共查询到10条相似文献，搜索用时 125 毫秒
1.
本文根据地震的断层说观点在室温、围压600—1,200巴条件下研究了具切口的花岗闪长岩、辉长岩和大理岩试件的破裂发展过程。在连续增加的差应力作用下观测到:切口内部充填的软弱夹层首先发生剪切变形和破裂,接着在切口端部一侧扩展张性裂纹,然后在切口前缘方向扩展剪切裂纹,最后发生贯通试件的剪切和张裂-剪切主破坏。张裂纹扩展长度受到围压的强烈抑制。岩石的切口结构和岩性变化对破裂迹线的空间展布和主破坏机制有重要影响。讨论了实验结果在断层扩展型地震的形成过程及其在预报预测方面的意义 相似文献
2.
In order to investigate the dynamic mechanical properties of amphibolite and sericite-quartz schist under confi ning pressure, two rocks are subjected to impact loadings with different strain rates and confi ning pressures by using split Hopkinson pressure bar equipment with a confi ning pressure device. Based on the experimental results, the stress-strain curves are analyzed and the effects of confi ning pressure and strain rates on the dynamic compressive strength, peak strain and failure mode are summarized. The results show that:(1) The characteristics of two rocks in the ascent stage of the stressstrain curve are basically the same, but in the descent stage, the rocks gradually show plastic deformation characteristics as the confi ning pressure increases.(2) The dynamic compressive strength and peak strain of two rocks increase as the strain rate increases and the confi ning pressure effects are obvious.(3) Due to the effect of confi ning pressure, the normal stress on the damage surface of the rock increases correspondingly, the bearing capacity of the crack friction exceeds the material cohesion and the slippage of the fractured rock is controlled, which all lead to the compression and shear failure mode of rock. The theoretical analysis and experimental methods to study the dynamic failure mode and other related characteristics of rock are useful in developing standards for engineering practice. 相似文献
3.
用两种加载方式对岩石的破裂进行了实验研究。一种方式是在一定的围压下增加轴压使岩石破裂（A型）;另一种方式是在一定围压下增加轴压直到破裂前某一应力状态,然后停止加轴压转而减小围压使岩石破裂（B型）。所用的岩石样品为济南辉长岩和山东掖县白大理岩。着重研究应力途径对岩石脆性-延性变化的影响。辉长岩在1.5千巴以下两种应力途径下的破裂都表现为脆性,但是对于同样的应力状态,B型实验比A型实验显得更脆。随着围压增加到200-250巴之间,大理岩由脆性转变为延性。围压250巴以上,大理岩的A型实验发生延性破裂。样品承受载荷的能力是逐渐丧失的。破裂过程中声发射率极低,听不到破裂声响。最后在样品中形成了剪切断面,但破裂很慢。然而,在大理岩的B型实验中,围压在250巴以上发生了脆性破裂,其表现为轴向应力突然下降,伴随着脆性破裂的声响并有声发射率剧增的前兆。看来,B型应力途径对岩石起了一个脆化的作用。 相似文献
4.
本文以共线剪切裂纹的归并为例,研究裂纹系的动态相互作用．实验结果表明：在张破裂的意义上,小间距共线剪切裂纹的内端部实际上是阻碍结构,通过迂回弯曲的张破裂归并．本文提出一种估计张破裂扩展途径的近似方法,利用张应力破裂判据找出了潜在的破裂扩展途径的第一近似,较好地模拟了共线裂纹的破裂途径,和现有的数值模拟方法比较,可以大大缩短机时,简化计算程序,保证精确度．本研究结出了岩石剪切破裂“隧道效应”（即破裂跳过障碍体,而障碍体本身不破坏）的机理,还给出了脆性介质在摩擦、磨损过程中碎屑产生的机理． 相似文献
5.
P. W. J. Glover J. B. Gomez P. G. Meredith S. A. Boon P. R. Sammonds S. A. F. Murrell 《Surveys in Geophysics》1996,17(3):307-330
Measurement of complex electrical conductivity as a function of frequency is an extremely sensitive probe for changes in pore and crack volume, crack connectivity, and crack surface topography. Such measurements have been made as a function of pore fluid chemistry, hydrostatic confining pressure, as well as uniaxial and triaxial deformation. This paper will; (1) describe the effects of triaxial deformation on the complex electrical conductivity of saturated porous rocks, (2) use the electrical data to model the mechanical stress-strain behaviour, and (3) compare the modelled behaviour with the stress-strain behaviour measured during the deformation. Experimental conductivity data tracks how the rock undergoes compaction with progressive loss of crack volume, followed by dilatation due to new crack formation, growth of existing cracks, crack interlinkage, and finally failure, as axial strain is increased. We have used the complex electrical data to produce a direction-sensitive (anisotropic) crack damage parameter, and used it to calculate the effective Young's modulus by employing the models of Walsh and Bruner. Comparison of the synthetic stress-strain curves so produced, with the experimentally derived stress-strain curves shows good agreement, particularly for undrained tests. This modelling is an improvement on similar curves produced using isotropic crack damage parameters derived from acoustic emission data. The improvement is likely to be due to the directional sensitivity of the electrical conductivity measurement, and its ability to discriminate between the formation of isolated cracks, and those cracks that contribute to the inter-connected crack space i.e. those cracks upon which transport properties of the rock such as electrical conductivity, and mechanical properties depend most critically during triaxial deformation. 相似文献
6.
