大开间小型混凝土砌块10层模型房屋抗震性能试验研究(Ⅰ)   总被引：8，自引：3，他引：8  

周抚生  郭迅  郑志华  毛国成 《地震工程与工程振动》2002,22(6):58-64

我国抗震设计规范（GB50011－2001）规定在6、7、8度区，混凝土小砌块结构分别可以建七、六、五层。由于混凝土小砌块结构的最大优势在于10－20层（与混凝土框架或框架剪力墙结构比）。本文按1／4比例制作了10层混凝土小砌块结构模型，按7度设防要求实施构造措施，通过振动台试验研究模型结构的抗震性能。结果表明，模型结构完全能够满足在7度区“小震不坏，大震不倒”的要求。圈梁、构造柱以及水平拉结筋构成的约束体系抗震作用是明显的。试验利用砌块的非注芯孔灌注铁砂来模拟墙体出平面动力效应。在本模型的构造措施下，平出面反应不对结构破坏起控制作用。  相似文献   

某中学教学楼的抗震鉴定与加固设计   总被引：1，自引：0，他引：1  

赵更歧  张冰华  张哲  王俊岭 《世界地震工程》2004,20(3):90-94

按老规范设计的砌体结构未考虑抗震，使用年代过长会出现承载力不足的问题，需对原结构按新规范进行全面检测和抗震鉴定，若鉴定结果表明该结构不符合抗震要求，则需进行加固，结合一实际工程对检测程序和加固方法做一全面论述，供工程实际中参考。  相似文献   

Pseudo‐dynamic seismic response of reinforced concrete frames infilled with non‐structural brick masonry     

F. Colangelo 《地震工程与结构动力学》2005,34(10):1219-1241

This paper presents pseudo‐dynamic test results on the in‐plane seismic behaviour of infilled frames. Thirteen single‐storey, single‐bay, half‐size‐scale, reinforced concrete‐frame specimens, most of which infilled with non‐structural masonry made of perforated bricks and cement mortar are tested. The infills are in contact with frames, without any connector; openings are not covered. The frames are different in their strength and details, reinforcement grade, and aspect ratio. Seismic input is the 1976 Tolmezzo (Friuli, Italy) ground acceleration, to which specimens are subjected two times: virgin and damaged by the previous test. The global seismic response of initially virgin infilled specimens considerably differs from that of bare specimens. This follows a dramatic change of properties: compared to a bare frame, the initial stiffness increases by one order of magnitude, and the peak strength more than doubles. The peak drift lessens; however, the displacement ductility demand does not. The energy demand is greater. Nevertheless, the influence of infill decreases as damage proceeds. Displacement time histories of damaged specimens are quite similar. At the local level, infill causes asymmetry and concentration of the frame deformation. Copyright © 2005 John Wiley & Sons, Ltd.  相似文献   

Nonlinear aspects of energy dissipation in wood-panel joints   总被引：1，自引：1，他引：0  

Sara Casciati 《地震工程与工程振动(英文版)》2007,6(3):259-268

The joints connecting vertical and horizontal elements are the "weak link" in structural systems assembled from wood panels. If they are too weak, local failures may occur, resulting in performance that is significantly below expectations. If they are too resistant, the joints may be unable to dissipate energy during vibrations, thus possibly initiating a fast progressive failure. This paper re-processes and re-elaborates the results of shaking table tests previously carried out by the author and other co-workers. The goal is to assess the feasibility of a joint which is able to dissipate energy during vibration, without degrading the connection performance.  相似文献   

新型灌浆材料在已建砌体结构抗震加固中的应用     

施养杭  余建星 《地震工程与工程振动》2005,25(2):88-92

具有悠久历史的石结构是砌体结构的重要组成部分，本文作者经广泛调研和试验分析：(1)提出以石粉为集料对石砌体进行抗震加固，寓环保与防灾于一体；(2)给出新型浆体配比和复合砂浆的强度等级，阐述加固技术和方法，建立灌浆石砌体抗震抗剪强度公式；(3)阐明抗震验算方法，提出基于模糊随机可靠理论的可靠性分析方法。  相似文献   

Pure aluminium shear panels as dissipative devices in moment‐resisting steel frames     

G. De Matteis  F. M. Mazzolani  S. Panico 《地震工程与结构动力学》2007,36(7):841-859

The use of energy dissipation systems for the seismic control of steel structures represents a valid alternative to conventional seismic design methods. The seismic devices currently employed are mostly based on the metallic yielding technology due to the large feasibility and efficiency they can provide. Within this context, in the current paper an innovative solution based on the adoption of low‐yield‐strength pure aluminium shear panels (SPs) for seismic protection of steel moment‐resisting frames is proposed and investigated. In order to prove the effectiveness of the system, a wide numerical study based on both static and dynamic non‐linear analyses has been carried out, considering a number of different frame‐to‐shear panel combinations, aiming at assessing the effect of the main influential parameters on the seismic response of the structure. The obtained results show that the contribution provided by aluminium SPs is rather significant, allowing a remarkable improvement of the seismic performance of the structure in terms of stiffness, strength and ductility, with the possibility to strongly limit the damage occurring in the members of moment‐resisting frames. In particular, it is clearly emphasized that the stiffening effect provided by SPs allows a more rational design procedure to be adopted, since the serviceability limit state check does not lead to unavoidable and uneconomical increase of the size of main structural members. Copyright © 2007 John Wiley & Sons, Ltd.  相似文献   

