Fluctuations of CaFz(Eu) scintillator background     

Z. Dvořák  K. Štukheil 《Solar physics》1989,123(1):189-192

Background signal of the scintillation detector routinely used for atmospheric Kr-85 counting follows fluctuations, and their connection with cosmic ray variations is searched for. A strong correlation between the 27-day moving average of sunspot numbers and the background is obtained from the 1988 data.  相似文献   

The ionization balance of the Fe in the solar corona for a non-Maxwellian electron distribution function     

Elena Dzifčáková 《Solar physics》1992,140(2):247-267

The ionization equilibrium of the Fe in the solar corona for a non-Maxwellian electron distribution with an enhanced number of particles in the high-energy tail is presented. A parametric form of the distribution function is used to demonstrate the changes in the ionization equilibrium with changes in the shape of the distribution. The results over the range of temperature 10⁵ K T 10⁸ K for different deviations of the distribution from a Maxwellian are given in tabular form. The results can be used for specific applications in the solar corona, especially in the active corona, where deviations from the Maxwellian distribution can be significant.  相似文献   

The Hα development of an intense limb flare and associated flaring arches     

A. Antalová  M. B. Ogir 《Solar physics》1992,138(2):361-378

The H analysis of the development of the strong impulsive and faint gradual phase of the June 26, 1983 flare indicates the following: (1) The flare originated from two microprominences on the southeast border of NOAA 4227. Several similar events are summarized in Table II. (2) The main flare structure was a flare cone, which consisted of a bright surge-like stream, elevated above two flare ribbons (located in the cone's base). The flare cone had a height of about 40 × 10³ km and lasted 4 min in H. The upper part of the cone was terminated by a very fine loop, which was bent to the west, where later a chromospheric brightening occurred at the footpoint of a flaring arch. A 300 keV burst and radio spikes were observed during the maximum flare phase. (3) The flaring arch system, with its apex at a height of about 48 × 10³ km, formed the skeleton for the coronal helmet structure (Figure 7(c)). The velocity of the plasma moving along the flaring arch was between 3500 km s^–1} and 6900 km s^–1} during the first brightening (14:07 UT).  相似文献   

Effect of Multipoint Heterogeneity on Nonlinear Transformations for Geological Modeling： Porosity-Permeability Relations Revisited     

J A Vargas-Guzmán 《中国地质大学学报(英文版)》2008,19(1):85-92

An analysis of statistical expected values for transformations is performed in this study to quantify the effect of heterogeneity on spatial geological modeling and evaluations. Algebraic transformations are frequently applied to data from logging to allow for the modeling of geological properties. Transformations may be powers, products, and exponential operations which are commonly used in well-known relations (e.g., porosity-permeability transforms). The results of this study show that correct computations must account for residual transformation terms which arise due to lack of independence among heterogeneous geological properties. In the case of an exponential porosity-permeability transform, the values may be positive. This proves that a simple exponential model back-transformed from linear regression underestimates permeability. In the case of transformations involving two or more properties, residual terms may represent the contribution of heterogeneous components which occur when properties vary together, regardless of a pair-wise linear independence. A consequence of power- and product-transform models is that regression equationswithin those transformations need corrections via residual cumulants. A generalization of this result isthat transformations of multivariate spatial attributes require multiple-point random variable relations. This analysis provides practical solutions leading to a methodology for nonlinear modeling using correct back transformations in geology.  相似文献   

SVLBI用于大地测量的卫星轨道及其跟踪网设计(英文)     

魏二虎  刘经南  KULKARNI M.N.  FREY Sándor 《地球空间信息科学学报》2008,11(1):6-12

SVLBI （space very long baseline interferometry） has some important potential applications in geodesy and geodynamics, for which one of the most difficult tasks is to precisely determine the orbit of an SVLBI satellite. This work studies several technologies that will possibly be able to determine the orbit of a space VLBI satellite. Then, according to the types and charac- teristics of the satellite and the requirements for geodetic study and the geometry of the GNSS （GPS, GALILEO） satellite to track the space VLBI satellite, the six Keplerian elements of the SVLBI satellite （TEST-SVLBI） are determined. A program is designed to analyze the coverage area of space of different altitudes by the stations of the network, with which the tracking network of TEST-SVLBI is designed. The efficiency of tracking TEST-SVLBI by the network is studied, and the results are presented.  相似文献   

Accuracy assessment of lidar-derived digital elevation models   总被引：2，自引：0，他引：2  

Fernando J.  Aguilar  Jon. P.  Mills 《The Photogrammetric Record》2008,23(122):148-169

Despite the relatively high cost of airborne lidar-derived digital elevation models (DEMs), such products are usually presented without a satisfactory associated estimate of accuracy. For the most part, DEM accuracy estimates are typically provided by comparing lidar heights against a finite sample of check point coordinates from an independent source of higher accuracy, supposing a normal distribution of the derived height differences or errors. This paper proposes a new methodology to assess the vertical accuracy of lidar DEMs using confidence intervals constructed from a finite sample of errors computed at check points. A non-parametric approach has been tested where no particular error distribution is assumed, making the proposed methodology especially applicable to non-normal error distributions of the type usually found in DEMs derived from lidar. The performance of the proposed model was experimentally validated using Monte Carlo simulation on 18 vertical error data-sets. Fifteen of these data-sets were computed from original lidar data provided by the International Society for Photogrammetry and Remote Sensing Working Group III/3, using their respective filtered reference data as ground truth. The three remaining data-sets were provided by the Natural Environment Research Council's Airborne Research and Survey Facility lidar system, together with check points acquired using high precision kinematic GPS. The results proved promising, the proposed models reproducing the statistical behaviour of vertical errors of lidar using a favourable number of check points, even in the cases of data-sets with non-normally distributed residuals. This research can therefore be considered as a potentially important step towards improving the quality control of lidar-derived DEMs.  相似文献   

