Determining Hydraulic Conductivity Using Pumping Data from Low-Flow Sampling |
| |
| Authors: | by Gary A Robbins Alejandra T Aragon-Jose and Andres Romero |
| |
| Institution: | Department of Natural Resources Management and Engineering, University of Connecticut, 1376 Storrs Road, Storrs, CT 06269-4087. |
| |
| Abstract: | Hydraulic conductivity values computed using the steady-state discharge and drawdown attained while low-flow sampling were evaluated to determine if they were equivalent to those determined from slug testing. Based on testing 12 wells, it was found that the results were statistically equivalent. Conductivity values computed using low-flow sampling parameters were also evaluated as to their reproducibility in actual practice by analyzing consultant data for three wells sampled over three quarterly monitoring periods by four field technicians. The results were found to be reproducible within about a factor of 2 or better. Since the method is based on only one pair of parameters, diligence is required in attaining steady state and in accurately measuring the flow rate and drawdown. Conductivity values computed using this approach can enhance the use of low-flow data gathered in water quality sampling, avoid the need for slug testing in a subsequent phase of investigation, and help reduce the cost of characterizing sites when multilevel samplers are used. Given the practical range of discharge in low-flow sampling, the method was found to be applicable at conductivity values somewhat greater than 10?6 cm/s. Given the typical accuracy of water level meters and pressure transducers and a maximum discharge of 1 L/min, as mandated by regulatory guidance, the method has a calculated upper conductivity limit in the range of 10?3 to 10?2 cm/s. |
| |
| Keywords: | |
|
|
