排序方式： 共有14条查询结果，搜索用时 515 毫秒
1.
Erdem Emin Maras Mustafa Caniberk Mehmet Serhat Odabas Burcu Degerli Süleyman Sirri Maras Hadi Hakan Maras 《Arabian Journal of Geosciences》2016,9(2):164
We investigated the relationships between mineral content and the physical and mechanical properties of landscape rock using a non-destructive remote sensing method applied in the laboratory. Using this technique, the spectral properties of the landscape rock could be collected at different wavelengths without harming the samples. Differences in spectral reflectance were compared with the physical and mechanical properties of the stone. Significant correlations were observed between reflectance values and the rocks’ mechanical and physical properties, with correlation coefficients of 95 to 99 %. However, establishing a correlation between two variables is not a sufficient condition to establish a causal relationship. Mineral densities and mineral content are characteristics used for the classification of landscape rock. We have concluded that although spectral signatures from landscape rock can be used for predicting which stones might have similar features when comparing two batches of stone, the high correlations we discovered cannot confirm a cause and effect relationship that would allow for the prediction of a rock’s physical and mechanical properties. Although this conclusion is disappointing, the mineral content and the significant correlations discovered by hyperspectral reflectance scanning can be used as supplementary information when comparing two samples of landscape rock. 相似文献
2.
M. Ali Kokpinar A. Burcu Altan-Sakarya S. Yurdagul Kumcu Mustafa Gogus 《水文科学杂志》2013,58(12):2189-2203
AbstractAnalyses of data from reservoir surveys and sediment rating curves are compared to predict sediment yield in three large reservoir watershed areas in Turkey. Sediment yield data were derived from reservoir sedimentation rates and suspended sediment measurements at gauging stations. The survey data were analysed to provide the volume estimates of sediment, the time-averaged sediment deposition rates, the long-term average annual loss rates in the reservoir storage capacity, and the long-term sediment yield of the corresponding watershed areas. Four regression methods, including linear and nonlinear cases, were applied to rating curves obtained from gauging stations. Application of the efficiency test to a power function form of a rating curve with nonlinear regression yielded the highest efficiency values. Based on the analysis of the sediment rating curves, sediment load fluxes were calculated by using average daily discharge data at each gauging station. Comparison of these two sediment yield values for each reservoir showed that the sediment yields from the suspended sediment measurements, SYGS, are 0.99 to 3.54 times less than those obtained from the reservoir surveys, SYRS. The results from the reservoir surveys indicate that all three reservoirs investigated have lost significant storage capacity due to high sedimentation rates. 相似文献
3.
Dissolved oxygen is one of the most important water quality parameters. Aeration improves the water quality by maintaining good dissolved oxygen levels in water. Dissolved oxygen enters water by entrainment of air bubbles. A method of aeration that has become popular in recent years is the venturi aeration. In the present paper, experimental studies were conducted to investigate the effect of the location of the air hole in venturi tubes upon air injection. It was observed from the results that the location of the air hole playes a significant role for the air injection. The optimal air hole location that maximized the air injection in venturi aerators was determined. 相似文献
4.
Water is a vital resource for the survival of not only human population, but also almost all ecosystems. Constituting 30 % of all freshwater, groundwater is the main source of available freshwater. Coastal aquifers, which serve as the major freshwater source for densely populated zones, are of vital importance and quite vulnerable to climate change. This paper examines the significant consequences of climate change, decreasing recharge rates, sea-level rise and increasing freshwater demand on the sustainable management of coastal aquifers, via a hypothetical case study. A 3-D numerical model is developed using SEAWAT, to simulate a circular island aquifer in the form of a freshwater lens surrounded by saltwater. Issues such as sloping land surface resulting in landward migration of the coastal boundary and transient response of the system due to pumping are considered through a set of predictive simulations. To assess the sensitivity of the model results to important parameters, a sensitivity analysis is performed. Results of this research, revealing the effects of mentioned pressures on the long-term sustainability of the freshwater resource, are evaluated on the basis of groundwater reserves and intrusion of the freshwater–saltwater interface in lateral and vertical directions. These outcomes are further used to determine the sustainable pumping rate of the system, considering both quantity and quality of the groundwater resources. 相似文献
5.