Spin rate estimation of sounding rockets using GPS wind-up   总被引：2，自引：1，他引：1  

M. García-Fernández  M. Markgraf  O. Montenbruck 《GPS Solutions》2008,12(3):155-161

Carrier phase wind-up is a well-known effect that arises from the relative rotation between a transmitting and receiving antenna. In GPS measurements at L1 frequency, this effect translates into an error of 19.029 cm per full relative rotation of antennas. Since this effect is independent of the satellite elevation for pure rotation about the antenna boresight axis, it is usually absorbed by the clock estimation in navigation algorithms. Therefore, the impact of wind-up is usually neglected for applications that do not require accuracies to the cm level like RTK. However, in receiving platforms with high rotation rate, the accumulated wind-up value can be important and actually be larger than receiver noise or even ionospheric variations. Therefore, in such scenarios, the wind-up contribution can be isolated and used as a source of information to compute the spin rate of such platforms using an appropriate combination of GPS observables. This work shows some results of a coarse, yet simple, approach to monitor the rotation angle and spin-rate of spin stabilized sounding rockets flown by DLR.  相似文献   

Simulations of 3D DC borehole resistivity measurements with a goal-oriented <Emphasis Type="Italic">hp</Emphasis> finite-element method. Part II: through-casing resistivity instruments     

D. Pardo  C. Torres-Verdín  M. Paszynski 《Computational Geosciences》2008,12(1):83-89

We simulate direct current (DC) borehole resistivity measurements acquired in steel-cased deviated wells for the assessment of rock formation properties. The assumed data acquisition configuration considers one current (emitter) and three voltage (collector) electrodes that are utilized to measure the second difference of the electric potential along the well trajectory. We assume a homogeneous, 1.27-cm-thick steel casing with resistivity equal to 10^− 5 Ω· m. Simulations are performed with two different numerical methodologies. The first one is based on transferring two-dimensional (2D) axisymmetric optimal grids to a three-dimensional (3D) simulation software. The second one automatically produces optimal 3D grids yielded by a 3D self-adaptive goal-oriented algorithm. Both methodologies utilize high-order finite elements (FE) that are specially well-suited for problems with high-contrast coefficients and rapid spatial variations of the electric field, as it occurs in simulations that involve steel-cased wells. The method based on transferring 2D-optimal grids is efficient in terms of CPU time (few seconds per logging position). Unfortunately, it may produce inaccurate 3D simulations in deviated wells, even though the error remains below 1% for the axisymmetric (vertical) well. The method based on optimal 3D grids, although less efficient in terms of CPU time (few hours per logging position), produces more accurate results that are validated by a built-in a posteriori error estimator. This paper provides the first existing simulations of through-casing resistivity measurements in deviated wells. Simulated resistivity measurements indicate that, for a 30° deviated well, measurements in conductive layers 0.01 Ω· m) are similar to those obtained in vertical wells. However, in resistive layers (10,000 Ω· m), we observe 100% larger readings in the 30° deviated well. This difference becomes 3,000% for the case of a 60° deviated well. For this highly-deviated well, readings corresponding to the conductive formation layer are about 30% smaller in magnitude than those in a vertical well. Shoulder effects significantly vary in deviated wells.  相似文献   

Editors’ message: Eduardo Usunoff     

Leticia Rodríguez  Luis Sebastián Vives 《Hydrogeology Journal》2008,16(7):1237-1237

  相似文献   

Giant ancient landslide in the Alma water gap (Crimean Mountains,Ukraine): notes to the predisposition,structure, and chronology     

Tomáš Pánek  Jan Hradecký  Veronika Smolková  Karel Šilhán 《Landslides》2008,5(4):367-378

Large-scale ancient landslides of the area of more than 5 km² and volume exceeding 200 × 10⁶ m³ are characteristic features of the valleys incised in the northern periphery of the Crimean Mountains (Ukraine). The largely affected area is located in the outermost cuesta range of the Crimean Mountains which consists of rigid Sarmatian limestones overlying weak Middle Miocene and Upper Palaeogene deposits. A giant landslide arose in the Alma water gap as a reflection of several coincident preparatory factors such as suitable bedrock stratification, smectite-rich bedrock exposed to swelling activity, presence of faults parallel to the valley trend, and river capture event which preceded the landslide event. The occurrence of such ancient megaslides is particularly interesting in the area which is characterized by low precipitation (<500 mm/year) and weak contemporary seismicity. It probably reflects a more dynamic environment in humid phases of the Holocene; however, seismic triggering along the Mesozoic suture zone cannot be rejected. Compressional features such as gravitational folds in the central and distal parts of the landslide, which probably correlate with the whole landslide genesis or its significant reactivation, arose, according to the radiocarbon dating, during the Holocene climatic optimum in the Atlantic period. The slope deformation has been relatively quiescent since that time, except minor historic reactivization which took place in the frontal part of the landslide. We suppose that the studied landslide could be classified as a transitional type of slope deformation with some signs of spreading and translational block slides.  相似文献