| Abstract: | We have measured concentrations of heat producing elements (Th, U, and K) in 58 samples representative of the main lithologies in a 100 km transect of the Superior Province of the Canadian Shield, from the Michipicoten (Wawa) greenstone belt, near Wawa, Ontario, through a domal gneiss terrane of amphibolite grade, to the granulite belt of the Kapuskasing Structural Zone, near Foleyet. This transect has been interpreted as an oblique cross section through some 25 km of crust, uplifted along a major thrust fault, and thus provides an opportunity to examine in detail a continuous profile into deep continental crust of Archean age. Mean heat production values for these terranes, based on aereal distribution of major rock types and calculated from their Th, U, and K concentrations are: Michipicoten greenstone belt = 0.72 μW m−3; Wawa domal gneiss terrane (amphibolite grade) = 1.37 μW m−3; Kapuskasing granulites = 0.44 μW m−3. Among the silicic plutonic rocks (tonalites, granites, and their derivative gneisses), the relatively large variation in heat production correlates with modal abundances of accessory minerals including allanite, sphene, zircon, and apatite. We interpret these variations as primary (pre-metamorphic). The relatively high weighted mean heat production of the domal gneiss terrane can be accounted for by the larger proportion there of late-stage Th-, U-, and K-rich granitoid plutons. These may have been derived from the underlying Kapuskasing granulite terrane, leaving it slightly depleted in heat producing elements. Transport of Th, U, and K, therefore, could have taken place in silicate melts rather than in aqueous or carbonic metamorphic fluids. This conclusion is supported by the lack of a statistically significant difference in heat production between tonalites, tonalite gneisses and mafic rocks of amphibolite versus granulite grade.The pre-metamorphic radioactivity profile for this crustal section is likely to have been uniformly low, with a mean heat production value less than 1 μW m−3. This result is distinctly different from measured profiles in more silicic terranes, which show decreasing heat production with depth. This implies fundamental differences in crustal radioactivity distributions between granitic and more mafic terranes, and may be an important factor in selective reactivation of lithologically different terranes, possibly resulting in preferential stabilization of basic terranes in the geological record. Our results indicate that a previously determined apparently linear heat flow-heat production relationship for the Kapuskasing area does not relate to the distribution of heat production with depth. Low, but significant heat production, 0.4–0.5 μW m−3, continues to lower crustal depths with no correlation to the depth parameter from the linear relationship. This low heat production may be a minimum average granulite heat production and suggests that, in general, heat flow through the Moho is 8–10 mW m−2 lower than the reduced heat flow calculated from the heat flow-heat production regression. |
