and extensive agricultural practice in the basin, the sediments can in the long run become contaminated. Received: 9 November 1994 · Accepted: 18 June 1996  相似文献   

陆源碎屑沉积作用对化学元素配分的制约——兼论五台地区前寒武纪碎屑沉积岩示踪源区陆壳成分的意义   总被引：1，自引：0，他引：1  

杨忠芳  陈岳龙 《地质论评》1997,43(6):593-600

为探讨粒度分选沉积作用对沉积物化学成分配分的影响,对比研究了五台群中石英岩、长石石英岩、粉砂岩和粘土岩等不同粒度沉积岩的化学成分特征,结果表明:不同粒度沉积岩的主元素及微量元素均具有较大的变化范围,SiO_2与Al_2O_3及TFe_2O_3之间呈线性负相关关系,这种负相关关系还表现在SiO_2与REE,Rb,Sr之间,这种特征可以用石英的稀释作用进行解释;铁族元素Cr,Ni,Co和REE,Rb,Sr等大离子亲石元素与Al_2O_3呈正相关关系,表明这些元素易在富铝的粘土岩中聚积。不同粒度成分沉积岩的稀土  相似文献   

颗粒分析用量筒的规格标准和计量标定     

杨斌娟  马骏  刘燕 《上海国土资源》2004,(4):19-22

文章讨论了国内外用于密度计法颗粒分析用量筒的计量标准的规定，提出了相应的建议和标定方法。  相似文献   

表生风化作用下多年冻土土壤的理论粒径分布     

Igor E. Guryanov 《冰川冻土》2004,26(Z1):70-75

The paper discusses the distinctive features of grain size distribution of permafrost soils formed under conditions of continental lithogenesis and cryogenic weathering of rocks. As a functional consequence of surface erosion of mineral particles, the log-normal distribution of the density function of grain size is derived confirmed for any conditions and sediment types.  相似文献   

A hybrid method for size characterization of coarse subsurface fluvial sediments     

Stephen P. Rice  Judith K. Haschenburger 《地球表面变化过程与地形》2004,29(3):373-389

This paper introduces and evaluates a novel method for ascertaining the grain‐size distribution of subsurface sediments that involves profoundly less sampling effort than standard methods. It is based on hybrid sampling principles previously applied to the construction of synthetic surface grain‐size distributions. The method is developed from an empirical demonstration of the approximate similarity of surface and subsurface grain‐size distributions when compared over a common range of sizes. Subsurface hybrid models are found to provide good facsimiles of grain‐size distributions de?ned using standard criteria and to yield distribution percentiles with millimetre accuracy. The technique is presented as an expedient alternative to standard methods for large, perennial gravel‐bed rivers. As this is a new technique, prudent application is advised in lieu of further investigation. Copyright © 2004 John Wiley & Sons, Ltd.  相似文献   

Grain coarsening in contact metamorphic carbonates: effects of second-phase particles, fluid flow and thermal perturbations   总被引：3，自引：0，他引：3  

A. Berger  M. Herwegh 《Journal of Metamorphic Geology》2004,22(5):459-474

Under contact metamorphic conditions, carbonate rocks in the direct vicinity of the Adamello pluton reflect a temperature‐induced grain coarsening. Despite this large‐scale trend, a considerable grain size scatter occurs on the outcrop‐scale indicating local influence of second‐order effects such as thermal perturbations, fluid flow and second‐phase particles. Second‐phase particles, whose sizes range from nano‐ to the micron‐scale, induce the most pronounced data scatter resulting in grain sizes too small by up to a factor of 10, compared with theoretical grain growth in a pure system. Such values are restricted to relatively impure samples consisting of up to 10 vol.% micron‐scale second‐phase particles, or to samples containing a large number of nano‐scale particles. The obtained data set suggests that the second phases induce a temperature‐controlled reduction on calcite grain growth. The mean calcite grain size can therefore be expressed in the form D = C₂ e^Q*/RT(d_p/f_p)^m*, where C₂ is a constant, Q* is an activation energy, T the temperature and m* the exponent of the ratio d_p/f_p, i.e. of the average size of the second phases divided by their volume fraction. However, more data are needed to obtain reliable values for C₂ and Q*. Besides variations in the average grain size, the presence of second‐phase particles generates crystal size distribution (CSD) shapes characterized by lognormal distributions, which differ from the Gaussian‐type distributions of the pure samples. In contrast, fluid‐enhanced grain growth does not change the shape of the CSDs, but due to enhanced transport properties, the average grain sizes increase by a factor of 2 and the variance of the distribution increases. Stable δ¹⁸O and δ¹³C isotope ratios in fluid‐affected zones only deviate slightly from the host rock values, suggesting low fluid/rock ratios. Grain growth modelling indicates that the fluid‐induced grain size variations can develop within several ka. As inferred from a combination of thermal and grain growth modelling, dykes with widths of up to 1 m have only a restricted influence on grain size deviations smaller than a factor of 1.1. To summarize, considerable grain size variations of up to one order of magnitude can locally result from second‐order effects. Such effects require special attention when comparing experimentally derived grain growth kinetics with field studies.  相似文献   

合理设计岩屑规程保证正常钻进条件——金刚石钻进技术专题之一          下载免费PDF全文

汤凤林  段隆臣  В.Ф.Чихоткин  刘晓阳 《探矿工程》2004,31(6):45-48

论述了正常钻进的条件，提出了合理岩屑规程是保证正常钻进的关键和设计钻头的主要依据之一，讨论了岩屑规程与金刚石钻头唇面工作状态、孔底表面粗糙度和岩屑粒度的关系，提出了相应的建议。  相似文献   

