Lake Sediment Core Records of Sulphur Accumulation and Sulphur Isotopic Composition in Central Ontario, Canada Lakes     

M. Catherine Eimers  Andrew M. Paterson  Peter J. Dillon  Sherry L. Schiff  Brian F. Cumming  Roland I. Hall 《Journal of Paleolimnology》2006,35(1):99-109

Stable isotopic compositions and concentrations of total sedimentary sulphur (S) were determined in cores from 6 lakes in the acid-sensitive Muskoka-Haliburton region of south-central Ontario. The isotopic composition of S in deep sediment (> ~ 20 cm) was approximately constant in all lakes, and indicated a pre-industrial δ ³⁴S value between +4.0 and +5.3‰, which is similar to current bulk deposition. Similarly, total S concentrations in deep sediment were relatively low (1.9–5 mg S g⁻¹ dwt) and approximately constant with depth within cores. All lakes exhibited up-core increases in total S and decreases in δ ³⁴S at a depth corresponding to the beginning of industrialization in the Great Lakes region ( ~ 1900), resulting in a generally reciprocal depth pattern between total S concentration and δ ³⁴S ratios. While initial shifts in total S and δ ³⁴S were likely due to enhanced SO₄ reduction of newly available anthropogenic SO₄, both the magnitude and pattern of up-core S enrichment and shifts in δ ³⁴S varied greatly among lakes, and did not match changes in S deposition post 1900. Differences between lakes in total S and δ ³⁴S were not related to any single hydrologic (e.g., residence time) or physical (e.g., catchment-area-to-lake area ratio) lake characteristic. This work indicates that sediment cores do not provide consistent records of changes in post-industrial S deposition in this region, likely due to redox-related mobility of S in upper sediment.  相似文献   

岩石、土壤样品中210Po测定方法的研究   总被引：1，自引：0，他引：1  

王玉学 《铀矿地质》2005,21(4):248-256

研究了以铜箔为镀片时,自沉积总α计数法定量测定岩石、土壤样品中210Po的最佳制源环境、同位素的干扰和去除、共存元素的允许量以及适宜的溶(熔)矿方法,同时研究了银、铜两种镀片的区别。试验发现,当盐酸浓度为2.0mol/L,恒温80℃,振荡频率为180次/min、振程20mm时,制源2.0h,210Po自镀回收率在99.6%～100.4%之间,210Po加入量与α净计数率线性相关系数为0.9999。放置衰变法可以消除212Bi和218Po等短半衰期核素对210Po测量产生的影响,Vc存在时其它共存元素不干扰测定。方法配合HNO3HFHClO4溶矿(对复杂试样酸溶后的不溶渣,再进行碱熔),全程回收率为99.5%～100.4%。  相似文献   

Elemental particle size distributions. Measured and estimated dry deposition in Sfax region (Tunisia)     

M. Masmoudi  I. Belghith  M. Chaabane 《Atmospheric Research》2002,63(3-4)

Mass size distribution of the crustal elements (Al, Ca, Fe, Mg, Si, Ti), anthropogenic elements (Zn, Mn, Cr, Cu, K, P, Pb) and sea elements (Na, Cl) were obtained from measurements carried out with an inertial cascade impactor in Sfax. A fitting procedure by data inversion was applied to those data. This procedure yields accurate size distributions of aerosols in the diameter range 0.1–25 μm in two different sites. In a coastal industrial site, the mass distribution of the aerosol showed a bimodal structure; and in urban area, the lower particle mode cannot be observed. The elemental dry deposition flux was calculated as a function of particle size. The element flux size distribution increased rapidly with particle size. The modelling results indicate that the majority of the crustal and anthropogenic elements flux (>90%) was due to particles larger than 3 μm in diameter.  相似文献   

山东尚南断块古近系东营组沉积相及其古地理?          下载免费PDF全文

毕义泉 《古地理学报》2002,4(3):19-25

尚南断块位于山东省胜利油田东营凹陷尚店油田西南部。该区的古近系东营组顶底均为不整合面或沉积间断面，发育了较好的湖侵三角洲相沉积。基于100余口钻井、地震资料，70多张单井剖面柱状图编制及14条剖面的对比，进行了东营组精细沉积相研究，编制出30余幅沉积微相投点图和岩相古地理图。研究表明，东营 沉积时期气候潮湿、雨水丰沛、河流纵横、湖泊扩大、湖水变深等为处于斜坡地区的尚南地区发育湖侵期三角洲提供了良好的条件。控制该区沉积和地层发育的区域性物源来自埕宁隆起和鲁西隆起，但来自滨县凸起和林樊家突起的局部物源也有很大影响。东营期岩相古地理经历了早、中、晚期的演化，早期发育了以三角洲平原为主的沉积环境，中期形成了大范围的破坏性三角洲环境，晚期以前三角洲环境为特色。  相似文献   

老柞山金矿田鸡爪沟金矿床地质特征及成因探讨   总被引：1，自引：1，他引：1  

何宝林  赵海鹏 《矿产与地质》2002,16(3):165-167

分析了鸡爪沟金矿床地质特征和成因 ,并对形成过程进行理论推导 ,认为该矿床为与火山作用有关的中温岩浆热液充填型矿床。  相似文献   

Evaluation of the Reduction in Uncertainty Obtained by Conditioning a 3D Stochastic Channel to Multiwell Pressure Data     

Fengjun Zhang  Albert C. Reynolds  Dean S. Oliver 《Mathematical Geology》2002,34(6):715-742

