3-D seismic structure of the source area of the 1993 Latur, India, earthquake and its implications for rupture nucleations   总被引：1，自引：0，他引：1  

S. Mukhopadhyay  O.P. Mishra  D. Zhao  J.R. Kayal 《Tectonophysics》2006,415(1-4):1-16

The Latur earthquake (M_w 6.1) of 29 September 1993 is a rare stable continental region (SCR) earthquake that occurred on a previously unknown blind fault. In this study, we determined detailed three-dimensional (3-D) P- and S-wave velocity (V_p, V_s) and Poisson's ratio (σ) structures by inverting the first P- and S-wave high-quality arrival time data from 142 aftershocks that were recorded by a network of temporary seismic stations. The source zone of the Latur earthquake shows strong lateral heterogeneities in V_p, V_s and σ structures, extending in a volume of about 90 × 90 × 15 km³. The mainshock occurred within, but near the boundary, of a low-V_p, high-V_s and low-σ zone. This suggests that the structural asperities at the mainshock hypocenter are associated with a partially fluid-saturated fractured rock in a previously unknown source zone with intersecting fault surfaces. This might have triggered the 1993 Latur mainshock and its aftershock sequence. Our results are in good agreement with other geophysical studies that suggest high conductivity and high concentration of radiogenic helium gas beneath the source zone of the Latur earthquake. Our study provides an additional evidence for the presence of fluid related anomaly at the hidden source zone of the Latur earthquake in the SCR and helps us understand the genesis of damaging earthquakes in the SCR of the world.  相似文献   

Continuous air rate measurement in flotation cells: Some fundamental considerations     

J.A. Torrealba-Vargas  J.A. Finch 《International Journal of Mineral Processing》2006

A robust and reliable sensor to measure gas (air) superficial velocity (J_g) continuously in flotation systems is introduced. It is based on the sampling of bubbles by buoyancy with the accumulating air allowed to exit through an orifice. At steady state, pressure drop is measured and related to the J_g by prior calibration. The continuous device is readily automated and extended to a multi-unit set-up. The sensor and data collections are described. The governing gas flow equation and models of the dynamic response to air flow rate set point change and fluctuations in froth depth are derived. Model predictions are confirmed against plant data. By taking a moving average, the J_g remains valid in the face of typical plant disturbances.  相似文献   

Sediment-Based Study of the Effects of Decreasing Mine Water Pollutionon a Heavily Modified, Nutrient Enriched Lake     

T. Kauppila 《Journal of Paleolimnology》2006,35(1):25-37

Ni and Cu mining and ore processing in Hitura, Western Finland, have resulted in emissions of metal-rich wastewaters into the nearby Kalajoki River since 1970. The wastewaters are discharged into the river 3 km upstream from the eutrophic Lake Pidisjärvi, which is a widening of the river by the town of Nivala. The water level of the lake was elevated by 1.5 m and the extensive macrophyte stands were cut in 1979, profoundly changing the environmental conditions. The effects of the decreasing metal emissions and nutrient concentrations since 1979 on the now open 3.9 km² lake were studied with paleolimnological techniques. A 2-m sediment core was taken from the lake in February 2004 and analysed for sediment chemistry and diatom assemblages. At the coring site, 13 cm of sediment had been deposited since 1979, on top of a bed of undecomposed macrophyte remains. When the sediment chemistry was compared with records of decreasing metal loading since 1979, no correlation was found because post-depositional mobility and changes in sediment characteristics affect the sediment metal profiles. Thus, the reduced emissions from the mine and the lower lake water phosphorus levels have not caused a corresponding decrease in sediment metal and P concentrations. However, both of these environmental variables accounted for a statistically significant percentage of variation in the sedimentary diatom assemblages in a redundancy analysis constrained to a single variable. This relationship persisted for Ni loading even in a partial analysis, while the importance of nutrients was confirmed by the good correlation between diatom-inferred and measured P concentrations. The results suggest that reductions in metal and nutrient loading have had an effect on the algal assemblages even though the sediment concentrations of Ni, Cu or P have not decreased.  相似文献   

