Analysis of repeated-load laboratory tests on buried plastic pipes in sand |
| |
| Authors: | SN Moghaddas Tafreshi O Khalaj |
| |
| Institution: | Department of Civil Engineering, K.N. Toosi University of Technology, Valiasr St., Mirdamad Cr., Tehran, Iran |
| |
| Abstract: | This paper describes a laboratory model test carried out on high-density polyethylene (HDPE), small diameter pipes buried in trenches, which subjected to repeated loadings to simulate the vehicle loads. Deformation of the pipe was recorded at eight points on the circumference of the tested pipes to measure the radial deformations and detect cross-sectional pipe profiles. Also settlement of the soil surface during the test up to 1000 cycles of loadings was recorded, until its value become stable or the excessive settlement was happened. The parameters varied in the testing program include height of buried depth, relative density of the sand and intensity of stress on the soil surface. The influence of various repeated loads (with magnitude of 250, 400 and 550 kPa) at relative densities of 42%, 57% and 72% in different embedded depth of 1.5–3 times of pipe diameter were investigated. Based on the results, in medium and dense sand relative density, the pipe embedded in depth of 3.0D and 2.0D, respectively, mostly remained undamaged (the maximum value of VDS is less than 5%) and increased the safety of buried pipes under different magnitude of repeated loads. The records of the pipe deformation and settlement of the soil surface due to the repeated loads have been compared in different conditions. These values increase rapidly during the initial loading cycles by a rate decreasing significantly as the number of cycles increase. The influence of the first cycle was also found to be one of the main behavioral characteristics of buried pipes under repeated loads. The ratio of deformation of pipe at first cycle to last cycle changes from 0.60 to 0.85 in different of tests. Finally for the obtained results, a non-linear power model has been developed to estimate the vertical diametral strain of buried pipe and settlement of the soil surface based on the model test data. It should be noted that only one type of pipe and one type of sand are used in laboratory tests. |
| |
| Keywords: | |
| 本文献已被 ScienceDirect 等数据库收录！ |
|
