排序方式： 共有14条查询结果，搜索用时 15 毫秒
1.
The material loss factor for technically orthotropic plates was measured by half-power bandwidth method. Rectangular and trapezoidal corrugated plates of steel were considered. A simple isotropic steel plate was also considered for comparison of the results. The concept of single degree of freedom system was adopted. The tests were undertaken at very low frequency range (0–100) Hz. The plate models were suspended freely with two wires to minimize or prevent excessive extraneous energy dissipation. Out of plane point force, random in nature was applied to the top middle of the plates and the responses were measured from the middle point of the plates by FFT analyzer using miniature small mass accelerometer as sensor. The aim of these tests is to investigate the effects of bending rigidity and mode orders over material loss factor. The values of estimated modal damping loss factors are compared and tabulated for the plates models considered. Natural frequencies of some of the initial modes of the plates are also presented.It is observed that the higher the value of bending rigidity of the plates, the larger the values of loss factor of it. There was a significant increase in value of loss factor in corrugated plates to that of the isotropic plate. 相似文献
2.
3.
4.
Razarul Naim Roslan Mohamed Rozali Othman Xan Xue Yan Che Abd Rahim Mohamed 《Marine pollution bulletin》2010,60(9):1584-5700
A study was done to determine the concentrations of surfactants on the sea-surface microlayer and in atmospheric aerosols in several coastal areas around the Malaysian peninsula. The concentrations of surfactants from the sea-surface microlayer (collected using rotation drum) and from aerosols (collected using HVS) were analyzed as methylene blue active substances and disulphine blue active substances through the colorimetric method using a UV-vis spectrophotometer. The results of this study showed that the average concentrations of surfactants in the sea-surface microlayer ranged between undetected and 0.36 ± 0.34 μmol L−1 for MBAS and between 0.11 ± 0.02 and 0.21 ± 0.13 μmol L−1 for DBAS. The contribution of surfactants from the sea-surface microlayer to the composition of surfactants in atmospheric aerosols appears to be very minimal and more dominant in fine mode aerosols. 相似文献
5.
Noraini Mohd. Tamin Rozainah Zakaria Roslan Hashim Yu Yin 《Estuarine, Coastal and Shelf Science》2011,94(4):334-342
Avicennia marina saplings were established within a restoration area at Sg. Hj. Dorani, Malaysia between May and August 2010. Sapling establishment was achieved following the construction of segmented and hard breakwater as mitigating measure against coastal erosion. Geostructures known as brush faschines were installed within the restoration area as secondary sediment and seed traps. There was a steady increase in the sand content of the soil from 5% in November 2008 to 18% in May 2010. The dominant soil content was silt but it fluctuated and declined slightly over the same period, between 80% in November 2008 and 72% in May 2010. The accreting shoreline behind the breakwater had stabilised within 18 months. Subsequently, the first batch of A. marina wild seedlings or wildings was established on the mud surface in September 2009. Only about 10% of these wildings survived and showed high survival rate (90%) over the next eight months. Wildings that were naturally established near mother trees showed good growth performance. No wilding was established after the fruiting season in August 2010 as all seeds that were dispersed into the restoration area were washed away by September 2010. Tall, A. marina wild saplings (1 m) planted within the restoration area showed higher survival rate (80%) compared to planted saplings of Rhizophora apiculata (30%). Final planting of a thousand 1 m tall A. marina wild saplings was carried out from June 2010, in clumps of 20 and in 1 m × 1 m spacing. By the end of September 2010 clusters of regenerating A. marina mangroves about 1.5 m tall were successfully established on the accreting coastline. 相似文献
6.
