Fundamental study for morphodynamic modelling: Sand mounds in oscillatory flows     

P.K. Stansby  J. Huang  D.D. Apsley  M.I. García-Hermosa  A.G.L. Borthwick  P.H. Taylor  R.L. Soulsby 《Coastal Engineering》2009

Experiments on sand mounds in oscillatory flow, undertaken in controlled, large-scale laboratory conditions, have produced well-defined data sets for model comparison. Three bathymetries with different levels of submergence, including a surface-piercing case, were tested. The maximum slope was about 1:5.5. Sediment transport is due to bed load with ripple formation. The principal time-dependent bulk parameters are the vertical distance of the centre of gravity above the base and the volume of the mound. A semi-implicit finite-volume depth-averaged hydrodynamic model is used to drive morphodynamics, using van Rijn's sediment flux model generalized to take account of bed slope, and some justification is given for depth-averaged modeling in these conditions. Starting the model runs with the conditions at the end of the first cycle avoided initial atypical physical behaviour. In general good predictions were obtained with an angle of repose reduced from the standard value of about 30° for stationary beds to 15°. For these situations, morphodynamics was largely unaffected by a hydrodynamic roughness height in the range 2.5D₅₀ to 51D₅₀, with larger values accounting for ripple roughness. The reduced angle of repose may be physically expected with mobile beds but this specific value is only expected to be suited to this form of bed motion. In one case an exaggerated ripple formed near the top of the mound reducing agreement with experiment. For the submerged case with normal ripple structure excellent predictions were obtained. For the initially surface-piercing mound, the time of submergence was better predicted with a 30° angle of repose, presumably due to the prominent influence of the near stationary bed near the wet/dry interface, although long term predictions were better predicted with 15°. The occurrence of vortex shedding in the first cycle modeled was in agreement with experimental observation.  相似文献   

Adaptive Predictive Inverse Control of Offshore Jacket Platform Based on Rough Neural Network     

崔洪宇  赵德有  周平 《中国海洋工程》2009,23(2):185-198

The offshore jacket platform is a complex and time-varying nonlinear system,which can be excited of harmful vibration by external loads.It is difficult to obtain an ideal control performance for passive control methods or traditional active control methods based on accurate mathematic model.In this paper,an adaptive inverse control method is proposed on the basis of novel rough neural networks (RNN) to control the harmful vibration of the offshore jacket platform,and the offshore jacket platform model is established by dynamic stiffness matrix (DSM) method.Benefited from the nonlinear processing ability of the neural networks and data interpretation ability of the rough set theory,RNN is utilized to identify the predictive inverse model of the offshore jacket platform system.Then the identified model is used as the adaptive predictive inverse controller to control the harmful vibration caused by wave and wind loads,and to deal with the delay problem caused by signal transmission in the control process.The numerical results show that the constructed novel RNN has advantages such as clear structure,fast training speed and strong error-tolerance ability,and the proposed method based on RNN can effectively control the harmfid vibration of the offshore jacket platform.  相似文献   

大气负荷对新疆地区地壳形变和地面重力变化的影响     

王海涛  王斌  王伟  章传银 《大地测量与地球动力学》2019,39(2):189-194

基于ECMWF全球大气模型和中国地面气候资料日值数据集中新疆及周边的气象站气压数据,根据弹性地壳形变理论,采用移去-恢复法,利用负荷格林函数法和球谐函数法,计算新疆及周边区域2011～2015年大气负荷变化对地壳垂直、水平形变的影响,同时采用大气导纳方法计算大气变化对地面重力的影响。结果表明,大气负荷对新疆地区垂直形变的影响达到cm级,对地面重力的影响可达10μGal;大气负荷影响具有明显的季节性。  相似文献   

一种适用大旋转角的GPS网三维平差方法     

杜向锋  张兴福  蒋利龙 《测绘科学》2009,34(4)

在工程测量中往往采用工程坐标系,该坐标系坐标轴可能与GPS采用的WGS84坐标系的相应坐标轴间存在较大的旋转角,此时若仍直接按照一般方法进行三维约束平差计算会给结果带来不利影响,本文给出了一种适用大旋转角的GPS网三维平差方法,该方法能够很好地处理大旋转角时直接采用一般三维平差模型计算带来的不利影响,同时又能够获得平差后工程网中各点的点位精度。工程应用表明该方法非常有效,具有很好的应用价值。  相似文献   

三维旋转扫描测量平台设计与实现     

吴俣  叶泽田  孙立业  康永伟 《测绘科学》2009,34(6)

本设计主要用于360°旋转的三维扫描,实现角度数据的实时获取。设计中采用单片机控制交流伺服电机进行自定的角度、速度与方向的旋转并实时上传时间、角度数据至上位机进行处理,实现了对平台旋转精度的控制与检测,着重研究了该传感器误差源的产生,对实际应用中的误差进行了定量分析,利用偏心改正、4分频等方法减少了误差,提高了参数精度。角度范围为360°,角度分辨率为0.01°。  相似文献   

从苏北海岸的进退谈黄河泥沙利用问题     

张天义  张克伟 《河南国土资源》1999,(4)

