Investigating the vibration properties of integrated ceiling systems considering interactions with surrounding equipment     

Liangjie Qi  Keiichiro Kunitomo  Masahiro Kurata  Yoshiki Ikeda 《地震工程与结构动力学》2020,49(8):772-793

Studies on recent earthquakes highlighted that buildings with minimal structural damage still suffer from extensive damage and failure of nonstructural components. The dropping and damage of suspended ceiling systems, which typically consist of acceleration-sensitive nonstructural elements, resulted in lengthy functional disruptions and extended recovery time. This article experimentally and analytically examined the vibration properties of an integrated ceiling system considering the interactions with surrounding electrical equipment. The theoretical stiffness and corresponding frequency of electrical equipment were initially derived and then verified by subsequent vibration tests and numerical analyses. The seismic performance of the air conditioner (AC) was evaluated with different installment configurations based on design spectra and floor response spectra. Vibration tests of the suspended integrated ceiling system considering the interactions with surrounding equipment showed that the inclusion of peripheral constraints increased the first horizontal vibration frequency of the ceiling system by a factor of approximately 6. The natural frequencies of all components in the integrated ceiling system were almost identical, which was attributed to the coupled behavior between the ceiling panels and surrounding equipment, emphasizing the effect of interactions between adjacent components during dynamic analysis. Based on the above experimental investigation, an associated numerical model of the integrated ceiling system was created. Finally, corresponding parametric studies that included the interactions with surrounding equipment, reinforcing braces of ACs and strengthening members at the rise-up location between two elevations were performed.  相似文献   

Bidirectional shaking table tests of a low-cost friction sliding system with flat-inclined surfaces     

Miguel B. Brito  Mitsuyoshi Akiyama  Yoshitaka Ichikawa  Hiroki Yamaguchi  Riki Honda  Naomitsu Ishigaki 《地震工程与结构动力学》2020,49(8):817-837

A novel low-cost friction sliding system for bidirectional excitation is developed to improve the seismic performance of reinforced concrete (RC) bridge piers. The sliding system is a spherical prototype developed by combining a central flat surface with an inclined spherical segment, characterized by stable oscillation and a large reduction in response accelerations on the flat surface. The inclined part provides a restoring force that limits the residual displacements of the system. Conventional steel and concrete are employed to construct a flat-inclined spherical surface atop an RC pier. The seismic forces are dissipated through the frictions generated during the sliding movements; hence, the seismic resilience of bridges can be ensured with a low-cost design solution. The proposed system is fabricated utilizing a mold created by a three-dimensional printer, which facilitates the use of conventional concrete to construct spherical shapes. The concrete surface is lubricated with a resin material to prevent abrasion from multiple input ground motions. To demonstrate the effectiveness of the system, bidirectional shaking table tests are conducted in the longitudinal and transverse directions of a scaled bridge model. The effect of the inclination angle and the flat surface size is investigated. The results demonstrate a large decrease in response acceleration when the system exhibits circular sliding displacement. Furthermore, the inclination angle that generates the smallest residual displacement is identified experimentally.  相似文献   

Simultaneous water and vapour transfer in an unsaturated mudstone in badlands terrain,southwestern Taiwan     

Kohei Higuchi  Masahiro Chigira  Der-Her Lee  Jian-Hong Wu 《地球表面变化过程与地形》2020,45(13):3323-3335

The simultaneous transfer of pore fluid and vapour was studied in the unsaturated shallow subsurface of a Plio-Pleistocene marine mudstone badland slope in southwestern Taiwan during the dry season using field monitoring data and numerical simulations. Data from field monitoring show mass-basis water contents of ~0.05 to ~0.10 that decrease towards the unsaturated ground surface and were invariant during the middle part of the dry season, except for daily fluctuations. In addition, the observed daily fluctuations in water content correlate with fluctuations in bedrock temperature, especially at depths of 2.5–5.0 cm. Periodic increases in water content occurred most notably during the day, when the bedrock temperature showed the greatest increase. Water contents then decreased to the previous state as bedrock temperature decreased during the night. Calculated vapour fluxes within the mudstone during the day increased up to 6 × 10⁻⁶–1 × 10⁻⁵ kg m⁻² s⁻¹, deriving a 0.01–0.02 increase in mass-basis water content at 2.5 cm depth for a 12-h period. This agrees with field monitoring data, suggesting that increases in water content occurred due to vapour intrusions into the bedrock. Pore water electrical conductivity (EC) showed periodic variations due to vapour intrusion, and gradually increased between the ground surface and depths of 2.5–5.0 cm. In contrast, pore water EC gradually decreased between 15 and 40 cm depth. Calculated water fluxes at depths of 2.5–40.0 cm varied from −4 × 10⁻⁶ to −2 × 10⁻⁹ kg m⁻² s⁻¹. These fluxes generated an increase in solute concentrations at the ground surface, with negative values of water flux indicating an upwards movement of water towards the surface. We show that the increase in solute content due to solute transfer from depth is highly dependent on variations in water flux with depth. © 2020 John Wiley & Sons, Ltd.  相似文献   

Runoff response of a small agricultural basin in the argentine Pampas considering connectivity aspects     

María Guadalupe Ares  Marcelo Varni  Celio Chagas 《水文研究》2020,34(14):3102-3119

  相似文献   

Characterizing spatial and temporal variation in 18O and 2H content of New Zealand river water for better understanding of hydrologic processes     

Jing Yang  Bruce D. Dudley  Kelsey Montgomery  Will Hodgetts 《水文研究》2020,34(26):5474-5488

