基于主成分分析法和监测数据的阿尔泰山采金废弃矿区人工恢复措施效益分析          下载免费PDF全文

艾沙江·艾力  徐海量  苑塏烨 《干旱区地理》2019,42(2):288-294

本文以阿尔泰山两河源保护区采金废弃矿区为研究区，从地形、土壤、水分和地表植被4个方面出发，结合矿区现有条件，设置11种恢复措施，选取丰富度指数、优势度指数、多样性指数、均匀度指数、生物量、植被盖度、物种数及土石比等7个评价指标，采用主成分分析法，得出不同恢复措施的主成分得分及生态效益排名。结果表明，单一恢复措施，如推平、羊群驻扎、泥浆等基本上是从某一个方面来考虑生态恢复的，存在一定的缺陷，恢复效益排名比较靠后；多种措施相结合，不仅能改善土壤环境，也会引起植物群落多样性格局的变化，生态恢复效益很好；同一种恢复措施，施行年限越长恢复效果越好。  相似文献   

三峡库区龙门寨危岩体崩塌产生涌浪研究   总被引：1，自引：1，他引：0  

郑嘉豪  黄波林  张全  赵海林  冯万里  王健  陈小婷 《地质力学学报》2020,26(4):533-543

长江两岸高耸的危岩体对航道、沿岸居民带来巨大安全隐患。大宁河属于长江一级支流，龙门寨危岩体位于大宁河上，距离巫山县城仅1 km。利用FLOW-3D软件，模拟了145 m、175 m两种水位工况下龙门寨危岩体崩塌产生涌浪过程和涌浪传播过程。模拟结果表明，涌浪在145 m水位工况下最大浪高约为17.9 m，175 m水位工况下最大浪高约为11.6 m；在巫山县的五个码头处，两种水位工况最大涌浪爬高分别约为10.9 m、3.8 m；根据涌浪高度，对大宁河进行危险分区，145 m水位工况下极高危险区长度约4.4 km，很高危险区长度约1.9 km；175 m水位工况下极高危险区长度约3.0 km，很高危险区长度约1.0 km。研究结果有助于防控龙门寨危岩体潜在涌浪灾害危害，保障大宁河航道和巫山县码头安全，同时也为三峡库区滑坡涌浪灾害提供了预警依据。   相似文献   

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

Artificial recharge efficiency assessment by soil water balance and modelling approaches in a multi-layered vadose zone in a dry region     

Mojtaba Pakparvar  Hossein Hashemi  Meisam Rezaei  Wim M. Cornelis  Gholamali Nekooeian  Sayyed Ahang Kowsar 《水文科学杂志》2018,63(8):1183-1202

To assess recharge through floodwater spreading, three wells, approx. 30 m deep, were dug in a 35-year-old basin in southern Iran. Hydraulic parameters of the layers were measured. One well was equipped with pre-calibrated time domain reflectometry (TDR) sensors. The soil moisture was measured continuously before and after events. Rainfall, ponding depth and the duration of the flooding events were also measured. Recharge was assessed by the soil water balance method, and by calibrated (inverse solution) HYDRUS-1D. The results show that the 15 wetting front was interrupted at a layer with fine soil accumulation over a coarse layer at the depth of approx. 4 m. This seemed to occur due to fingering flow. Estimation of recharge by the soil water balance and modelling approaches showed a downward water flux of 55 and 57% of impounded floodwater, respectively.  相似文献   

Analytical study of ground motion caused by seismic wave propagation across faulted rock masses          下载免费PDF全文

J.C. Li  N.N. Li  S.B. Chai  H.B. Li 《国际地质力学数值与分析法杂志》2018,42(1):95-109

Studying seismic wave propagation across rock masses and the induced ground motion is an important topic, which receives considerable attention in design and construction of underground cavern/tunnel constructions and mining activities. The current study investigates wave propagation across a rock mass with one fault and the induced ground motion using a recursive approach. The rocks beside the fault are assumed as viscoelastic media with seismic quality factors, Q_p and Q_s. Two kinds of interactions between stress waves and a discontinuity and between stress waves and a free surface are analyzed, respectively. As the result of the wave superposition, the mathematical expressions for induced ground vibration are deduced. The proposed approach is then compared with the existing analysis for special cases. Finally, parametric studies are carried out, which includes the influences of fault stiffness, incident angle, and frequency of incident waves on the peak particle velocities of the ground motions.  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

