Geoacoustic and physical properties of carbonate sediments of the Lower Florida Keys   总被引：4，自引：0，他引：4  

M. D. Richardson  D. L. Lavoie  K. B. Briggs 《Geo-Marine Letters》1997,17(4):316-324

 Near-surface sediment geoacoustic and physical properties were measured from a variety of unconsolidated carbonate sediments in the Lower Florida Keys. Surficial values of compressional and shear speed correlate with sediment physical properties and near-surface acoustic reflectivity. Highest speeds (shear 125–150 m s^-1; compressional 1670–1725 m s^-1) are from sandy sediments near Rebecca Shoal and lowest speeds (shear 40–65 m s^-1; compressional 1520–1570 m s^-1) are found in soft, silty sediments which collect in sediment ponds in the Southeast Channel of the Dry Tortugas. High compressional wave attenuation is attributed to scattering of acoustic waves from heterogeneity caused by accumulation of abundant shell material and other impedance discontinuities rather than high intrinsic attenuation. Compared to siliciclastic sediments, carbonate sediment shear wave speed is high for comparable values of sediment physical properties. Sediment fabric, rather than changes due to the effects of biogeochemical processes, is responsible for these differences.  相似文献   

Characterization of interface roughness of rippled sand off Fort Walton Beach, Florida   总被引：1，自引：0，他引：1  

Briggs  K.B. Dajun Tang Williams  K.L. 《Oceanic Engineering, IEEE Journal of》2002,27(3):505-514

As part of the environmental characterization to model acoustic bottom scattering during the high-frequency sediment acoustics experiment (SAX99), fine-scale sediment roughness of a medium sand was successfully measured within a 600 /spl times/ 600-m area by two methods: stereo photography and a technique using a conductivity system. Areal coverage of the two methods, representing approximately 0.16 m/sup 2/ of the sea floor, was comparable, resulting in the depiction and quantification of half-meter wavelength sand ripples. Photogrammetric results were restricted to profiles digitized at 1-mm intervals; sediment conductivity results generated gridded micro-bathymetric measurements with 1- to 2-cm node spacing. Roughness power spectra give similar results in the low-spatial-frequency domains where the spectra estimated from both approaches overlap. However, spectra derived from higher resolution photogrammetric results appear to exhibit a multiple-power-law fit. Roughness measurements also indicate that spectrum changes as a function of time. Application of statistical confidence bounds on the power spectra indicates that roughness measurements separated by only 1-2 m may be spatially nonstationary.  相似文献   

Can turbidity caused by Corophium volutator (Pallas) activity be used to assess sediment toxicity rapidly?     

Briggs AD  Greenwood N  Grant A 《Marine environmental research》2003,55(3):181-192

The standard toxicity test organism, Corophium volutator, exhibits a behavioural response to contaminated sediments that causes increased turbidity of overlying water. We quantify the effects of this response to an estuarine sediment spiked with copper and hydrocarbon contaminated sediments from an oil installation in the North Sea. Turbidity measured 24 h after the start of a toxicity test shows a strong relationship with contaminant concentrations and with mortality after 10 days. Turbidity measurements can therefore give a rapid indication of sediment toxicity, permitting a reduction in storage time of sediments to be used in dilution series and toxicity identification evaluation (TIE) tests, reducing the likelihood of contaminants degrading prior to testing.  相似文献   

Integration of GPS and dead reckoning for real-time vehicle performance and emissions monitoring     

Washington Ochieng  J. Polak  R. Noland  J.-Y. Park  L. Zhao  D. Briggs  J. Gulliver  A. Crookell  R. Evans  M. Walker  W. Randolph 《GPS Solutions》2003,6(4):229-241

  相似文献   

A comparison of fibre‐optic distributed temperature sensing to traditional methods of evaluating groundwater inflow to streams     

