| 质心误差对分布式InSAR基线确定的影响及消除 |
| |
| 引用本文： | 鞠冰,昌虓,谷德峰,段晓君,朱炬波,王正明.质心误差对分布式InSAR基线确定的影响及消除[J].遥感学报,2017,21(4):558-565. |
| |
| 作者姓名： | 鞠冰 昌虓 谷德峰 段晓君 朱炬波 王正明 |
| |
| 作者单位： | 国防科学技术大学 理学院, 长沙 410073,国防科学技术大学 理学院, 长沙 410073,国防科学技术大学 理学院, 长沙 410073,国防科学技术大学 理学院, 长沙 410073,国防科学技术大学 理学院, 长沙 410073,国防科学技术大学 理学院, 长沙 410073 |
| |
| 基金项目： | 国家自然科学基金（编号：91438202，61573367，61370013） |
| |
| 摘 要： | 高精度星间基线确定是分布式InSAR干涉测量中的关键技术。针对卫星在轨运行期间的质心与地面标校结果不一致问题,仿真分析了星体系x、y、z不同方向1 cm质心误差对InSAR星间基线确定的影响。结果表明:x、y方向的质心误差对基线解算影响很小;z方向的质心误差对基线解算影响显著,使得InSAR基线产品中含有明显的系统误差。提出了两种消除卫星质心误差影响的方法:一是在星载GNSS定轨过程中增加轨道径向的经验加速度予以补偿;二是增加星体系z方向的质心偏差估计。实验结果表明,经两种方法处理后得到的InSAR基线3维误差由8.8 mm分别降至0.13 mm和0.09 mm,98%以上的卫星质心误差影响被消除。
|
| 关 键 词： | 卫星质心误差 分布式InSAR 星间基线确定 星载GNSS 经验加速度 |
| 收稿时间： | 2016/9/9 0:00:00 |
Analysis and mitigation of the Center-of-Mass errors for InSAR baseline determination |
| |
| JU Bing,CHANG Xiao,GU Defeng,DUAN Xiaojun,ZHU Jubo and WANG Zhengming.Analysis and mitigation of the Center-of-Mass errors for InSAR baseline determination[J].Journal of Remote Sensing,2017,21(4):558-565. |
| |
| Authors: | JU Bing CHANG Xiao GU Defeng DUAN Xiaojun ZHU Jubo and WANG Zhengming |
| |
| Institution: | College of Science, National University of Defense Technology, Changsha 410073, China,College of Science, National University of Defense Technology, Changsha 410073, China,College of Science, National University of Defense Technology, Changsha 410073, China,College of Science, National University of Defense Technology, Changsha 410073, China,College of Science, National University of Defense Technology, Changsha 410073, China and College of Science, National University of Defense Technology, Changsha 410073, China |
| |
| Abstract: | High-precision inter-satellite baseline determination is essential for the distributed InSAR system.The reduced dynamic orbit determination method,which employs onboard GNSS measurements and the dynamical constraints,is most extensively used to generate a baseline solution between two formation-fly satellites in low-Earth orbits.However,the reference point of the dynamical model is the centerof-mass (CoM) of the satellite rather than the phase center of the SAR antenna.Owing to the effect of structural deformation and the inevitable formation-keeping maneuvers,the CoM of a satellite in orbit is usually different from the point calibrated on ground.Thus,the effect of CoM errors must be carefully considered in GNSS-based precision baseline determination;otherwise,CoM errors are likely to induce systematic errors in the spatial baseline solution of the InSAR formation.Simulations are carried out in this study to analyze and mitigate the effect of CoM errors on the InSAR baseline determination.First,a constant CoM error of 1 cm is added to the x-,y-,and z-directions of the satellite-fixed frame.Simulation results show that the effect of such 1 cm error in the x-and y-directions are extremely tiny and can be safely neglected.By contrast,the effect of CoM error in the z-direction is significant,and the results in a systematic variation in the baseline product.In view of this,we further propose two independent methods in GNSS-based InSAR baseline determination to mitigate the z-component CoM errors by adding the following:(1) constant empirical acceleration in the radial direction;(2) an offset parameter in the z-direction of the satellite-fixed frame.The first method is based on dynamical modeling and does not need any extra correction for CoM variations.In addition,the first method is suitable for the mitigation of the CoM errors caused by formation-keeping maneuvers.The second method is based on geometric modeling,and an online calibration for the CoM errors is necessary.Moreover,the second method is suitable for the CoM calibration at the beginning of the in-orbit validation phase.Both methods are proven effective according to the numerical experiments.The 3D RMS caused by the simulated 1 cm CoM errors in the satellite-fixed z-direction can be reduced from 8.8 mm to 0.13 mm and 0.09 mm,respectively.Over 98% of the CoM errors can be mitigated.Using our proposed methods,the systematic errors caused by the CoM offset in the baseline solution can be considerably mitigated. Compared with traditional in-orbit CoM calibration,the proposed method not only avoids the complex design for satellite attitude control but also improves the efficiency of the InSAR system.The current research is based on simulations.Further validation of real data will be carried out in future studies. |
| |
| Keywords: | Center-of-Mass errors distributed InSAR inter-satellite baseline determination spaceborne GNSS empirical acceleration |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《遥感学报》浏览原始摘要信息 |
| 点击此处可从《遥感学报》下载免费的PDF全文 |
|
