Escape route analysis after water inrush from the working face during submarine tunnel excavation |
| |
| Authors: | S C Li J Wu Z H Xu B Zhang X Huang |
| |
| Institution: | Geotechnical and Structural Engineering Research Center, Shandong University, Ji’nan, Shandong, China |
| |
| Abstract: | More and more deep-seated long submarine tunnels are under construction, which greatly promotes the development of tunneling technology. The complex geological conditions and frequent geological disasters have become great challenges during submarine tunnel excavation. Among them, casualties and economic losses caused by water inrush are on the top levels in all kinds of tunnel geological disasters. Escape routes after water inrush from the working face during submarine tunnel excavation are investigated and optimized in the present study. Numerical simulations are performed using the FLUENT software to probe water flow characteristics after inrush. Two common cases of water inrush during double-line submarine tunnel excavation are researched. The variation rules of velocity and pressure in the tunnels after inrush are analyzed and discussed. The optimized escape routes are achieved. Finally, the water movement laws after inrush from the working face under different excavation situations are further discussed by comparing the two case studies. Water inrush of high velocity occurs on one working face of the double-line submarine tunnel, and the research results are as follows: (1) The velocity close to the tunnel side wall is the minimum, while it is the maximum in the middle position. (2) The pressure changes greatly at the intersection area of the cross passage and the tunnels. (3) The velocity and pressure nearby the working face without water inrush are both small. (4) The velocity at the high location of the cross passage is relatively small. |
| |
| Keywords: | Flow characteristics optimized escape routes submarine tunnel water inrush |
|
|
