|
|||||
|
|
Analysis on mechanism of landslides under ground shaking: a typical landslide in the Wenchuan earthquake |
|
| Authors: | Yang Changwei Liu Xinmin Zhang Jianjing Chen Zhiwei Shi Cong Gao Hongbo |
| Institution: | 1. Key Laboratory of High-speed Railway Engineering, Ministry of Education, School of Civil Engineering, Southwest Jiaotong University, Chengdu, 610031, China 4. Henan University of Urban Construction, Pingdingshan, Henan Province, 467036, China 2. Civil Engineering Department, Southwest Jiaotong University Emei Campus, Chengdu, 610031, China 3. School of Civil Engineering, Xinyang Normal University, Xinyang, 610031, China |
| Abstract: | A high steep rock hill with two-side slopes near National Road 213 is used as a prototype in this paper. The full process from initial deformation to sliding of the slope during ground shaking is simulated by a new discrete element method—continuum-based discrete element method. Then, the seismic responses of a high steep rock hill with two-side slopes are researched from the base of time, frequency and joint time–frequency domain using Hilbert–Huang transform and Fourier Transform. The findings are: first, the stress concentration phenomenon occurs at the top of the sliding mass, and then some tension and shear failure points appear, which expand from the top toward the toe of the sliding mass along the structural plane. At the same time, the number of tension failure points gradually increases. Then the toe of the sliding mass fails, and shears out from its toe which results in the landslide. If the material parameters are under the same conditions, the landslide in the middle of the slope occurs before that at the foot of slope, and the starting time of landslide and the arrival time of the peak ground acceleration are synchronous or the former slightly lags behind the latter. The difference of distribution and dissipation of earthquake energy in the sliding body and sliding bed is the major influence factor to induce the landslide. When the accelerations are small, the instantaneous frequency of accelerations between sliding bed and sliding body is generally consistent, the energy transmittance coefficients of the sliding structural plane and the controlled frequency band of the energy all range in a limitation; with the increase of the seismic intensity, the instantaneous frequency and the energy transmittance coefficients gradually decrease, and then they are steady within the lower limitation. At the same time, the controlled frequency band also shifts gradually from high frequency band to the lower one. Based on the input seismic wave, the peak acceleration amplifies as the increase of elevation, regardless of the monitoring points on the steep slope, gentle slope side or inside of the slope. Generally speaking, amplification of the vertical peak acceleration is stronger than that of the horizontal peak acceleration, and amplification of the peak acceleration on a steep slope is stronger than that on a gentle slope, and that of inside of the slope is the weakest amplification. |
| Keywords: | |
| 本文献已被 SpringerLink 等数据库收录！ | |