Shallow seismicity, stress distribution and crustal deformation pattern in the Andaman-West Sunda arc and Andaman Sea, northeastern Indian Ocean     

M. Radha Krishna  T.D. Sanu 《Journal of Seismology》2002,6(1):25-41

Shallow seismicity and available source mechanisms in the Andaman–westSunda arc and Andaman sea region suggest distinct variation in stressdistribution pattern both along and across the arc in the overriding plate.Seismotectonic regionalisation indicates that the region could be dividedinto eight broad seismogenic sources of relatively homogeneousdeformation. Crustal deformation rates have been determined for each oneof these sources based on the summation of moment tensors. The analysisshowed that the entire fore arc region is dominated by compressive stresseswith compression in a mean direction of N23^°, and the rates ofseismic deformation velocities in this belt decrease northward from 5.2± 0.65 mm/yr near Nias island off Sumatra and 1.12 ±0.13 mm/yr near Great Nicobar islands to as much as 0.4 ±0.04 mm/yr north of 8^°N along Andaman–Nicobar islandsregion. The deformation velocities indicate, extension of 0.83 ±0.05 mm/yr along N343^° and compression of 0.19 ±0.01 mm/yr along N73^° in the Andaman back arc spreadingregion, extension of 0.18 ± 0.01 mm/yr along N125^° andcompression of 0.16 ± 0.01 mm/yr along N35^° in NicobarDeep and west Andaman fault zone, compression of 0.84 ±0.12 mm/yr N341^° and extension of 0.77 ± 0.11 mm/yralong N72^° within the transverse tectonic zone in the Andamantrench, N-S compression of 3.19 ± 0.29 mm/yr and an E-Wextension of 1.24 ± 0.11 mm/yr in the Semangko fault zone ofnorth Sumatra. The vertical deformation suggests crustal thinning in theAndaman sea and crustal thickening in the fore arc and Semangko faultzones. The apparent stresses calculated for all major events range between0.1–10 bars and the values increase with increasing seismic moment.However, the apparent stress estimates neither indicate any significantvariation with faulting type nor display any variation across the arc, incontrast to the general observation that the fore arc thrust events showhigher stress levels in the shallow subduction zones. It is inferred that theoblique plate convergence, partial subduction of 90^°E Ridge innorth below the Andaman trench and the active back arc spreading are themain contributing factors for the observed stress field within the overridingplate in this region.  相似文献   

Optimal placement of dampers and actuators based on stochastic approach     

Franklin Y. Cheng  Hongping Jiang  Xiaozhe Zhang Ph.D. Candidate 《地震工程与工程振动(英文版)》2002,1(2):237-249

A general method is developed for optimal application of dampers and actuators by installing them at optimal location on seismic-resistant structures. The study includes development of a statistical criterion, formulation of a general optimization problem and establishment of a solution procedure. Numerical analysis of the seismic response in time-history of controlled structures is used to verify the proposed method for optimal device application and to demonstrate the effectiveness of seismic response control with optimal device location. This study shows that the proposed method for the optimal device application is simple and general, and that the optimally applied dampers and actuators are very efficient for seismic response reduction.  相似文献   

单层柱面网壳弹塑性地震反应特征   总被引：12，自引：0，他引：12  

薛素铎  曹资  王健宁 《地震工程与工程振动》2002,22(1):56-60

本文对网壳结构的弹塑性抗震性能进行了探讨。根据结构弹性有限元理论，结合网壳结构受力特点，推导出网壳结构单元的弹塑性矩阵表达式。然后对单层柱面网壳结构的弹塑性地震反应进行了具体分析，给出了节点位移和杆件应力变化规律，并讨论了矢跨比变化对网壳弹塑性性能的影响，从而揭示出这类网壳的弹塑性地震反应特点。  相似文献   

结构动力反应分析的三阶显式方法   总被引：14，自引：6，他引：14  

张晓志  程岩  谢礼立 《地震工程与工程振动》2002,22(3):1-8

本通过对传统动力反应分析方法的总结，阐明了建立隐式和显式方法的一般思路及数学本质，提出了使用系统位移反向向量三阶导数的隐工和实用显式积分方法－3阶显式方法，分析了该显式方法的精度和稳定性，并对建立更高阶隐式和显式方法以及方法的精度和稳定性作了初步讨论。最后，通过算例对本方法、献[1]方法和经典的常平均加速度法（隐式方法、视为精确解）的精度和稳定性进行了比较分析。结果表明，本方法具有明显的优点。  相似文献   

