敦煌-格尔木铁路沿线风动力环境特征     

鱼燕萍  张克存  安志山  张余 《中国沙漠》2020,40(1):41-48

敦煌-格尔木铁路沿线地形复杂、起沙因素多变、沙源丰富，沙害问题日益严重。目前对其风沙活动规律还未有研究，不利于防沙工作的开展。为此，通过对自北向南的5个观测点（S1、S2、S3、S4、S5）风速和风向的观测、计算和分析，利用平均风速、起沙风况及输沙势对敦格铁路沿线的风动力环境特征进行研究。结果表明：S5、S4和S3的风况对铁路风沙灾害防治意义较大。S5年平均风速、起沙风频率和输沙势最大，春季风沙活动最为强烈，且风向单一、风力强劲，风沙运动方向基本与铁路垂直，沙粒易在铁路附近堆积。S4夏季风沙活动最为强烈；S3春季风沙活动最为强烈，且风向单一，S4和S3的风沙运动方向与铁路夹角小于90°，附近沙源广阔，铁路易受风沙侵蚀，阻碍交通运营。  相似文献   

Geoheritage at the small scale: tidal-zone bubble-sand structures as diagnostic paleo-environmental indicators,and their geoheritage significance     

V. Semeniuk  M. Brocx 《Australian Journal of Earth Sciences》2019,66(6):913-922

In identifying sites of geoheritage significance, commonly there has been an emphasis on the larger-scale features. However, the story of geology and the significant features that are critical to unravel geological processes and geological history are commonly small in scale. This contribution focuses on bubble sand and bubble-sand structures as features that are small-scale but nonetheless important to geology, and hence are of geoheritage significance. Bubble sand and bubble-sand structures are ubiquitous on modern beaches and tidal flats, occurring in the uppermost tidal zone of sandy beaches, as a distinct layer in a shoaling beach-to-dune stratigraphy, and are a diagnostic indicator of upper-tidal conditions where a rising tide and a concomitantly rising water-table interacts with the upper swash-zone wave processes. On sandy tidal flats, bubble sand and bubble-sand structures may occur in the mid- to upper-tidal zones; here they are also diagnostic indicators of tidal conditions, forming during a rising tide where a rising water-table forces air upwards to be trapped in moist sand. If found in ancient sequences, bubble-sand structures are a powerful environmental indicator of tidal conditions and, for beach sequences, an indicator of the high-tide level and sea level. Bubble-sand structures have been found in a number of ancient sequences throughout the geological record as far back as the Neoproterozoic, e.g. within beach-to-dune stratigraphy in Pleistocene limestones of the Perth Basin and in southeastern USA, and in tidal-flat sands of the Mesozoic Broome Sandstone of the Canning Basin. The bubble-sand structure is a significant geological tool for use in paleo-environmental and paleo-oceanographic reconstructions, and determination of the position of a paleo-water-table. Given the rarity of their preservation, these occurrences of bubble-sand structures are of geoheritage significance in their own right and, depending on age of sequence and how common they are in the region, they may be nationally significant or globally significant.  相似文献   

厚层切叠砂体自然层描述方法:以北一区断东葡一组1-4小层为例     

吴迪  马世忠  景丽娟  周志国 《世界地质》2020,39(1):106-112

将多期切叠河道砂体归类合并,建立一个“垂向连续,横向联通的表外砂岩空间体”(其中砂岩间夹层厚度≤0.4 m)的自然层概念来控制多期河道复合切叠厚砂体。以北一匹断东萄一组1-4小层为例,利用自然层间砂体厚度、切叠程度、测井曲线形态、相叠加类型及砂体叠加期次将自然层分为5类;再依据砂体间切叠位置、切叠程度和切叠形态的差异建立自然层剖面表征方法;依据砂体叠加期次,建立自然层在平面上表征模式。  相似文献   

A finite element approach for predicting the full resistance profile of a spudcan deeply penetrating in dense sand overlying clay     

《Applied Ocean Research》2019

This paper presents a finite element approach to calculate the full resistance profile of a spudcan deeply penetrating in dense sand overlying clay, in which a potential for an installing spudcan to experience a sudden uncontrolled punch-through failure exists. A modified Mohr-Coulomb model characterized by incorporating a four-phase variation of the mobilized strength and dilation parameters with an equivalent accumulated plastic strain is developed and tested for the overlying dense silica sand. An extended Tresca model is used for the strain softening of the underlying clay. A series of large deformation finite-element (LDFE) analyses are carried out, varying the strength and dilation parameters as well as the spudcan geometries. A fairly good performance of the present approach is verified by validating against groups of centrifuge tests data, allowing the numerical study to be extended parametrically. The four-phase variation of the mobilized strength and dilation parameters involved in the progressive failure of the upper dense sand is parametrically studied and extended to cover the range of sand relative densities that are of practical interest. Additionally, comparisons with the typical existing LDFE analyses using both simple and sophisticated constitutive models are carried out. It shows that the present approach performs fairly well to calculate the full resistance profile of a spudcan deeply penetration in both thin and thick dense sand overlying clay, especially the peak and post-peak resistance, within around 5% of the corresponding centrifuge tests results.  相似文献   

Effects of long-term cyclic horizontal loading on bucket foundations in saturated loose sand     