Coordinative similitude law considering fluid‐structure interaction for underwater shaking table tests     

Zhong‐Xian Li  Kun Wu  Yundong Shi  Ning Li  Yang Ding 《地震工程与结构动力学》2018,47(11):2315-2332

Generally, when a model is made of the same material as the prototype in shaking table tests, the equivalent material density of the scaled model is greater than that of the prototype because mass is added to the model to satisfy similitude criteria. When the water environment is modeled in underwater shaking table tests, however, it is difficult to change the density of water. The differences in the density similitude ratios of specimen materials and water can affect the similitude ratios of the hydrodynamic and wave forces with those of other forces. To solve this problem, a coordinative similitude law is proposed for underwater shaking table tests by adjusting the width of the upstream face of the model or the wave height in the model test to match the similitude ratios of hydrodynamic and wave forces with those of other forces. The designs of the similitude relations were investigated for earthquake excitation, wave excitation, and combined earthquake and wave excitation conditions. Series of numerical simulations and underwater shaking table tests were performed to validate the proposed coordinative similitude law through a comparison of coordinative model and conventional model designed based on the coordinative similitude law and traditional artificial mass simulation, respectively. The results show that the relative error was less than 10% for the coordinative model, whereas it reached 80% for the conventional model. The coordinative similitude law can better reproduce the dynamic responses of the prototype, and thus, this similitude law can be used in underwater shaking table tests.  相似文献   

茅山竹矿断层气定点观测场地勘选     

戴波  吴晓峰  张敏  孟科 《大地测量与地球动力学》2019,39(11):1202-1206

拟在茅山断裂带沿线布设若干个断层气连续观测点，建组断层气观测网。以茅山竹矿地区为例，通过断层气测量的初步结果，结合地质、人工地震、跨断层短水准等多种手段联合分析研究区断层的活动性，从而确定断层气定点观测的点位，为组建断层气观测网的选点提供借鉴和参考。  相似文献   

SH波地表散射的局域边界元模拟          下载免费PDF全文

盖增喜  陈晨旭 《地球物理学报》2020,63(6):2274-2280

本文提出了一种计算不规则起伏地形中SH波散射的有效方法——局域边界元法.本方法基于传统边界元法,为计算复杂地表散射问题提供了一种更加高效的解决方案.根据地震波满足的边界积分方程中牵引力格林函数的特性,我们将自由边界分解成水平部分和起伏部分.通过公式推导,可将水平部分的位移由起伏部分的位移通过格林函数线性叠加表示,因此只需对起伏部分的位移进行直接求解,从而极大地减少了待求解的未知数个数,显著提高了计算效率.通过与半圆形山谷SH波平面波入射的解析解比较,验证了方法的正确性.数值模型比较显示,局域边界元模拟结果与传统边界元数值解完全吻合,但是大幅提高了计算效率.因此,局域边界元法可以作为模拟不规则地形中地震波散射的有效工具.  相似文献   

Data-based modelling approach for variable density flow and solute transport simulation in a coastal aquifer   总被引：1，自引：1，他引：0  

Basant Yadav  Shashi Mathur  Sudheer Ch  Brijesh Kumar Yadav 《水文科学杂志》2018,63(2):210-226

Data-based models, namely artificial neural network (ANN), support vector machine (SVM), genetic programming (GP) and extreme learning machine (ELM), were developed to approximate three-dimensional, density-dependent flow and transport processes in a coastal aquifer. A simulation model, SEAWAT, was used to generate data required for the training and testing of the data-based models. Statistical analysis of the simulation results obtained by the four models show that the data-based models could simulate the complex salt water intrusion process successfully. The selected models were also compared based on their computational ability, and the results show that the ELM is the fastest technique, taking just 0.5 s to simulate the dataset; however, the SVM is the most accurate, with a Nash-Sutcliffe efficiency (NSE) ≥ 0.95 and correlation coefficient R ≥ 0.92 for all the wells. The root mean square error (RMSE) for the SVM is also significantly less, ranging from 12.28 to 77.61 mg/L.  相似文献