滇东北地区地震弱活动前兆异常特征研究     

李利波  付虹  李琼  何德强 《地震》2019,39(3):115-126

以鲁甸M_S6.5地震震中附近的鲁甸大坪子泉水氡、 水质观测资料为基础, 通过对其地震前后的异常特征进行差异性对比, 分析认为震前地震活动丛集, 水氡、 水质异常持续时间较长, 幅度较大, 表现为破年变异常现象; 震后为小震群弱活动, 水氡、 水质异常幅度相对较小, 持续时间较短, 多次出现同步转折, 表现为介质弱化区的前兆异常特征。 从水样测试结果, GNSS位移观测资料、 GPS时间序列曲线及地震活动性等方面分析了鲁甸水氡、 水质的异常机理, 认为鲁甸的水质离子组分群体异常, 与区域的变形活动有关, 局部应力的不断积累, 加剧了地下深部物质活动及构造活动; 近期的同步转折现象属于介质弱化区应力调整状态下的前兆异常。  相似文献   

大陆下地壳麻粒岩的流变学研究进展   总被引：1，自引：0，他引：1  

李丽敏  刘祥文  谢战军 《地球科学进展》2011,26(3):275-285

大险下地壳麻粒岩的流变学研究可以解释地壳变形、壳幔物质交换以及岩石圈深部动力学过程等科学问题.前人通过研究各矿物的显微构造变形特征与变形机制,运用广义混合流变律探讨多矿物复合岩石的流变性质,结合水与流体对岩石变形强度的弱化作用,阐明在大陆下地壳变形环境下复矿麻粒岩的塑性变形和韧性流变性质.目前人们致力于对天然变形岩石和...  相似文献   

Particle mechanics modeling of creep behavior of rockfill materials under dry and wet conditions     

《Computers and Geotechnics》2015

Rockfill is an important construction material for infrastructure engineering, such as dams, railways and airport foundations, which display a long-term post-construction settlement. However, the main mechanisms for rockfill creep and weathering influence still remain poorly understood. Particle mechanics method is used to understand the rockfill creep process under dry and wet conditions. Different bond-aging models and wetting models that represent different degradation and weakening mechanisms are compared, in order to clarify the principle and secondary mechanisms for rockfill creep and weathering influence. The results show that rockfill aggregate breakage in terms of angularity abrasion is the main source for rockfill creep under dry state. Wetting can induce additional strain mainly due to the reduction of contact friction coefficient, i.e. lubrication, and the bond strength reduction just plays a secondary role in producing additional strain. The earlier the wetting occurs during rockfill creep, the more rapidly the rockfill becomes stable. The wetting–drying cycles can induce strain evolution in a ‘stepped’ way, which is in agreement with experimental observation. The practical implications from the modeling and the outstanding issues in this study are also discussed.  相似文献   

中国各季节气候对热盐环流减弱的不同响应     

程军  刘征宇  张福颖  郭品文  杨洋 《南京气象学院学报》2011,34(6):653-661

使用CCSM3（community climate system model version 3）模式的＂淡水扰动试验＂结果,对热盐环流强度减弱后中国区域冬、夏气候的不同响应特征进行了研究。结果表明：CCSM3可较为准确地再现中国附近区域表面气温及降水量的量值和分布形态。当热盐环流年平均强度减弱约80%之后,中国区域冬、夏季的表面气温与降水量显著降低,但冬、夏季的降低幅度与空间分布形态存在显著的差异。冬季的降温幅度较大且分布较为一致,平均降温幅度可达2.2℃,最大的降温幅度可达4℃;夏季的降温幅度相对较小且南北差异较大,平均降温幅度为1.3℃,最大的降温幅度为3℃。冬、夏季降水量的降低幅度都在6%左右,但其成因及其分布形态都存在显著差异。  相似文献   

巴颜喀拉块体地壳结构多样性探测   总被引：3，自引：2，他引：1       下载免费PDF全文

嘉世旭  林吉焱  郭文斌  赵楠  邱勇 《地球物理学报》2017,60(6):2226-2238

青藏高原内部地壳岩性的改造、岩性随深度变化及形变构造是探索研究地壳增厚、物质运动问题的关键.巴颜喀拉块体位于青藏高原中北部,地域广袤,通过对块体内中、东部不同区域的深地震广角反射/折射震相的综合分析,利用反射率理论地震图方法对不同性质震相走时及振幅特征进行细致的模拟计算,进一步研究巴颜喀拉块体内部不同区域地壳精细结构.结果显示:巴颜喀拉块体地壳厚度50~60 km、整体向西逐渐增厚,结晶地壳平均速度6.07~6.18 km·s~(-1)、岩层速度大幅降低,壳内多强反射界面结构、但不同区域差异明显;东部若尔盖盆地地壳介质速度整体低速、壳幔边界较为清晰;中部玉树一玛多段下部地壳发现约6.8 km·s~(-1)的"高速度"介质结构,壳幔边界不清、被改造为2~4 km厚的高速度梯度层,显示了巴颜喀拉块体内部地壳增厚、介质岩性结构被改造的差异性.地壳内部多组强反射、低视速度走时震相揭示了介质岩性的低速破碎、弱化蠕变以及可能的壳内解耦构造.局部地区下地壳的高视速度震相特征显示了青藏高原地壳改造增厚大背景下可能存在稳定的"原始地壳"结构残留或是与上地幔物质的浸入交流.巴颜喀拉块体内不同区域地壳增厚、岩性结构、结晶基底及壳幔边界性质被改造的多样性为深入认识青藏高原地壳形变及动力学过程带来新的启迪.  相似文献   