A Comparison of Sediment Varves (1950–2003 AD) in Two Adjacent Lakes in Northern Sweden     

V. Gälman  G. Petterson  I. Renberg 《Journal of Paleolimnology》2006,35(4):837-853

Koltjärnen and Nylandssjön are two closely situated lakes (<2 km apart) in northern Sweden. During the past century, distinct varved sediments have formed in these lakes. Nylandssjön has two varved, deep basins. Since lake and catchment characteristics superficially appear very similar for the two lakes and they are exposed to the same climate, one would expect the sediment varves to be similar. This investigation compares the varves in the two deep basins of Nylandssjön, and in the two lakes. The comparison of basins of Nylandssjön shows that varve thickness, water content and annual accumulation rates of organic matter and nitrogen are correlated for the period (1970–2003). The grey-scale curves are only clearly similar in about 50% of the varves. In the between-lake comparison varve thickness, water content and annual accumulation rates of organic matter and nitrogen are correlated for the period (1950–1996). However, the annual accumulation rates of dry mass, minerogenic matter and biogenic silica differ between the lakes, as well as within-varve successions in grey-scale. A general explanation to the differences is that the prerequisites for varve formation are not totally similar because of differences in catchment size, catchment- to-lake material fluxes, lake productivity and land-use influence. This study illustrates the complex relationships that exist between a lake, its catchment, in-lake productivity and formation of sediment varves. As a consequence, we must not apply a too simplistic view of the potential of varves as past climatic indicators, especially if the lakes are affected by land-use.  相似文献   

Application of membrane technology for water treatment： Ultrasound-associated cleaning of fouled microfiltration membranes     

Rui CHEN Xiaoli WANG Yonggang ZHANG Xueqi FU 《中国地球化学学报》2006,25(B08):128-129

The use of membranes is a widely employed, versatile, and effective separation process. One of the limiting aspects in applying microfiltration （MF） for wastewater treatment is that of problems with membrane fouling and consequent flux reduction. Membrane fouling occurs by the irreversible deposition of retained particles, colloids, macromolecules, salts, etc. at the membrane surface and/or inside the membrane. The predominant fouling mechanisms observed with MF membranes are classified as three categories： the build-up of a cake layer on the membrane surface, blocking of membrane pores, and adsorption of fouling material on the membrane surface or in the pore walls. Although many techniques have been developed to overcome fouling, studies on membrane cleaning still seem to be insufficient for practical membrane filtration systems. Current membrane cleaning technologies include hydraulic, chemical, and mechanical methods. Ultrasound （US） has been widely used as a method of cleaning materials because of the cavitation phenomenon. In this study, US cleaning technique was applied to removing the fouling of polyvinglidenefluoride （PVDF） MF membrane, which was used to treat yeast cell and isolated soybean protein （ISP） solution, respectively. The US employed 40 kHz frequency and the output power of 1.43-2.85 W/cm^2. The evolution of the cleaning effect is followed by the measurements of the flux recovery rate （FRstat） and the cleaning time cycle. Results showed that the membrane property, which was fouled by yeast cell solution, could be recovered by water cleaning with US irradiation. And the cleaning time with the same FRstat decreased with the increase of US intensity.  相似文献   

基于点重要度的地形LOD简化算法及精度   总被引：1，自引：0，他引：1  

张寅宝王光霞  王国庆 《测绘学院学报》2005,22(4):281-284

在分析、讨论目前关于3维地形模型简化与误差控制方法的基础上,提出了一种基于点重要度进行连续LOD模型简化的算法.并以5种典型地貌的实验数据作为运行实例,给出了点重要度与地貌类型之间的精度关系.这为今后连续LOD模型的合理建立提供了一种新思路和方法,也为模型的简化提供了科学依据.  相似文献   

