A revised version of synchrotron radiation in a magnetized plasma     

P. C. W. Fung  P. L. Leung 《Astrophysics and Space Science》1990,165(1):83-93

We analyze the propagation features of synchrotron radiation of a charge moving with a gyrating helix trajectory (3-dimensional) in a magnetoplasma. We found that a new factor (1+ cot ) should be included into the relevant spectrum radiation formulae and the usual relativistic factor has to be modified as , ifv <v _g , the radiative energy are more concentrated along the velocity of the moving charge; but ifv>v _g, the direction of maximum energy cone deviates from the direction of the moving charge.  相似文献   

Structural similarity and variety at the tips in a wide range of strike–slip faults: a review     

Young‐Seog Kim  David J. Sanderson 《地学学报》2006,18(5):330-344

Strike–slip faults are often accompanied by a variety of structures, particularly at their tips. The zones of additional fracturing are classified as tip‐damage zones. These zones can be subdivided into several different damage patterns based on the nature and orientation of faults and fractures developed. Damage zones at the ends of small strike–slip faults (mode II tips) develop wing cracks, horsetail splays, antithetic faults, synthetic branch faults and solution surfaces. Similar tip‐damage patterns are also commonly observed at larger (regional) scales, but with a dominance of faulting over tensile cracks and solution surfaces. Wing cracks and horsetail splays developed at small‐scale faults are replaced by normal faults in large‐scale faults. Antithetic faults and synthetic branch faults are observed at small and large scales. Thrust faults are developed at large scales, in a similar pattern to solution surfaces at a small scale. All these structures may show slightly different angular relationships to the master fault at small and large scale, but develop in response similar stress distribution and mechanics around the fault. Thus, mode II tip‐damage zones show similar patterns over a wide range of fault scales.  相似文献   

Food Deserts in the Prairies? Supermarket Accessibility and Neighborhood Need in Edmonton,Canada*     

Karen E. Smoyer‐Tomic  John C. Spence  Carl Amrhein 《The Professional geographer》2006,58(3):307-326

The U.S. and U.K. literatures have discussed “food deserts,” reflecting populated, typically urban, low‐income areas with limited access to full‐service supermarkets. Less is known about supermarket accessibility within Canadian cities. This article uses the minimum distance and coverage methods to determine supermarket accessibility within the city of Edmonton, Canada, with a focus on high‐need and inner‐city neighborhoods. The results show that for 1999 both of these areas generally had higher accessibility than the remainder of the city, but six high‐need neighborhoods had poor supermarket accessibility. We conclude by examining potential reasons for differences in supermarket accessibility between Canadian, U.S., and U.K. cities.  相似文献   

伊敏五牧场区煤质特征及变质规律   总被引：3，自引：0，他引：3  

陈冰冰  池海 《中国煤田地质》2005,17(5):34-36,86

伊敏五牧场区存在着从褐煤到贫煤完整的变质系列,其主要煤变质类型为接触变质.在本区煤系地层底部有一酸性侵入岩体,该侵入岩体是引起本区煤变质的直接热源,它提供了褐煤向烟煤转化的热动力.本区出现的隐爆角砾岩也是受热不均匀或热叠加造成煤类复杂多变的原因.区内构造十分发育,构造条件是煤变质的又一主要因素.研究该区煤变质规律对伊敏煤田及海拉尔褐煤盆地烟煤预测具有指导作用.  相似文献   

伴随模式同化系统在修正模式地形中的应用   总被引：7，自引：1，他引：7  

李华宏  沈桐立  王曼  洪萍 《南京气象学院学报》2005,28(3):330-336

任何模式都只是实际大气的一种近似模拟，存在误差。鉴于传统的四维资料伴随模式同化系统都是假设模式完全正确仅对初始场进行修正。将伴随模式同化系统应用于修正模式地形误差，通过对不同初始地形的修正试验表明，MM5伴随模式同化系统能很好地对地形误差进行修正，能够反演出与初始气象要素场分辨率相匹配、与模式更协调的地形场，为伴随模式同化系统的广泛应用提供了一种新的思路。  相似文献   

基于小波统计特性的遥感图像像素与特征联合最优融合方法   总被引：8，自引：0，他引：8  

肖刚  敬忠良  HenryLeung  王淑 《遥感学报》2005,9(4):381-386

遥感影像的IHS融合方法由于匹配误差导致光谱畸变和退化,而小波变换在变换域具有良好的分频特性,小波系数的统计特性反映了遥感影像的边缘、线和区域等显著特征。提出了基于小波统计特性的遥感影像的像素和特征联合最优融合方法,在IHS空间,对强度分量I的高频部分利用多分辨率小波融合方法进行影像的高频细节特征融合,低频部分选取光谱信息和空间分辨率评价指标作为融合权系数求优指标,进行像素级最优融合,实验结果证明了该方法的有效性。  相似文献   

Structural damage detection using the optimal weights of the approximating artificial neural networks     

Shih‐Lin Hung  C. Y. Kao 《地震工程与结构动力学》2002,31(2):217-234

This work presents a novel neural network‐based approach to detect structural damage. The proposed approach comprises two steps. The first step, system identification, involves using neural system identification networks (NSINs) to identify the undamaged and damaged states of a structural system. The partial derivatives of the outputs with respect to the inputs of the NSIN, which identifies the system in a certain undamaged or damaged state, have a negligible variation with different system errors. This loosely defined unique property enables these partial derivatives to quantitatively indicate system damage from the model parameters. The second step, structural damage detection, involves using the neural damage detection network (NDDN) to detect the location and extent of the structural damage. The input to the NDDN is taken as the aforementioned partial derivatives of NSIN, and the output of the NDDN identifies the damage level for each member in the structure. Moreover, SDOF and MDOF examples are presented to demonstrate the feasibility of using the proposed method for damage detection of linear structures. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

A mathematical hysteretic model for elastomeric isolation bearings     

J. S. Hwang  J. D. Wu  T.‐C. Pan  G. Yang 《地震工程与结构动力学》2002,31(4):771-789

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations     

Ser‐Tong Quek  Chengmei Bian  Xilin Lu  Wensheng Lu  Haibei Xiong 《地震工程与结构动力学》2002,31(2):459-474

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

Optimal design of passive energy dissipation systems based on H∞ and H2 performances     

J. N. Yang  S. Lin  J‐H. Kim  A. K. Agrawal 《地震工程与结构动力学》2002,31(4):921-936

Passive energy dissipation devices (EDDs), such as viscous dampers, viscoelastic dampers, etc., have been used to effectively reduce the dynamic response of civil infrastructures, such as buildings and bridges, subject to earthquakes and strong winds. The design of these passive energy dissipation devices (EDDs) involves the determination of the optimal locations and the corresponding capacities. In this paper, we present two optimal design methodologies for passive EDDs based on active control theories, including H_∞ and H₂ performances, respectively. The optimal design methodologies presented are capable of determining the optimal locations and the corresponding capacities of EDDs. Emphasis is placed on the application of linear matrix inequality (LMI) for the effective design of passive EDDs using the popular MATLAB toolboxes. One important advantage of the proposed approaches is that the computation of the structural response is not needed in the design process. The proposed optimal design methodologies have been applied to: (i) a 10‐storey building and a 24‐storey building both subject to earthquake excitations, and (ii) a 76‐storey wind‐excited benchmark building, to demonstrate the advantages of the proposed design methodologies over the conventional equal capacity design. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献