Secular acceleration of solar rotation from 1943 to 1986     

Hirokazu Yoshimura  Maspul Aini Kambry 《Solar physics》1993,143(2):205-214

The rotation of the surface layer of the Sun is found to have been accelerated secularly from the sunspot data of 1943 to 1986. To represent the overall state of rotation of the differentially rotating Sun, we define an indexM, by integrating the angular momentum density over the whole surface of the Sun, and call it the angular momentum layer density. The indexM increased monotonically or secularly from 1943 to 1986. This period corresponds to solar cycles 18, 19, 20, and 21. The monotonic increase ofM indicates that a net angular momentum must have steadily been coming from the layer down below the surface. The differential rotation latitudinal dependence profile did not change much from cycle 18 to cycle 20, but at cycle 21 the degree of equatorial acceleration dropped. This aspect is discussed in the context of the 55-year grand cycle. Cycle 21 is the start of grand cycle VI. The latitudinal dependence is less steep at cycle 21. The time scale of secular change of the indexM reflects the time scale of change of linkage of the surface and the deep layer in form of the angular momentum transfer, and that the time scale of the profile change of the differential rotation reflects the time scale of the angular momentum transfer within the surface layer.  相似文献   

Experimental study on loss factor for corrugated plates by bandwidth method     

Nirmal Kumar Mandal  Roslan Abd. Rahman  M. Salman Leong 《Ocean Engineering》2004,31(10):1313-1323

The material loss factor for technically orthotropic plates was measured by half-power bandwidth method. Rectangular and trapezoidal corrugated plates of steel were considered. A simple isotropic steel plate was also considered for comparison of the results. The concept of single degree of freedom system was adopted. The tests were undertaken at very low frequency range (0–100) Hz. The plate models were suspended freely with two wires to minimize or prevent excessive extraneous energy dissipation. Out of plane point force, random in nature was applied to the top middle of the plates and the responses were measured from the middle point of the plates by FFT analyzer using miniature small mass accelerometer as sensor. The aim of these tests is to investigate the effects of bending rigidity and mode orders over material loss factor. The values of estimated modal damping loss factors are compared and tabulated for the plates models considered. Natural frequencies of some of the initial modes of the plates are also presented.It is observed that the higher the value of bending rigidity of the plates, the larger the values of loss factor of it. There was a significant increase in value of loss factor in corrugated plates to that of the isotropic plate.  相似文献   

Effect of environmental factors on the flora of alluvial fans in southern Sinai     

Abd El-Raouf A. Moustafa  A. Zayed 《Journal of Arid Environments》1996,32(4):431-443

The purpose of this study was to elucidate the floristic and structural characteristics of simple alluvial fan vegetation of southern Sinai and to relate them to environmental variation. The main question addressed was: how does the floristic composition of fan habitats, species richness and life-form vary in relation to environmental change? Thirty-seven alluvial fans, randomly selected in two mainwadis(WadiFeiran andWadiDahab) were analysed quantitively. Two-way Indicator Species Analysis (TWINSPAN) classification and Canonical Correspondence Analysis (CCA) were applied in successive stages of the data analysis to describe vegetational variation in relation to physical gradients. Seven main clusters of fans were defined on the basis of environmental variation. These clusters are divided into three main groups of species richness. Species richness varied along a moisture gradient. The richest fans were the driest habitats, indicating that maximum species richness did not occur at high moisture availability. The moisture gradient is a complex gradient correlated with elevation, slope, climatic aridity, soil texture and the nature of the soil surface. Fine sand, silt plus clay and calcium carbonate showed significant differences between the internal groups and subgroups of the first and second level of the TWINSPAN classification.  相似文献   

