地中海直布罗陀海峡附近内孤立波的地球物理特征          下载免费PDF全文

孙绍箐  张锟  宋海斌 《地球物理学报》2019,62(7):2622-2632

本文主要利用地震海洋学方法研究地中海直布罗陀海峡附近内孤立波的结构特征，此处内孤立波为第一模态下沉型，为中幅度和大幅度内孤立波，垂向振幅最大可达74.5 m，振幅随深度增加呈增大趋势，传播速度随振幅增大而增大，可以确定"真"最大振幅位置位于密跃层附近.由于类多普勒效应和孤立波与测量船之间存在夹角的原因，从地震剖面上得到的为视半高宽参数，需要进行校正后才能得到比较真实的半高宽参数，校正后半高宽最高可达到1721.8 m，但是校正后的半高宽与理论结果有些差距，这可能与内孤立波的发育稳定程度有关.随着内孤立波包不断向东运动，整体波宽变大，垂向速度变小.本文将地震海洋学方法拓展应用于地中海区域内孤立波分析，进一步证明了利用地震海洋学方法研究海水运动的可行性.  相似文献   

花岗岩残积土动态冲击性能的SHPB试验研究     

刘新宇  张先伟  岳好真  孔令伟  徐超 《岩土力学》2020,41(6):2001-2008

为研究花岗岩残积土的动态冲击性能，开展了高速冲击下的分离式霍普金森压杆（SHPB）试验，与常规应变率下的试验结果比较，分析了高应变率对花岗岩残积土的应力?应变特性和强度的影响。结果表明：低、高应变率下的花岗岩残积土的?-?a（轴向应力?轴向应变）曲线均呈现出软化型。随着应变率 增加，?-?a曲线向?a增大的方向移动，破坏应变?af增加。但高应变率下?af增加的程度更加明显。花岗岩残积土的峰值强度普遍具有应变率依赖性，二者可用直线关系拟合，但低、高应变率下的拟合关系并不一致。提出了率敏性因子m定量评价依赖性强弱。研究发现，随着应变率的提高，强度的应变率依赖性减弱，低应变率下的m为26.694，而高应变率下仅为0.013。相关试验结果指出，高速冲击荷载对土体总体有害。工程中应该采取合理措施控制冲击荷载的危害。该研究有助于深化花岗岩残积土动态冲击性能的理解，为相关工程的施工与设计提供技术参考。  相似文献   

2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析     

高丽娟  邢喜民  高歌  李尚伟 《大地测量与地球动力学》2019,39(10):1002-1006

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。  相似文献   

唐山地区波速比变化特征研究     

王亚茹  宋昭  刘晓丹  郭蕾  王妍  王时  宫猛  王想 《大地测量与地球动力学》2019,39(7):686-690

选取唐山地区2008~2018年震相数据，利用单台多震和达法和多台多震和达法分别计算波速比，结合研究区内的地震活动对波速比的变化特征进行研究。结果显示，多台多震和达法得到的波速比结果较为稳定，而单台多震和达法得到的结果变化幅度大，显示更多细节；唐山地区ML≥4.5地震发生前单台波速比存在不同程度的异常，异常台站的方位与地震具有一定的对应性。  相似文献   

海上风电升压站平台高程确定标准的合理性研究     

潘晓春 《海洋技术学报》2019,38(6):83-88

为保证海上风电升压电站建设的经济合理与安全可靠,合理确定海上风电升压电站平台高程十分必要。文中从波浪与潮位的遭遇组合、最大波高取值与现行相关标准的比较、最大波峰高度计算的合理性等方面,全面分析了确定海上风电升压站平台高程各组成项取值标准的合理性,研究认为现行标准明显偏高。建议海上升压站平台底部高程按"100年一遇极端高水位+重现期50年波列累积频率1%的最大波峰高度+安全超高"确定。结合工程实例计算分析,按本文建议可使海上升压站平台高程明显降低,从而节省工程造价,还可减轻升压站工程对周边风机的遮蔽影响,以达到多发电量的效果。  相似文献   

鄂尔多斯地块周缘垂直形变场负位错反演与应变积累研究     

张希  刘立炜  郝明  白卓立 《大地测量与地球动力学》2019,39(6):551-556

利用鄂尔多斯地块及其周缘1970～2014年的垂直形变速率场资料，借助负位错反演研究该区域长期应变积累。结果表明，地块东北缘山西断陷带中北段年均能量积累增量、剪应力强度都较高，西南缘六盘山断裂与渭河断裂西段次之；山西断陷带中南段至晋陕交界处年均剪应力强度较高且显示一定程度的能量积累；西秦岭构造区尤其西秦岭北缘断裂西段、晋冀蒙交界区也反映一定程度的能量积累特性。  相似文献   

Obtaining the distribution of quiescent periods directly from the power spectral densities of Sea waves     

