By using small scale model tests, the interference effect on the vertical load-deformation behavior of a number of equally
spaced strip footings, placed on the surface of dry sand, was investigated. At any stage, all the footings were assumed to
(i) carry exactly equal magnitude of load, and (ii) settle to the same extent. No tilt of the footing was permitted. The effect
of clear spacing (s) among footings on the results was explored. A new experimental setup was proposed in which only one footing
needs to be employed rather than a number of footings. The bearing capacity increases continuously with decrease in spacing
among the footings. The interference effect becomes further prominent with increase in soil friction angle. In contrast to
an increase in the bearing capacity, with decrease in spacing of footings, an increase in the footing settlement associated
with the ultimate state of shear failure was observed. The present experimental observations were similar to those predicted
by the available theory, based on the method of characteristics. As compared to the theory, the present experimental data,
however, indicates much greater effect of interference especially for larger spacing among footings. 相似文献
The influence of cyclic loading on the strength and deformation behavior of cemented marine clay has been studied. This marine clay is of recent Pleistocene origin and deposited in a shallow water marine environment. Open pits were dug in sheeted enclosures and from these pits, undisturbed samples were taken for strength testing. A series of standard triaxial shear tests and stress controlled one-way cyclic load tests were conducted at consolidation stress ranges below and above the preconsolidation pressure. For the stress levels below the preconsolidation pressure, the cyclic loading has brought about the collapse of the cementation bond through an increase in strains, and at higher pressure ranges, the soil behaves like typical soft clay. This experiment studied the rate of development of strain and pore water pressure and shows that rate is a function of number of cycles, applied stress, and stress history. In addition, soil degradation during cyclic loading is studied in terms of Degradation Index. Attempt has been made to predict stain, pore water pressure, and degradation index through an empirical model. 相似文献
Low-frequency damping of a moored semisubmersible drilling platform was obtained from numerical extinction tests simulated in still water and in regular waves and from mean wave drift forces calculated at zero forward speed. The influence of drag forces was represented by the modified Morison equation. The platform as used for the 18th ITTC Comparative Mooring Study was analyzed in irregular beam waves. The computed time series of sway as well as the corresponding sway response spectrum compared favourably with model test measurements, demonstrating that this procedure to determine low-frequency damping can be effective. 相似文献
Profiles observed by Sea-Wing underwater gliders are widely applied in scientific research. However, the quality control(QC) of these data has received little attention. The mismatch between the temperature probe and conductivity cell response times generates erroneous salinities, especially across a strong thermocline. A sensor drift may occur owing to biofouling and biocide leakage into the conductivity cell when a glider has operated for several months. It is therefore critical to design a mature real-time QC procedure and develop a toolbox for the QC of Sea-Wing glider data. On the basis of temperature and salinity profiles observed by several Sea-Wing gliders each installed with a Sea-Bird Glider Payload CTD sensor, a real-time QC method including a thermal lag correction, Argo-equivalent real-time QC tests, and a simple post-processing procedure is proposed. The method can also be adopted for Petrel gliders. 相似文献
Structures in locations susceptible to severe seismic disturbances should be designed properly in order to resist lateral forces induced by earthquake motions. Steel offshore platforms are some of those structures which are built to withstand environmental and accidental loads during oil exploitation operation. Particular attention is being paid to earthquake loads in seismic active areas because it directly influences the capacity of the offshore installations.
In this paper, a small-scaled planar platform has been modelled analytically using nonlinear finite element program, based on an experimental test, conducted simultaneously in order to assess the local and global behavior of pile–leg interaction in Jacket Type Offshore Platforms (JTOPs). A combination of nonlinear beam column elements and fatigue affected elements are used to capture the inelastic cyclic behavior of planar frame as accurately as possible. Results of analytical tests are to be compared with experiments and it is concluded that an analytical approach can be best used for modelling JTOPs with reasonable accuracy regardless of the type and scale of the structure. Moreover, a special study on joints has been carried out and the best model has been selected to simulate brittle behavior of joints resulting from heat affected zone. 相似文献
A fairing method is presented for giving a good representation of ship model resistance test data, which in general tend to exhibit a scattered trend and need to be smoothed appropriately. One component of the test data originates from the frictional resistance and can be formulated smoothly. The second component is the wave resistance which exhibits a specific harmonic character with peaks and troughs. In this method, this component is modelled using suitable harmonic cosine terms for obtaining the best representation of the corresponding resistance data. The performance of the method is then tested on two example cases, using the characteristic parameters of the sample data as input during the smoothing process. 相似文献
In 1995, Suh and Park developed a numerical model that computes the reflection of regular waves from a fully perforated-wall caisson breakwater. This paper describes how to apply this model to a partially perforated-wall caisson and irregular waves. To examine the performance of the model, existing experimental data are used for regular waves, while a laboratory experiment is conducted in this study for irregular waves. The numerical model based on a linear wave theory tends to over-predict the reflection coefficient of regular waves as the wave nonlinearity increases, but such an over-prediction is not observed in the case of irregular waves. For both regular and irregular waves, the numerical model slightly over- and under-predicts the reflection coefficients at larger and smaller values, respectively, because the model neglects the evanescent waves near the breakwater. 相似文献