青藏高原及邻区未来地震活动性趋势数值分析          下载免费PDF全文

董培育  石耀霖  程惠红  乔学军 《地球物理学报》2020,63(3):1155-1169

区域中长期地震危险性数值分析研究,需要对其初始构造应力场有所了解,但目前以及未来一段时期内仍无法直接观测到深部孕震层区域的应力场状况.本文首先基于岩石库仑-摩尔破裂准则,利用青藏高原及邻区百年历史范围内的强震信息,来反演估算该区域的初始应力场.然后,考虑区域构造应力加载及强震造成的应力扰动共同作用,重现了历史强震的发展过程.然而对于初始应力场的反演估算,本文仅能给出区域其上下限的极限值,并不能唯一确定.因此,采用Monte Carlo随机法,进行大量独立的随机试验计算,生成数千种有差异的区域初始应力场模型,且保证每种模型都能令历史强震有序发生,但未来应力场演化过程不尽相同.最后,将数千种模型在未来时间段内的危险性预测结果集成为数理统计结果,据此给出了区域未来的地震危险性概率分布图.初步结果显示未来强震危险性概率较高地区集中在巴颜喀拉块体边界及鲜水河断裂带地区.  相似文献   

波粒相互作用导致环电流质子沉降的卫星共轭观测          下载免费PDF全文

王杰  袁志刚  余雄东  薛祖祥 《地球物理学报》2020,63(6):2131-2140

波粒相互作用是环电流损失的重要机制之一,但波粒相互作用导致的环电流离子沉降而损失迄今为止缺乏直接的观测证据.基于磁层及电离层卫星的协同观测,本文报道了发生在2015年9月7日,由电磁离子回旋波(EMIC波)导致环电流质子沉降的共轭观测事件.在等离子体层的内边界,Van Allen Probe B卫星观测到,存在EMIC波的区域和不存在EMIC波的区域相比,离子通量的投掷角分布的各向异性变弱.我们将Van Allen Probe B卫星沿着磁力线投影到电离层高度,同时在该投影区域内DMSP 16卫星在亚极光区域观测到环电流质子沉降.而且,通过从理论上计算质子弹跳平均扩散系数,我们进一步证实观测的EMIC波确实能将环电流质子散射到损失锥中.本文的研究工作为EMIC波导致环电流质子沉降提供了直接的观测证据,揭示了环电流衰减的重要物理机制:EMIC波将环电流质子散射到损失锥中,从而沉降到低高度大气层中而损失.  相似文献   

Estimation of the 3D correlation structure of an alluvial aquifer from surface-based multi-frequency ground-penetrating radar reflection data     

Zhiwei Xu  James Irving  Kyle Lindsay  John Bradford  Peimin Zhu  Klaus Holliger 《Geophysical Prospecting》2020,68(2):678-689

Knowledge about the stochastic nature of heterogeneity in subsurface hydraulic properties is critical for aquifer characterization and the corresponding prediction of groundwater flow and contaminant transport. Whereas the vertical correlation structure of the heterogeneity is often well constrained by borehole information, the lateral correlation structure is generally unknown because the spacing between boreholes is too large to allow for its meaningful inference. There is, however, evidence to suggest that information on the lateral correlation structure may be extracted from the correlation statistics of the subsurface reflectivity structure imaged by surface-based ground-penetrating radar measurements. To date, case studies involving this approach have been limited to 2D profiles acquired at a single antenna centre frequency in areas with limited complementary information. As a result, the practical reliability of this methodology has been difficult to assess. Here, we extend previous work to 3D and consider reflection ground-penetrating radar data acquired using two antenna centre frequencies at the extensively explored and well-constrained Boise Hydrogeophysical Research Site. We find that the results obtained using the two ground-penetrating radar frequencies are consistent with each other, as well as with information from a number of other studies at the Boise Hydrogeophysical Research Site. In addition, contrary to previous 2D work, our results indicate that the surface-based reflection ground-penetrating radar data are not only sensitive to the aspect ratio of the underlying heterogeneity, but also, albeit to a lesser extent, to the so-called Hurst number, which is a key parameter characterizing the local variability of the fine-scale structure.  相似文献   

Application of surface-wave tomography to mineral exploration: a case study from Siilinjärvi,Finland     

Federico Da Col  Myrto Papadopoulou  Emilia Koivisto  Łukasz Sito  Mikko Savolainen  Laura Valentina Socco 《Geophysical Prospecting》2020,68(1):254-269

In order to assess the feasibility and validity of surface-wave tomography as a tool for mineral exploration, we present an active seismic three-dimensional case study from the Siilinjärvi mine in Eastern Finland. The aim of the survey is to identify the formation carrying the mineralization in an area south of the main pit, which will be mined in the future. Before acquiring the data, we performed an accurate survey design to maximize data coverage and minimize the time for deployment and recollection of the equipment. We extract path-averaged Rayleigh-wave phase-velocity dispersion curves by means of a two-station method. We invert them using a computationally efficient tomographic code which does not require the computation of phase-velocity maps and inverts directly for one-dimensional S-wave velocity models. The retrieved velocities are in good agreement with the data from a borehole in the vicinity, and the pseudo three–dimensional S-wave velocity volume allows us to identify the geological contact between the formation hosting most of the mineralization and the surrounding rock. We conclude that the proposed method is a valid tool, given the small amount of equipment used and the acceptable amount of time required to process the data.  相似文献   

Bidirectional shaking table tests of a low-cost friction sliding system with flat-inclined surfaces     

