四元体系Na~ ∥Cl~-,CO_3~(2-),B_4O_7~(2-)-H_2O 273K介稳相平衡研究     

《矿物岩石》2008,(4)

采用等温蒸发法研究简单四元体系Na ∥Cl-,CO32-,B4O72--H2O273K时的介稳相平衡,并测定该体系273K平衡液相中各组分的溶解度及密度,该体系的介稳相图和密度组成图显示:该四元体系在273K时的相图由3条溶解度单变量线、3个结晶区及1个共饱和点组成。体系属简单共饱型,无复盐或固溶体形成,3个结晶区分别对应单盐Na2CO3·10H2O,NaCl和Na2B4O7·10H2O。共饱点E处于Na2CO3·10H2O,NaCl及Na2B4O7·10H2O3盐共饱和,所对应的平衡液相组成为w(Na2CO3)=6.81%,w(NaCl)=21.69%,w(Na2B4O7)=0.65%,w(H2O)=70.85%。研究体系在273K下,Na2CO3·10H2O是碳酸钠盐的唯一析出形式,且硼酸钠对碳酸钠有盐析作用。  相似文献   

沸石基储能基元的研究     

杨玉山  董发勤  段涛 《矿物岩石》2008,28(1):13-16

以酸活化沸石为载体,十二醇为储能工质.制备沸石基储能基元,并采用X射线衍射、红外光谱和差示扫描量热等对沸石基储能基元进行表征.结果表明:储能基元在2θ=22.50时的衍射峰变强,相变储能材料十二醇和沸石栽体之间仅仅是简单的嵌合关系.储能基元的相变温度有一定的降低,并且熔融峰变宽.  相似文献   

相控建模技术在羊二庄油田的应用   总被引：1，自引：0，他引：1       下载免费PDF全文

冯国杰  向赞  刘存林 《地质找矿论丛》2008,23(3):240-244

羊二庄油田的明馆储层非均质性严重,高含水、高开发后期的剩余油分布比较复杂,第一次油藏描述中应用传统的确定性建模方法已经不能满足剩余油挖潜的需要.采用RMS相控建模软件,通过构造建模、沉积微相建模、储层物性建模,建立羊二庄油田三维可视化相控地质模型,并实现了与数模软件的无缝接口.  相似文献   

GPS signal acquisition using the repeatability of successive code phase measurements     

Zhen Zhu  Frank van Graas  Janusz Starzyk 《GPS Solutions》2008,12(1):43-53

This paper introduces a new method for GPS signal acquisition, which is based on the repeatability of successive code phase measurements and the M-of-N search algorithm. The performance of the proposed method in terms of probability of signal detection is similar to that of traditional methods, except that the calculation of the probability of detection does not rely on the noise distribution or the Carrier-to-Noise ratio (C/N₀). The code phase repeatability-based method is presented along with equations for probability of detection and probability of false detection. If the distribution of the noise is known, it also provides an estimate of the C/N₀. The proposed method is illustrated for coherent and non-coherent acquisition and C/N₀ estimation.  相似文献   

抗滑桩设计推力计算方法研究   总被引：2，自引：0，他引：2  

和海芳  祁生文  伍法权  贺可强 《工程地质学报》2008,16(5):694-698

滑坡推力是抗滑桩设计推力的重要依据,工程中通常使用剩余推力法来计算滑坡推力。为了比较准确合理地计算出抗滑桩的设计推力,提出了在剩余推力法基础上的一种新的抗滑桩设计推力取值方法。分析极限平衡状态下和工程安全要求下各条块的剩余下滑力,选择合理的桩位,使得抗滑桩位于滑坡体的抗滑段;然后调整桩后滑体的剩余下滑力,其调整量一方面保证桩前桩后滑体满足工程安全要求,另一方面则作为抗滑桩设计推力的修正依据,其过程由程序实现。通过实例证明了该方法的合理性。同时对今后抗滑桩设计推力的合理取值提供了参考作用。  相似文献   

人工边坡潜在滑动面研究——以广州科学城某人工高边坡为例   总被引：2，自引：2，他引：0  

徐佩华  陈剑平  石丙飞  仲志成 《吉林大学学报(地球科学版)》2008,38(5)