Assessment of contaminants in Dubai coastal region, United Arab Emirates     

H. A. Al-Darwish  E. A. Abd El-Gawad  F. H. Mohammed  M. M. Lotfy 《Environmental Geology》2005,49(2):240-250

Coastal uses and other human activities have inevitably impinged on the Gulf environment; therefore, these regions require continuous monitoring. The investigated area covered the maximum fragments of Dubai coastal region in the Arabian Gulf. The determination of major oxides and trace metal concentrations in Dubai sediments revealed three heavily and moderately contaminated regions. One is in the far northeastern part at Al-Hamriya Sts 1–3 and contaminated by Fe, Cu, Pb, and Zn; the second is in the mid-northeastern part at Dry Docks and contaminated by Cu, Ni, Pb, and Zn; and finally, the third is in the near southwestern part at Dubal and contaminated by Fe, Mg, Cr, Ni, and Zn. Al-Hamriya St 3 represented the highest values of Cu, Pb, and Zn, whereas Dubal exhibited the maximum values of Fe, Mg, Ba, Cr, Mn, Ni, and V. The anthropogenic discharge and natural deposits are the main sources of contamination. In general, all trace and major elements showed the minimal levels at Jebel Ali Sanctuary (Sts 11, 12, 13) except for Sr and Ca, which showed their maximum values. The highest concentrations of Ca and Sr are mainly attributed to carbonate gravel sands and sands, which cover most stations. Each of V and Ni showed negative correlation with TPH, which may be indicated that the source of oil contamination in the region is not related to crude oil but mostly attributable to anthropogenic sources. The significant positive correlation, which was found between trace metals and TOC indicates that organic matter plays an important role in the accumulation of trace metals in case of Cu, Zn, and Pb.  相似文献   

Response of soil aggregate disintegration to the different content of organic carbon and its fractions during splash erosion     

Hairu Li  Gang Liu  Ju Gu  Hong Chen  Hongqiang Shi  Mohamed A. M. Abd Elbasit  Feinan Hu 《水文研究》2021,35(2):e14060

Aggregate disintegration is a critical process in soil splash erosion. However, the effect of soil organic carbon (SOC) and its fractions on soil aggregates disintegration is still not clear. In this study, five soils with similar clay contents and different contents of SOC have been used. The effects of slaking and mechanical striking on splash erosion were distinguished by using deionized water and 95% ethanol as raindrops. The simulated rainfall experiments were carried out in four heights (0.5, 1.0, 1.5 and 2.0 m). The result indicated that the soil aggregate stability increased with the increases of SOC and light fraction organic carbon (LFOC). The relative slaking and the mechanical striking index increased with the decreases of SOC and LFOC. The reduction of macroaggregates in eroded soil gradually decreased with the increase of SOC and LFOC, especially in alcohol test. The amount of macroaggregates (>0.25 mm) in deionized water tests were significantly less than that in alcohol tests under the same rainfall heights. The contribution of slaking to splash erosion increased with the decrease of heavy fractions organic carbon. The contribution of mechanical striking was dominant when the rainfall kinetic energy increased to a range of threshold between 9 J m⁻² mm⁻¹ and 12 m⁻² mm⁻¹. This study could provide the scientific basis for deeply understanding the mechanism of soil aggregates disintegration and splash erosion.  相似文献   

Study of horizontal drain effect on slope stability     

Muhammad Mukhlisin  Nurul Aini Binti Abd Aziz 《Journal of the Geological Society of India》2016,87(4):483-490

Slope failure usually occurs when soil particles are unable to build a strong bond with each other and become loose because of the presence of water. Water pressure weakens the ties between the particles and they tend to slip. Therefore, this study focused on the use of horizontal drains to reduce water entry and control the ground water level as a method of slope stabilization. Several previous studies have shown that the use of horizontal drains to lower the water level in soil is one of the fastest and cheapest slope stabilization methods. The main objective of this study is to analyze the effect of horizontal drains on slope stability. Information on slope condition during the landslides which happened at Precinct 9, Putrajaya, Malaysia was used for analytical simulation. Seep/W and Slope/W analyses were carried out with GeoStudio version 2007 software. Slopes with and without horizontal drains were then compared in terms of groundwater level and factor of safety (FOS) values. Scenarios were created for seven types of soil namely: residual, clay, silt, loam, sandy loam, sandy clay loam, and silt clay loam for a case wise analysis. The effect of daily steady rainfall and realcondition rainfall was studied. These cases were studied to find the effectiveness of horizontal drains as a slope stabilization tool. The results revealed that when a drain was installed on a slope, the groundwater level dropped immediately and the safety factor of the slope increased. Sandy loam (sL) soil was identified as the best candidate for a horizontal drain. Its highly saturated hydraulic conductivity Ks facilitated groundwater drain through the horizontal drain effectively. Silt clay loam (scL) soil was identified as the least effective candidate.  相似文献   

Prediction of ground vibration due to quarry blasting based on gene expression programming: a new model for peak particle velocity prediction   总被引：1，自引：1，他引：0  

R Shirani Faradonbeh  D Jahed Armaghani  M. Z. Abd Majid  M. MD Tahir  B. Ramesh Murlidhar  M. Monjezi  H. M. Wong 《International Journal of Environmental Science and Technology》2016,13(6):1453-1464