Miguel B. Brito  Mitsuyoshi Akiyama  Yoshitaka Ichikawa  Hiroki Yamaguchi  Riki Honda  Naomitsu Ishigaki 《地震工程与结构动力学》2020,49(8):817-837

A novel low-cost friction sliding system for bidirectional excitation is developed to improve the seismic performance of reinforced concrete (RC) bridge piers. The sliding system is a spherical prototype developed by combining a central flat surface with an inclined spherical segment, characterized by stable oscillation and a large reduction in response accelerations on the flat surface. The inclined part provides a restoring force that limits the residual displacements of the system. Conventional steel and concrete are employed to construct a flat-inclined spherical surface atop an RC pier. The seismic forces are dissipated through the frictions generated during the sliding movements; hence, the seismic resilience of bridges can be ensured with a low-cost design solution. The proposed system is fabricated utilizing a mold created by a three-dimensional printer, which facilitates the use of conventional concrete to construct spherical shapes. The concrete surface is lubricated with a resin material to prevent abrasion from multiple input ground motions. To demonstrate the effectiveness of the system, bidirectional shaking table tests are conducted in the longitudinal and transverse directions of a scaled bridge model. The effect of the inclination angle and the flat surface size is investigated. The results demonstrate a large decrease in response acceleration when the system exhibits circular sliding displacement. Furthermore, the inclination angle that generates the smallest residual displacement is identified experimentally.  相似文献   

高层高强钢组合偏心支撑框架抗震性能简化分析          下载免费PDF全文

洪敏  秦瑞  王凤  高永国  高中南  李少华 《地震工程学报》2020,42(2):332-336

高强钢组合偏心支撑钢框架是一种新型的抗震结构体系,为分析其抗震性能,利用ABAQUS有限元软件建立了简化分析模型。在验证该简化模型合理有效的基础上,建立了某十层算例的整体模型,施加竖向荷载的同时施加水平倒三角形循环荷载作用,进而分析了该算例的滞回性能。研究表明:本文提出的简化分析模型不仅可以较准确的模拟该结构体系的延性和抗侧刚度,还可以有效预测结构的变形分布和非线性性能。  相似文献   

基于模糊理论的高铁连续梁桥地震风险评估          下载免费PDF全文

冯莉  樊燕燕  王力  李子奇 《地震工程学报》2020,42(3):639-645

以某高速铁路线上一座连续梁桥为例,运用模糊综合评判法,结合基于位移的支座损伤分析和截面曲率的桥墩损伤分析,以全概率理论地震损失模型为基础,提出了基于模糊理论的桥梁系统地震经济风险评估方法。结果表明:综合考虑桥梁系统的模糊地震经济风险分析方法能更全面地计算出连续梁桥在地震作用下的经济损失,仅以桥墩构件代表全桥所得地震经济损失误差较大。基于模糊理论的年预期损失风险框架方法通过结构抗震性能的概率特征可对高速铁路连续梁桥的地震直接经济风险进行全面评估,为该类桥梁的抗震设计、维修加固和灾后重建等方案做出合理评价。  相似文献   

柱顶层间隔震体系增量动力响应研究          下载免费PDF全文

袁梦醒  陈望  刘彦辉  谭平  金建敏 《地震工程学报》2020,42(4):872-880

针对悬臂柱顶有拉梁和无拉梁层间隔震体系的抗震性能问题,运用增量动力分析(IDA)方法进行弹塑性分析,模拟结构从弹性到弹塑性直至最后倒塌的全过程。通过调幅地震动得到相应的层间位移角及峰值加速度,分别绘制单条与多条IDA曲线分析拉梁对隔震结构动力响应的影响,研究两种结构的抗震性能。结果表明:在相同性能点,有拉梁和无拉梁对纤维铰弯矩值和曲率值基本无影响,而在不同性能点,纤维铰状态明显不同;两种体系从正常使用阶段到防止倒塌阶段所需的加速度峰值的差距慢慢增大;在极罕遇地震下,柱顶有拉梁层间隔震体系的下部结构抗震性能要高于柱顶无拉梁层间隔震体系。  相似文献   

重力数据约束的二维地震层析成像在台湾海峡南部的应用     

王笋  闫培  刘善虎 《大地测量与地球动力学》2019,39(3):302-306

地震-重力联合反演可以降低多解性，针对大勘探范围内岩石波速-密度关系存在较大散布的问题，引入交叉梯度结构约束构建统一的目标函数是一种有效的解决方案。利用台湾海峡南部HX-13测线进行验证：由于火成岩侵入体的存在，部分区域难以拾取可靠的地震初至，常规的走时反演无法准确恢复基底面的形态。搜集研究区的船测重力资料，根据地震地质条件和数据特点设置合适的反演参数，实现基于物性和结构双重约束的重力-地震联合反演。由对反演结果的分析和解释可以看出，该方法可在很大程度上弥补地震数据不完备的缺陷，使反演过程稳定，并提高模型的可靠性。  相似文献   

高分辨率反射波地震勘探在城市隐伏断裂探测中的应用——以成都天府新区苏码头断裂为例     

刘远志  刘胜  李大虎  夏友钢  李颖  周德帅 《大地测量与地球动力学》2019,39(9):910-915

采用“三小三高二绝招”的工作方法，通过静校正、多域多方法联合噪音衰减和精细的速度分析获得较高分辨率的地震时间剖面，揭示苏码头断裂的展布位置、构造形态及变形样式等。结果表明，区域构造以冲起式为主，在反冲断层与逆冲断层之间形成冲起构造或逆冲三角构造，在地震剖面上有明显的楔状特征。通过地震测线的断层走向以NE为主，倾向以SE为主，部分断层倾向为NW。  相似文献