Time series of hydrogen and oxygen stable isotope ratios (δ²H and δ¹⁸O) in rivers can be used to quantify groundwater contributions to streamflow, and timescales of catchment storage. However, these isotope hydrology techniques rely on distinct spatial or temporal patterns of δ²H and δ¹⁸O within the hydrologic cycle. In New Zealand, lack of understanding of spatial and temporal patterns of δ²H and δ¹⁸O of river water hinders development of regional and national-scale hydrological models. We measured δ²H and δ¹⁸O monthly, together with river flow rates at 58 locations across New Zealand over a two-year period. Results show: (a) general patterns of decreasing δ²H and δ¹⁸O with increasing latitude were altered by New Zealand's major mountain ranges; δ²H and δ¹⁸O were distinctly lower in rivers fed from higher elevation catchments, and in eastern rain-shadow areas of both islands; (b) river water δ²H and δ¹⁸O values were partly controlled by local catchment characteristics (catchment slope, PET, catchment elevation, and upstream lake area) that influence evaporation processes; (c) regional differences in evaporation caused the slope of the river water line (i.e., the relationship between δ²H and δ¹⁸O in river water) for the (warmer) North Island to be lower than that of the (cooler, mountain-dominated) South Island; (d) δ²H seasonal offsets (i.e., the difference between seasonal peak and mean values) for individual sites ranged from 0.50‰ to 5.07‰. Peak values of δ¹⁸O and δ²H were in late summer, but values peaked 1 month later at the South Island sites, likely due to greater snow-melt contributions to streamflow. Strong spatial differences in river water δ²H and δ¹⁸O caused by orographic rainfall effects and evaporation may inform studies of water mixing across landscapes. Generally distinct seasonal isotope cycles, despite the large catchment sizes of rivers studied, are encouraging for transit time analysis applications.  相似文献   

柱顶层间隔震体系增量动力响应研究          下载免费PDF全文

袁梦醒  陈望  刘彦辉  谭平  金建敏 《地震工程学报》2020,42(4):872-880

针对悬臂柱顶有拉梁和无拉梁层间隔震体系的抗震性能问题,运用增量动力分析(IDA)方法进行弹塑性分析,模拟结构从弹性到弹塑性直至最后倒塌的全过程。通过调幅地震动得到相应的层间位移角及峰值加速度,分别绘制单条与多条IDA曲线分析拉梁对隔震结构动力响应的影响,研究两种结构的抗震性能。结果表明:在相同性能点,有拉梁和无拉梁对纤维铰弯矩值和曲率值基本无影响,而在不同性能点,纤维铰状态明显不同;两种体系从正常使用阶段到防止倒塌阶段所需的加速度峰值的差距慢慢增大;在极罕遇地震下,柱顶有拉梁层间隔震体系的下部结构抗震性能要高于柱顶无拉梁层间隔震体系。  相似文献   

基岩倾角对盆地地震响应的影响分析          下载免费PDF全文

卓发成 《地震工程学报》2020,42(4):1035-1042

为了研究盆地基岩倾角对盆地地表动力反应的影响,选取了一个跨度2 km,深度500 m的二维成层盆地为研究对象进行有限元动力反应分析。以持时0.25 s的狄拉克脉冲作为输入地震动,探讨了P波和SV波垂直入射时,盆地基岩倾角从10°\,20°\,30°\,40°依次增加的情况下盆地地震反应。结果表明:入射波在倾斜基岩处发生波型转化,同时产生面波,在盆地中心区域发生汇聚;随着基岩倾角的增加地表中心处的卓越频率有减小的趋势。  相似文献   

结合BM3D和多级非线性加权平均中值滤波的遥感影像混合噪声去噪方法     

任超  李现广  邓开元  潘亚龙  朱子林  张志刚  施显健 《测绘通报》2020,(1):89-93

提出了一种基于三维块匹配（BM3D）和多级非线性加权平均中值滤波的遥感影像混合噪声去噪方法，使用coief3小波和sym2小波替换传统三维块匹配算法中的bior1.5和hear参数，将三维块匹配算法和多级非线性加权平均中值滤波相结合以提高算法对混合噪声的去噪能力。进行一个仿真对比试验和一个真实遥感影像去噪试验，试验表明，本文提出的方法在遥感影像混合噪声去噪方面效果要优于传统混合噪声去噪方法。  相似文献   

无人机技术在海岛测绘中的应用     

李雪瑞  魏征  田松  李明杰 《测绘通报》2020,(1):150-153

为提高海岛测绘的技术手段，将无人机引入海岛地形调查中，以Swallow-P小型固定翼无人机开展惠州市大亚湾虎洲海岛大比例尺测图为例，系统归纳了无人机外业数据采集与内业数据处理的具体流程，并制作了DEM和DOM成果；经过实测地面点精度分析得出虎洲无人机大比例尺测图成果平面位置中误差和高程中误差符合1∶1000测图精度要求。  相似文献   

面向数字孪生城市的智能化全息测绘   总被引：2，自引：0，他引：2  

顾建祥  杨必胜  董震  杨常红 《测绘通报》2020,(6):134-140

以大数据、物联网、人工智能、虚拟现实、云计算、智能驾驶等新技术为代表的信息化浪潮席卷全球，数字世界与物理世界正形成两大平行发展、相互作用的体系，数字孪生技术应运而生。随着物联网技术（IOT）的发展，数字孪生的理念被引入到智慧城市建设中来，深刻影响着城市规划、建设与治理。笔者所在单位面向数字孪生城市和自然资源统一监管对测绘地理信息的新需求，在全国开创性地开展了面向数字孪生城市的智能化全息测绘试点工作。本文结合上海市智能化全息测绘试点工作，从数字孪生城市、数字孪生城市对地理信息的新需求、智能化全息测绘关键技术及测绘成果等方面展开了论述，重点介绍了智能化全息测绘的技术体系和产品体系，以及在社会各领域的应用成果。  相似文献