Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

Micromechanical approach to effective viscoelastic properties of micro‐fractured geomaterials          下载免费PDF全文

Cássio B. Aguiar  Samir Maghous 《国际地质力学数值与分析法杂志》2018,42(16):2018-2046

The aim of this paper is to formulate a micromechanics‐based approach to non‐aging viscoelastic behavior of materials with randomly distributed micro‐fractures. Unlike cracks, fractures are discontinuities that are able to transfer stresses and can therefore be regarded from a mechanical viewpoint as interfaces endowed with a specific behavior under normal and shear loading. Making use of the elastic‐viscoelastic correspondence principle together with a Mori‐Tanka homogenization scheme, the effective viscoelastic behavior is assessed from properties of the material constituents and damage parameters related to density and size of fractures. It is notably shown that the homogenized behavior thus formulated can be described in most cases by means of a generalized Maxwell rheological model. For practical implementation in structural analyses, an approximate model for the isotropic homogenized fractured medium is formulated within the class of Burger models. Although the approximation is basically developed for short‐term and long‐term behaviors, numerical applications indicate that the approximate Burger model accurately reproduce the homogenized viscoelastic behavior also in the transient conditions.  相似文献   

Muon density measurements with the KASCADE central detector     

《Astroparticle Physics》2002,16(4):183-386

Frequency distributions of local muon densities in high-energy extensive air showers (EAS) are presented as signature of the primary cosmic ray energy spectrum in the knee region. Together with the gross shower variables like shower core position, angle of incidence, and the shower sizes, the KASCADE experiment is able to measure local muon densities for two different muon energy thresholds. The spectra have been reconstructed for various core distances, as well as for particular subsamples, classified on the basis of the shower size ratio N_μ/N_e. The measured density spectra of the total sample exhibit clear kinks reflecting the knee of the primary energy spectrum. While relatively sharp changes of the slopes are observed in the spectrum of EAS with small values of the shower size ratio, no such feature is detected at EAS of large N_μ/N_e ratio in the energy range of 1–10 PeV. Comparing the spectra for various thresholds and core distances with detailed Monte Carlo simulations the validity of EAS simulations is discussed.  相似文献   

On the accretion geometry of Cyg X-1 in the low/hard state     

F. Eugenio Barrio  Chris Done  Sergei Nayakshin 《Monthly notices of the Royal Astronomical Society》2003,342(2):557-563

  相似文献   

Warm gas kinematics in shell galaxies     

R. Rampazzo  H. Plana  M. Longhetti  P. Amram  J. Boulesteix  J.-L. Gach  O. Hernandez 《Monthly notices of the Royal Astronomical Society》2003,343(3):819-830

  相似文献   

Deuterium fractionation on interstellar grains studied with the direct master equation approach     

Tatiana Stantcheva  Eric Herbst 《Monthly notices of the Royal Astronomical Society》2003,340(3):983-988

  相似文献   

The emission distribution in RR Pictoris     

L. Schmidtobreick  C. Tappert  I. Saviane 《Monthly notices of the Royal Astronomical Society》2003,342(1):145-150

  相似文献   

Laboratory kinetics of C₂H radical reactions with ethane, propane, and n-butane at T = 96-296 K: implications for Titan     

James E. Murphy  Stephen R. Leone 《Icarus》2003,163(1):175-181

The kinetics of the reactions of C₂H radical with ethane (k₁), propane (k₂), and n-butane (k₃) are studied over the temperature range of T = 96-296 K with a pulsed Laval nozzle apparatus that utilizes a pulsed laser photolysis-chemiluminescence technique. The C₂H decay profiles in the presence of both the alkane reactant and O₂ are monitored by the CH(A²Δ) chemiluminescence tracer method. The results, together with available literature data, yield the following Arrhenius expressions: k₁(T) = (0.51 ± 0.06) × 10⁻¹⁰ exp[(−76 ± 30)K/T] cm³ molecule⁻¹ s⁻¹ (T = 96-800 K), k₂(T) = (0.98 ± 0.32) × 10⁻¹⁰exp[(−71 ± 60)K/T] cm³ molecule⁻¹ s⁻¹ (T = 96-361 K), and k₃(T) = (1.23 ± 0.26) × 10⁻¹⁰ cm³ molecule⁻¹ s⁻¹ (T = 96-297 K). At T = 296 K, k₁ is measured as a function of total pressure and has little or no pressure dependence. The results from this work support a direct hydrogen abstraction mechanism for the title reactions. Implications to the atmospheric chemistry of Titan are discussed.  相似文献   

The effects of topographically-controlled thermal tides in the martian upper atmosphere as seen by the MGS accelerometer     

Paul Withers  S.W Bougher 《Icarus》2003,164(1):14-32

Mars Global Surveyor accelerometer observations of the martian upper atmosphere revealed large variations in density with longitude during northern hemisphere spring at altitudes of 130-160 km, all latitudes, and mid-afternoon local solar times (LSTs). This zonal structure is due to tides from the surface. The zonal structure is stable on timescales of weeks, decays with increasing altitude above 130 km, and is dominated by wave-3 (average amplitude 22% of mean density) and wave-2 (18%) harmonics. The phases of these harmonics are constant with both altitude and latitude, though their amplitudes change significantly with latitude. Near the South Pole, the phase of the wave-2 harmonic changes by 90° with a change of half a martian solar day while the wave-3 phase stays constant, suggesting diurnal and semidiurnal behaviour, respectively. We use a simple application of classical tidal theory to identify the dominant tidal modes and obtain results consistent with those of General Circulation Models. Our method is less rigorous, but simpler, than the General Circulation Models and hence complements them. Topography has a strong influence on the zonal structure.  相似文献