排序方式： 共有28条查询结果，搜索用时 453 毫秒
1.
Changes in Geomorphic characteristics in the lower reaches of the Gongola River channel following construction of Kiri dam have been investigated. The study focused on changes in the channel bankfull width and of riverbed width after the control of the river flow, variation in discharge characteristics between pre- and post- dam periods and the impact of discharge variation on post- dam river channel. Results of the analysis revealed that the main effect of the impoundment of the Gongola channel is a drastic decrease in flood peaks below the reservoir by 11.5% (from 1,420 m3/sec to 1,256 m3/sec). The low flows have on the other hand increased by 268% (from 5.7 m3/sec to 21 m3/sec). The resultant effect of decrease in the discharge was reduction in the channel bankfull and riverbed widths by 38.3% and 72.2% respectively. Also, the post- dam channel became less sinuous and braided in some of the reaches downstream. Discharges of high peaks were found during the period of maximum precipitation (June to September) whereas low discharges were recorded during the period of minimum or no precipitation (December to May). Some of the observed implications of the flow control on the geometric variables were reduction in the overall channel width, concave bank erosion and emergence of vegetation in some of the reaches. 相似文献
2.
3.
4.
Muhammed Duman 《Geo-Marine Letters》1994,14(4):272-278
During New Euxinian time when sea level dropped below the sill connecting the Black and Marmara seas, the Black Sea became isolated and freshwater sediments were deposited. Now it is a semieuxinic basin with the oxic/anoxic boundary at 100–150 m. The seasonal changes in sedimentation are preserved in the form of laminated sequences. The counting of varves in southeastern Black Sea cores show the chronology of the O2/H2S interface. The age of the Holocene sapropel along the eastern margin ranges from 4000 to 1000 yr BP in deep water and 2500—1000 yr BP in shallower water. Sapropel formation started at 3650 yr BP at a water depth of 2200 m. 相似文献
5.
Cem Iyigun Murat Türkeş İnci Batmaz Ceylan Yozgatligil Vilda Purutçuoğlu Elçin Kartal Koç Muhammed Z. Öztürk 《Theoretical and Applied Climatology》2013,114(1-2):95-106
In this study, the hierarchical clustering technique, called Ward method, was applied for grouping common features of air temperature series, precipitation total and relative humidity series of 244 stations in Turkey. Results of clustering exhibited the impact of physical geographical features of Turkey, such as topography, orography, land–sea distribution and the high Anatolian peninsula on the geographical variability. Based on the monthly series of nine climatological observations recorded for the period of 1970–2010, 12 and 14 clusters of climate zones are determined. However, from the comparative analyses, it is decided that 14 clusters represent the climate of Turkey more realistically. These clusters are named as (1) Dry Summer Subtropical Semihumid Coastal Aegean Region; (2) Dry-Subhumid Mid-Western Anatolia Region; (3 and 4) Dry Summer Subtropical Humid Coastal Mediterranean region [(3) West coast Mediterranean and (4) Eastern Mediterranean sub-regions]; (5) Semihumid Eastern Marmara Transition Sub-region; (6) Dry Summer Subtropical Semihumid/Semiarid Continental Mediterranean region; (7) Semihumid Cold Continental Eastern Anatolia region; (8) Dry-subhumid/Semiarid Continental Central Anatolia Region; (9 and 10) Mid-latitude Humid Temperate Coastal Black Sea Region [(9) West Coast Black Sea and (10) East Coast Black Sea sub-regions]; (11) Semihumid Western Marmara Transition Sub-region; (12) Semihumid Continental Central to Eastern Anatolia Sub-region; (13) Rainy Summer Semihumid Cold Continental Northeastern Anatolia Sub-region; and (14) Semihumid Continental Mediterranean to Eastern Anatolia Transition Sub-region. We believe that this study can be considered as a reference for the other climate-related researches of Turkey, and can be useful for the detection of Turkish climate regions, which are obtained by a long-term time course dataset having many meteorological variables. 相似文献
6.