Martin A. Briggs  Laura K. Lautz  Jeffrey M. McKenzie 《水文研究》2012,26(9):1277-1290

There are several methods for determining the spatial distribution and magnitude of groundwater inputs to streams. We compared the results of conventional methods [dye dilution gauging, acoustic Doppler velocimeter (ADV) differential gauging, and geochemical end‐member mixing] to distributed temperature sensing (DTS) using a fibre‐optic cable installed along 900 m of Ninemile Creek in Syracuse, New York, USA, during low‐flow conditions (discharge of 1·4 m³ s^?1). With the exception of differential gauging, all methods identified a focused, contaminated groundwater inflow and produced similar groundwater discharge estimates for that point, with a mean of 66·8 l s^?1 between all methods although the precision of these estimates varied. ADV discharge measurement accuracy was reduced by non‐ideal conditions and failed to identify, much less quantify, the modest groundwater input, which was only 5% of total stream flow. These results indicate ambient tracers, such as heat and geochemical mixing, can yield spatially and quantitatively refined estimates of relatively modest groundwater inflow even in large rivers. DTS heat tracing, in particular, provided the finest spatial characterization of groundwater inflow, and may be more universally applicable than geochemical methods, for which a distinct and consistent groundwater end member may be more difficult to identify. Copyright © 2011 John Wiley & Sons, Ltd.  相似文献   

Surface inhomogeneity effects on convective diffusion     

Gary A. Briggs 《Boundary-Layer Meteorology》1988,45(1-2):117-135

It is suggested that convective scaling, with appropriate extensions, provides the most useful framework for estimating the effects of urban-scale surface inhomogeneities on diffusion in convective conditions. Strong contrasts in surface heat flux exist between cropland, forests, urban areas, and water or marshland surfaces. It is argued that a typical fetch for convective turbulence to readjust to changed heat (or buoyancy) input from the surface below is 2(U/w ^*)h, where U is the mean wind speed in the mixing layer, w ^* is the convective scaling velocity, and h is the mixing depth. In contrast, the fetch required for wind speed to readjust to new underlying surface roughness is of the order (U/u ^*)²h/2, where u ^* is the friction velocity.The ratio w ^*/U is the best index of diffusion rates in moderately to very unstable conditions. General urban effects on heat flux, h, and U are discussed separately, then their combined effects on w ^*/U are estimated. While this ratio can double over a large city during light winds, its increase is much less for small cities, or during moderate winds. Finally, some examples of heat flux in- homogeneities causing stationary convective features are presented. Steady downdrafts associated with these features are of the order of 0.4w ^*, and could significantly increase surface concentrations from elevated sources.On assignment from the National Oceanic and Atmospheric Administration, U.S. Department of Commerce.This paper is based on a presentation made at the AMS Specialty Conference on Air Quality Modeling of the Urban Boundary Layer, in Baltimore, late 1983.  相似文献   

Similarity forms for ground-source surface-layer diffusion     

Gary A. Briggs 《Boundary-Layer Meteorology》1982,23(4):489-502

Past work on analyzing ground-source diffusion data in terms of surface-layer similarity theory is reviewed; these analyses assume that _z /L orh/L is a function of u ^* x/L (where h = Q/ dy). It is argued that an alternative scaling, h ^*/L versus x/L, is nearly as universal in that it is very weakly influenced by surface roughness, except for a modest influence in the free convective case (h ^* = Q/u ^* dy); the advantage of this scaling is that it eliminates the need to reassess as vertical diffusion progresses. The Prairie Grass data set is adjusted for the difference in source and sampling heights, and is plotted with this scaling. Simple analytic equations are suggested that fit the resultant data plots for stable and unstable conditions, and suggestions are made towards practical application of these results.On assignment from the National Oceanic and Atmospheric Administration, U.S. Department of Commerce.  相似文献   

Earth science,F. M. Brown and W. Bailey. Silver Burdett Co., Morristown,New Jersey, 1978. No. of pages: 530. Price: £10.25     

David J. Briggs 《地球表面变化过程与地形》1979,4(2):204-204

  相似文献   

Environmental influences on the yield of spring Barley in England and Wales     

David J. Briggs 《Geoforum》1981,12(1):99-106

Using data on crop yields and soil conditions derived from reports of the Soil Survey of England and Wales, and incorporating a variety of climatic and topographic data, relationships were identified between the yield of spring barley and edaphic and climatic conditions. Yields are highest on fine loamy and silty soils and on freely to imperfectly drained soils. Multiple regression analysis indicated that yields are related to sand contents, drainage conditions and available water capacity of the soil, potential summer soil moisture deficit and annual accumulated temperature.  相似文献   

Physical geography: Analytical and applied,J. J. Monk,and C. S. Alexander,Duxbury Press,North Scituate,Mass., 1977     

D. Briggs 《地球表面变化过程与地形》1978,3(4):425-425

  相似文献