2008年夏季南海北部海区生物光学特性的垂向变化特征     

王桂芬  周雯  许占堂  徐文龙  杨跃忠  曹文熙 《海洋学报(英文版)》2020,39(4):42-56

Vertical variability in the bio-optical properties of seawater in the northern South China Sea(NSCS) including inherent optical properties(IOPs) and chlorophyll a concentration(Chl) were studied on the basis of in situ data collected in summer 2008 using an absorption/attenuation spectrophotometer. An empirical model was developed to estimate Chl profiles based on the absorption line height at long wavelengths, with a relative root mean square error of 37.03%. Bio-optical properties exhibited large horizontal and vertical spatial variability. As influenced by coastal upwelling and the Zhujiang River(Pearl River) discharge, both IOPs and Chl exhibited high values in the surface waters of the inner shelf, which tended to decrease with distance offshore. Subsurface maximum layers of IOPs and Chl were observed in the middle and outer shelf regions, along with significantly higher values of attenuation coefficients beneath this layer that rapidly increased towards the bottom. In the open ocean, both IOPs and Chl exhibited consistent variability, with the subsurface maximum layer typically located at34–84 m. Phytoplankton were found to be one of the major components in determining the vertical variability of bio-optical properties, with their vertical dynamics influenced by both physical forcing and light attenuation effects. The depth of the subsurface maximum layer was found to be closely related to the fluctuation of the oceanic thermocline and the depth of the euphotic zone, which also affected the total integrated biomass of the upper ocean. Typically high values of attenuation coefficients observed in the bottom waters of the continental shelf reflected the transport of particulate matter over the bottom boundary layer. Our results reveal large spatial differences in bio-optical profiles in response to complex marine ecodynamics in the NSCS. From the perspective of marine research, high-resolution optical measurements are clearly advantageous over conventional bottle sampling.  相似文献   

Using recycled calcium sources to solidify sandy soil through microbial induced carbonate precipitation     

Shihua Liang  Juntao Chen  Jiuge Niu  Deluan Feng 《Marine Georesources & Geotechnology》2020,38(4):393-399

Abstract

The use of calcium solutions is a cost-limiting factor for bio-cement production from microbially induced carbonate precipitation (MICP). The aim of this article is to analyse the feasibility of using recycled calcium sources to solidify sand, including oyster shells, scallop shells and eggshells, by comparing the physical and mechanical properties and microstructural characteristics of solidified sand with different recycled calcium sources and chemical calcium nitrate. The results show that oyster shells have the optimal effect on MICP, with values of permeability, dry density, unconfined compressive strength and calcium carbonate precipitation of 1.12?×?10^?4 m s^?1, 2.09?g cm^?3, 1454.6?kPa and 15.28%, respectively. Strength values of bio-cemented sands made from different recycled calcium sources in this article range from 845.1 to 1454.6?kPa. According to the SEM and XRD analysis, calcium carbonates originating from the above recycled calcium sources precipitate as globular vaterite, whereas the precipitation from calcium nitrate is a cluster mixture of vaterite and calcite. Oyster shells, scallop shells and eggshells derived from kitchen waste, which is more economical and environmentally friendly than calcium nitrate, can be applied as recycled calcium solutions in MICP.  相似文献   

Numerical simulations on cutting of frozen soil using HJC Model     

WenQiang Zhang  YongHong Niu 《寒旱区科学》2020,12(3):134-143

Numerical simulation is known as an effective method for mechanical properties during frozen soil excavation. In order to reveal the development of cutting force, effective stress and cutting fragments in frozen silt during the cutting process, we introduce an explicit finite element program LS-DYNA to establish a two-dimensional numerical model of the frozen soil cut. We also use the Holmquist-Johnson-Cook(HJC) damage constitutive model for simulating the variation of soil mechanical properties according to the strong dependence between the cutting tool and frozen silt during the process with different cutting depths, angles and velocities. Meanwhile, a series of experimental results are acquired of frozen silt cutting to prove the application of the HJC model during simulation of cutting force variations. The result shows that the cutting force and fragment size are strongly influenced by cutting depths and cutting velocities increased, and the maximum effective stress at points where the tool contacts frozen soil during the cutting process. In addition, when the cutting angle is 52°, the cutting force is the smallest, and the cutting angle is optimum. Thus, the prediction of frozen soil mechanical properties on the cutting process by this model is conducive to selecting machinery equipment in the field.  相似文献   

基于Chirp数据和Biot-Stoll模型反演南海北部陆坡海底表层沉积物物理性质   总被引：1，自引：1，他引：0  

周庆杰  李西双  刘乐军  刘洋廷  高珊  周航  王景强  李天光 《海洋学报》2020,42(3):72-82

浅地层剖面是基于声学信号(频率在几百至几千赫兹)在沉积物中的传播得到可反映沉积地层结构的数据，海底反射系数与沉积物物理性质密切相关。Biot-Stoll声波传播理论模型可以预测海底沉积物的物理性质，构建反射系数等声学参数与物理参数之间的关系，但在不同的海域采用不同的参数所获得的效果不同。为此，本文基于南海北部陆坡海底表层沉积物的实测物理参数，利用Biot-Stoll模型建立研究区海底反射系数和沉积物物理性质之间的关系，结果表明模型计算值与样品实测值吻合度总体较好，偏差在0.1%～4.9%之间，并建立了频率3.5 kHz时海底反射系数与沉积物孔隙度、密度、平均粒径之间的关系方程，且方程拟合度较高，可决系数R2均大于0.99。在对典型Chirp剖面数据计算其海底反射系数的基础上，反演了海底表层沉积物的孔隙度、密度、颗粒平均粒径等物理性质，其中反演孔隙度、密度、平均粒径与实测孔隙度、密度、平均粒径相对误差均小于5%，结果与实测值基本相符，表明该反演方法在南海北部陆坡区的应用是可行的。  相似文献   

