首页 | 本学科首页   官方微博 | 高级检索  
     检索      

井下定向钻进用小直径通缆水力振荡器的研制
引用本文:王力,徐保龙,王毅,黄寒静,贾明群,马斌.井下定向钻进用小直径通缆水力振荡器的研制[J].煤田地质与勘探,2020,48(2):30-35,41.
作者姓名:王力  徐保龙  王毅  黄寒静  贾明群  马斌
作者单位:煤炭科学研究总院,北京 100013;中煤科工集团西安研究院有限公司,陕西 西安 710077;中煤科工集团西安研究院有限公司,陕西 西安 710077
基金项目:国家科技重大专项;科技创新基金
摘    要:针对煤矿井下定向钻进过程中由于托压效应引起的钻进摩阻大、钻进效率低、钻孔深度受限等问题,提出通过钻柱振动减阻的技术思路。采用理论分析和数值模拟进行激振力、激振频率等关键技术参数的设计,研制Φ89 mm小直径通缆水力振荡器。在室内测试碟簧和圆柱弹簧两种辅助复位原件结构的振荡器性能,并在淮南张集煤矿井下进行实钻试验。结果表明:碟簧式水力振荡器在300 L/min流量时,最大压降1.9 MPa、激振力8.11 kN、频率13 Hz,适合安装在近钻头位置辅助减阻;圆柱弹簧式水力振荡器频率在300 L/min流量时,模拟测试150 m通缆定向管柱最大变形量2.86 mm,最大复位力7.98 kN,频率11 Hz,适合安装在钻柱中间主要减阻;在张集矿井下-600m疏水巷10号孔定向钻进产生明显托压时使用圆柱弹簧式水力振荡器,使平均钻压降低33%,钻效提高126%,显著降低钻进摩阻,提高定向钻进效率。研制的Φ89 mm小直径通缆水力振荡器为煤矿水平定向钻进中托压问题提供一种新的解决方法。

关 键 词:煤矿井下  定向钻进  小直径  水力振荡器  通缆  淮南张集煤矿
收稿时间:2019-11-13

Development of small diameter hydraulic agitator with cable for directional drilling in underground coal mine
WANG Li,XU Baolong,WANG Yi,HUANG Hanjing,JIA Mingqun,MA Bin.Development of small diameter hydraulic agitator with cable for directional drilling in underground coal mine[J].Coal Geology & Exploration,2020,48(2):30-35,41.
Authors:WANG Li  XU Baolong  WANG Yi  HUANG Hanjing  JIA Mingqun  MA Bin
Institution:(China Coal Research Institute,Beijing 100013,China;Xi’an Research Institute Co.Ltd.,China Coal Technology and Engineering Group Corp.,Xi’an 710077,China)
Abstract:Aiming at the problems of large drilling pressure, low drilling efficiency and limited hole depth caused by the backing effect of drill string during deep hole directional drilling in underground coal mine, the technical idea of using hydraulic agitator was proposed. The ø89 mm small diameter hydriculic agitator was designed based on valve principle, the exciting force, excitation frequency were identified, and the cabled sub was developed. The performance parameters of hydraulic agitator with disc spring and cylindrical spring were tested. The results show that when the flow rate of 300 L/min the disc spring hydraulic agitator has the maximum pressure drop of 1.9 MPa, the exciting force of 8.11 kN, the frequency of 13 Hz, can be installed near the bit for friction reduction partly. The maximum deformation of drill string is 2.86 mm, the reset force is 7.98 kN, the frequency is 11 Hz with cylindrical spring with 150 m cabled drill string under the flow rate of 300 L/min. The agitator was used when the baking pressure was obviously generated during drilling No.10 hole in -600 m drainage lane, in Zhangji coal mine of Huainan. The average drilling pressure was reduced by 33% and the average drilling efficiency was increased by 126%. The friction of drilling was significantly reduced and the efficiency of directional drilling was improved. The developed small-diameter ø89 mm cabled hydraulic agitator provides a solution for the backing pressure problem in horizontal directional drilling in coal mines. 
Keywords:underground coal mine  directional drilling  small diameter  hydraulic agitator  cabled  Zhangji coal mine in Huainan
本文献已被 CNKI 维普 万方数据 等数据库收录!
点击此处可从《煤田地质与勘探》浏览原始摘要信息
点击此处可从《煤田地质与勘探》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号