Radon concentrations in soil gas,considering radioactive equilibrium conditions with application to estimating fault-zone geometry   总被引：1，自引：0，他引：1  

Katsuaki Koike  Tohru Yoshinaga  Hisafumi Asaue 《Environmental Geology》2009,56(8):1533-1549

A calculation method for determining the amount of Rn isotopes and daughter products at the start of measurement (CRAS) is proposed as a more accurate means of estimating the initial Rn concentration in soil gas. The CRAS utilizes the decay law between ²²²Rn and ²²⁰Rn isotopes and the daughter products ²¹⁸Po and ²¹⁶Po, and is applicable to α-scintillation counter measurements. As Rn is both inert and chemically stable, it is useful for fault investigation based on the soil gas geochemistry. However, the total number of α particles emitted by the decay of Rn has generally been considered to be proportional to the initial Rn concentration, without considering the gas condition with respect to radioactive equilibrium. The CRAS method is shown to be effective to derive Rn concentration for soil gases under both nonequilibrium conditions, in which the total number of decays increases with time, and equilibrium conditions, which are typical of normal soil under low gas flux. The CRAS method in conjunction with finite difference method simulation is applied to the analysis of two active fault areas in Japan, and it is demonstrated that this combination could detect the sharp rises in ²²²Rn concentrations associated with faults. The method also allows the determination of fault geometry near the surface based on the asymmetry variation of the Rn concentration distribution when coupled with a numerical simulation of ²²²Rn transport. The results for the new method as applied to the two case studies are consistent with the data collected from the geological survey. It implies that the CRAS method is suitable for investigating the fault system and interstitial gas mobility through fractures. The present analyses have also demonstrated that high Rn concentrations require the recent and repeated accumulation of ²²²Rn parents (²³⁰Th and ²²⁶Ra) in fault gouges through deep gas release during fault movement.  相似文献   

Hydrogeologic-structure and groundwater-movement imaging in tideland using electrical sounding resistivity: a case study on the Ariake Sea coast, southwest Japan     

Toshiharu Misonou  Hisafumi Asaue  Tohru Yoshinaga  Yuta Matsukuma  Katsuaki Koike  Jun Shimada 《Hydrogeology Journal》2013,21(7):1593-1603

Groundwater flow exerts a crucial control on the boundary between the sea and freshwater and is thus a key factor for preserving groundwater resources and preventing seawater intrusion in coastal areas. Although it is highly probable that geological faults in coastal areas affect groundwater flow patterns, the effect has not been described yet in detail. This study is aimed at detecting and imaging groundwater flow and its temporal change around a fault in a coastal area through resistivity and chargeability distributions using electrical sounding. The Okoshiki area in central Kyushu, southwest Japan, was selected as a case study area, because of the presence of Kamiouda Fault. The measurements were conducted along six lines of both parallel and perpendicular orientations to the coastline. A feature suggesting a fault zone was evident on two lines. Through the temporal change of resistivity, movement and mixing processes of the seawater and freshwater during the ebb, low and flood tides were interpreted. A conceptual model of the processes was constructed in which a fault zone and the configuration of bedrock are dominant elements by acting as a selective path and a barrier to the groundwater flow, respectively.  相似文献   

Application of Magnetotelluric (MT) Resistivity to Imaging of Regional Three-Dimensional Geologic Structures and Groundwater Systems     

Hisafumi Asaue  Taiki Kubo  Toru Yoshinaga  Katsuaki Koike 《Natural Resources Research》2012,21(3):383-393

