| GNSS导航信号仿真中运动轨迹设计 |
| |
| 引用本文： | 李俊毅,孙倩,李军正.GNSS导航信号仿真中运动轨迹设计[J].海洋测绘,2013(6):26-28. |
| |
| 作者姓名： | 李俊毅 孙倩 李军正 |
| |
| 作者单位： | [1]解放军信息工程大学导航与空天目标工程学院,河南郑州450002 [2]解放军信息工程大学训练部,河南郑州450002 |
| |
| 摘 要： | GNSS信号仿真器模拟GNSS信号时需要提供轨迹数据,要求轨迹数据连续、平滑且二阶可导。要满足上述条件,传统的方式通常是对轨迹进行分段仿真,设置仿真轨迹的时候较为复杂,在仿真高动态载体时,还常常会出现轨迹不平滑的现象。为此提出采用三次样条插值的方法来仿真载体轨迹,既满足GNSS信号仿真器对轨迹数据的要求,又保证与真实轨迹的相似性。
|
| 关 键 词： | 轨迹仿真 三次样条 GNSS信号仿真器 |
Motion Trajectory Design for GNSS Signal Simulator |
| |
| LI Junyi,SUN Qian,LI Junzheng.Motion Trajectory Design for GNSS Signal Simulator[J].Hydrographic Surveying and Charting,2013(6):26-28. |
| |
| Authors: | LI Junyi SUN Qian LI Junzheng |
| |
| Institution: | 1. Institute of Navigation and Aerospace Target Engineering, Information Engineering University ,Zhengzhou 450(02, China; 2. Training Department, Information Engineering University, Zhengzhou 450002, China) |
| |
| Abstract: | While GNSS Signal Simulator is simulating GNSS signals, continuous smooth and second order derivable trajectory data are needed. In order to meet the above requirements, the trajectory is always simulated in segment with the traditional method, which is very complicated in setting the trajectory. Moreover, when simulating high-dynamic carriers, the trajectory may not be smooth. In this paper the cubic spline interpolation method is used to simulate the vehicle and vessel trajectory, which can fulfill GNSS simulator＇ s demand for trajectory data and guarantee the similarity with real trajectory. |
| |
| Keywords: | trajectory simulate cubic spline GNSS signal simulator |
| 本文献已被 维普 等数据库收录！ |
| 点击此处可从《海洋测绘》浏览原始摘要信息 |
| 点击此处可从《海洋测绘》下载免费的PDF全文 |
|
