Approach to Mountain Hazards in Tibet, China   总被引：1，自引：1，他引：0  

MADongtao TUJianjun CUIPeng LURuren 《山地科学学报》2004,1(2):143-154

Tibet is located at the southwest boundary of China. It is the main body of the Qinghai-Tibet Plateau, the highest and the youngest plateau in the world. Owing to complicated geology, Neo-tectonic movements, geomorphology, climate and plateau environment, various mountain hazards, such as debris flow, flash flood, landslide, collapse, snow avalanche and snow drifts, are widely distributed along the Jinsha River (the upper reaches of the Yangtze River), the Nu River and the Lancang River in the east, and the Yarlungzangbo River, the Pumqu River and the Poiqu River in the south and southeast of Tibet. The distribution area of mountain hazards in Tibet is about 589,000 km^2, 49.3% of its total territory. In comparison to other mountain regions in China, mountain hazards in Tibet break out unexpectedly with tremendously large scale and endanger the traffic lines, cities and towns, farmland, grassland, mountain environment, and make more dangers to the neighboring countries, such as Nepal, India, Myanmar and Bhutan. To mitigate mountain hazards, some suggestions are proposed in this paper, such as strengthening scientific research, enhancing joint studies, hazards mitigation planning, hazards warning and forecasting, controlling the most disastrous hazards and forbidding unreasonable human exploring activities in mountain areas.  相似文献   

利用自回归模型检测地球极移重力效应     

杨学峰  孙和平  徐建桥 《大地测量与地球动力学》2004,24(2):110-114

同时采用4个台站的国际超导重力仪长期连续重力观测资料和国际地球自转服务中心提供的同步地球自转参数，研究了极移引起的地球重力场变化特征。利用自回归模型估计了各序列的功率谱密度和积谱密度，结果表明极移导致的重力效应的主要能量集中在Chandler摆动和周年项附近，叠积后实际重力观测与极移重力信号理论值之间的差异分别为0．4％和3．9％，说明超导重力仪可有效监测极移导致的重力变化。  相似文献   

Near-Infrared Imaging Spectrophotometry Of Comet C/1995 O1 (Hale-Bopp) Near Perihelion     

Harker  David E.  Woodward  Charles E.  McMURTRY  Craig W.  Goetz  J. A.  Pipher  J. L.  Forrest  W. J. 《Earth, Moon, and Planets》1997,78(1-3):259-264

We present 1- to 5-μm broadband and CVF images of comet Hale-Bopp taken 1997 February 10.5 UT, 50 days before perihelion. All the images exhibit a nonspherical coma with a bright “ridge” in the direction of the dust tail approximately 10″ from the coma. Synthetic aperture spectrophotometry implies that the optically important grains are of a radius ≤0.4 μm; smallest radius for any comet seen to date. The variation of the integrated surface brightness with radial distance from the coma (ρ) in all the images closely follows the “steady state” ρ⁻¹ model for comet dust ablation (Gehrz and Ney, 1992). The near-infrared colors taken along the dust tail are not constant implying the dust grain properties vary with coma distance. This revised version was published online in July 2006 with corrections to the Cover Date.  相似文献   

S－闭空间上的函数     

Chang Anding 《地球科学与环境学报》1997,(3)

研究了当Ｘ为Ｓ－闭空间时，Ｃ（Ｘ）的子集Ｆ为紧的充要条件，从而扩充了著名的Ａｓｃｏｌｉ定理。  相似文献   

Elastic solutions for stresses in a transversely isotropic half‐space subjected to three‐dimensional buried parabolic rectangular loads     

Cheng‐Der Wang  Jyh‐Jong Liao 《国际地质力学数值与分析法杂志》2002,26(14):1449-1476

In many areas of engineering practice, applied loads are not uniformly distributed but often concentrated towards the centre of a foundation. Thus, loads are more realistically depicted as distributed as linearly varying or as parabola of revolution. Solutions for stresses in a transversely isotropic half‐space caused by concave and convex parabolic loads that act on a rectangle have not been derived. This work proposes analytical solutions for stresses in a transversely isotropic half‐space, induced by three‐dimensional, buried, linearly varying/uniform/parabolic rectangular loads. Load types include an upwardly and a downwardly linearly varying load, a uniform load, a concave and a convex parabolic load, all distributed over a rectangular area. These solutions are obtained by integrating the point load solutions in a Cartesian co‐ordinate system for a transversely isotropic half‐space. The buried depth, the dimensions of the loaded area, the type and degree of material anisotropy and the loading type for transversely isotropic half‐spaces influence the proposed solutions. An illustrative example is presented to elucidate the effect of the dimensions of the loaded area, the type and degree of rock anisotropy, and the type of loading on the vertical stress in the isotropic/transversely isotropic rocks subjected to a linearly varying/uniform/parabolic rectangular load. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Influence of soft clays on the response spectra for structures in eastern Canada     