自１８５５ 年黄河改道北行至今,山东省的渤海湾海岸线向海方面推移了１９ｋｍ ,黄河泥沙的造陆面积达２８２７ｋｍ２ ,而在江苏省北部从双洋口至小丁港１５０ｋｍ 的海岸线上共失去土地１３２０ｋｍ２ 以上。作者认为,可以疏通明清黄河故道作为引黄工程,利用黄河携带的大量泥沙淤积于黄海沿岸,以减缓黄海岸线的侵蚀,还可抑制黄河泥沙沉积而造成的渤海的淤积。  相似文献   

局部角度域波传播步进算法研究   总被引：4，自引：2，他引：2       下载免费PDF全文

高静怀  周艳辉  毛剑  陈文超  吴如山  李幼铭 《地球物理学报》2007,50(1):248-259

本文从非均匀介质中波动方程出发,提出了基于一般标架的相空间（局部角度域）波传播的步进算法. 该方法在构造单程波的步进算法时,在选择标架或正交基等方面有更大的自由度. 我们以不随频率及深度变化且具有变尺度特性的Gabor_Daubechies紧标架为例,给出了单程波传输算子的具体形式及相应的波场步进算法;详细讨论了基于Gabor_Daubechies标架的传输算子的高频渐近展开问题,得出了在高频、小传输步长条件下传输算子的近似解析表达式,并给出使用条件. 通过模型算例,比较了精确传输算子与高频近似传输算子用于非均匀介质中波传播的结果,说明在一定条件下由两者得出的波场几乎是相同的.  相似文献   

城市非点源污染负荷估算研究   总被引：9，自引：3，他引：6       下载免费PDF全文

胡成  潘美霞 《气象与环境学报》2006,22(5):14-18

针对污染地表水环境的城市径流污染源,利用SCS降雨径流模拟建立了城市径流不同土地利用类型径流系数与年降雨量的相关关系,其相关性显著;在不同降雨强度条件下,对典型示范区城市排污口实施降雨过程监测,获得了有代表性的城市径流污染物平均浓度,从而估算出辽宁省城市径流污染负荷总量。  相似文献   

Bearing capacity of strip foundations reinforced with geogrid sheets by using upper bound finite‐element limit analysis     

Jyant Kumar  Jagdish Prasad Sahoo 《国际地质力学数值与分析法杂志》2013,37(18):3258-3277

By using the upper bound finite‐elements limit analysis, with an inclusion of single and two horizontal layers of reinforcements, the ultimate bearing capacity has been computed for a rigid strip footing placed over (i) fully granular, (ii) cohesive‐frictional, and (iii) fully cohesive soils. It is assumed that (i) the reinforcements are structurally strong so that no axial tension failure can occur, (ii) the reinforcement sheets have negligible resistance to bending, and (iii) the shear failure can take place between the reinforcement and soil mass. It is expected that the different approximations on which the analysis has been based would generally remain applicable for reinforcements in the form of geogrid sheets. A method has been proposed to incorporate the effect of the reinforcement in the analysis. The efficiency factors, η_c and η_γ, to be multiplied with N_c and N_γ , for finding the bearing capacity of reinforced foundations, have been established. The results have been obtained (i) for different values of ? in case of fully granular and cohesive‐frictional soils, and (ii) for different rates at which the cohesion increases with depth for a fully cohesive soil. The optimum positions of the reinforcements' layers have also been determined. The effect of the reinforcements' length on the results has also been analyzed. As compared to cohesive soils, the granular soils, especially with higher values of ?, cause a much greater increase in the bearing capacity. The results compare reasonably well with the available theoretical and experimental data from literature. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   

Re‐establishment of soil water repellency after destruction by intense burning in a Mediterranean heathland (SW Spain)     

Antonio Jordán  Félix A. González  Lorena M. Zavala 《水文研究》2010,24(6):736-748

Soil water repellency has been conventionally considered as a fire‐induced effect, but an increasing number of studies have suggested that natural background repellency occurs in many soil types, and many of them have suggested that water repellency can be re‐established over time after being destroyed. An experimental fire was conducted to study changes of the soil surface during the first 18 months following intense burning. The main objectives of this paper are as follows: (1) to investigate in situ water repellency changes at three soil depths (0, 2 and 4 cm) immediately after burning; (2) to evaluate the medium‐term evolution of water repellency under field conditions; and (3) to outline the main hydrological consequences of these changes. Also, different water repellency tests (water drop penetration time, ethanol percentage test (EPT) and contact angle (CA) between water drops and the soil surface) were carried out for comparison purposes. Field experiments showed that soil water repellency was partly destroyed after intense burning. Changes were relatively strong at the soil surface, but diminished progressively with depth. Levels of water repellency were practically re‐established 18 months after burning. This suggests that water repellency in the studied area is not necessarily a consequence of fire, but can instead be a natural attribute. Finally, although limited in time, destruction of soil water repellency has important consequences for runoff flow generation and soil loss rates, and, indirectly, for water quality. Copyright © 2009 John Wiley & Sons, Ltd.  相似文献