脐带缆螺旋滑移分析及力学性能研究   总被引：1，自引：0，他引：1  

李英  吴潘  冯雅萍  曹静萱 《海洋工程》2018,36(6):58-68

针对脐带缆内部螺旋层,应用Darboux标架建立螺旋结构空间坐标系,推导弯曲载荷下螺旋结构的局部变形和滑移。考虑螺旋构件间的接触和摩擦作用,建立螺旋结构的受力平衡偏微分方程,并研究螺旋角和摩擦系数对螺旋结构滑移的影响。基于同层螺旋结构本构关系相同假设,将所有螺旋结构力学性能线性叠加,拟合脐带缆整体弯曲刚度。运用建立的理论解析方法,对某双层铠装脐带缆的力学性能进行研究,并与数值模拟结果进行对比验证。对比结果表明,理论解析得到的螺旋滑移结果与数值模拟结果一致,理论解析得到的脐带缆弯曲刚度与数值模拟结果在全滑动阶段比较接近。  相似文献   

GPS约束下陇西地区断裂带现今滑动速率的非连续接触模拟研究     

孟庆筱  景鹏旭  何申海  党学会 《大地测量与地球动力学》2018,38(12):1227-1231

以中国地壳运动观测网络1999、2001、2004和2007年4期GPS观测数据为边界条件，使用非连续接触有限元技术构建陇西块体二维有限元模型，在摩擦系数不确定性分析基础上，计算区内主要断裂带滑动速率。结果表明，现今地壳形变运动状态下陇西块体的北东向运动在海原断裂附近受到鄂尔多斯块体、阿拉善块体阻碍，陇西块体周缘的海原断裂带、老虎山断裂、西秦岭北缘断裂呈现左旋走滑特征，滑动速率为3.5 mm/a、2.2 mm/a和1.9 mm/a，说明在青藏高原推挤作用下以上关键部位正在进行快速的构造应变积累。  相似文献   

Numerical evaluation of soft inter‐slab joint in concrete‐faced rockfill dam with dual mortar finite element method          下载免费PDF全文

Mozhen Zhou  Bingyin Zhang  Chong Peng 《国际地质力学数值与分析法杂志》2018,42(5):781-805

Recently constructed concrete‐faced rockfill dams (CFRDs) often use soft inter‐slab joints to prevent axial compression‐induced extrusion damage in the concrete face. Due to the complexity of the multibody contact and the lack of information on the actual behavior of soft joints, it is highly challenging to numerically assess the effect of soft joints in CFRDs. In this paper, we present a numerical approach for the three‐dimensional modeling of CFRDs with hard and soft joints. A dual mortar finite element method with Lagrange multiplier is developed to treat the multibody contact in hard joints with impenetrability condition. The soft joint slab‐filler‐slab contact system is modeled using an equivalent contact interface approach, where the soft contact constraints are imposed using a perturbed Lagrange formulation. Through a series of laboratory tests, the mechanical behavior of soft joint is investigated. An extrusion model for the soft joint is presented and implemented in the dual mortar finite element method. The proposed numerical method is applied to the three‐dimensional analysis of Tianshengqiao‐1 CFRD. Despite the complex multibody contact and strong material and geometry nonlinearities in the CFRD, the proposed method is stable and capable of capturing salient characteristics of the CFRD. Numerical results show that in Tianshengqiao‐1, the employment of soft joints can effectively reduce the axial compression stress, thus greatly alleviating the risk of extrusion damage in the concrete face.  相似文献   

Dynamic loading tests and seismic response analysis of a stud-type damper composed of multiple friction units with disc springs     

Takeshi Sano  Kazutaka Shirai  Yasumasa Suzui  Yoshikazu Utsumi 《地震工程与结构动力学》2020,49(13):1259-1280

This paper presents an experimental study on the performance of a shear-sliding stud-type damper composed of multiple friction units with high-tension bolts and disc springs. A numerical evaluation of the response reduction effects achieved by the stud-type damper is also presented. In dynamic loading tests, the behavior of stud-type multiunit friction damper specimens was investigated. Three different full-scale damper specimens, which were composed of five, six, or seven friction units with two or four sliding surfaces, were incorporated into loading devices for testing. The stud-type friction dampers demonstrated stable rigid-plastic hysteresis loops without any remarkable decrease in the sliding force even when subjected to repetitive loading, in addition to showing no unstable behavior such as lateral buckling. The damper produced a total sliding force approximately proportional to the number of sliding surfaces and friction units. The total sliding force of the stud-type damper can thus be estimated by summing the contributions of each friction unit. In an earthquake response simulation, the control effects achieved by stud-type dampers incorporated into an analytical high-rise building model under various input waves, including long-period, long-duration and pulse-like ground motions, were evaluated. A satisfactory response reduction was obtained by installing the developed stud-type dampers into the main frame without negatively impacting usability and convenience in terms of building planning.  相似文献   

基于ABAQUS的深水连接器连接性能分析     

曹博  蔡志杰  石中玉  张玉龙  段梦兰 《海洋工程》2020,38(3):132-139

为解决现有深水连接器连接性能研究中力学分析建模不准确,且缺乏抗弯抗扭能力分析的问题,基于ABAQUS有限元分析软件对深水连接器进行三维模型动态仿真分析,对连接器的受力、密封性能以及在实际工程需求中不同内压下的抗弯及抗扭性能进行深入研究。结果表明:在安装及生产两种工况下,深水连接器各部件除密封环外受力均满足其强度设计要求,密封环接触表面发生合理塑性变形,满足密封要求;随着内压的增加,深水连接器的抗弯能力逐渐下降,抗扭能力则呈现增加的趋势;极限弯矩分别在0 MPa与35 MPa内压下的判定依据为密封失效,在14 MPa与52 MPa内压下的判定依据为下毂座屈服,而极限扭矩在不同内压下的判定依据均为密封失效。  相似文献   