Ren  Tinawi  Marc Sarrazin  Andr  Filiatrault 《Soil Dynamics and Earthquake Engineering》1993,12(8):469-477

The 1990 edition of the National Building Code of Canada (Associate Committee of the National Building Code, National Research Council, Ottawa, 1990) makes a clear distinction between eastern and western Canada in terms of seismic acceleration and velocity zones. While it is well established that ground motions can be amplified significantly through loose clay deposits, no results are available that take into consideration the typical high frequency content of ground motions in eastern Canada. This paper develops ground amplification curves for clays having depths between 10 and 70 m excited by typical eastern Canadian ground motions scaled to two different values of peak horizontal accelerations. Simplified free-field spectral design curves, which could be used by structural designers, are proposed. The curves show that maximum spectral accelerations occur for structural periods between 0.2 and 0.5 s. In addition, soil depth does not appear to be an important parameter controlling the response of typical clay deposits in eastern Canada.  相似文献   

Spectrophotometric Variability of Mira     

A. A. Arkharov  E. I. Hagen-Torn  T. U. Puzakova  E. V. Ruban 《Astrophysics》2005,48(2):143-155

Data from the Pulkovo spectrophotometric data base on the absolute quasimonochromatic fluxes from oCet in the 320–1080 nm range are used to determine the physical parameters of this star in different phases of its light curve. The continuum emission layer is found to expand between the phases of the cycle corresponding to the rising and falling branches of the light curve. The average expansion velocity is 32 km/s. By the time the star’s brightness has fallen by roughly three magnitudes, its radius has increased by almost a factor of three. Over this same time the temperature of the layer has fallen from 3000 K to 2200 K. For this expansion velocity, the calculated mass rate loss is ⊙ M /year.__________Translated from Astrofizika, Vol. 48, No. 2, pp. 175–189 (May 2005).  相似文献   

Predicting ground-motion variations at the Turkey-flat test site,California     

J. Zahradník  J. Jech  V. Barták 《Pure and Applied Geophysics》1991,137(1-2):63-84

Results of a single group participating in an international experiment are analyzed. The experiment served to verify computational predictions of the ground-motion variations due to near-surface geological effects at a site established for that purpose by the California Department of Conservation. Based on an acceleration record at a rock location, and geotechnical model of medium, records at the other locations of a nearby sedimentary deposit were predicted. A 2-D finite-difference sensitivity analysis suggested that the lateral wave-propagation effects are negligibly small, and locally 1-D computations are sufficient for the present site. Those computations are compared with observations not available to the authors during the blind prediction. Peak accelerations, peak velocities and RMS accelerations were predicted with errors less than 159%, 114% and 62%, respectively. Maxima of the response spectra were fitted within a factor of 2. The predicted and observed Husid's plots (i.e., the normalized cumulative plots of the acceleration squared) have the correlation coefficients 0.98. The detected misfits do not show any simple relation to the instrument location, component, frequency, or time.  相似文献   

On the practice of estimating fractal dimension   总被引：11，自引：0，他引：11  

James R. Carr  William B. Benzer 《Mathematical Geology》1991,23(7):945-958

Coastlines epitomize deterministic fractals and fractal (Hausdorff-Besicovitch) dimensions; a divider [compass] method can be used to calculate fractal dimensions for these features. Noise models are used to develop another notion of fractals, a stochastic one. Spectral and variogram methods are used to estimate fractal dimensions for stochastic fractals. When estimating fractal dimension, the objective of the analysis must be consistent with the method chosen for fractal dimension calculation. Spectal and variogram methods yield fractal dimensions which indicate the similarity of the feature under study to noise (e.g., Brownian noise). A divider measurement method yields a fractal dimension which is a measure of complexity of shape.  相似文献   

A seismic source zone model for the seismic hazard assessment of the Italian territory   总被引：3，自引：0，他引：3  

Carlo Meletti  Fabrizio Galadini  Gianluca Valensise  Massimiliano Stucchi  Roberto Basili  Salvatore Barba  Gianfranco Vannucci  Enzo Boschi 《Tectonophysics》2008,450(1-4):85-108

We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map.

We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning.

The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4.

ZS9 is made out of 36 zones where earthquakes with M_w > = 5 are expected. It also assumes that earthquakes with M_w up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates.

Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates.  相似文献