Towards error‐free hybrid simulation using mixed variables     

Tarek Elkhoraibi  Khalid M. Mosalam 《地震工程与结构动力学》2007,36(11):1497-1522

Two procedures are developed and implemented in a hybrid simulation system (HSS) with the aim of enhancing the accuracy and reliability of the online, i.e. pseudo‐dynamic, test results. The first procedure aims at correcting the experimental systematic error in executing the displacement command signal. The error is calculated as the difference between command and feedback signals and correlated to the actuator velocity using the least‐squares method. A feed‐forward error compensation scheme is devised leading to a more accurate execution of the test. The second procedure employs mixed variables with mode switching between displacement and force controls. The newly derived force control algorithm is evaluated using a parametric study to assess its stability and accuracy. The implementation of the mixed variables procedure is designed to adopt force control for high stiffness states of the structural response and displacement control otherwise, where the resolution of the involved instruments may favour this type of mixed control. A simple pseudo‐dynamic experiment of steel cantilever members is used to validate the HSS. Moreover, two experiments as application examples for the two developed procedures are presented. The two experiments focus on the seismic response of (a) timber shear walls and (b) reinforced concrete frames with and without unreinforced masonry infill wall. Copyright © 2007 John Wiley & Sons, Ltd.  相似文献   

Modelling methods of historic masonry buildings under seismic excitation     

M. Mistler  C. Butenweg  K. Meskouris 《Journal of Seismology》2006,10(4):497-510

Historic masonry buildings in seismically active regions are severely damaged by earthquakes, since they certainly have not been explicitly designed by the original builders to withstand seismic effects, at least not in a ‘scientific’ way from today’s point of view. The assessment of their seismic safety is an important first step in planning the appropriate interventions for improving their pertinent resistance. This paper presents a procedure for assessing the seismic safety of historic masonry buildings based on measurements of their natural frequencies and numerical simulations. The modelling of the brittle nonlinear behaviour of masonry is carried out on the macro-level. As an example, a recently completed investigation of the seismic behaviour of the Aachen Cathedral is given, this being the first German cultural monument to be included in the UNESCO cultural heritage list in 1978. Its construction goes back to the 9th century a.d. and it is considered as one of the finest examples of religious architecture in Central Europe. The investigation is based on measurements of the natural frequencies at different positions and numerical simulations using a detailed finite element model of the Cathedral.  相似文献   

Elasto‐plastic analysis of block structures through a homogenization method     

G. de Felice  A. Amorosi  M. Malena 《国际地质力学数值与分析法杂志》2010,34(3):221-247

The paper describes the development and numerical implementation of a constitutive relationship for modeling the elasto‐plastic behavior of block structures with periodic texture, regarded at a macroscopic scale as homogenized anisotropic media. The macroscopic model is shown to retain memory of the mechanical characteristics of the joints and of the shape of the blocks. The overall mechanical properties display anisotropy and singularities in the yield surface, arising from the discrete nature of the block structure and the geometrical arrangement of the units. The model is formulated in the framework of multi‐surface plasticity. It is implemented in an finite element (FE) code by means of two different algorithms: an implicit return mapping scheme and a minimization algorithm directly derived from the Haar–Karman principle. The model is validated against analytical and experimental results: the comparison between the homogenized continuum and the original block assembly shows a good agreement in terms of ultimate inelastic behavior, when the size of the block is small as compared with that of the whole assembly. Copyright © 2009 John Wiley & Sons, Ltd.  相似文献   

The sediment infill of subglacial meltwater channels on the West Antarctic continental shelf     

James A. Smith  Claus-Dieter Hillenbrand  Alastair G.C. Graham 《Quaternary Research》2009,71(2):190-200

Subglacial meltwater plays a significant yet poorly understood role in the dynamics of the Antarctic ice sheets. Here we present new swath bathymetry from the western Amundsen Sea Embayment, West Antarctica, showing meltwater channels eroded into acoustic basement. Their morphological characteristics and size are consistent with incision by subglacial meltwater. To understand how and when these channels formed we have investigated the infill of three channels. Diamictons deposited beneath or proximal to an expanded grounded West Antarctic Ice Sheet are present in two of the channels and these are overlain by glaciomarine sediments deposited after deglaciation. The sediment core from the third channel recovered a turbidite sequence also deposited after the last deglaciation. The presence of deformation till at one core site and the absence of typical meltwater deposits (e.g., sorted sands and gravels) in all three cores suggest that channel incision pre-dates overriding by fast flowing grounded ice during the last glacial period. Given the overall scale of the channels and their incision into bedrock, it is likely that the channels formed over multiple glaciations, possibly since the Miocene, and have been reoccupied on several occasions. This also implies that the channels have survived numerous advances and retreats of grounded ice.  相似文献