Optimal weakening and damping using polynomial control for seismically excited nonlinear structures     

Gian Paolo Cimellaro 《地震工程与工程振动(英文版)》2009,8(4):607-616

This paper presents an approach for the optimal design of a new retrofi t technique called weakening and damping that is valid for civil engineering inelastic structures.An alternative design methodology is developed with respect to the existing ones that is able to determine the locations and the magnitude of weakening and/or softening of structural elements and adding damping while insuring structural stability.An optimal polynomial controller that is a summation of polynomials in nonlinear states is used...  相似文献   

FRICTIONAL SLIDING OF PLAGIOCLASE GOUGE UNDER LOWER-CRUST TEMPERATURE AND RELATIVELY LOW EFFECTIVE NORMAL STRESS          下载免费PDF全文

YAO Sheng-nan  HE Chang-rong 《地震地质》2016,38(2):290-302

The discovery of tremors on the lower crust portion of the San Andreas Fault has attracted more attention on the mechanical properties of the lower crust in recent years, and some experimental studies have been carried out to understand the mechanical behavior. Previous experiments under effective normal stresses of 200MPa have shown that pyroxene and plagioclase mineral separated from the gabbro and their mixtures all show velocity weakening in the lower-crust temperature range, which results in unstable slip when frictional sliding is the dominant deformation mechanism. This work is to examine whether the velocity-weakening behavior of plagioclase gouge also applies to relatively lower effective normal stress. Our experiments were performed under effective normal stress of about 100MPa, with a constant confining pressure control, with pore pressure of 30MPa and temperature of 100℃ to 600℃. We found that the frictional sliding of plagioclase are basically the same with the previous results obtained under effective normal stress of 200MPa, both of which show velocity weakening over the entire temperature range. The only difference is the out-of-trend drop of constitutive parameter a at 600℃ for the lower effective normal stress of 100MPa. It is thus concluded that reducing the effective normal stress has little effect on the sliding stability of plagioclase, and the previous conclusion made for mechanical behavior of the lower crust that unstable slips are possible therein also applies to the lower effective normal stress of 100MPa.  相似文献   

A numerical method for the study of shear band propagation in soft rocks     

Marta Castelli  Andrea Allodi  Claudio Scavia 《国际地质力学数值与分析法杂志》2009,33(13):1561-1587

This paper investigates the possibility of interpreting progressive shear failure in hard soils and soft rocks as the result of shear propagation of a pre‐existing natural defect. This is done through the application of the principles of fracture mechanics, a slip‐weakening model (SWM) being used to simulate the non‐linear zone at the tips of the discontinuity. A numerical implementation of the SWM in a computation method based on the boundary element technique of the displacement discontinuity method (DDM) is presented. The crack and the non‐linear zone at the advancing tip are represented through a set of elements, where the displacement discontinuity (DD) in the tangential direction is determined on the basis of a friction law. A residual friction angle is assumed on the crack elements. Shear resistance decreases on elements in the non‐linear zone from a peak value at the tip, which is characteristic of intact material, to the residual value. The simulation of a uniaxial compressive test in plane strain conditions is carried out to exemplify the numerical methodology. The results emphasize the role played by the critical DD on the mechanical behaviour of the specimen. A validation of the model is shown through the back analysis of some experimental observations. The results of this back analysis show that a non‐linear fracture mechanics approach seems very promising to simulate experimental results, in particular with regards to the shear band evolution pattern. Copyright © 2009 John Wiley & Sons, Ltd.  相似文献   

Transition process from nucleation to high-speed rupture propagation: scaling from stick-slip experiments tonatural earthquakes     

Bunichiro Shibazaki  & Mitsuhiro Matsu'ura 《Geophysical Journal International》1998,132(1):14-30

  相似文献   

大陆岩石圈塑性流动网络的延性弱面效应   总被引：1，自引：1，他引：0       下载免费PDF全文

王绳祖 《地震地质》2004,26(3):405-415

岩石圈下层的网状塑性流动 ,作为包含塑性流动网络的黏塑性流动 ,控制着大陆板块内部的构造变形和动力学过程。塑性流动网络由两组网带共轭相交而成 ,而塑性流动网带是黏塑性流动过程中因剪切局部化、黏性摩擦生热和网带介质的弱化而形成的延性弱面 (弱带 )。研究表明 ,类似于断裂和节理等脆性弱面 ,延性弱面对介质强度的影响也具有条件性 ,即当应力方向改变时 ,只有在滑移角θ不超出一定限值的条件 (θ1≤θ≤θ2 )下才可能沿原有弱面滑移 ,显示其弱化效应 ;延性弱面可以用弱化度R表示其屈服限的相对降低程度 ,弱化度与滑移角下限值之间的关系为R =sin2θ1;根据亚洲中东部地区“塑性流动 -地震”网络的最大共轭角推算 ,网带的弱化度R近似于 0 81。基于延性弱面效应的认识 ,文中就网带由剪切滑移向压性褶皱的转化、网带的继承与弃置以及应力方向的允许偏角等问题进行了探讨  相似文献