Hale Ozgun Mustafa Evren Ersahin Selime Erdem Burcu Atay Sema Sayili Esra Eren Pelin Hoshan Doga Atay Mahmut Altinbas Cumali Kinaci Ismail Koyuncu 《洁净——土壤、空气、水》2013,41(12):1175-1182
A reliable wastewater characterization is a prerequisite for the selection of an acceptable treatment strategy for produced water which exhibits significant differences due to the varied kinds of wells, seasonal changes, and formation types. A complete characterization of produced water generated from oil, gas, and oil–gas fields in Turkey was performed based on seasonal and locational variations. The results showed that the produced water generated from oil field wells was highly polluted and wastewater volume was higher in comparison to gas and oil–gas field wells. Besides, the characterization of produced water was varying in a wide range based on seasonal and locational variations. Useful relationships were observed between chloride, sodium, bromide, and total dissolved solids concentrations. The results can be used in the design, operation, and optimization of wastewater treatment systems of petroleum and oil industries for future studies. 相似文献
6.
This work describes the modification of silica gel with dimethylglyoxime, in order to prepare an effective sorbent for the preconcentration and determination of copper. The sorption capacity of dimethylglyoxime‐modified silica‐gel (DMGMS) was 71.37 mg g–1 and the optimum pH for the quantitative recovery of copper was found to be 5.0. The optimum flow rate, sorbent amount, and sample volume were 1 mL min–1, 300 mg, and 50 mL, respectively. 10 mL of 0.1 mol L–1 HCl was the most suitable eluent. The detection limit of copper was 6.0 ng mL–1. The recommended method, for the determination of copper, is simple and reliable, without any notable matrix effect and can be successfully applied to environmental water samples. Copper recovery in the range from 99–100% was obtained from seawater and thermal spring water using this method. The method was applied to standard reference materials, NIST‐1515 (apple leaves) and NIST‐1643e (simulated fresh water), for the determination of copper and the results were in good agreement with certified values. 相似文献
7.
8.
Disaster mitigation as a pre-disaster measure within the scope of disaster risk management is significant in the sense of reducing the adverse effects of earthquakes in the context of earthquake-sensitive risk planning. In the urban planning context, the existence of numerous decision makers and alternatives, which are depending on many criteria, makes decision-making process difficult. This difficulty was overcomed through geographical information systems (GIS). In the context of GIS-based multicriteria decision-making (MCDM) analysis, we used analytic hierarchy process (AHP) and technique for order preference by similarity to ideal solution (TOPSIS) to determine earthquake-risky areas in Yalova City Center. First, AHP analysis related to geological and superstructure/infrastructure criteria was conducted and two separate AHP maps were obtained. Then, we conducted TOPSIS analysis to consider both criteria in the sense of earthquake risk-sensitive planning. Then, overall earthquake risk map obtained which could be used as an input for disaster mitigation processes.
相似文献9.
Burcu Togral Koca 《Geographical review》2019,109(4):544-561
Using the case of Berlin, this article examines civil society actors in relation to local bordering practices following the large number of refugee arrivals in 2015. Combining critical border, migration, and urban studies and adopting a Foucauldian lens, the article aims to illustrate to what extent civil society actors have challenged and transformed local bordering practices vis‐à‐vis refugees within a specific urban space. The analysis illustrates that civil society actors have created new spaces of inclusion for refugees and brought new political and normative challenges to the established notions of belonging. On the other hand, they have also reproduced bordering practices either by their integration into formal state structures or by reinforcing hierarchical categorizations and unequal power relations embedded in the notion of humanitarianism. Finally, the article argues that these de/re‐bordering practices of civil society actors should be understood in line with the constraints that established bordering processes and the existing political and structural dynamics placed on them. 相似文献
10.
Nadav Sorek Eduardo Gildin Fani Boukouvala Burcu Beykal Christodoulos A. Floudas 《Computational Geosciences》2017,21(2):247-266
The objective of this paper is to introduce a novel paradigm to reduce the computational effort in waterflooding global optimization problems while realizing smooth well control trajectories amenable for practical deployments in the field. In order to overcome the problems of slow convergence and non-smooth impractical control strategies, often associated with gradient-free optimization (GFO) methods, we introduce a generalized approach which represent the controls by smooth polynomial approximations either by a polynomial function or by a piecewise polynomial interpolation, which we denote as function control method (FCM) and interpolation control method (ICM), respectively. Using these approaches, we aim to optimize the coefficients of the selected functions or the interpolation points in order to represent the well-control trajectories along a time horizon. Our results demonstrate significant computational savings, due to a substantial reduction in the number of control parameters, as we seek the optimal polynomial coefficients or the interpolation points to describe the control trajectories as opposed to directly searching for the optimal control values (bottom hole pressure) at each time interval. We demonstrate the efficiency of the method on two and three-dimensional models, where we found the optimal variables using a parallel dynamic-neighborhood particle swarm optimization (PSO). We compared our FCM-PSO and ICM-PSO to the traditional formulation solved by both gradient-free and gradient-based methods. In all comparisons, both FCM and ICM show very good to superior performances. 相似文献