Self-centering friction spring dampers for seismic resilience     

Wei Wang  Cheng Fang  Yashuo Zhao  Richard Sause  Shuling Hu  James Ricles 《地震工程与结构动力学》2019,48(9):1045-1065

  相似文献   

围压与冲击扰动作用下组合煤岩超低摩擦效应分析     

李利萍  吴金鹏  鞠翔宇  王淋 《地质力学学报》2019,25(6):1099-1106

深部煤岩在垂直扰动作用下发生振动，当水平冲击足以克服块体间摩擦阻力时，极易发生超低摩擦型冲击地压。文章以细砂岩-煤-细砂岩组合块体为研究对象，考虑顶板-煤-底板临近工作面开采工况，采用数值模拟方法，建立围压与冲击扰动下组合煤岩数值模型，以煤块水平位移、垂直加速度差值作为超低摩擦效应特征参数，分析围压、垂直冲击及水平冲击对特征参数的影响规律。研究结果表明:在垂直冲击与围压共同作用下，煤岩体残余位移及水平位移峰值随围压增大且呈指数增长趋势；在垂直冲击、水平冲击和围压三者共同作用下，煤岩体超低摩擦效应强度与作用时间都随着围压呈增加趋势；垂直冲击对组合煤岩超低摩擦效应的影响最为显著。   相似文献   

Monitoring Contact State of Laboratory Fault with Coda Transmission Waves     

XIE Fan  REN Yaqiong  HOU Jinxin 《中国地震研究》2019,33(3):431-436

We monitored the amplitude changes of coda transmission waves around 500kHz across the frictional interface of a simulated 1.5-meter-long fault during normal stress holding test. We find that the amplitude of coda transmission waves increases with the logarithm of stationary contact time. Localized increase amounted to a level ranging from 4% to 16% along the fault is observed during the 1-hour experiment. We discuss that the frictional strength at mesoscopic scale, which is related to the amplitude of coda transmission waves, is responsible for the phenomenon. Combining the reported method with other complementary approaches will enhance the understanding of fault mechanism either at laboratory or on-site applications.  相似文献   

Laboratory investigations of the role of biofilms on stream-bed surfaces in debris-flow runout     

Yong-Jun Tang  Ze-Min Xu  Zhen-Chen Shao  Zhe Ren  Kun Wang  Kui Yang  Jun-Yao Luo  Hai-Yan Gao  Lin Tian 《地球表面变化过程与地形》2020,45(4):999-1012

Debris-flow runout is a fascinating process to understand due to its implications for downstream alluvial fans. Based on the propagation-deposition behaviors of the Dongyuege (DYG) debris flow, in Yunnan, the effect of biofilms on channel surfaces on debris-flow runout is investigated in laboratory flumes with two different internal surfaces: surfaces are lined with granite slabs (Model I) and gravel (Model II), respectively. Our results show that biofilms can significantly reduce frictional resistance to flows. They increase flow velocities, slow down the deceleration of the snouts, prolong runout distances, and subsequently extend the areas covered with resulting deposits, thus greatly assisting the propagation of experimental debris flows. Slippery biofilms consisting mainly of diatoms and their extracellular mucus (ECM) reduce the contact friction between the flume-beds and the overlying fluids, and greatly promote the propagation of tested flows. Well-developed biofilms are found on the underwater channel surfaces of the DYG Creek. Acting as lubricating layers, they likely played a key role in the DYG debris-flow runout. Most of the debris transported during the DYG event was deposited on overbanks, and the sediment that caused the disaster was transported to the populated fan region through the stream-bed clad in the thick biofilms. Owing to their impacts on the development and width of the temporary debris dam breach, the stream-bed covered with biofilms became a direct contributor to the debris-flow hazard. Because of the ubiquitous presence of biofilms on mountain stream-bed surfaces, the development of perennial streamflows can be viewed as an indicator of gully susceptibility to debris flows threatening creek fans. The underwater areas of pre-event channel cross-sections should be regarded as slip or low-friction boundaries, and the parts above stream-levels can be viewed as no-slip boundaries. © 2019 John Wiley & Sons, Ltd.  相似文献   

基于桩土界面摩擦特性和桩周土体应力状态的基桩极限侧阻力分析          下载免费PDF全文

刘卡伟  邓少华 《探矿工程》2019,46(3):68-74

结合基桩承载过程中的桩周土体应力状态分析和桩土界面摩擦特性分析，推导出基于土体应力状态的沿桩土界面的土体抗剪强度计算模型和基于界面摩擦特性的界面抗剪强度计算模型。通过对比土体抗剪强度和界面抗剪强度，推导出受该两种强度耦合作用影响的极限侧阻力计算模型，并用上海某工程算例验证该模型的合理性和可行性，同时利用该模型分析不同类型的土的极限侧阻力随埋深的分布规律。结果显示：因内摩擦角和侧压力系数之间的不同关系，极限侧阻力随埋深表现出不同的分布特点，在特定关系下，存在一个临界深度，超过该深度极限侧阻力维持在一个稳定值甚至不断减小直至为零。  相似文献