高层钢框架-支撑结构二阶非线性随机地震响应分析   总被引：1，自引：0，他引：1  

陈兰  汤海波  梁启智 《地震工程与工程振动》2002,22(3):170-174

针对常用的高层钢框架－支撑结构，考虑材料非线性和几何非线性，建立了框架部分、支撑部分的二阶动力分析模型。用等效线性方法对结构进行非线性随机地震响应分析，结合工程算例，论述不同场地土、不同层数、不同支撑情况下，二阶效应对结构地震响应统计量的影响。  相似文献   

拱坝非线性地震反应分析   总被引：2，自引：0，他引：2  

肖诗云  林皋  李宏男 《地震工程与工程振动》2002,22(4):36-40

本文根据一致粘弹性模型的概念，引入应变率的影响，将混凝土静态William-Warnke三参数模型改造成一致粘塑性William-Warnke三参数本构模型，并用这个模型对某高拱坝进行了非线性地震响应分析，与线弹性模型和应变率无关的William-Warnke三参数模型的结果进行了比较，初步探讨了应变率对拱坝地震反应的影响。  相似文献   

挡块对斜拉桥抗震性能的影响   总被引：1，自引：0，他引：1  

余建星  王新岐 《地震工程与工程振动》2002,22(4):114-119

本文基于现有永和斜拉桥挡块设施的严重破损，引入非线性挡块元，采用有限元计算分析挡块对斜拉桥抗震性能的影响。结果表明，斜拉桥塔根挡块的调协对减震效果影响不大，但挡块具有减小塔顶残余变形的有利作用。鉴于此，对永和斜拉桥挡块进行修复是必要的。  相似文献   

大开间小型混凝土砌块10层模型房屋抗震性能试验研究(Ⅰ)   总被引：8，自引：3，他引：8  

周抚生  郭迅  郑志华  毛国成 《地震工程与工程振动》2002,22(6):58-64

我国抗震设计规范（GB50011－2001）规定在6、7、8度区，混凝土小砌块结构分别可以建七、六、五层。由于混凝土小砌块结构的最大优势在于10－20层（与混凝土框架或框架剪力墙结构比）。本文按1／4比例制作了10层混凝土小砌块结构模型，按7度设防要求实施构造措施，通过振动台试验研究模型结构的抗震性能。结果表明，模型结构完全能够满足在7度区“小震不坏，大震不倒”的要求。圈梁、构造柱以及水平拉结筋构成的约束体系抗震作用是明显的。试验利用砌块的非注芯孔灌注铁砂来模拟墙体出平面动力效应。在本模型的构造措施下，平出面反应不对结构破坏起控制作用。  相似文献   

基于高温高压岩石破裂实验结果对中强地震前震中附近区域部分地震学现象的初步解释   总被引：6，自引：1，他引：6       下载免费PDF全文

蒋海昆  张流  周永胜  侯海峰  晁文海 《地震工程学报》2002,24(2):113-122

依据高温高压岩石破裂实验结果并结合理论分析，对 附近区域不同深度温压条件下岩石变形破坏性质及破坏失稳的力学行为进行了研究，在一次应力加载循环中，发生破坏的部位随时间具有向深部下迁的趋势。考虑到深度温压条件下岩石的渐进式破坏行为及突发失稳，对主震前震中附近区域小地震活动的增强、平静、活化等现象，以及b值等时间序列参数变化的可能机理进行初步探讨，并简单讨论了两类平静和两类b值变化的可能原因。  相似文献   

Recent developments in seismically isolated buildings in Japan     

Shin Okamoto  Nagahide Kani  Masahiko Higashino  Norihide Koshika  Masayuki Kimizuka  Mitsumasa Midorikawa  Masanori Iiba 《地震工程与工程振动(英文版)》2002,1(2):213-225

The Building Standard Law of Japan and related Enforcement Order and Notifications have been substantially revised since the year 2000 to introduce a performance-based regulatory and deregulation system for building control systems. Up to then, time-history analyses were mandatory for isolated buildings and had to be specially approved by the Minster of the Ministry of Construction (MOC). Simplified design procedures based on the equivalent linear method for seismically isolated buildings have been issued as “Notification 2009 — Structural calculation procedure for buildings with seismic isolation” from MOC, and are now integrated into the Ministry of Land, Infrastructure, and Transportation (MLIT). Along with Notification 2009, “Notification 1446 of year 2000 — Standard for specifications and test methods for seismic isolation devices” was also issued. Buildings with heights equal to or less than 60m and that are designed according to these Notifications, including base isolated buildings, only need approval from local building officials, and no longer require the special approval of the Minister of MLIT. This paper summarizes: 1) some statistics related to buildings with seismic isolation completed up to the end of 2001; 2) simplified design procedures required by Notification 2009 of year 2000; and 3) performance of seismic isolation devices required by Notification 1446 of year 2000.  相似文献