青藏高原东缘龙门山晚新生代剥蚀厚度与弹性挠曲模拟   总被引：7，自引：3，他引：7       下载免费PDF全文

李勇  ALDENSMORE  周荣军  MA  ELLIS 《地质学报》2005,79(5):608-615

龙门山是青藏高原东缘边界山脉,具有青藏高原地貌、龙门山高山地貌和山前冲积平原三个一级地貌单元。利用数字高程模式图像和裂变径迹年代测定方法研究和计算龙门山晚新生代剥蚀厚度与剥蚀速率,结果表明:3.6 Ma以来龙门山的剥蚀厚度介于1.91-2.16 km之间,剥蚀速率介于0.53-0.60 mm/a之间。在此基础上,开展了该地区岩石圈的弹性挠曲模拟,结果表明龙门山的隆升机制具有以构造缩短隆升和剥蚀卸载隆升相叠合的特点。3.6 Ma之前,龙门山的隆升与逆冲推覆构造负载有关,以构造缩短驱动的构造隆升为特色;3.6 Ma之后,龙门山的隆升与剥蚀卸载驱动的抬升有关,并以剥蚀卸载隆升为特色,进而提出了龙门山晚新生代以来的隆升机制以剥蚀成山作用为主的认识。  相似文献   

现阶段地表油气化探技术难题与发展对策   总被引：2，自引：1，他引：2  

姚俊梅 《物探与化探》2005,29(6):477-480,486

虽然地表油气化探方法技术已取得显著的应用效果, 但是由于成功率计算标准不同及方法技术本身的缺陷, 导致人们对方法的认同度较低。当前, 地表油气化探技术的发展, 一方面要以可靠的实验依据、严谨的数理推导及理论模型应对来自方法技术本身的挑战, 另一方面也要利用其快速、廉价和直接的优势, 加强与地质、遥感、非震物探等方法综合应用。  相似文献   

环境矿物材料治理镉（Cd^2＋）污染研究进展   总被引：4，自引：0，他引：4  

商平  王丽娜 《岩石矿物学杂志》2005,24(6):681-685

近年来,环境矿物材料以其经济、有效、无二次污染等特点,在重金属废水处理和土壤修复方面显示出了众多优势,可替代传统的镉污染处理方法。本文综述了国内外环境矿物材料在处理镉污染方面的研究进展,并对今后应用环境矿物材料治理镉污染提出了一些建议。  相似文献   

中国大陆科学钻探工程主孔100～2000 m 放射性产热元素的垂向分布特征及其成因   总被引：2，自引：0，他引：2       下载免费PDF全文

曾令森刘福来  张泽明杨经绥 许志琴 《中国地质》2005,32(2):230-238

地球内部放射性产热元素U、Th及K(HPE)含量如何随深度的变化而变化是固体地球科学中的一个重要参数,在限定地壳的热和流变学结构、地球化学、岩石和构造模型中起关键性的作用。对HPE深部分布的认识主要来自于对大型花岗岩岩基的研究及对地表热流值和产热率之间关系的模拟,对高压-超高压变质地体的HPE随深度的分布缺乏认识。在苏鲁超高压变质带中实施的中国大陆科学钻探工程届时将提供超过5km的岩心,为确定苏鲁超高压带的HPE结构提供了最好的机会。对CCSD的100～2000m岩心的732块样品详细的放射性产热元素含量的测试及现今产热率计算的初步结果表明:(1)花岗质片麻岩具有最高的产热率,平均为1665×10-11W/kg;(2)副片麻岩(变沉积岩)具有中等的产热率,为994×10-11W/kg;(3)金红石榴辉岩及石榴石橄榄岩具有最低的产热率,为17×10-11～20×10-11W/kg;(4)放射性产热元素的浓度及相应的产热率随岩性的变化而变化,呈现阶梯状的分布特征。产热率随深度的变化特征表明CCSD主孔中的HPE三明治结构。该结构可能代表着高压-超高压变质地体中的典型HPE结构,比大型花岗岩岩基的HPE结构更复杂,与传统的HPE指数衰减分布模式不吻合。CCSD主孔中所揭示的三明治式HPE结构是大陆被动陆缘中的基性及超基性岩、沉积岩及花岗岩在深  相似文献