首页 | 本学科首页   官方微博 | 高级检索  
     检索      

滇池水域双酚A的环境多介质迁移和归趋模拟
引用本文:陈蓉,刘华英,黄斌,杨小霞,李晓曼,孙雯雯,潘学军.滇池水域双酚A的环境多介质迁移和归趋模拟[J].湖泊科学,2015,27(6):1093-1100.
作者姓名:陈蓉  刘华英  黄斌  杨小霞  李晓曼  孙雯雯  潘学军
作者单位:昆明理工大学环境科学与工程学院, 昆明 650500,昆明理工大学环境科学与工程学院, 昆明 650500,昆明理工大学环境科学与工程学院, 昆明 650500,昆明理工大学环境科学与工程学院, 昆明 650500,昆明理工大学环境科学与工程学院, 昆明 650500,昆明理工大学环境科学与工程学院, 昆明 650500,昆明理工大学环境科学与工程学院, 昆明 650500
基金项目:国家自然科学基金项目(41401558、21267012)、中国博士后科学基金项目(2014T70887,2013M531987)、云南省应用基础研究计划项目(2012FB124)和中国科学院环境化学与生态毒理学国家重点实验室开放基金项目(KF2013-04)联合资助.
摘    要:以双酚A为研究对象,利用四级多介质逸度模型模拟非稳态非平衡条件下1991-2011年间双酚A在滇池水域水相、表层沉积物相和中层沉积物相中的浓度分布、相间的迁移通量,确定主要迁移过程;结合实测数据,对模型进行可靠性验证;并对常数之外的12个模型参数进行灵敏度分析.结果表明:入滇总量98%的双酚A主要通过水体降解去除,滇池出水去除量和水体残留量共约占1%,余下部分进入沉积物相;沉积物相是残留双酚A最主要的汇,其中,表层沉积物相中双酚A浓度最高,3相中浓度变化趋势受外界输入影响较大;水相→表层沉积物相的迁移为双酚A在滇池的主要迁移过程,其次为表层沉积物相→中层沉积物相;双酚A在水中的降解速率、有机碳分配系数,各环境相中有机碳含量、固相体积比等参数灵敏度较高,对模型的影响较为显著;模型计算浓度与实测浓度吻合较好,表明建立的四级多介质逸度模型适用于滇池水域双酚A环境多介质迁移和归趋模拟.

关 键 词:双酚A  多介质归趋  逸度模型  滇池
收稿时间:9/4/2014 12:00:00 AM
修稿时间:2015/1/22 0:00:00

Simulation of multimedia transfer and fate of Bisphenol A in Lake Dianchi
CHEN Rong,LIU Huaying,HUANG Bin,YANG Xiaoxi,LI Xiaoman,SUN Wenwen and PAN Xuejun.Simulation of multimedia transfer and fate of Bisphenol A in Lake Dianchi[J].Journal of Lake Science,2015,27(6):1093-1100.
Authors:CHEN Rong  LIU Huaying  HUANG Bin  YANG Xiaoxi  LI Xiaoman  SUN Wenwen and PAN Xuejun
Institution:Faculty of Environmental Science and Engineering, Kunming University of Science and Technology, Kunming 650500, P.R.China,Faculty of Environmental Science and Engineering, Kunming University of Science and Technology, Kunming 650500, P.R.China,Faculty of Environmental Science and Engineering, Kunming University of Science and Technology, Kunming 650500, P.R.China,Faculty of Environmental Science and Engineering, Kunming University of Science and Technology, Kunming 650500, P.R.China,Faculty of Environmental Science and Engineering, Kunming University of Science and Technology, Kunming 650500, P.R.China,Faculty of Environmental Science and Engineering, Kunming University of Science and Technology, Kunming 650500, P.R.China and Faculty of Environmental Science and Engineering, Kunming University of Science and Technology, Kunming 650500, P.R.China
Abstract:A multimedia fugacity model (Level IV) was applied to simulate the concentration distribution and transfer fluxes of Bisphenol A (BPA) in three environmental compartments including water, up-sediment, middle-sediment in Lake Dianchi from 1991 to 2011. The reliability of this model was analyzed by comparing modeling results with measured data and the key parameters were selected by means of sensitivity analysis. The study results showed that sediment was the main reservoir of BPA in Lake Dianchi. The highest concentration of BPA was observed in the up-sediment. 98% of the total BPA that discharged into Lake Dianchi was removed by its degradation in water with ~1% was removed by water flow or as residual in sediments. The flux from water to sediment was the main process of migration among different media. The study results also indicated that the degradation rate of BPA in water, organic carbon partition coefficient of BPA, organic carbon content of sediment and solid phase volume ratio had significant influences on the sensitivity of the model. The reliability of the model was verified by the agreement between calculated and measured concentrations. The study showed that the established model was suitable for simulating the multimedia transfer and fate of BPA in the Lake Dianchi.
Keywords:Bisphenol A  multimedia fate  fugacity model  Lake Dianchi
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《湖泊科学》浏览原始摘要信息
点击此处可从《湖泊科学》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号