A stochastic channel embedded in a background facies is conditioned to data observed at wells. The background facies is a fixed rectangular box. The model parameters consist of geometric parameters that describe the shape, size, and location of the channel, and permeability and porosity in the channel and nonchannel facies. We extend methodology previously developed to condition a stochastic channel to well-test pressure data, and well observations of the channel thickness and the depth of the top of the channel. The main objective of this work is to characterize the reduction in uncertainty in channel model parameters and predicted reservoir performance that can be achieved by conditioning to well-test pressure data at one or more wells. Multiple conditional realizations of the geometric parameters and rock properties are generated to evaluate the uncertainty in model parameters. The ensemble of predictions of reservoir performance generated from the suite of realizations provides a Monte Carlo estimate of the uncertainty in future performance predictions. In addition, we provide some insight on how prior variances, data measurement errors, and sensitivity coefficients interact to determine the reduction in model parameters obtained by conditioning to pressure data and examine the value of active and observation well data in resolving model parameters.  相似文献   

Spatial variation of overbank aggradation rate and its influence on avulsion frequency   总被引：4，自引：0，他引：4  

Torbjörn E. Törnqvist  John S. Bridge† 《Sedimentology》2002,49(5):891-905

Abstract River avulsions are commonly considered to be driven by the aggradation and growth of alluvial ridges, and the associated increase in cross‐valley slope relative to either the down‐channel slope or the down‐valley slope (the latter is termed the slope ratio in the present paper). Therefore, spatial patterns of overbank aggradation rate over stratigraphically relevant time scales are critical in avulsion‐dominated models of alluvial architecture. Detailed evidence on centennial‐ to millennial‐scale floodplain deposition has, to date, been largely unavailable. New data on such long‐term overbank aggradation rates from the Rhine–Meuse and Mississippi deltas demonstrate that the rate of decrease of overbank deposition away from the channel belt is much larger than has been supposed hitherto, and can be similar to observations for single overbank floods. This leads to more rapid growth of alluvial ridges and more rapid increase in slope ratios, potentially resulting in increased avulsion frequencies. A revised input parameter for overbank aggradation rate was used in a three‐dimensional model of alluvial architecture to study its effect on avulsion frequency. Realistic patterns of avulsion and interavulsion periods (≈1000 years) were simulated with input data from the Holocene Rhine River, with avulsions occurring when the slope ratio is in the range 3–5. However, caution should be practised with respect to uncritical use of these numbers in different settings. Evidence from the two study areas suggests that the avulsion threshold cannot be represented by one single value, irrespective of whether critical slope ratios are used, as in the present study, or superelevation as has been proposed by other investigators.  相似文献   

Quantitative analysis of variations in depositional sequence thickness from submarine channel levees   总被引：2，自引：0，他引：2  

Kenneth I. Skene  David J. W. Piper†  Paul S. Hill 《Sedimentology》2002,49(6):1411-1430

Abstract Thickness variations across‐levee and downchannel in acoustically defined depositional sequences from six submarine channel‐levee systems show consistent and quantifiable patterns. The thickness of depositional sequences perpendicular to the channel trend, i.e. across the levee, decreases exponentially, as characterized by a spatial decay constant, k. Similarly, the thickness of sediment at the levee crest decreases exponentially down the upper reaches of submarine channels and can be characterized by a second spatial decay constant, λ. The inverse of these decay constants has units of length and defines depositional length scales such that k^?1 is a measure of levee width and λ^?1 is a measure of levee length. Quantification of levee architecture in this way allowed investigation of relationships between levee architecture and channel dimensions. It was found that these measures of levee e‐folding width and levee e‐folding length are directly related to channel width and relief. The dimensions of channels and levees are thus intimately related, thereby limiting the range of potential channel‐levee morphologies, regardless of allocyclic forcing. A simple sediment budget model relates the product of the levee e‐folding width and e‐folding length to through‐channel volume discharge. A classification system based on the quantitative downchannel behaviour of levee architecture allows identification of a ‘mid‐channel’ reach, where sediment is passively transferred from the through‐channel flow to the levees as an overspilling flow. Downstream from this reach, the channel gradually looses its control on guiding turbidity currents, and the resulting flow can be considered as an unconfined or spreading flow.  相似文献   

陕西凤县八卦庙金矿床成矿地质特征及外围找矿前景分析   总被引：3，自引：0，他引：3  

张万业  刘方杰  黄长青 《矿产与地质》2003,17(2):136-139

阐述了八卦庙金矿床经历了长期、复杂的非线性成矿过程，着重分析了：含矿建造为与同生伸展断裂伴生的海底喷流热水沉积岩、热水浊积碎屑岩；脆-韧性剪切构造控制着主成矿过程；后期幔源岩浆气液叠加富集使其成为超大型金矿床。指出矿床成因为热水同生沉积细碎屑岩-剪切蚀变岩-幔源岩浆气液叠加富集型。八卦庙金矿床外围仍有巨大的找矿前景。  相似文献   

锡铁山铅锌矿地质特征、矿床成因及找矿标志   总被引：4，自引：1，他引：4  

李如满  汪树栋 《矿产与地质》2003,17(3):218-221

通过找矿工作的实践，认为锡铁山铅锌矿床是由火山喷流沉积—后期热液叠加改造富集的块状硫化物多金属矿床。区域上NW—SE向早古生代形成的裂谷带，三级盆地内沉积的晚奥陶世滩间山群的大理岩与绿片岩系是表区找矿的最佳区段。而绢云绿泥斜长片岩、含碳质绢云绿泥片岩、白色大理岩、条带状大理岩是铅锌矿的最重要的找矿标志。  相似文献