排序方式： 共有5条查询结果，搜索用时 142 毫秒
1
1.
2.
Measurement of sediment resuspension rates in Long Island Sound 总被引：1，自引：0，他引：1
Resuspension rates have been measured on Long Island Sound sediments (New York/Connecticut, USA) under an oscillating grid,
using a flume, and in place, using high frequency acoustics, transmissometers, and sediment traps. Despite differences, the
results compare favorably. The methods all provide an order-of-magnitude estimate of the resuspension rate and increases under
storm conditions can be estimated. 相似文献
3.
Hurford G.J. Schmahl E.J. Schwartz R.A. Conway A.J. Aschwanden M.J. Csillaghy A. Dennis B.R. Johns-Krull C. Krucker S. Lin R.P. McTiernan J. Metcalf T.R. Sato J. Smith D.M. 《Solar physics》2002,210(1-2):61-86
The Reuven Ramaty High-Energy Solar Spectroscopic Imager (RHESSI) observes solar hard X-rays and gamma-rays from 3 keV to
17 MeV with spatial resolution as high as 2.3 arc sec. Instead of focusing optics, imaging is based on nine rotating modulation
collimators that time-modulate the incident flux as the spacecraft rotates. Starting from the arrival time of individual photons,
ground-based software then uses the modulated signals to reconstruct images of the source. The purpose of this paper is to
convey both an intuitive feel and the mathematical basis for this imaging process. Following a review of the relevant hardware,
the imaging principles and the basic back-projection method are described, along with their relation to Fourier transforms.
Several specific algorithms (Clean, MEM, Pixons and Forward-Fitting) applicable to RHESSI imaging are briefly described. The
characteristic strengths and weaknesses of this type of imaging are summarized. 相似文献
4.
Sequences of line-of-sight (LOS) magnetograms recorded by the Michelson Doppler Imager are used to quantitatively characterize photospheric magnetic structure and evolution in three active regions that rotated across the Sun??s disk during the Whole Heliosphere Interval (WHI), in an attempt to relate the photospheric magnetic properties of these active regions to flares and coronal mass ejections (CMEs). Several approaches are used in our analysis, on scales ranging from whole active regions, to magnetic features, to supergranular scales, and, finally, to individual pixels. We calculated several parameterizations of magnetic structure and evolution that have previously been associated with flare and CME activity, including total unsigned magnetic flux, magnetic flux near polarity-inversion lines, amount of canceled flux, the ??proxy Poynting flux,?? and helicity flux. To catalog flare events, we used flare lists derived from both GOES and RHESSI observations. By most such measures, AR 10988 should have been the most flare- and CME-productive active region, and AR 10989 the least. Observations, however, were not consistent with this expectation: ARs 10988 and 10989 produced similar numbers of flares, and AR 10989 also produced a few CMEs. These results highlight present limitations of statistics-based flare and CME forecasting tools that rely upon line-of-sight photospheric magnetic data alone. 相似文献
5.
The NOAA listings of solar flares in cycles 21?–?24, including the GOES soft X-ray magnitudes, enable a simple determination of the number of flares each flaring active region produces over its lifetime. We have studied this measure of flare productivity over the interval 1975?–?2012. The annual averages of flare productivity remained approximately constant during cycles 21 and 22, at about two reported M- or X-flares per region, but then increased significantly in the declining phase of cycle 23 (the years 2004?–?2005). We have confirmed this by using the independent RHESSI flare catalog to check the NOAA events listings where possible. We note that this measure of solar activity does not correlate with the solar cycle. The anomalous peak in flare productivity immediately preceded the long solar minimum between cycles 23 and 24. 相似文献
1