Attenuation of compressional waves in peridotite measured as a function of temperature at 200 MPa |
| |
| Authors: | Hiroki Sato I Selwyn Sacks Tsutomu Murase Gregory Muncill Hiroyuki Fukuyama |
| |
| Institution: | (1) Department of Terrestrial Magnetism, Carnegie Institution of Washington, 20015 Washington, D.C., USA;(2) Department of Physics, Institute for Vocational Training, 229 Sagamihara, Japan;(3) Geophysical Laboratory, Carnegie Institution of Washington, 20008 Washington, D.C., USA;(4) Geological Institute, University of Tokyo, 113 Tokyo, Japan;(5) Present address: Geophysical Laboratory, Carnegie Institution of Washington, 2008 Washington, D.C., USA |
| |
| Abstract: | A technique has been developed to determine attenuation in rocks at high temperature using a gas-media, high-pressure apparatus. A pulse transmission technique and a spectral ratio method are used to study compressional seismic properties of rocks. Seismic waves are transmitted to and from the sample through buffer rods of mullite. The effect of seismic wave reflections within the sample assembly are cancelled out by taking ratios of the spectra measured at different temperatures. In order to obtain good signal-to-noise ratio for resolving the attenuation at high pressure and temperature, special care is taken in the sample assembly and the ultrasonic coupling between the sample, buffer rods and transducers. A very tight connection of the sample-buffer rod-transducer is essential for obtaining high frequency signals (>300 kHz) at high temperature. A small mass is attached to each outside end of the transducer to drive low frequency signals (<250 kHz) into the sample. Before attenuation measurements, the sample and the buffer rods are tightly compacted in a platinum tube at high pressure and room temperature to ensure pressure seal of the sample assembly. The frequency range of measurement covers 50 to 450 kHz for the sample. Attenuation is very small in the buffer rod compared to the sample for the entire temperature range of the study. Because of the small attenuation, a wide frequency band of 50 kHz to 3.2 MHz can be covered for investigating the attenuation in the buffer rod. The technique has been used to measure attenuation at high confining pressure, and temperatures including sub- and hyper-solidus of upper mantle rocks. Therefore, effects of partial melting on attenuation can be studied.The method is applied to the attenuation measurement in a peridotite as a function of temperature to 1225°C at 200 MPa confining pressure. At high temperature, signal amplitude decays more rapidly at high frequency than at low frequency, from which attenuation (andQ) can be determined using a spectral ratio method. No frequency dependence ofQ is resolved for both the sample and the buffer rod over the entire temperature and frequency ranges of the measurement. The results show thatQ decreases rapidly with increasing temperature even in the temperature range below the solidus of peridotites. Such temperature sensitivity ofQ is probably more useful to probe thermal structure in the upper mantle than that of conductivity at temperatures below the solidus. The results in this study are compared with available seismic velocity, electrical conductivity and solidus data for peridotites, suggesting that there is no discontinuous change in both mechanical and electrical properties of peridotites at the solidus temperature. Even at hypersolidus temperatures, it appears that velocity drops and conductivity increases continuously (not abruptly) with increasing melt fraction. This implies that mechanical and electrical properties of the upper mantle will gradually change at the boundary where the geotherm crosses the solidus. |
| |
| Keywords: | Attenuation spectral ratio peridotite partial melting high pressure and temperature |
| 本文献已被 SpringerLink 等数据库收录！ |
|
