Ripple formation in combined transdirectional steady and oscillatory flow     

J. S. LEE YOUNG  J. F. A. SLEATH 《Sedimentology》1990,37(3):509-516

Measurements are described of the geometry of ripples formed on beds of sand exposed to a steady current at right angles to an oscillatory flow. Four different sands were studied. The oscillation was produced by an oscillating tray set into the bed of a steady-flow flume. It was observed that straight-crested ripples formed by oscillatory flow would usually develop a ‘serpentine’ form when the superimposed steady current exceeded a certain limit. For amplitudes of the tray velocity U_∞ less than about 0.38 m s^-1 this limit corresponded to U_∞/ū_*c>31, where ū_*c is the shear velocity measured just upstream of the oscillating tray. It is suggested that the serpentine form is caused by the interaction of vortices carried back and forth between adjacent ripples. On this assumption, the wavelength of the serpentine form would be proportional to the product of period of oscillation and near-bed steady current velocity. The present measurements appear to support this hypothesis although there is also evidence that the wavelength is influenced by preferred spacing patterns between vortices. The measurements also show the ratio of the amplitude of the serpentine form to its wavelength to be approximately constant. Empirical relationships are derived relating ripple geometry to flow and sediment properties. It is observed that the influence of Reynolds number and sediment properties on the geometry is very weak. It is suggested that this is typical of ripples formed with relatively low sediment transport rates. It is also found that, under the present experimental conditions, the ripple spacing in the direction of oscillation is almost independent of the magnitude of the steady current and in close agreement with the wavelengths previously measured in an oscillating water tunnel. This suggests that the additional inertia effects associated with oscillating tray rigs were not sufficient to affect bed geometry under the present test conditions.  相似文献   

COMPUTER MODELING OF VERTICAL SEISMIC PROFILING*     

T. K. YOUNG  C. B. MONASH  R. M. TURPENING 《Geophysical Prospecting》1984,32(5):851-870

There are numerous modeling techniques commonly employed for the computer simulation of seismic wave propagation. The capabilities of these techniques vary according to the theoretical foundations and subsequent approximations upon which the algorithms are based. This paper constitutes a comparative review of seven modeling methods: geometric ray theory, asymptotic ray theory, generalized ray theory, Kirchhoff wave theory, Fourier synthesis, finite differences, and finite elements. These methods can be categorized as ray or wave, acoustic or elastic, and can be contrasted according to their relative abilities to simulate such behavior as wave interference effects, diffractions, and mode conversions. As is implied by their names, geometric ray theory and asymptotic ray theory are both ray methods. The other five methods provide wave theory simulations. Geometric ray theory and Kirchhoff wave theory are normally implemented in acoustic form, while the other methods are readily adapted for computing elastic theory solutions. Generalized ray theory and Fourier synthesis are more limited in the complexity of geological model they can accommodate than are the other techniques. The methods which typically demand the greatest computer resources are the finite-difference and the finite-element techniques. All methods can incorporate at least some multiple events. Diffractions, however, are only inherent in the solutions computed by Kirchhoff wave theory, finite differences and finite elements. Attenuation is readily incorporated in both the Fourier synthesis and the finite-element methods. As an example of the application of seismic modeling, a geological model representative of a typical petroleum exploration target is used to compare vertical seismic profiles calculated by different modeling methods.  相似文献   

VELOCITY ANALYSIS IN THE p—x-PLANE FROM A SLANT STACK WAVEFIELD*     

R. TANG  A. CARSWELL  WOOIL MOON 《Geophysical Prospecting》1984,32(6):1016-1032

Classical methods of interpretation of reflection seismic data are such that interpretation and processing usually occur in the “collected” frame of reference. However, in recent times other data planes have gained increasing acceptance in seismology as a viable alternative. Through linear transformations applied to a record section, both the t—p- and p—x-planes can be produced. The r—p-domain may be obtained from the t—x-plane by a transformation known as slant stacking. Normal practice has been to do most of the data processing in the t—x-plane and then transforming to the r—p-plane. However, many of the procedures used in the t—x-domain can be modified for use in the t—p-plane to increase the coherence. Velocity inversion may be carried out either in the r—p-domain or further transformed to the p—x-plane where the modified Herglotz-Wiechert inversion may be applied. To perform the inversion, the t—p-wavefield is converted to a p—x-representation by the use of a new linear transformation technique, the cross-stack. By a simple sampling process along a particular p—x-trajectory, the Herglotz-Wiechert method can be used to reconstruct an acceptable velocity model of the subsurface. A comparison of derived velocity structures is made between that produced by the Herglotz-Wiechert technique and that of the Dix method.  相似文献   

ON THE NEW FINDS OF FOSSIL EGGS OF STRUTHIO ANDERSSONI LOWE IN NORTH CHINA WITH REMARKS ON THE EGG REMAINS FOUND IN SHANSI,SHENSI AND IN CHOUKOUTIEN     

楊鍾健 《地质学报》1933,(1)

In the Museum of the Geological Survey only a single complete speci-men of a fossil egg of Struthio is exhibited.This specimen came from Ssushui(汜水) and it was described briefly by J.G.Andersson in his "Essays on theCenozoic of Northern China."~1 The othe  相似文献   

Time and space distribution of megaripples and associated bedforms, Middle Atlantic Bight, North American Atlantic Shelf     