A scale‐invariant property of the water retention curve in weakly heterogeneous vadose zones     

Gerardo Severino  Samuele De Bartolo 《水文研究》2019,33(7):1032-1039

Abrupt changes of hydraulic properties in a vadose zone are modelled within a stochastic framework, which regards the saturated conductivity and parameters related to the distribution of soil pores as stationary, log‐normally distributed, random space functions. As a consequence, flow variables become random fields, and we aim at deriving an effective Richards equation. To obtain the latter, we adopt a perturbation expansion truncated at the first order (weakly heterogeneous media), which leads to the effective hydraulic conductivity and water retention curves. Overall, the effective properties are scale dependent. However, within the proposed framework, we demonstrate that the inflection point of the laboratory scale retention curve is not affected by the heterogeneity of the vadose zone. Finally, to illustrate the quantitative implications of our results, we consider a monitoring experiment at field scale, and we show how our approach leads to an effective water retention curve, which differs significantly from that which would be obtained without accounting for the above scale‐invariance property.  相似文献   

马里亚纳海沟表层沉积物物理性质与微观结构初探     

戴旭  单仁亮  孔祥松  阳宁  孙嵩 《海洋工程》2019,37(2):150-156

针对取样于141°48.700 8'E,11°11.698 8'N,深度为8 638 m的马里亚纳海沟海底表层沉积物,考虑该沉积物中的孔隙水为海水,提出一种测定其基本物理性质指标的修正方法,并测定其相关的物理性质指标,最后通过扫描电子显微镜观察其微观结构。研究结果表明:本次取样处的深海海底表层沉积物具有极高的含水率、高孔隙率、低密度、低比重、高饱和度等特性。考虑海水中盐分影响的修正后,该土样的含水率比修正前提高了11.68%,比重比修正前降低了7.66%。该沉积物显微结构以絮凝结构为主,中间夹杂着大量多孔隙的硅藻碎片和生物体的空壳,这使得该沉积物中的孔隙数量增多。研究结果将有助于了解马里亚纳海沟地区的深海沉积环境和历史,为深海集矿车的设计提供参考。  相似文献   

A three‐dimensional staggered finite element approach for random parametric modeling of thermo‐hygral coupled phenomena in porous media     

F. Meftah  S. Dal Pont  B. A. Schrefler 《国际地质力学数值与分析法杂志》2012,36(5):574-596

The aim of this paper is to present a three‐dimensional (3D) finite element modeling of heat and mass transfer phenomena in partially saturated open porous media with random fields of material properties. Randomness leads to transfer processes within the porous medium that naturally need a full 3D modeling for any quantitative assessment of these processes. Nevertheless, the counterpart of 3D modeling is a significant increase in computations cost. Therefore, a staggered solution strategy is adopted which permits to solve the equations sequentially. This appropriate partitioning reduces the size of the discretized problem to be solved at each time step. It is based on a specific iterative algorithm to account for the interaction between all the transfer processes. Accordingly, a suitable linearization of mass convective boundary conditions, consistent with the staggered algorithm, is also derived. After some validation tests, the 3D numerical model is used for studying the drying process of a cementitious material with regard to its intrinsic permeability randomness. Copyright © 2011 John Wiley & Sons, Ltd.  相似文献   

Characterizing the changing environment of cropland in the Songnen Plain,Northeast China,from 1990 to 2015     

Zhang  Yuan  Zang  Shuying  Sun  Li  Yan  Binghe  Yang  Tianpeng  Yan  Wenjia  Meadows  Michael E.  Wang  Cuizhen  Qi  Jiaguo 《地理学报(英文版)》2019,29(5):658-674

Journal of Geographical Sciences - Quantitative characterization of environmental characteristics of cropland (ECC) plays an important role in maintaining sustainable development of agricultural...  相似文献   

Preparation and characterization of magnetic resin made from chitosan and cerium     

Lina Yu  Dongfeng Wang  Haiyan Li  Bingjie Liu  Xingyu Wang  Ying Xu 《中国海洋大学学报(英文版)》2010,9(2):185-192

In this study,the water-based ferromagnetic fluid and magnetic resin made from chitosan and cerium complex(MRCCC) were successfully prepared by using the chemical co-precipitation technique and by the reversed-phase suspension cross-linking polymerization.MRCCC presented uniform and narrow particle size distribution as determined by the Laser Particles Sizer.The Inductively Coupled Plasma-Atomic Emission Spectrometry(ICP-AES),Fourier transform infrared spectroscopy(FT-IR),differential scanning calorimetry(DSC)and X-ray powder diffraction(XRD)study demonstrated that there were iron and cerium existing in MRCCC.The movement of MRCCC under magnetic field proved its magnetic property.The swelling kinetics in water or solutions with different pH indicated that MRCCC could be applied in solutions with pH greater than 1.0.The ferromagnetic fluid particles were stable in MRCCC soaked in solutions with pH >2.0.In view of these results,MRCCC can be used as material for separation,clarification,adsorption,sustained release and hydrolysis activity.  相似文献   

微波真空干燥波纹巴非蛤肉工艺的研究     

张常松  张良  刘书成  高加龙  卢虹玉 《广东海洋大学学报》2010,30(3):95-98

采用微波真空干燥方法对波纹巴非蛤肉进行干制,探究微波真空干燥的最佳工艺条件。结果表明:微波真空干燥的最佳工艺条件为微波功率2.66 kW,真空度0.08 MPa,预煮盐水质量分数8%,达到干燥终点5 min左右;与热风干燥相比,微波真空干燥贝肉的物理及感官特性优于热风干燥的贝肉,而且干燥速度快、时间短。  相似文献