This article presents a micromechanical approach to the problem of unsaturated water flow in heterogeneous porous media in
transient conditions. The numerical formulation is based on the two-scale model obtained previously by periodic homogenization.
It allows for a coupled solution of the non-linear flow equations at macroscopic and microscopic scales and takes into account
the macroscopic anisotropy of the medium and the local non-equilibrium of the capillary pressure. The model was applied to
simulate two-dimensional water infiltration at constant flux into an initially dry medium containing inclusions of square
and rectangular shapes. The numerical results showed the influence of the inclusion–matrix conductivity ratio and the local
geometry on the macroscopic behavior. The influence of the conductivity ratio manifested itself by the acceleration or retardation
of the onset of the macroscopic water flux at the outlet, while the local geometry (anisotropy) significantly affected the
macroscopic spatial distribution of the water flux. Such type of approach can be extended to simulate coupled phenomena (for
example hydro-mechanical problems) with evolving local geometry. 相似文献
A local-scale model for temperature-dependence of water-retention curves may be applicable to large scales. Consideration of this temperature dependence is important for modeling unsaturated flow and transport in the subsurface in numerous cases. Although significant progress has been made in understanding and modeling this temperature effect, almost all the previous studies have been limited to small scales (on the order of several centimeters). Numerical experiments were used to investigate the possibility of extending a local-scale model for the temperature-dependence of water retention curves to large scales (on the order of meters). Temperature effects on large-scale hydraulic properties are of interest in many practical applications. Numerical experiment results indicate that the local-scale model can indeed be applicable to large-scale problems for special porous media with high air entry values. A typical porous medium of this kind is the porous tuff matrix in the unsaturated zone of Yucca Mountain, Nevada, the proposed geologic disposal site for national high-level nuclear wastes. Whether this finding can approximately hold for general cases needs to be investigated in future studies. 相似文献
The formation of colloids during the weathering of phyllite was investigated by exposing ground phyllite to Milli-Q water. Secondary mineral colloids of 101–102 nm were detected in significant concentrations. At pH of about 8.5, the solution concentration of these colloids reached up to 10 mg/L (however, acidification to pH 4.0 prevented the formation of the colloids). The mineralogical composition of the secondary mineral colloids is assumed to be a mixture of ferrihydrite, manganese oxyhydroxides, aluminosilicates, amorphous Al(OH)3 and gibbsite with possible additions of iron silicates and␣iron-alumino silicates. The colloids were stable over longer periods of time (at least several weeks), even in the presence of suspended ground rock. Direct formation of iron-containing secondary mineral colloids at the rock–water interface by the weathering of rock material is an alternative to the well-known mechanism of iron colloid formation in the bulk of water bodies by mixing of different waters or by aeration of anoxic waters. This direct mechanism is of relevance for colloid production during the weathering of freshly crushed rock in the unsaturated zone as for instance crushed rock in mine waste rock piles. Colloids produced by this mechanism, too, can influence the transport of contaminants such as actinides because these colloids have a large specific surface area and a high sorption affinity. 相似文献
Contaminant migration behaviour in the unsaturated zone of a fractured porous aquifer is discussed in the context of a study site in Cheshire, UK. The site is situated on gently dipping sandstones, adjacent to a linear lagoon historically used to dispose of industrial wastes containing chlorinated solvents. Two cores of more than 100 m length were recovered and measurements of chlorinated hydrocarbons (CHCs), inorganic chemistry, lithology, fracturing and aquifer properties were made. The results show that selecting an appropriate vertical sampling density is crucial both to providing an understanding of contaminant pathways and distinguishing whether CHCs are present in the aqueous or non-aqueous phase. The spacing of such sampling should be on a similar scale to the heterogeneity that controls water and contaminant movement. For some sections of the Permo-Triassic aquifer, significant changes in lithology and permeability occur over vertical distances of less than 1 m and samples need to be collected at this interval, otherwise considerable resolution is lost, potentially leading to erroneous interpretation of data. At this site, although CHC concentrations were high, the consistent ratio of the two main components of the plume (tetrachloroethene and trichloroethene) provided evidence of movement in the aqueous phase rather than in dense non-aqueous phase liquid (DNAPL). 相似文献
The sources of and pathways for groundwater recharge in urban areas are more numerous and complex than in rural environments.
Buildings, roads, and other surface infrastructure combine with man-made drainage networks to change the pathways for precipitation.
Some direct recharge is lost, but additional recharge can occur from storm drainage systems. Large amounts of water are imported
into most cities for supply, distributed through underground pipes, and collected again in sewers or septic tanks. The leaks
from these pipe networks often provide substantial recharge. Sources of recharge in urban areas are identified through piezometry,
chemical signatures, and water balances. All three approaches have problems. Recharge is quantified either by individual components
(direct recharge, water-mains leakage, septic tanks, etc.) or holistically. Working with individual components requires large
amounts of data, much of which is uncertain and is likely to lead to large uncertainties in the final result. Recommended
holistic approaches include the use of groundwater modelling and solute balances, where various types of data are integrated.