Blasting is a widely used technique for rock fragmentation in opencast mines and tunneling projects. Ground vibration is one of the most environmental effects produced by blasting operation. Therefore, the proper prediction of blast-induced ground vibrations is essential to identify safety area of blasting. This paper presents a predictive model based on gene expression programming (GEP) for estimating ground vibration produced by blasting operations conducted in a granite quarry, Malaysia. To achieve this aim, a total number of 102 blasting operations were investigated and relevant blasting parameters were measured. Furthermore, the most influential parameters on ground vibration, i.e., burden-to-spacing ratio, hole depth, stemming, powder factor, maximum charge per delay, and the distance from the blast face were considered and utilized to construct the GEP model. In order to show the capability of GEP model in estimating ground vibration, nonlinear multiple regression (NLMR) technique was also performed using the same datasets. The results demonstrated that the proposed model is able to predict blast-induced ground vibration more accurately than other developed technique. Coefficient of determination values of 0.914 and 0.874 for training and testing datasets of GEP model, respectively show superiority of this model in predicting ground vibration, while these values were obtained as 0.829 and 0.790 for NLMR model.  相似文献   

Petrogenesis of lamprophyre and associated diabase dykes in Wadi Mandar-Um Adawi area,South Sinai,Egypt     

Waheed I. Elwan  Shehta E. Abd Allah 《Arabian Journal of Geosciences》2018,11(9):223

The mafic dykes in Wadi Mandar-Wadi Um Adawi area are as follows: (1) calc-alkaline lamprophyre (i.e., kersantite and spessartite), (2) diabase, and (3) alkaline lamprophyre (i.e., camptonite). The field relations reveal that the emplacement of calc-alkaline lamprophyres preceded the diabase dykes, while alkaline lamprophyres emplaced later than the diabase dykes. Calc-alkaline are basaltic andesite, basaltic trachyandesite to basalt, while the diabase dykes and alkaline lamprophyres are basaltic in composition. These dykes are characterized by metaluminous character. Calc-alkaline lamprophyres and diabase dykes show transitional affinity from calc-alkaline to alkaline, while the alkaline lamprophyres exhibit more strong alkaline character. The mafic dykes were crystallized under temperature 1100–1150 °C and pressure 3–5 kbars in a high oxygen fugacity conditions. Fe-Ti oxides in the dykes are represented by ilmenite and Ti-magnetite. The chemistry of the sulfides hosted in those mafic dykes suggests a magmatic-hydrothermal origin for these minerals. The geochemical behavior of high field strength elements and large ion lithophile elements in these dykes excludes the derivation of diabase or alkaline lamprophyre either by partial melting or fractional crystallization from calc-alkaline lamprophyre. The parental magmatic sources of the studied dykes were generated from crustal material with addition of mantle-derived melt during the post-collisional stage. The mafic dykes in Wadi Mandar-Wadi Um Adawi area were generated from different magmatic sources by partial melting and subsequent fractional crystallization. In addition, the crustal contamination/assimilation process has a prominent role in the magmatic evolution of diabase and alkaline lamprophyre dykes.  相似文献   

Response of Mollusk Assemblages to Environmental Conditions: A Case Study from the Burullus Lagoon,Egypt     

Orabi H. Orabi  Abd El-Monsef A. El-Badry  Ikhlas Alhejoj 《Journal of the Geological Society of India》2018,91(5):583-588

The identified mollusks from the Burullus lagoon of Egypt (Eastern Mediterranean) are represented by four bivalve species and four gastropod species. Sources of heavy metals pollution in the Burullus lagoon include phosphate fertilizers, sewage and oil spills from fishing boats.The Cerastoderma glaucum species has a wide distribution in the central part of the studied area with satisfying criteria required for good bio-monitors of pollution. High concentrations of heavy metals are found in water, at the eastern side of the lagoon, while low concentrations were detected in the central and western sides of the lagoon. Pirenella conica constitutes the total gastropods assemblages, reflecting this species tolerance to the high concentration of heavy metals. Meanwhile, the total pelecypods in bottom lagoon sediments are completely absent in the eastern parts of the lagoon, which may be due to the sensitivity of pelecypods to the accumulation of heavy metals.  相似文献   

Geospatial analysis of land use driving force in coal mining area: case study in Ningdong,China     

El-Hamid  Hazem T. Abd  Caiyong  Wei  Yongting  Zhang 《GeoJournal》2021,86(2):605-620

GeoJournal - Geospatial techniques such as remote sensing and Geographic Information System are very important for studying the dynamic process of land use. To analyze the land use change and...  相似文献