2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析     

高丽娟  邢喜民  高歌  李尚伟 《大地测量与地球动力学》2019,39(10):1002-1006

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。  相似文献   

扇束CT探测器偏转的重建图像伪影校正     

李忠传  孟凡勇  杨民 《CT理论与应用研究》2014,(2):237-248

对于CT扇束扫描，射线源焦点与被测工件旋转中心的连线不垂直于探测器所在直线时，采用标准的滤波反投影重建算法重建出的图像会存在伪影，降低图像质量。本文基于经典滤波反投影重建算法理论，分析了此类伪影形成的原因，给出了利用投影原始数据（正弦图）计算校正算法所必需的几何参数的方法。本方法无需专用模体，不必进行二次扫描，方便、快捷并有效。计算机仿真及实验结果证明本方法的有效性。  相似文献   

A simple prediction model for wall deflection caused by braced excavation in clays     

《Computers and Geotechnics》2015

Deep excavations particularly in deep deposits of soft clay can cause excessive ground movements and result in damage to adjacent buildings. Extensive plane strain finite element analyses considering the small strain effect have been carried out to examine the wall deflections for excavations in soft clay deposits supported by retaining walls and bracing. The excavation geometry, soil strength and stiffness properties, and the wall stiffness were varied to study the wall deflection behavior. Based on these results, a simple Polynomial Regression (PR) model was developed for estimating the maximum wall deflection. Wall deflections computed by this method compare favorably with a number of field and published records.  相似文献   

Inverse Analysis of Deep Excavation Using Differential Evolution Algorithm   总被引：1，自引：0，他引：1       下载免费PDF全文

B. D. Zhao  L. L. Zhang  D. S. Jeng  J. H. Wang  J. J. Chen 《国际地质力学数值与分析法杂志》2015,39(2):115-134

This paper presents the applications of the differential evolution (DE) algorithm in back analysis of soil parameters for deep excavation problems. A computer code, named Python‐based DE, is developed and incorporated into the commercial finite element software ABAQUS, with a parallel computing technique to run an FE analysis for all trail vectors of one generation in DE in multiple cores of a cluster, which dramatically reduces the computational time. A synthetic case and a well‐instrumented real case, that is, the Taipei National Enterprise Center (TNEC) project, are used to demonstrate the capability of the proposed back‐analysis procedure. Results show that multiple soil parameters are well identified by back analysis using a DE optimization algorithm for highly nonlinear problems. For the synthetic excavation case, the back‐analyzed parameters are basically identical to the input parameters that are used to generate synthetic response of wall deflection. For the TNEC case with a total of nine parameters to be back analyzed, the relative errors of wall deflection for the last three stages are 2.2, 1.1, and 1.0%, respectively. Robustness of the back‐estimated parameters is further illustrated by a forward prediction. The wall deflection in the subsequent stages can be satisfactorily predicted using the back‐analyzed soil parameters at early stages. Copyright © 2014 John Wiley & Sons, Ltd.  相似文献   

一种改进的单目视觉桥梁挠度非接触测量方法     

刘少平  杨永波  张东升  赵芳  邹宇 《测绘通报》2021,(10):98-102

本文在现有单目视觉测量方法基础上,提出了一种相机真实俯仰角计算算法,结合图像快速相关匹配与定位算法,可完成桥梁挠度的快速精确测量。通过精度验证试验和挠度对比测试试验,得到了相应的结果,结果表明：①不考虑目标点真实俯仰角变化的测量方法在距离视场中心较远的位置测量结果中误差较大;②单目视觉方法测量结果与角钢作竖直向下的刚体位移保持一致;③单目视觉方法与GPS测量的挠度曲线变化趋势和测量数值基本一致。试验验证了本文方法的可行性及准确性,可为今后基于数字图像相关方法的土木工程变形测量技术研究提供参考。  相似文献   

数字天顶摄影仪确定垂线偏差及其精度分析     

郭金运  宋来勇  常晓涛  刘新 《武汉大学学报(信息科学版)》2011,36(9):1085-1088,1101

给出了数字天顶摄影仪的基本结构和垂线偏差测量的基本算法,结合仪器和测量过程,分析了垂线偏差测量误差。数字天顶摄影仪的自动化程度和测量精度都高于传统的天文大地测量。  相似文献   

利用大地水准面模型计算垂线偏差的方法及精度分析     

李伟超  张兴福  陈智伟  崔家武 《大地测量与地球动力学》2019,39(8):843-848

根据大地水准面与垂线偏差的关系，设计合理的计算方案，给出利用大地水准面模型计算垂线偏差的简化公式，并通过模拟计算探讨大地水准面相对精度、取点间距和已知点选取及个数对计算结果的影响。利用GEOID12B模型分别计算GSVS2011、GSVS2014项目中各测站点和美国西部区域（40°~45°N，100°~105°W，分辨率为1′）的垂线偏差，并与GSVS项目垂线偏差实测值和DEFLEC12B模型值进行比较。结果表明，垂线偏差南北分量和东西分量的计算精度均优于±0.5″，说明利用相对精度为cm甚至亚cm级的大地水准面模型可获取较高精度的垂线偏差。  相似文献   

Ring foundation on elastic subgrade: an analytical solution for computer modelling using the Lagrangian multiplier method          下载免费PDF全文

Shahin Nayyeri  Masood Hajali  Caesar Abi Shdid 《国际地质力学数值与分析法杂志》2016,40(14):2017-2030

In the practice of geotechnical engineering, the case of a ring footing carrying a set of concentrated point loads is a common problem. At times, the induced vertical and angular displacements for the ring footing need to be evaluated at a relatively precise level. By making use of the governing set of equations derived for the case of a general curved beam, expressions that can be easily implemented in modern computing software are derived for the vertical and angular displacements of a ring footing of rectangular cross section as functions of the radial position. The loading case considered is a vertical point load, and the soil is modelled as elastic. Estimates of the displacements have been shown for a common range of practical applications. The behaviour for a set of concentrated loads may be evaluated using the derived equations through direct superposition. Nonlinear finite element analysis is used to evaluate the vertical deflection and angular twist of the ring foundation. Numerical analysis performed for three ring foundations with different radii and cross sections is reported to validate the accuracy of the derived analytical solution. Copyright © 2016 John Wiley & Sons, Ltd.  相似文献   

移动荷载作用下Kerr地基梁稳态响应解答          下载免费PDF全文

黄强  黄宏伟  张冬梅 《地震工程学报》2015,37(S1):40-45

研究Kerr地基上的均质Euler-Bernoulli梁在移动集中荷载作用下的稳态响应,分析有无阻尼存在时列车速度、地基压缩刚度、剪切刚度对Kerr地基梁挠度曲线的影响。计算结果表明,地基阻尼的存在能明显减少移动荷载引起的地基梁挠度,地基梁的挠度受地基压缩刚度的影响比剪切刚度更为明显。  相似文献   

钟祥地震台面波震级测定     

赵瑞  李俊超  万禹  刘迁  宋俊朋  兰天 《地震地磁观测与研究》2017,38(4):49-52

整理钟祥地震台2012年至2016年6月全球M_S≥6地震目录,与中国地震台网中心发布的面波震级进行对比分析,统计发现,该地震台面波震级误差主要集中在-1.0—+0.5,为此分析误差存在的原因,并根据实际情况给出解决办法。  相似文献