共查询到19条相似文献，搜索用时 328 毫秒
1.
利用GAMIT/GLOBK软件处理2011年特种监测网的观测数据,将IGS站的选取分10种方案进行试验,计算结果从基线长度变化、测站坐标、NRMS、基线重复率等方面进行了比较。得出利用GAMIT/GLOBK软件处理该特种监测网时的几点建议:建议选取IGS站为GPS网提供参考框架;IGS站选取的数量不一定最多,但空间上应尽量均匀分布;选取7个IGS站时得到较高精度的结果。在日后处理此类型的特种监测网时对IGS站选取具有一定的参考价值。 相似文献
2.
3.
4.
5.
目前IGS共提供6类精度和时效性不同的精密星历产品,为了验证不同精度和时效性的IGS精密星历产品在海洋测绘中的适用情况,使用6类不同的IGS精密星历产品,分别对固定点观测数据和海上浮动点观测数据进行精密单点定位解算,并对解算结果分别进行比对分析和统计。固定点比对结果表明,IGS和IGR精密星历精密单点定位解算在平面位置方向均能达到平均8厘米的外符合精度,IGU00至IGU18精密单点定位解算精度稍差,平面外符合精度在10～13cm,且精度随着发布时间的推迟而提高;PPP潮位的解算结果表明,从IGS至IGU18,高程方向的解算精度相当,和固定潮位站的数据相比,均方根差在16～18cm。 相似文献
6.
常规精密单点定位实时反演水汽,存在精度低或稳定性差等问题,因此提出了一种基于参考站改正信息的PPP实时水汽反演方法。首先利用参考站的天顶对流层延迟解算观测值改正信息,然后对流动站共视卫星的观测值进行误差改正,利用IGU预报星历和钟差产品,采用PPP算法进行实时水汽反演。以中国香港HKSC为流动站,分别选取中国台湾TWTF和中国香港HKWS作为参考站,开展参考站辅助的PPP实时水汽反演试验。结果表明,分别以无线电探空数据和ECMWF数据为参考,本方法4个时段的平均标准差分别为1.9 mm和2.9 mm;相比基于IGU的常规PPP实时水汽反演方法,精度分别提升60%和51%。本方法参考站的选择不受距离限制,精度与使用IGS事后精密星历的PPP水汽反演基本一致,相比常规PPP和相对定位方式的实时水汽反演具有明显优势。 相似文献
7.
8.
组织实施了连续一周的渤海湾船载动态GPS定位试验,对BNC软件客户端接收的IGS实时数据流4种综合产品(IGC01、IGS01、IGS02和IGS03)的数据可用性和精度进行了验证;对基于RTS改正的船载实时精密单点定位的精度进行了分析。结果表明,4种RTS产品的数据可用率均在90%以上,其中IGS01的数据可用率最高为97.68%;以IGS最终精密星历和钟差产品为参考,4种RTS轨道产品在X、Y、Z方向的精度(RMS)均优于4cm,钟差产品的精度(STD)优于0.2ns;以采用IGS最终精密星历和钟差产品的事后PPP结果为参考,基于RTS的船载RTPPP的水平方向精度优于7cm,高程方向精度为12cm,三维位置精度约为15cm。 相似文献
9.
不规则重磁测线网误差模型的约束最小二乘平差 总被引：5，自引：1，他引：5
传统实用的海洋重力、磁力测线网平差方法主要为规则测线网设计,并只就线偏差进行调整,用于处理航次数据之间的拼接时效果不理想。为了解决重磁测线数据拼接和建库工作中碰到的误差难以调平的问题,设计、建立了不规则海洋重磁测线网的任意复杂误差模型的最小二乘平差方法,将线偏差纳入到任意复杂(如非线性和周期性)的误差模型中,归纳出最小二乘条件方程系数矩阵的直接构制法。针对可能出现的解不稳定,放弃不易实用的权矩阵,引入两种解决方法:先验确定部分测线误差分布的固定测线法和视误差大小实施系数矩阵对角线微扰动的泛约束法。 相似文献
10.
11.
We have determined the azimuth of bottom-current flow in drift deposit sediments recovered at ODP Sites 1095 and 1101, Antarctic Peninsula, using paleomagnetic reorientation of anisotropy of magnetic susceptibility (AMS) ellipsoids. A total of 38 cores from the two ODP sites have been measured, providing spatial and directional information on the physical record of the ACC (Antarctic Circumpolar Current) in the Plio-Pleistocene. Declination and inclination of the paleomagnetic vector of each core segment were used to reorient the AMS principal axes to the geographic coordinates. The cores were reoriented using the measured direction of the characteristic remanent magnetization (ChRM) with respect to a common reference line for the core, from which we are able to determine the orientation of the paleocurrent flow for Sites 1095 (Drift 7) and 1101 (Drift 4) relative to the geographic coordinates. Both sites have paleocurrent directions trending ~ NW-SE, which in the former locality are parallel to a sediment wave field. Our study shows that a combination of magnetic fabric analysis and paleomagnetism allows deep-sea sedimentary fabric to be used as a long-term proxy of bottom-current flow history. 相似文献
12.
13.
