Field calibration and performance of sediment traps in a eutrophic holomictic lake   总被引：1，自引：0，他引：1  

R. J. Flower 《Journal of Paleolimnology》1991,5(2):175-188

In wind-stressed and unstratified Lough Neagh low aspect ratio sediment traps, which allow for internal resuspension, collected sediment at a rate close to the natural sediment accumulation rate inferred from dated sediment cores. High aspect ratio traps grossly overestimated the natural rate of sediment accumulation as did, but to a lesser extent, burial rate measurements on an artificial stratigraphic marker. The former type of trap deployed over long exposure periods is therefore recommended as providing the best estimate of net downward particle flux in lakes such as Lough Neagh. However, it is emphasized that all sediment trap types, when operated in shallow turbulent lakes, will to a greater or lesser extent be contaminated by secondary or redeposited material and so will not provide a direct measure of primary sedimentation. Use of tube traps in lakes such as Lough Neagh should not, however, be discounted since they can provide a record of the quality of sedimenting material through time.  相似文献   

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength   总被引：2，自引：0，他引：2  

S. Okubo  K. Fukui  Qi Qingxin 《International Journal of Coal Geology》2006,68(3-4):196-204

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.  相似文献   

XANES analysis of the mechanisms of arsenic removal in biological iron and manganese treatment unit     

Yoko Fujikawa Daisuke Yoneda Atushi Minami Hiroshi Yashima Toshio Tonokai Sotoji Tani Masami Fukui Tatuhide Hamasaki Masataka Sugahara 《中国地球化学学报》2006,25(B08):113-113

Biological iron and manganese removal utilizing indigenous iron and manganese oxidizing bacteria （IRB hereafter） in groundwater can also be applied to arsenic removal according to our pilot-scale test. The arsenic removal probably occurred through sorption and complexation of arsenic to iron and manganese oxides formed by enzymic action of IRB. We investigated the chemical properties of iron and manganese oxides in IRB floc and the valence state of arsenic sorbed to the floc to clarify the mechanisms of the arsenic [especially As （Ⅲ）] removal. The floc samples were collected from two drinking water plants using IRB （Jyoyo and Yamatokoriyama, Japan）, and our pilot - scale test site where arsenic and iron removal using IRB is under way （Mukoh, Japan）. The Jyoyo and Yamatokoriyama IRB floc samples were subjected to As （Ⅲ） and As（Ⅴ） sorption experiments. The elemental composition of the floc samples was measured. XANES spectra were collected on As, Fe and Mn K-edges at synchrotron radiation facility Spring 8 （Hyogo, Japan）. FT-IR and the X-ray diffraction spectra of the samples were also obtained. The IRB floc contained ca. 35 % Fe, 0.3%-3.5% Mn and 2%-6% P. The samples were highly amorphous and contained ferrihidrites and hydrated iron phosphate. According to XANES analyses of IRB, As associated with IRB was in ＋5 valence state when As （Ⅲ） （or As （Ⅴ）） was added in laboratory sorption test, Fe in ＋3 valence state, and Mn a mixture of＋3 and ＋4 valence states. Small shift was observed in the XANES spectra of IRB on As K-edge as the equilibration time of the sorption experiment was increased. Gradual oxidation of a small amount of As （Ⅲ） associated with IRB or change in arsenic binding with sorption site were the probable mechanism.  相似文献   

Ecological risk assessment for heavy metal contamination of a new consideration Agricultural soils     

《中国地球化学学报》2006,25(B08):123-123

  相似文献   

Treatment of high fluoride concentration wastewater by layered double hydroxides： Mechanism studies   总被引：1，自引：0，他引：1  

Liang LU Jing HE 《中国地球化学学报》2006,25(B08):160-161

An appropriate concentration of fluoride in drinking water is required to prevent dental cavities, but long-term ingestion of water that contains more than a suitable level of fluoride can cause bone disease and mottling of the teeth. Fluoride ions can be found in wastewater from the fluoride chemical industry, as well as the semiconductor, metal processing, fertilizer, and glass-manufacturing industries. The discharge standard for fluoride in industrial wastewater in China is 10 mg/L. Efficient treatment of fluoride-containing wastewater is therefore of major concern in China, following the rapid development of the fluoride chemical industry. Several methods have been used to remove fluoride from water, such as adsorption, chemical precipitation, electrodialysis, ion exchange and electrochemical processes. Layered double hydroxides （LDHs） are anionic clays with high anion exchange capacities which are effective adsorbents for removal of a variety of anionic pollutants. LDHs have been studied as potential adsorbents for removing toxic anionic species such as CrO4^2-, TcO4^-, SeO3^2-, pesticides, and anionic surfactants from aqueous systems. One of the main attractions of using LDHs for fluoride removal, is that unlike other chemical treatment methods, no chemical sludge should be produced. In the present study, an attempt was made to investigate the mechanism of fluoride removal by LDHs under different conditions using batch methods. In addition, the release of fluoride adsorbed on LDHs by treatment with an aqueous solution of Na2CO3 was studied. The residual fluoride was found to be 10 mg/L in a solution with an initial concentration of 1000 mg/L, which meets the discharge standard for fluoride in industrial wastewater in China.  相似文献   