运用强度参数的改变对边坡破坏面形迹影响不明显这一特点,在数值模拟过程中通过改变岩体强度参数,有效地获取潜在滑动面的位置和形态,较好地解决了滑动面搜索的难题。将该法应用于广州科学城某人工高边坡稳定性的研究,在三维数值模拟过程中,将强度参数大幅度折减,计算后获得各剖面的剪应变增量图,从这些图中可获得潜在滑动面。这与人们通常将此类边坡的中风化面作为滑动面存在较大差别。将该滑动面运用极限平衡法进行计算,计算结果显示各剖面的安全系数基本都大于1.2,边坡稳定但仍需要加固处理,与三维数值模拟结果相一致。由此认为用这种分析法确定出的潜在滑动面合理、计算结果可靠,可作为搜索边坡潜在滑动面并计算安全系数的方法之一。  相似文献   

On some problems of seismic crustal phase     

葛焕称 《地震学报(英文版)》1995,8(1):57-63

ＯｎｓｏｍｅｐｒｏｂｌｅｍｓｏｆｓｅｉｓｍｉｃｃｒｕｓｔａｌｐｈａｓｅＨｕａｎ－ＣｈｅｎｇＧＥ（葛焕称）（ＳｅｉｓｍｏｌｏｇｉｃａｌＢｕｒｅａｕｏｆＪｉａｎｇｓｕＰｒｏｖｉｎｃｅ,Ｎａｎｊｉｎｇ２１００１４,Ｃｈｉｎａ）Ａｂｓｔｒａｃｔ：Ｉｎｔｈｉｓ...  相似文献   

井下记录的PP和SS震相     

乌统昱  赵惠君 《地震地磁观测与研究》1992,13(2):20-26

本文在系统分析静海台井下地震记录图的基础上,发现并解决了具有一定实际和理论意义的两个问题:其一是证明了最初误认为是干扰的“双脉冲”图形实际上均是微地震。从而指出研究静海周围地区的地震活动性应考虑微震活动问题。其二确认静海周围地区微震波形的4个主要震相是P、PP、S和SS,并对地面反射波PP和SS能够观测到的条件作了初步分析,其结果进一步说明井下地震记录较之地面记录更为“逼真”,复杂和丰富。  相似文献   

Scattering of elastic waves by a fracture zone containing randomly distributed cracks     

Jun Kawahara  Teruo Yamashita 《Pure and Applied Geophysics》1992,139(1):121-144

We theoretically study the scattering ofP, SV andSH waves by a zonal distribution of cracks, which simulates a fault fracture zone. An investigation is conducted how the geometrical properties of the crack distribution and the frictional characteristics of the crack surface are reflected in the attenuation and dispersion of incident waves, as well as in the amplitudes of the transmitted and reflected waves from the zone. If the crack distribution within the fault zone changes temporally during the preparation process of the expected earthquake, it will be important for earthquake prediction to monitor it, utilizing the scattering-induced wave phenomena.We consider the two-dimensional problem. Aligned cracks with the same length are assumed to be randomly distributed in a zone with a finite width, on which elastic waves are assumed to be incident. The distribution of cracks is assumed to be homogeneous and sparse. The crack surface is assumed to be stress-free, or to undergo viscous friction; the latter case simulates fluid-filled cracks. The opening displacement of the crack is assumed to be negligibly small. The idea of the mean wave formalism is employed in the analysis, and Foldy's approximation is assumed.When the crack surface is stress-free, it is commonly observed for every wave mode (P, SV andSH) that the attenuation coefficientQ ^–1 peaks aroundka1, the phase velocity is almost independent ofk in the rangeka<1 and it increases monotonically withk in the rangeka>1, wherek is the intrinsicS wavenumber anda is the half length of the crack. The effect of the friction is to shift the peak ofQ ^–1 and the corner of the phase velocity curve to the low wavenumber range. The high wavenumber asymptote ofQ ^–1 is proportional tok ^–1 independently of model parameters and the wave modes. If the seismological observation thatQ ^–1 ofS waves has a peak at around 0.5 Hz in the earth's crust is combined with our results, the upper limit of crack size within the crust is estimated about 4 km. The information regarding the transmitted and reflected waves, such as the high wavenumber limit of the amplitude of the transmitted wave etc., allows estimation of the strength of the friction.  相似文献   

Effects of dynamic shear strength and time-histories stress analysis on newmark sliding block analyses     

LI Hong-jun  CHI Shi-chun  LIN Gao 《岩土力学》2006,27(Z1):1063-1068

A simplified procedure for evaluating aseismic stability of slope subjected to earthquake shaking, in which the effect of dynamic shear strength and time-history stress on the yielding angular acceleration of sliding block is taken into account, is presented. The fundamental feature of this procedure is the dynamic shear strength. The numerical computations are performed by using the proposed method. It is shown that the computed sliding displacement for a given core dam, with either method of dynamic shear strength properly considered, is more rational compared with the conventional computational results based on static shear strength.  相似文献