Widespread definition of a groundwater system in three dimensions is necessary for the management and maintenance of groundwater resources. A magnetotelluric (MT) survey can be an effective geophysical prospecting method for imaging regional geological structures by measuring both shallow and deep resistivity. To demonstrate the capability of an MT survey to characterize a groundwater system, the Kumamoto area of central Kyushu in southwestern Japan was selected as a case study site because of its rich groundwater resources. Three-dimensional (3D) MT resistivity structure to a depth of 5?km was modeled by 1D inversion analysis of raw MT data and 3D interpolation of the resultant resistivity column data by the optimization principle method. Consequently, both deep and shallow aquifers were detected. A high-resistivity zone appears at depths between 500 and 2,000?m between the Futagawa?CHinagu faults and the Usuki?CYatsushiro tectonic line, which supports the existence of an aquiclude under the aquifer. The most important characteristic inferred from the 3D resistivity model is that the deep groundwater system below a depth of 1,000?m has two main flow paths. One path is likely to be through porous rocks because the low resistivity zone is regarded as tuff with sand and gravel, and the other flow path is interpreted to be through fractured zones along the Hinagu faults. Hence, the path and direction of the groundwater flows are probably controlled by geologic structures and the configuration of the active faults. These findings support the effectiveness of the MT method for investigating groundwater systems.  相似文献   

Co-kriging for modeling shallow groundwater level changes in consideration of land use/land cover pattern     

Jean Aurelien Moukana  Hisafumi Asaue  Katsuaki Koike 《Environmental Earth Sciences》2013,70(4):1495-1506

This study aimed at clarifying the relationship between the dynamics of land use/land cover (LULC) changes and decline in the groundwater levels, and specifying an LULC category strongly affecting such decline in a Quaternary sedimentary basin. Groundwater level data recorded at 26 observation wells for a 14-year period in the Kumamoto Plain, central Kyushu, southwest Japan, were used for the analysis. The general trends of LULC were detected by a satellite image classification technique and surface spline method, which highlighted the decreases in groundwater-recharge materials. As the next step, those trends of groundwater levels that were closely correlated with rainfall were removed from the level data set, and the resultant residual component levels were applied to co-kriging analysis with LULC categories. Co-kriging provided a detailed map of groundwater level variability. Furthermore, we propose a method, prediction of residual of groundwater level (PWL), to infer future residual groundwater levels from the supposed LULC pattern by co-kriging-based modeling. PWL was demonstrated to be effective because it clearly represented the decrease and increase in negative residual level areas, depending on the extent of rice fields in the past and in predicted future distribution scenarios.  相似文献   

Magnetotelluric resistivity modeling for 3D characterization of geothermal reservoirs in the Western side of Mt. Aso, SW Japan   总被引：1，自引：1，他引：1  

Hisafumi Asaue  Katsuaki Koike  Toru Yoshinaga  Shinichi Takakura   《Journal of Applied Geophysics》2006,58(4):296

Geothermal reservoirs are usually located at a depth range of 2 to 5 km, so to efficiently utilize such resources an advanced prospecting method is needed to detect these deep geologic structures. This study aimed to three-dimensionally characterize geothermal reservoirs by a combination of Magnetotelluric (MT) survey, inversion analysis of apparent resistivity, and interpolation of the resistivity data obtained. The western side of Mt. Aso crater, southwest Japan, was chosen as the case study area. Three hot springs exist there and a fault is assumed to go in the direction connecting them. A MT survey was carried out at 26 sites and the data processed by a remote reference method to reduce artificial noises. Based on skewness and Mohr circle analyses of the impedance tensor, the local geologic structure at each site could be approximated as horizontally layered and therefore, a one-dimensional inversion analysis was applied to the MT raw data. The resultant resistivity column data were then interpolated by the three-dimensional optimization principle method. The resistivity distributions obtained clarified continuous conductors with especially low resistivity (less than 10 Ω·m) at the hot springs along the fault. Because the resistivity decreases largely with an abundance of clay minerals, the conductors could be considered to correspond with the cap rocks. Thus, two geothermal reservoirs, whose shapes were estimated to be pillar, were detected under the cap rocks in an elevation range of − 1000 to − 3000 m. By comparing the resistivity distributions with the temperature distributions based on fluid-flow calculations at a steady state using FEM, the validity of the location and dimension of the estimated reservoirs were confirmed.  相似文献