《Applied Ocean Research》2019

A 1-g model experimental study was conducted to investigate the accumulated rotations and unloading stiffness of bucket foundations in saturated loose sand. One-way horizontal cyclic loading was applied to model bucket foundations with embedment ratios 0.5 and 1.0. Up to 10⁴ cycles of loading were applied at a frequency of 0.2 Hz varying load amplitudes. The accumulated rotation of the bucket foundations increased with the number of cycles and the load amplitudes. Empirical equations were proposed to describe the accumulated rotation of the foundations. The unloading stiffness of foundations increased with the number of cycles but decreased with an increase in load amplitude. The initial unloading stiffness of L/D = 1.0 (L is skirt length; D is foundation diameter) was approximately twice that of L/D = 0.5. Excess pore water pressure difference of 50% was observed between L/D = 0.5 and 1.0. The suction and static capacity of the bucket increased with increase of bucket embedment ratio with a difference of 69.5% and 73.6% respectively between L/D = 0.5 and 1.0.  相似文献   

Mixed sand–mud bedforms produced by transient turbulent flows in the fringe of submarine fans: Indicators of flow transformation     

Megan L. Baker  Jaco H. Baas 《Sedimentology》2020,67(5):2645-2671

  相似文献   

硅灰加固宁波软土的试验研究     

王泽平  王常明  江南  张在恒 《岩土工程技术》2020,(2):111-116,121

为探索硅灰对软土的力学性质的影响,以宁波鄞州地区一种淤泥质黏土为试样,掺入不同量的硅灰,对硅灰加固土的力学性质和结构特征进行了测试。采用三轴不固结不排水剪切试验,测试分析了不同掺入量的硅灰加固土的应力应变关系,通过扫描电镜SEM照片分析了不同硅灰掺入量的硅灰加固土的结构特征。结果表明:(1)硅灰可以提高软土的黏聚力,黏聚力随着硅灰掺入量的增加而增大;(2)随着硅灰掺入量的增加,硅灰加固土的抗变形能力呈先增加后减小的趋势;(3)同一围压条件下,随着硅灰掺入量的增加,硅灰加固土的破坏偏应力逐渐增加;(4)随着硅灰掺入量的增加,硅灰加固土中大孔隙逐渐减少,小孔隙逐渐数量增加,孔径<1μm的小孔隙组分逐渐占优。  相似文献   

Effect of sand on the vacuum consolidation of dredged slurry     

Jun Wang  Yuanqiang Cai  Xueyu Geng  Fengqi Xu 《Marine Georesources & Geotechnology》2018,36(2):238-244

Vacuum preloading is often used to improve the geotechnical properties of dredged slurry. Although the performance of this method has improved with rapidly developing technology, soil columns usually formed on the drainage boundary induce the decrease of permeability around the boundary, thereby limiting the further development of this method. To address this issue, this paper proposes a method for pretreating the slurry combined with sand prior to vacuum consolidation. This method partially replaces the fine particles with sand to reduce the formation of soil columns. Two groups of vacuum preloading tests were performed to investigate the effect of sand content and sand grain size on the vacuum consolidation of dredged slurry. The test results revealed that for a given sand grain size, increasing the sand content of the sand–slurry mixture increased the pore water drainage and accelerated the dissipation of pore water pressure, thereby increasing the vane shear strength. In contrast, for a constant sand content, the samples containing coarse sand exhibited increased pore water drainage and accelerated dissipation of pore water pressure, thereby increasing the vane shear strength of the soil.  相似文献   

Acoustic and petrophysical properties of mechanically compacted overconsolidated sands: Part 2 – Rock physics modelling and applications     

Sirikarn Narongsirikul  Nazmul Haque Mondol  Jens Jahren 《Geophysical Prospecting》2019,67(1):114-127

Part one of this paper reported results from experimental compaction measurements of unconsolidated natural sand samples with different mineralogical compositions and textures. The experimental setup was designed with several cycles of stress loading and unloading applied to the samples. The setup was aimed to simulate a stress condition where sediments underwent episodes of compaction, uplift and erosion. P-wave and S-wave velocities and corresponding petrophysical (porosity and density) properties were reported. In this second part of the paper, rock physics modelling utilizing existing rock physics models to evaluate the model validity for measured data from part one were presented. The results show that a friable sand model, which was established for normally compacted sediments is also capable of describing overconsolidated sediments. The velocity–porosity data plotted along the friable sand lines not only describe sorting deterioration, as has been traditionally explained by other studies, but also variations in pre-consolidation stress or degree of stress release. The deviation of the overconsolidated sands away from the normal compaction trend on the V_P/V_S and acoustic impedance space shows that various stress paths can be predicted on this domain when utilizing rock physics templates. Fluid saturation sensitivity is found to be lower in overconsolidated sands compared to normally consolidated sands. The sensitivity decreases with increasing pre-consolidation stress. This means detectability for four-dimensional fluid saturation changes can be affected if sediments were pre-stressed and unloaded. Well log data from the Barents Sea show similar patterns to the experimental sand data. The findings allow the development of better rock physics diagnostics of unloaded sediments, and the understanding of expected 4D seismic response during time-lapse seismic monitoring of uplifted basins. The studied outcomes also reveal an insight into the friable sand model that its diagnostic value is not only for describing sorting microtextures, but also pre-consolidation stress history. The outcome extends the model application for pre-consolidation stress estimation, for any unconsolidated sands experiencing similar unloading stress conditions to this study.  相似文献   

Numerical study of sand scour with a modified Eulerian model based on incipient motion theory     

Qingqing Yuan  Min Zhao  Tong Ge 《Marine Georesources & Geotechnology》2018,36(7):818-826

Application of the standard Eulerian model to simulations of sand scour results in unrealistic phenomena. Therefore, the present work develops a modified Eulerian model based on sand incipient motion theory. The modified model is applied for simulating a two-dimensional single vertical jet and a moving planar jet. The simulation results generally demonstrate fairly good agreement with published results of scour profiles and the velocity contours of the water and sand phases. In addition, equations to describe self-similar scour profiles for the moving planar jet cases are given. The results demonstrate that the modified model efficiently and accurately simulates the two-dimensional sand scour produced by jets, particularly for the moving jet cases.  相似文献