Urban recharge remains an under-researched topic, with few high-quality case studies reported in the literature.
Electronic Publication 相似文献
After the initiation of gravity drainage, water is often assumed to be either (a) draining under unit gradient, or (b) at capillary/gravity equilibrium. Both of these simplifications can be useful, but the regimes of validity of each assumption must be delineated. Water pressures are measured versus time and distance as water drains out of a 1.6 m long sand column to determine the relative effects of capillary and gravitational forces during drainage. For medium sized sands (0.15–0.3 mm in diameter), the capillary pressure is constant in space in a large region of the column for over 12 days, and the water continues to flow under unit gradient for relatively long time scales. Similar results are seen for finer sands, but with a much faster approach to equilibrium. Numerical simulations and analytical estimates are presented and compare favorably to the measurements. Together, the experimental, theoretical and analytical results are used to calculate when capillary/gravity equilibrium is reached as a function of porous media properties and length of the unsaturated zone. The ratio of the length of the unsaturated zone to the bubbling pressure is a key parameter in determining the drainage regime, and that even for relatively short unsaturated zones the equilibrium time scale can be on the order of years. 相似文献
We present results of laboratory experiments to study the behavior of liquids moving in unsaturated wide-aperture fractures. A 5-mm-thick glass plate cut with a 1.7-mm aperture was used as a fractured rock analog to study behavior of film and capillary droplet flow modes. Flow rates ranged between 0.6 and 6.0 ml/min. Variability in the ambient barometric pressure, resulting from weather conditions, seemed to play a role in the natural selection of flow mode. For droplet mode, constant input conditions resulted in highly variable transport properties within the fracture. The advancing meniscus exhibited a dynamic contact angle that was a function of the droplet speed and much larger than the static contact angle. Flow rate was reduced due to the larger contact angle. Analytical expressions for droplet velocity and flow capacity are presented as a function of the dynamic rather than the static contact angle. 相似文献
Accidental spills of hydrocarbons, such as Light Non-Aqueous Phase Liquids (LNAPLs), are one of the most common sources of subsurface contamination. Migration of LNAPL in a porous medium is influenced by various factors such as the number of fluids present in the unsaturated/saturated zones and the proportion of pores occupied by each fluid. The results for relationship between matric suction and degree of saturation are presented in this paper for water–air, water–LNAPL and LNAPL–air systems in a sand. A simple and reliable setup using Buchner funnel was designed to obtain these relations. It was found that the relationship between matric suction head and degree of saturation is hysteretic for all the fluid systems (water–air, water–LNAPL and LNAPL–air). Furthermore, the amount of hysteresis depended upon the fluid system, with the maximum hysteresis occurring for water–air system. The results suggest that the amount of trapped air depends upon the reversal degree of saturation from drying to wetting. 相似文献
The understanding of the thermo-hydro-mechanical behaviour of a clay barrier is needed for the prediction of its final in situ properties after the hydration and thermal transient in a radioactive waste repository.
As part of the CEC 1990–1994 R&D programme on radioactive waste management and storage, the CEA (Fr), CIEMAT (Sp), ENRESA (Sp), SCK · CEN (B), UPC (Sp) and UWCC (UK) have carried out a joint project on unsaturated clay behaviour (Volckaert et al., 1996). The aim of the study is to analyse and model the behaviour of a clay-based engineered barrier during its hydration phase under real repository conditions. The hydro-mechanical and thermo-hydraulic models developed in this project have been coupled to describe stress/strain behaviour, moisture migration and heat transfer. A thermo-hydraulic model has also been coupled to a geochemical code to describe the migration and formation of chemical species.
In this project, suction-controlled experiments have been performed on Boom clay (B), FoCa clay (Fr) and Almeria bentonite (Sp). The aim of these experiments is to test the validity of the interpretive model developed by Alonso and Gens (Alonso et al., 1990), and to build a database of unsaturated clay thermo-hydro-mechanical parameters. Such a database can then be used for validation exercises in which in situ experiments are simulated.
The Boom clay is a moderately swelling clay of Rupellian age. It is studied at the SCK · CEN in Belgium as a potential host rock for a radioactive waste repository. In this paper, suction-controlled experiments carried out on Boom clay by SCK · CEN are described. SCK · CEN has performed experiments to measure the relation between suction, water content and temperature and the relation between suction, stress and deformation. The applied suction-control techniques and experimental setups are detailed. The results of these experiments are discussed in the perspective of the model of Alonso and Gens. The influence of temperature on water uptake was rather small. The measured swelling-collapse behaviour can be explained by the Alonso and Gens model. 相似文献