3-D seismic structure of the source area of the 1993 Latur, India, earthquake and its implications for rupture nucleations   总被引：1，自引：0，他引：1  

S. Mukhopadhyay  O.P. Mishra  D. Zhao  J.R. Kayal 《Tectonophysics》2006,415(1-4):1-16

The Latur earthquake (M_w 6.1) of 29 September 1993 is a rare stable continental region (SCR) earthquake that occurred on a previously unknown blind fault. In this study, we determined detailed three-dimensional (3-D) P- and S-wave velocity (V_p, V_s) and Poisson's ratio (σ) structures by inverting the first P- and S-wave high-quality arrival time data from 142 aftershocks that were recorded by a network of temporary seismic stations. The source zone of the Latur earthquake shows strong lateral heterogeneities in V_p, V_s and σ structures, extending in a volume of about 90 × 90 × 15 km³. The mainshock occurred within, but near the boundary, of a low-V_p, high-V_s and low-σ zone. This suggests that the structural asperities at the mainshock hypocenter are associated with a partially fluid-saturated fractured rock in a previously unknown source zone with intersecting fault surfaces. This might have triggered the 1993 Latur mainshock and its aftershock sequence. Our results are in good agreement with other geophysical studies that suggest high conductivity and high concentration of radiogenic helium gas beneath the source zone of the Latur earthquake. Our study provides an additional evidence for the presence of fluid related anomaly at the hidden source zone of the Latur earthquake in the SCR and helps us understand the genesis of damaging earthquakes in the SCR of the world.  相似文献   

Flotation and depression control of arsenopyrite through pH and pulp redox potential using xanthate as the collector     

A. López Valdivieso  A.A. Sánchez López  C. Ojeda Escamilla  M.C. Fuerstenau 《International Journal of Mineral Processing》2006

The role of pH and pulp redox potential (E_H) to control the flotation and depression of arsenopyrite has been investigated through studies on microflotation of arsenopyrite crystals and batch flotation of an arsenopyritic ore using isopropyl xanthate as collector. The transition between flotation and depression of arsenopyrite is established by the reversible potential of the xanthate/dixanthogen couple. Adsorption of arsenate ions on ferric hydroxide has been studied through electrokinetics to delineate mechanisms involved in the depression of arsenopyrite using oxidants. Chemical binding between arsenate species and ferric hydroxide sites on arsenopyrite is suggested as the mechanism responsible for depression of arsenopyrite. E_H conditions are given for the flotation and depression of arsenopyite at various pH values for the arsenopyritic ore.  相似文献   

Continuous air rate measurement in flotation cells: Some fundamental considerations     

J.A. Torrealba-Vargas  J.A. Finch 《International Journal of Mineral Processing》2006

A robust and reliable sensor to measure gas (air) superficial velocity (J_g) continuously in flotation systems is introduced. It is based on the sampling of bubbles by buoyancy with the accumulating air allowed to exit through an orifice. At steady state, pressure drop is measured and related to the J_g by prior calibration. The continuous device is readily automated and extended to a multi-unit set-up. The sensor and data collections are described. The governing gas flow equation and models of the dynamic response to air flow rate set point change and fluctuations in froth depth are derived. Model predictions are confirmed against plant data. By taking a moving average, the J_g remains valid in the face of typical plant disturbances.  相似文献   

Chloride removal from wastewater by thermally treated hydrotalcite     

《中国地球化学学报》2006,25(B08):255-256

  相似文献   

A Comparison of Sediment Varves (1950–2003 AD) in Two Adjacent Lakes in Northern Sweden     

V. Gälman  G. Petterson  I. Renberg 《Journal of Paleolimnology》2006,35(4):837-853

Koltjärnen and Nylandssjön are two closely situated lakes (<2 km apart) in northern Sweden. During the past century, distinct varved sediments have formed in these lakes. Nylandssjön has two varved, deep basins. Since lake and catchment characteristics superficially appear very similar for the two lakes and they are exposed to the same climate, one would expect the sediment varves to be similar. This investigation compares the varves in the two deep basins of Nylandssjön, and in the two lakes. The comparison of basins of Nylandssjön shows that varve thickness, water content and annual accumulation rates of organic matter and nitrogen are correlated for the period (1970–2003). The grey-scale curves are only clearly similar in about 50% of the varves. In the between-lake comparison varve thickness, water content and annual accumulation rates of organic matter and nitrogen are correlated for the period (1950–1996). However, the annual accumulation rates of dry mass, minerogenic matter and biogenic silica differ between the lakes, as well as within-varve successions in grey-scale. A general explanation to the differences is that the prerequisites for varve formation are not totally similar because of differences in catchment size, catchment- to-lake material fluxes, lake productivity and land-use influence. This study illustrates the complex relationships that exist between a lake, its catchment, in-lake productivity and formation of sediment varves. As a consequence, we must not apply a too simplistic view of the potential of varves as past climatic indicators, especially if the lakes are affected by land-use.  相似文献