The published global ocean tide models show good agreement in deep oceans and exhibit differences in complex coastal areas, along with subsequent Ocean Tide Loading Displacement (OTLD) modeling differences. Meanwhile, OTLD parameters (amplitudes and phase lags) derived by Global Positioning System (GPS) Precise Point Positioning (PPP) approach need long time to converge to a stable state and show poor precision of S2, K1, and K2 constituents. Based on the fact that no constraint is imposed in the current kinematic solution, a new method is put forward, in which global ocean tide model predictions are taken as the priori information constraints to speed up the convergence rate and improve the accuracy of the GPS-derived OTLD parameters. First, the data of tide gauge from 01 January 2014 to 31 December 2016 are used to generate the harmonic parameters to evaluate the accuracy of six global ocean tide models and a regional ocean tide model (osu.chinesea.2010). Osu.chinesea.2010 model shows good agreement with the tide gauge results, while NAO99b model presents relatively large difference. The predictions from osu.chinesea.2010 and NAO99b model are employed as reference and the prior information, respectively. Second, continuous observations of 12 GPS sites during 2006–2013 in Hong Kong are collected to generate three dimensional OTLD amplitudes and phase lags of eight constituents using PPP with prior information constraints approach and harmonic analysis. Third, comparing the convergence time of eight constituents from PPP without and with priori information constraints approaches, the results show that the new method can significantly improve the convergence rate of OTLD amplitude estimates which obtain a certain level of stability seven years earlier than that derived by the PPP without priori information constraints. Precision of OTLD parameters derived by the new method is about 1 mm. By comparing with the precision of single PPP approach, the accuracy of eight constituents has been improved, especially for S2, K1, and K2 constituents. Finally, through comparing the different correction effects of OTLD estimates on the coordinates and their time series of the ground GPS stations, the results show that OTLD estimates derived by the new approach have similar influence as the osu.chinasea.2010 ocean tide model. The new method provides an effective means to improve the convergence and precision of the GPS-derived OTLD parameters, and achieve a similar correction as the high precision ocean tide model. 相似文献
14.
Wanshan area has been chosen to be the specified field to calibrate and validate(Cal/Val) the HY-2 altimeter and its follow-on satellites. In March 2018, an experiment has been conducted to determine the sea surface height(SSH) under the HY-2 A ground track(Pass No. 203). A GPS towing-body(GPS-TB) was designed to measure the SSH covering an area of about 6 km×28 km wide centered on the HY-2 A altimeter satellite ground track. Three GPS reference stations, one tide gauge and a GPS buoy were placed in the research area, in order to process and resolve the kinematic solution and check the precision of the GPS-TB respectively. All the GPS data were calculated by the GAMIT/GLOBK software and TRACK module. The sea surface was determined by the GPS-TB solution and the tide gauge placed on Zhiwan Island. Then the sea surface of this area was interpolated by Arc GIS10.2 with ordinary Kriging method. The results showed that the precision of the GPS-TB is about 1.10 cm compared with the tide gauge placed nearby, which has an equivalent precision with the GPS buoy. The interpolated sea surface has a bias of –1.5–4.0 cm with standard deviation of 0.2–2.4 cm compared with the checking line. The gradient of the measured sea surface is about 1.62 cm/km along the HY-2 orbit which shows a good agreement compared with the CLS11 mean sea surface(MSS). In the Cal/Val of satellites, the sea surface between the tide gauge/GPS buoy and the footprint of altimeter can be improved by this work. 相似文献
15.
16.
Formulation, implementation and examination of vertical coordinate choices in the Global Navy Coastal Ocean Model (NCOM) 总被引：3，自引：3，他引：3
Charlie N. Barron A. Birol Kara Paul J. Martin Robert C. Rhodes Lucy F. Smedstad 《Ocean Modelling》2006,11(3-4):347-375
A 1/8° global version of the Navy Coastal Ocean Model (NCOM) is described with details of its formulation, implementation, and configuration of the vertical coordinate. NCOM is a baroclinic, hydrostatic, Boussinesq, free-surface ocean model that allows its vertical coordinate to consist of σ coordinates for the upper layers and z-levels below a user-specified depth. This flexibility allows implementation of a hybrid σ–z coordinate system that is expected to mitigate some of the weaknesses that can be associated with either pure coordinate option. For the global NCOM application, the σ–z coordinate is used to allow terrain-following σ coordinates in the upper ocean, providing better resolution and topographic fidelity in shelf regions where flow is most sensitive to its representation. Including z coordinates for deeper regions efficiently maintains high near-surface vertical resolution in the open ocean. Investigation into the impact of the selected coordinate system focuses on differences between atmospherically-forced free-running (no assimilation) global solutions using σ–z and pure z coordinates. Comparisons with independent temperature observations indicate that global NCOM using the σ–z coordinate has improved skill relative to its z coordinate implementation. Among other metrics, we show that in comparison with time series of surface temperature from National Oceanic Data Center (NODC) buoys, mostly located in coastal regions, root mean squared differences (RMSD) improved for 63% and correlation improved for 71% of the stations when σ–z coordinates were used instead of pure z. For the exclusively open-ocean Tropical Atmosphere-Ocean (TAO) buoys, differences between the simulations were small, with the σ–z showing smaller RMSD for 45% of the stations and higher correlation for 65% of the stations. Additional comparisons using temperature profile observations further confirm a tendency for improved performance using the hybrid σ–z coordinates. 相似文献
17.
18.
19.
深度基准传递方法的比较与验潮站网基准的综合确定 总被引：1，自引：0，他引：1
分析了深度基准确定的不同方法及由此产生的理论最低潮面含义不一致性。重点比较研究了在长期站基准值的控制下,传递确定短期和临时验潮站深度基准的多种技术方法。以某水深测量工程实例对测区验潮站网深度基准值的统一、协调确定进行了示范论证。得出的基本结论是:在当今深度基准基础框架不完备的现实条件下,水深测量工程区域的深度基准应由所布设的短期和临时验潮站与测区及附近长期验潮站组网确定。确定方法应尽量利用实际观测信息,依据潮差比或略最低潮面比等不同方法传递,并依据规定的限差指标检核。示范实例的计算表明,由不同基准站、不同方法传递确定同一短期验潮站深度基准值的差异可控制在10cm以内。 相似文献