Texture and petrology of modern river, beach and shelf sands in a volcanic back-arc setting, northeastern Japan     

Atsushi  Noda 《Island Arc》2005,14(4):687-707

Abstract The focus in the present study is on characterizing spatial patterns of textural and petrological variabilities, and on evaluating mechanisms influencing the textural and petrological components of modern river, beach and shelf sands in a volcanically active back‐arc tectonic setting. Abashiri Bay and the surrounding area in eastern Hokkaido, Japan, has volcanic source land within a back‐arc region associated with subduction of the Pacific Plate beneath the Okhotsk (North American) Plate. A total of 41 river, beach and shelf sands were obtained for grain‐size and modal composition analyses. Multivariate analytical techniques of hierarchical cluster and principal component analyses were performed on the textural and petrological data for investigating relations among quantitative variables. On the basis of grain‐size data, four sedimentary zones were identified: zone I, palimpsest zone; zone II, relict zone; zone III, modern (proteric) zone; zone IV, coastal sedimentary zone. All sands are feldspatholithic and quartz‐deficient. The framework (quartz, feldspar and rock fragment) modal compositions were also classified into four clusters, A–D. The characteristic components of each cluster are as follows: cluster A, felsic volcanic rock fragments; cluster B, andesitic–basaltic volcanic rock fragments; cluster C, mixed or plagioclase; cluster D, sedimentary rock fragments. Almost all sands in western and central Abashiri Bay belong to cluster A, where the original compositions are influenced by Kutcharo pyroclastic flow deposits. Andesitic–basaltic lava and Neogene volcaniclastic and sedimentary rocks have a major influence on the compositions of shelf sands in eastern Abashiri Bay. The modal compositions are basically controlled by the source lithology. Compositional maturity (percentage of quartz to feldspar and rock fragments; Q/FR%) slightly increased, in order, from river (1.2), zone IV (coastal, 1.7), zone II (relict, 2.2), zone I (palimpsest, 3.6), to zone III (modern proteric, 7.0). Greater maturity in the recycled sediments is indicative of weathering under the sea or abrasion by transportation induced by sea‐level fluctuations, waves, or sea currents. Several controlling factors – (i) source lithological; (ii) mineralogical; (iii) climatic; and (iv) geomorphological controls – might still cause low maturity through all sedimentary zones other than the continental margin sands previously reported.  相似文献   

Testing a statistical curve‐fitting procedure for quantifying sediment populations within multi‐modal particle‐size distributions     

John Leys  Grant McTainsh  Terry Koen  Brian Mooney  Craig Strong 《地球表面变化过程与地形》2005,30(5):579-590

This paper describes a series of tests designed to evaluate the capacity of a personal computer (PC) based statistical curve‐fitting program called MIX to quantify composite populations within multi‐modal particle‐size distributions. Three natural soil samples were analysed by a Coulter Multisizer, and their particle‐size distributions analysed using MIX software to identify the modes, standard deviations and proportions of their composite populations. The particle‐size distributions of the three natural soil samples were then numerically combined in equal proportions using a spreadsheet program to create synthetic particle‐size distributions of known populations. MIX was then tested on the synthetic particle‐size distributions to see if the modes and proportions it identified were similar to those modes and proportions known to characterize the synthetic particle‐size distributions. The main outcome is that MIX can very accurately describe the modal particle size and proportions of the major composite populations within a particle‐size distribution. However MIX has difficulty in identifying small populations (those contributing <10 per cent of a total particle‐size distribution), particularly when they are located in the central sections of particle‐size distributions, overlain by larger populations, or when positioned in the fine tails of distributions. Despite these minor shortcomings, MIX is a valuable tool for the examination and interpretation of particle‐size data. Copyright © 2005 John Wiley & Sons, Ltd.  相似文献   

Kinetic energy–rainfall intensity relationship for Central Cebu, Philippines for soil erosion studies     

Ricardo L. Fornis  Hans R. Vermeulen  Jan D. Nieuwenhuis 《Journal of Hydrology》2005,300(1-4):20-32

In the study of soil erosion, specifically on detachment of soil particles by raindrop impact, kinetic energy is a commonly suggested indicator of the raindrop's ability to detach soil particles from the soil mass. Since direct measurement of kinetic energy requires sophisticated and costly instruments, the alternative approach is to estimate it from rainfall intensity. The present study aims at establishing a relationship between rainfall intensity and kinetic energy for rainfalls in Central Cebu, Philippines as a preface of a wider regional investigation.

Drop size distributions of rainfalls were measured using the disdrometer RD-80. There are two forms of kinetic energy considered here. One is kinetic energy per unit area per unit time (KE_R, J m⁻² h⁻¹) and the other is kinetic energy per unit area per unit depth (KE, J m⁻² mm⁻¹). Relationships between kinetic energy per unit area per unit time (KE_R) and rainfall intensity (I) were obtained using linear and power relations. The exponential model and the logarithmic model were fitted to the KE–I data to obtain corresponding relationships between kinetic energy per unit area per unit depth of rainfall (KE) and rainfall intensity (I). The equation obtained from the exponential model produced smaller standard error of estimates than the logarithmic model.  相似文献