Mapping of regional potential groundwater springs using Logistic Regression statistical method 总被引：1，自引：0，他引：1
Jalal?ZandiEmail author Pezhman?Taherei?Ghazvinei Roslan?Hashim Khamaruzaman?Bin?Wan?Yusof Junaidah?Ariffin Shervin?Motamedi 《Water Resources》2016,43(1):48-57
Increasing demand for fresh water extraction in the semi-arid regions necessitates the exploration of groundwater spring potential areas notwithstanding the importance of both conservation and management aspects for planning development. Potential map of groundwater springs reduces the costs of horizontal well drilling that provides useful tool for engineers to locate probable region for groundwater existence. The objective of this study is to establish a model of the potential map of groundwater spring occurrences. A statistical and probabilistic Logistic Regression (LR) model was developed in association with the specified spring location and effective occurrence factors. The most statistically significant effective factors on spring occurrences were selected to zone groundwater spring potential areas. The proposed model was evaluated statistically. Results showed a satisfactory prediction for the proposed model. The outcome of this study facilitates the low-cost utilization of groundwater resources when policy makers need strategic development planning. 相似文献
7.
Mohd Sofiyan Sulaiman Shanker Kumar Sinnakaudan Nik Nuraini Azhari Roslan Zainal Abidin 《Environmental Earth Sciences》2017,76(7):300
Mountain rivers and lowland rivers differ in many ways. Some of the many elements that distinguish both river systems apart are the rivers’ geomorphological appearances, hydraulic geometry, pollution transport, sediment transport, and its own roughness and coarseness. In this particular study, the element of sediment transport is given distinctive attention too. This study employs the deterministic approach for bed load prediction entailing the use of the parameterization concept where particle size and flow variation is taken into full consideration. Apart from that, the classical approach of Shields number is also used to determine the transport rates at the fluvial system. However, due to some limitation and range of applicability, the Shields number approach was re-modified to suit the range of applicability. Changes were made to the alleviating critical stress term and formulating exponential approach. For this research, it was important to deduce the underlying principles which are universal and common to all river systems, due to obvious and distinct differences between the mountain and lowland rivers. A special attribute was given to the Malaysian natural rivers because of the limited recorded data available. All datasets were compiled and tested with the bed load predictors to observe the commonality pattern between the lowland and mountain river systems. Most of the bed load transport equations limit the range of applicability by isolating the flow regime or bed roughness individually. Thus, it was vital for researchers to find the commonality pattern between these two river systems which needed to be statistically sound in its form. It was postulated that the particle densimetric Froude number is graphically and statistically fit for both river systems. Hence, this predictor is used as it has a high potential to be included in the sediment transport parameterization for Malaysian natural rivers. 相似文献
8.
9.
Adaptation of ANFIS model to assess thermal comfort of an urban square in moderate and dry climate 总被引：1，自引：0，他引：1
Shahab Kariminia Shervin Motamedi Shahaboddin Shamshirband Dalibor Petković Chandrabhushan Roy Roslan Hashim 《Stochastic Environmental Research and Risk Assessment (SERRA)》2016,30(4):1189-1203
Attractiveness of the open urban spaces, such as plazas or squares, depends on the visitor’s thermal comfort. In this respect, it is important to assess the environment of such open space along with the demographic factors of the visitors. This study used the soft-computing method of adaptive neuro fuzzy inference system (ANFIS) to investigate the thermal comfort of visitors at a public square in Iran during hot and cold weather conditions. The ANFIS process for variable selection was implemented in order to detect the predominant variables affecting the individual’s comfortable feeling. Model’s training and testing data were collected through the field measurement and survey during hot and cold times of the year. We used 18 input parameters, representative of demographic and environmental factors, to compute visitor’s thermal sensation, comfort feeling, and 4 common indices, namely the mean radiant temperature (Tmrt), mean physiological equivalent temperature (PET), standard effective temperature (SET) and predicted mean vote (PMV). The results indicated that among the examined factors, the air temperature (Ta) is the most influential parameter and best predictor of accuracy for the individual’s comfort feeling at the studied urban square. The results show that Ta can best predict the common indices of outdoor comfort, namely the PMV, PET, SET, thermal sensation, Tmrt, and comfortable felling compared to other parameters with the least error of 1.94, 18.87, 13.67, 0.91, 7.80, and 0.34 %, respectively. Some of the main advantages of the ANFIS scheme are that it is adaptable to the optimization and adaptive methods, and is computationally efficient. 相似文献