《Applied Ocean Research》2019

There is a growing practical interest in the ability to increase the sea states at which marine operations can be safely undertaken by exploiting the quiescent periods that are well known to exist under a wide range of sea conditions. While the actual prediction of quiescent periods at sea for the control of operations is a deterministic process, the long term planning of future maritime tasks that rely on these quiescent periods is a statistical process involving the anticipated quiescence properties of the forecasted sea conditions in the geographical region of interest. It is in principle possible to obtain such data in tabular form either large scale simulation or from field data. However, such simulations are computationally intensive and libraries of appropriate field data are not common. Thus, it is clearly attractive to develop techniques that exploit standard wave spectral models for describing the quiescence statistics directly from such spectra. The present study focuses upon such techniques and is a first step towards the production of a computationally low-cost quiescence prediction tool and compares its efficacy against simulations. Two significant properties emerge for a large class of wave spectral models that encompasses the ubiquitous Neumann and Pierson Moskowitz or Bretschneider forms. Firstly, the auto-correlation function of the wave profile that are required to produce the quiescence property can be obtained analytically in terms of standard special functions. This considerably reduces the computational cost making desktop computer-based planning tools a reality. Secondly, for each class of these parametric spectra, the probability of a given number of consecutive wave heights (normalised to the significant wave heights) less than some critical value is in fact independent of absolute wave height. Thus, for a broad class of practically interesting wave spectra all that is required to obtain the statistical distribution of the quiescent periods is simple rescaling.  相似文献   

The recognition of former melt flux through high‐strain zones          下载免费PDF全文

Catherine A. Stuart  Sandra Piazolo  Nathan R. Daczko 《Journal of Metamorphic Geology》2018,36(8):1049-1069

High‐strain zones are potential pathways of melt migration through the crust. However, the identification of melt‐present high‐strain deformation is commonly limited to cases where the interpreted volume of melt “frozen” within the high‐strain zone is high (>10%). In this contribution, we examine high‐strain zones in the Pembroke Granulite, an otherwise low‐strain outcrop of volcanic arc lower crust exposed in Fiordland, New Zealand. These high‐strain zones display compositional layering, flaser‐shaped mineral grains, and closely spaced foliation planes indicative of high‐strain deformation. Asymmetric leucosome surrounding peritectic garnet grains suggest deformation was synchronous with minor amounts of in situ partial melting. High‐strain zones lack typical mylonite microstructures and instead display typical equilibrium microstructures, such as straight grain boundaries, 120° triple junctions, and subhedral grain shapes. We identify five key microstructures indicative of the former presence of melt within the high‐strain zones: (a) small dihedral angles of interstitial phases; (b) elongate interstitial grains; (c) small aggregates of quartz grains with xenomorphic plagioclase grains connected in three dimensions; (d) fine‐grained, K‐feldspar bearing, multiphase aggregates with or without augite rims; and (e) mm‐ to cm‐scale felsic dykelets. Preservation of key microstructures indicates that deformation ceased as conditions crossed the solidus, breaking the positive feedback loop between deformation and the presence of melt. We propose that microstructures indicative of the former presence of melt, such as the five identified above, may be used as a tool for recognising rocks formed during melt‐present high‐strain deformation where low (<5%) volumes of leucosome are “frozen” within the high‐strain zone.  相似文献   

Dynamic modelling of retrogressive landslides with emphasis on the role of clay sensitivity          下载免费PDF全文

Xue Zhang  Scott W. Sloan  Eugenio Oñate 《国际地质力学数值与分析法杂志》2018,42(15):1806-1822

This paper presents a detailed numerical study of the retrogressive failure of landslides in sensitive clays. The dynamic modelling of the landslides is carried out using a novel continuum approach, the particle finite element method, complemented with an elastoviscoplastic constitutive model. The multiwedge failure mode in the collapse is captured successfully, and the multiple retrogressive failures that have been widely observed in landslides in sensitive clays are reproduced with the failure mechanism, the kinematics, and the deposition being discussed in detail. Special attention has been paid to the role of the clay sensitivity on each retrogressive failure as well as on the final retrogression distance and the final run‐out distance via parametric studies. Moreover, the effects of the viscosity of sensitive clays on the failure are also investigated for different clay sensitivities.  相似文献   

一种优化的频率域三维声波有限差分模拟方法   总被引：1，自引：1，他引：0       下载免费PDF全文

范娜  成景旺  秦雷  赵连锋  谢小碧  姚振兴 《地球物理学报》2018,61(3):1095-1108

为提高频率域有限差分（FD，finite-difference）正演模拟技术的计算精度和效率，基于旋转坐标系统的优化差分格式被广泛应用，但是只应用于正方形网格的情况.基于平均导数法（ADM）的优化差分格式，应用于正方形和长方形网格模拟.这些频率域有限差分算子，各自具有不同的差分格式和对应的优化系数求解表达式.本文基于三维声波方程发展了一种新的优化方法，只要给定FD模板形式，可直接构造频散方程，求取FD模板上各节点的优化系数.此方法的优点在于频率域FD算子的优化系数对应各个节点，可扩展优化其他格式.运用此优化方法，计算得到了不同空间采样间距比情况下27点和7点格式的优化系数.数值实验表明，优化27点格式与ADM 27点格式具有相同的精度，优化7点格式比经典的7点格式具有更小的数值频散.  相似文献