D. J. P. SWIFT  G. L. FREELAND  R. A. YOUNG 《Sedimentology》1979,26(3):389-406

Three genetically distinct size classes of lower regime transverse bedforms have long been known from laboratory studies, and from studies of the intertidal zone; ripples, megaripples, and sand waves. These features are also present on the subtidal shelf surface of the Middle Atlantic Bight, and their distribution in time and space allows us to draw inferences concerning the time and space pattern of sediment transport. Transverse bedforms in the Middle Atlantic Bight occur in response to tidal flows at estuary and inlet mouths and on tide-dominated banks; on the shelf surface, however, they are primarily responses to wind-driven flows. Ripples are the most widespread of the three classes. They are current-formed during peak storm flows, but are probably remade as oscillatory wave ripples as the flow wanes. Megaripples are found primarily on the inner shelf, also as responses to peak storm flows. Sand waves of several metres amplitude occur on the inner shelf in the vicinity of topographic highs; low amplitude sand waves (< 2m), solitary or in trains, are widespread on the inner shelf. They survive through many seasons of storm flows. Megaripples are especially interesting as records of specific flow events. They are widespread on the inner shelf during the winter, occurring in fields up to several kilometres in diameter. On a portion of the Long Island inner shelf during December 1976, megaripple fields covered approximately 15% of the shelf surface. They tend to be erased during the succeeding summer months. Both megaripples (short-term response elements) and sand waves (long-term response elements) indicate that sand transport in the Middle Atlantic Bight is directed to the southeast, parallel with the regional trend of the isobaths.  相似文献   

Compositions and taxonomy of 15 unusual carbonaceous chondrites     

Won Hie CHOE  Heinz HUBER  Alan E. RUBIN  Gregory W. KALLEMEYN  John T. WASSON 《Meteoritics & planetary science》2010,45(4):531-554

Abstract– We used instrumental neutron activation analysis and petrography to determine bulk and phase compositions and textural characteristics of 15 carbonaceous chondrites of uncertain classification: Acfer 094 (type 3.0, ungrouped CM‐related); Belgica‐7904 (mildly metamorphosed, anomalous, CM‐like chondrite, possibly a member of a new grouplet that includes Wisconsin Range (WIS) 91600, Dhofar 225, and Yamato‐86720); Dar al Gani (DaG) 055 and its paired specimen DaG 056 (anomalous, reduced CV3‐like); DaG 978 (type 3 ungrouped); Dominion Range 03238 (anomalous, magnetite‐rich CO3.1); Elephant Moraine 90043 (anomalous, magnetite‐bearing CO3); Graves Nunataks 98025 (type 2 or type 3 ungrouped); Grosvenor Mountains (GRO) 95566 (anomalous CM2 with a low degree of aqueous alteration); Hammadah al Hamra (HaH) 073 (type 4 ungrouped, possibly related to the Coolidge‐Loongana [C‐L] 001 grouplet); Lewis Cliff (LEW) 85311 (anomalous CM2 with a low degree of aqueous alteration); Northwest Africa 1152 (anomalous CV3); Pecora Escarpment (PCA) 91008 (anomalous, metamorphosed CM); Queen Alexandra Range 99038 (type 2 ungrouped); Sahara 00182 (type 3 ungrouped, possibly related to HaH 073 and/or to C‐L 001); and WIS 91600 (mildly metamorphosed, anomalous, CM‐like chondrite, possibly a member of a new grouplet that includes Belgica‐7904, Dhofar 225, and Y‐86720). Many of these meteorites show fractionated abundance patterns, especially among the volatile elements. Impact volatilization and dehydration as well as elemental transport caused by terrestrial weathering are probably responsible for most of these compositional anomalies. The metamorphosed CM chondrites comprise two distinct clusters on the basis of their Δ¹⁷O values: approximately ?4‰ for PCA 91008, GRO 95566, DaG 978, and LEW 85311, and approximately 0‰ for Belgica‐7904 and WIS 91600. These six meteorites must have been derived from different asteroidal regions.  相似文献   

Auto-correlation analysis in search of short-term patterns in varve data from sediments of Lake Gościā, Poland     

RAYMOND YOUNG  ADAM WALANUS  TOMASZ GOSLAR 《Boreas: An International Journal of Quaternary Research》2000,29(3):251-260

The annually laminated, or varved, sediments of Lake Gościź, Poland, cover the last c. 12900 years, from Late Allerød up to the present. We have analysed the thickness of 1912 varves in this time-series by means of auto-correlation analysis, in the hope of obtaining information on patterns in past climate, for example patterns of 11 years, which might indicate a relation with solar activity. We analysed the total varve thickness and the thickness of the summer and the winter layer. Two single-bootstrap experiments confirmed the validity of the methods in general, but they indicated that the moving-window technique with overlapping windows hampered the assessment of statistical significance. Three global significance assessment procedures, taking into account the total number of auto-correlation coefficients (ACs) that is tested, showed significance of the ACs only at a lag of one year and only for the winter layer and the total varve. This auto-correlation with the preceding year may be explained by a factor internal to the lake, for instance some depositional mechanism. We found no indication of a relation between varve formation and the sun-spot cycle.  相似文献   

A 10Be production‐rate calibration for the Arctic     

NICOLÁs E. YOUNG  JOERG M. SCHAEFER  JASON P. BRINER  BRENT M. GOEHRING 《第四纪科学杂志》2013,28(5):515-526

  相似文献   

West Greenland and global in situ 14C production‐rate calibrations          下载免费PDF全文

NICOLÁS E. YOUNG  JOERG M. SCHAEFER  BRENT GOEHRING  NATHANIEL LIFTON  IRENE SCHIMMELPFENNIG  JASON P. BRINER 《第四纪科学杂志》2014,29(5):401-406

  相似文献   

Fossil Vertebrates from Kuangyuan, N. Szechuan, China     

C. C. YOUNG 《地质学报》1942,(Z2):304-322

正 During the late spring of 1941, Messrs. M. N. Bien, T. H. Mi and the present writer were fortunate enough to discover several localities of vertebrate fossils. The geological condition will be reported in another paper' and need not be repeated there. Most of the fossils were derived from the hill  相似文献