花岗岩残积土动态冲击性能的SHPB试验研究     

刘新宇  张先伟  岳好真  孔令伟  徐超 《岩土力学》2020,41(6):2001-2008

为研究花岗岩残积土的动态冲击性能，开展了高速冲击下的分离式霍普金森压杆（SHPB）试验，与常规应变率下的试验结果比较，分析了高应变率对花岗岩残积土的应力?应变特性和强度的影响。结果表明：低、高应变率下的花岗岩残积土的?-?a（轴向应力?轴向应变）曲线均呈现出软化型。随着应变率 增加，?-?a曲线向?a增大的方向移动，破坏应变?af增加。但高应变率下?af增加的程度更加明显。花岗岩残积土的峰值强度普遍具有应变率依赖性，二者可用直线关系拟合，但低、高应变率下的拟合关系并不一致。提出了率敏性因子m定量评价依赖性强弱。研究发现，随着应变率的提高，强度的应变率依赖性减弱，低应变率下的m为26.694，而高应变率下仅为0.013。相关试验结果指出，高速冲击荷载对土体总体有害。工程中应该采取合理措施控制冲击荷载的危害。该研究有助于深化花岗岩残积土动态冲击性能的理解，为相关工程的施工与设计提供技术参考。  相似文献   

2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析     

高丽娟  邢喜民  高歌  李尚伟 《大地测量与地球动力学》2019,39(10):1002-1006

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。  相似文献   

鄂尔多斯地块周缘垂直形变场负位错反演与应变积累研究     

张希  刘立炜  郝明  白卓立 《大地测量与地球动力学》2019,39(6):551-556

利用鄂尔多斯地块及其周缘1970～2014年的垂直形变速率场资料，借助负位错反演研究该区域长期应变积累。结果表明，地块东北缘山西断陷带中北段年均能量积累增量、剪应力强度都较高，西南缘六盘山断裂与渭河断裂西段次之；山西断陷带中南段至晋陕交界处年均剪应力强度较高且显示一定程度的能量积累；西秦岭构造区尤其西秦岭北缘断裂西段、晋冀蒙交界区也反映一定程度的能量积累特性。  相似文献   

The recognition of former melt flux through high‐strain zones          下载免费PDF全文

Catherine A. Stuart  Sandra Piazolo  Nathan R. Daczko 《Journal of Metamorphic Geology》2018,36(8):1049-1069

High‐strain zones are potential pathways of melt migration through the crust. However, the identification of melt‐present high‐strain deformation is commonly limited to cases where the interpreted volume of melt “frozen” within the high‐strain zone is high (>10%). In this contribution, we examine high‐strain zones in the Pembroke Granulite, an otherwise low‐strain outcrop of volcanic arc lower crust exposed in Fiordland, New Zealand. These high‐strain zones display compositional layering, flaser‐shaped mineral grains, and closely spaced foliation planes indicative of high‐strain deformation. Asymmetric leucosome surrounding peritectic garnet grains suggest deformation was synchronous with minor amounts of in situ partial melting. High‐strain zones lack typical mylonite microstructures and instead display typical equilibrium microstructures, such as straight grain boundaries, 120° triple junctions, and subhedral grain shapes. We identify five key microstructures indicative of the former presence of melt within the high‐strain zones: (a) small dihedral angles of interstitial phases; (b) elongate interstitial grains; (c) small aggregates of quartz grains with xenomorphic plagioclase grains connected in three dimensions; (d) fine‐grained, K‐feldspar bearing, multiphase aggregates with or without augite rims; and (e) mm‐ to cm‐scale felsic dykelets. Preservation of key microstructures indicates that deformation ceased as conditions crossed the solidus, breaking the positive feedback loop between deformation and the presence of melt. We propose that microstructures indicative of the former presence of melt, such as the five identified above, may be used as a tool for recognising rocks formed during melt‐present high‐strain deformation where low (<5%) volumes of leucosome are “frozen” within the high‐strain zone.  相似文献   

Dynamic modelling of retrogressive landslides with emphasis on the role of clay sensitivity          下载免费PDF全文

Xue Zhang  Scott W. Sloan  Eugenio Oñate 《国际地质力学数值与分析法杂志》2018,42(15):1806-1822

This paper presents a detailed numerical study of the retrogressive failure of landslides in sensitive clays. The dynamic modelling of the landslides is carried out using a novel continuum approach, the particle finite element method, complemented with an elastoviscoplastic constitutive model. The multiwedge failure mode in the collapse is captured successfully, and the multiple retrogressive failures that have been widely observed in landslides in sensitive clays are reproduced with the failure mechanism, the kinematics, and the deposition being discussed in detail. Special attention has been paid to the role of the clay sensitivity on each retrogressive failure as well as on the final retrogression distance and the final run‐out distance via parametric studies. Moreover, the effects of the viscosity of sensitive clays on the failure are also investigated for different clay sensitivities.  相似文献   