本文介绍了以激光全息干涉法观测单轴压缩下,大理岩岩样表面的变形位移场。全息干涉图可以反映出由于岩石内部微裂隙丛集激增所导致的变形局部化,实验采用板状大理岩试件,在中心处预制了不同角度的裂缝,实验在MTS伺服压机中加载直至宏观破坏,观测了裂隙的发展过程。实验表明:当裂缝角小于45时,先在裂缝尖端处的张应力集中部位出现新裂纹,它的起裂角(与原裂缝的交角)90,裂纹弯向压力方向并趋于稳定。当>45时,在上述张裂纹稳定后,在裂缝尖端附近再次发生张裂,其起裂角60,同样弯向压力方向后稳定。在这些前期张破裂稳定后,在张裂的相反方向,也即裂缝的共轭方向上,出现内部微裂隙的丛集,并随后发生宏观的剪破坏,我们认为此逆向剪切破坏与大理岩的多晶组构有关,与应变弱化过程中变形和应力的调整有关。 相似文献
7.
运用三维非线性动态有限元方法(Non-linear Dynamic FEM)仿真模拟研究了菱形模型的动态应力作用,分析了1976年唐山7.8级地震.结果表明:(1)唐山地震前增强的中强地震产生的冲击力形成的应力波反射后发生半波损失, 成为动态的拉伸应力,通过减小内摩擦而引起岩石产生裂纹、局部破裂并发生串通,一方面触发地震,另一方面为孕育唐山地震积累能量,表现为正反馈过程.(2)唐山地震产生的冲击力加卸载存在时间差,造成加卸载冲击波相位不同,结果产生的动应力和围压叠加致使围压波动和下降,导致抗剪切强度降低,使初始破裂分别向北东、西南方向传播.(3)冲击力的卸载,相对于产生拉伸性的应力波,反射后发生半波损失,成为动态的压缩应力,致使围压增大并导致破裂停止;而动态应力在传播过程中衰减.因此,余震的发生是一个负反馈过程. 相似文献
8.
用实验方法研究水泥石动态断裂韧性 总被引：1，自引：0，他引：1
为了减轻射流侵彻对水泥环的破坏,改善界面的密封胶结性能,必须对现有的水泥石进行改性研究。根据超混复合材料的原理,我们在水泥石的配比中增加几种填料,通过填料影响改变水泥石的动态断裂韧性。将水泥石制成短棒试件,用分段式Hopk inson压杆对几种改性配方的水泥石的动态断裂韧性进行实验测定,给出了部分实验结果。采用反射式动态焦散线方法,对六种水泥石材料的动态断裂韧性进行了实验研究,给出了实验结果。并比较了短棒实验和动态焦散线法测量动态断裂韧性的结果,两者吻合较好。研究表明:纤维增强是提高水泥石抗冲击性能的有效途径。 相似文献
9.
Ultrasonic Velocities, Acoustic Emission Characteristics and Crack Damage of Basalt and Granite 总被引：2，自引：0，他引：2
Acoustic emissions (AE), compressional (P), shear (S) wave velocities, and volumetric strain of Etna basalt and Aue granite were measured simultaneously during triaxial compression
tests. Deformation-induced AE activity and velocity changes were monitored using twelve P-wave sensors and eight orthogonally polarized S-wave piezoelectric sensors; volumetric strain was measured using two pairs of orthogonal strain gages glued directly to the
rock surface. P-wave velocity in basalt is about 3 km/s at atmospheric pressure, but increases by > 50% when the hydrostatic pressure is
increased to 120 MPa. In granite samples initial P-wave velocity is 5 km/s and increases with pressure by < 20%. The pressure-induced changes of elastic wave speed indicate
dominantly compliant low-aspect ratio pores in both materials, in addition Etna basalt also contains high-aspect ratio voids.
In triaxial loading, stress-induced anisotropy of P-wave velocities was significantly higher for basalt than for granite, with vertical velocity components being faster than
horizontal velocities. However, with increasing axial load, horizontal velocities show a small increase for basalt but a significant
decrease for granite. Using first motion polarity we determined AE source types generated during triaxial loading of the samples.
With increasing differential stress AE activity in granite and basalt increased with a significant contribution of tensile
events. Close to failure the relative contribution of tensile events and horizontal wave velocities decreased significantly.
A concomitant increase of double-couple events indicating shear, suggests shear cracks linking previously formed tensile cracks. 相似文献
10.
在3种非含岩成分造成的岩石原始电阻率各向异性标本(在采集和加工过程中，标本完整性遭 到破坏的标本)，和一种由含岩成分形成的 岩石原始电阻率各向异性标本上，布设多个电极，并将标本用水饱和. 然后用多电极组合法 ，将己布电极组合成不同方向、不同极距的电阻率各向异性测线. 采用单轴压缩、低围压 三 轴压缩和剪切3种加载方式，对标本进行动态电阻率变化实验. 观测标本电阻率随承载力的 变化. 实验结果表明∶对于岩石原始电阻率各向异性标本，在电阻率变化各向异性方面，与 岩石 原始电阻率各向同性标本相似，即∶裂隙和破碎带通过区域的测点，视电阻率变化各向异性 结果好，４种组合求得的４个各向异性主轴方向趋向一致，且与破碎带方向基本吻合；裂隙 和破碎带不经过区域的测点，４个视电阻率变化各向异性主轴方向不一致，或者根本求不出 各向异性解. 这后一种情况，在裂隙面平行测量面时，表现最为明显. 相似文献