Muhammed O. Usman Hideki Masago Wilfried Winkler Michael Strasser 《International Journal of Earth Sciences》2014,103(4):1141-1161
Coring during Integrated Ocean Drilling Program Expeditions 315, 316, and 333 recovered turbiditic sands from the forearc Kumano Basin (Site C0002), a Quaternary slope basin (Site C0018), and uplifted trench wedge (Site C0006) along the Kumano Transect of the Nankai Trough accretionary wedge offshore of southwest Japan. The compositions of the submarine turbiditic sands here are investigated in terms of bulk and heavy mineral modal compositions to identify their provenance and dispersal mechanisms, as they may reflect changes in regional tectonics during the past ca. 1.5 Myrs. The results show a marked change in the detrital signature and heavy mineral composition in the forearc and slope basin facies around 1 Ma. This sudden change is interpreted to reflect a major change in the sand provenance, rather than heavy mineral dissolution and/or diagenetic effects, in response to changing tectonics and sedimentation patterns. In the trench-slope basin, the sands older than 1 Ma were probably eroded from the exposed Cretaceous–Tertiary accretionary complex of the Shimanto Belt and transported via the former course of the Tenryu submarine canyon system, which today enters the Nankai Trough northeast of the study area. In contrast, the high abundance of volcanic lithics and volcanic heavy mineral suites of the sands younger than 1 Ma points to a strong volcanic component of sediment derived from the Izu-Honshu collision zones and probably funnelled to this site through the Suruga Canyon. However, sands in the forearc basin show persistent presence of blue sodic amphiboles across the 1 Ma boundary, indicating continuous flux of sediments from the Kumano/Kinokawa River. This implies that the sands in the older turbidites were transported by transverse flow down the slope. The slope basin facies then switched to reflect longitudinal flow around 1 Ma, when the turbiditic sand tapped a volcanic provenance in the Izu-Honshu collision zone, while the sediments transported transversely became confined in the Kumano Basin. Therefore, the change in the depositional systems around 1 Ma is a manifestation of the decoupling of the sediment routing pattern from transverse to long-distance axial flow in response to forearc high uplift along the megasplay fault. 相似文献
7.
Sidali Denine Sadok Feia Rawaz Dlawar Muhammed Jean Canou Jean-Claude Dupla 《Marine Georesources & Geotechnology》2013,31(5):599-608
AbstractAn experimental study about the effects of initial conditions of soil and geotextile reinforcement on the mechanical behavior of reinforced sand is presented in this paper. A series of direct shear tests are conducted on reconstituted specimens of dry and moist natural sand prepared with different initial water content (w?=?0, 1.5, 3, and 5%) and including the two arrangements of geotextile layers (one and two layers, respectively). Both S41 and PEC55types of non-woven geotextile were used and placed at different heights of the specimens to investigate the effect of geotextile reinforcement on the behavior of sand. Test specimens were prepared at Dr =80% of relative density and were subjected to three different normal stresses of 100, 200, and 300?kPa. The experimental results showed that the deposition mode (wet and dry) and the geotextile reinforcement have significant effects on the behavior of reinforced sand. The increase in shear strength is relatively more significant for specimens prepared with dry deposition mode as compared to those prepared with wet deposition mode and it increases with the number of geotextile layers, this effect becomes less significant for wet specimens. The experimental results also demonstrated that (PEC55) non-woven geotextile shows a better performance than the (S41) of geotextile. These results can be explained by the effective tensile strength property of polyester yarns of the (PEC55) non-woven geotextile that it has led to a significant increase in the shear strength. 相似文献
8.
Nik Norsyahariati Nik Daud Abubakar S. Muhammed Ali M. Kundiri 《Geotechnical and Geological Engineering》2017,35(5):1967-1976
Laboratory tests were carried out on compacted granite residual soil treated with 0 to 15% Palm Oil Fuel Ash (POFA), with a view to evaluate its hydraulic conductivity for its application in landfilling. The Soil–POFA mixtures were compacted using both Standard and Modified Proctors compactive efforts at 2% dry of Optimum Moulding water Content (?2%), at Optimum Moulding water Content (0%), at 2 and 4% on the wet side of Optimum Moulding water Content (+2 and +4%). The samples were permeated with water and the effect of moulding water content; compactive effort and POFA content were examined. The samples that met the minimum threshold of 1 × 10?9 m/s were used in plotting the acceptable zones criterion at various POFA mixtures. The results gave indications of reduction in the hydraulic conductivity values, with increase in compactive efforts, moulding water content and POFA content up to about 10%. This was the most suitable soil–POFA mixture for the hydraulic application. 相似文献
9.
Ocean Dynamics - Directional wave data collected in the coastal area at 10-m water depth for a period of 1 year is used to describe the surface wave dynamics off Mumbai coast. Partitioning... 相似文献
10.
In this study, the oxidative decolorization of C.I. reactive yellow 145 (RY 145) from synthetic textile wastewater including RY 145 and polyvinyl alcohol by Fenton and sono‐Fenton processes which are the combination of Fenton process with ultrasound has been carried out. The effects of some operating parameters which are the initial pH of the solution, the initial concentration of Fe2+, H2O2, and the dye, temperature, and agitation speed on the color and chemical oxygen demand (COD) removals have been investigated. The optimum conditions have been found as [Fe2+] = 20 mg/L, [H2O2] = 20 mg/L, pH 3 for Fenton process and [Fe2+] = 20 mg/L, [H2O2] = 15 mg/L, pH 3 for sono‐Fenton process by indirectly sonication at 35 kHz ultrasonic frequency and 80 W ultrasonic power. The color and COD removal efficiencies have been obtained as 91 and 47% by Fenton process, and 95 and 51% by sono‐Fenton processes, respectively. Kinetic studies have been performed for the decolorization of RY 145 under optimum conditions at room temperature. It has been determined that the decolorization has occurred rapidly by sono‐Fenton process, compared to Fenton process. 相似文献