2017年四川九寨沟7.0级地震前地震应变场分析   总被引：2，自引：1，他引：1       下载免费PDF全文

罗国富  刘忠旺  丁凤和  马禾青  杨明芝 《地震工程学报》2018,40(6):1322-1330

以地震应变场作为地震活动的变量，通过自然正交函数展开方法，计算2017年8月8日四川九寨沟7.0级地震前的地震应变场，提取出震前时间因子的异常变化。计算结果发现应变场前4个时间因子在震前1~3年的中短期异常并不显著，只有第2个和第4个时间因子震前有小幅度的异常变化，分析其原因，时间因子可能受到2008年汶川8.0级地震和2013年岷县漳县6.6级地震前大幅度异常的影响。与时间因子对应的空间等值线形成局部应变高值异常危险区，可能是2013年岷县漳县6.6级地震和2017年九寨沟7.0级地震空间异常的中短期特征。再对比九寨沟7.0级地震前后与松潘-平武7.2级双震的空间异常随时间演变，分析异常发展变化模式的差异，最后应用地震资料的累积频次从物理角度解释异常形成的机制。  相似文献   

Equivalent continuum strain calculations based on 3D particle kinematic measurements of sand          下载免费PDF全文

Siavash Amirrahmat  Khalid A. Alshibli  Maha F. Jarrar  Boning Zhang  Richard A. Regueiro 《国际地质力学数值与分析法杂志》2018,42(8):999-1015

Constitutive modeling of granular materials has been a subject of extensive research for many years. While the calculation of the Cauchy stress tensor using the discrete element method has been well established in the literature, the formulation and interpretation of the strain tensor are not as well documented. According to Bagi, 1 researchers mostly adopt well‐known continuum or discrete microstructural approaches to calculate strains within granular materials. However, neither of the 2 approaches can fully capture the behavior of granular materials. They are considered complementary to each other where each has its own strengths and limitations in solving granular‐mechanics problems. Zhang and Regueiro 2 proposed an equivalent continuum approach to calculating finite strain measures at the local level in granular materials subjected to large deformations. They used three‐dimensional discrete element method results to compare the proposed strains measures. This paper presents an experimental application of the Zhang and Regueiro 2 approach using three‐dimensional synchrotron microcomputed tomography images of a sheared Ottawa sand specimen. Invariant Eulerian finite strain measures were calculated for representative element volumes within the specimen. The spatial maps of Eulerian octahedral shear and volumetric strain were used to identify zones of intense shearing within the specimen and compared well with maps of incremental particle translation and rotation for the same specimen. The local Eulerian volumetric strain was compared to the global volumetric strains, which also can be considered as an averaging of all local Eulerian volumetric strains.  相似文献   

Hypo‐elastic and hyper‐elastic equations of soils          下载免费PDF全文

Koichi Hashiguchi 《国际地质力学数值与分析法杂志》2018,42(13):1554-1564

  相似文献   

川滇块体东边界主要断裂带现今运动特征分析   总被引：2，自引：1，他引：1       下载免费PDF全文

朱爽  王洪栋 《地震工程学报》2018,40(1):79-85

基于2009年以来的GPS观测数据,利用块体模型和GPS剖面方法分别计算川滇块体东边界主要断裂带的滑动速度,并结合跨断裂带的区域应变时间序列分析断裂带现今的运动特征。结果表明:从速度场变化来看,2013—2015期的速度场在川滇块体东北部有东向增加的微弱变化;从滑动速率结果来看,鲜水河北段的左旋走滑运动有所增强,拉张运动有所增加;小江断裂带的左旋走滑运动普遍有微弱的增强;从去掉线性的区域应变时间序列结果来看,小江断裂带南段主张应变在2014年底出现了趋势性转折,值得进一步关注。  相似文献   

基于GPS应变、地震应变率与震源应力场对帕米尔高原现今构造变形特征的分析          下载免费PDF全文

潘正洋  邵志刚  周云  王洵  解孟雨  艾萨·伊斯马伊力 《地球物理学报》2020,63(3):1143-1154

研究帕米尔高原的构造变形特征对于理解印度板块向北推挤过程中的应变分配方式以及应力转换模式具有重要的意义.本文利用区域GPS应变场、地震应变场与震源应力场分析帕米尔高原的构造形变特征.主要结论为:(1)该区域变形主要以NNW-SSE或近N-S向的挤压为主,在高原内部伴有明显的近ENE-WSW或E-W向拉张,应力方向在帕米尔高原与塔吉克盆地区域呈现逆时针旋转的趋势,而在塔里木盆地则显示几乎与帕米尔高原的一致的应力状态,这可能与两侧盆地块体的强度差异有关.(2)安德森断层参数A∅显示帕米尔高原北缘与西侧区域为逆断层应力状态,在高原内部为正断层应力状态,这与GPS应变的结果显示的应变主要集中在主帕米尔断裂与阿莱谷地附近而在高原内部应变较低是一致的,另外应力在喀喇昆仑断裂北段的方向基本平行于断层走向,以及断层北端较低的滑动速率,这说明了地壳挤压缩短可能是帕米尔高原主要的的构造变形特征,并不支持由于边界走滑断裂导致的应变分异或者块体挤出的模式.(3)综合考虑地震应变方向与SHmax从帕米尔北部NNW-SSE方向到天山北部的近N-S方向的转换,GPS应变方向在帕米尔高原两侧盆地都存在不同程度的旋转,应力场安德森参数A∅显示的应力状态以及SKS的结果显示的近ENE-WSW方向,我们认为印度板块向北推挤与天山造山带碰撞导致帕米尔高原不对称的径向逆冲是帕米尔高原现今构造变形的主要成因与构造模式.  相似文献