Observational aspects on a dominant spectral frequency in an airflow over a weeping-lovegrass stand     

Yousay Hayashi 《Boundary-Layer Meteorology》1986,36(3):239-243

Mean and fluctuating wind velocities were measured above a flexible stand (weeping-lovegrass). A waving phenomenon Honami appeared over the stand during the observation period. Some spectral parameters were derived from the vertical wind fluctuations. A dependency of frequency on mean horizontal wind velocity was found. The result, n _m = 0.66u, was obtained under the range of wind speeds from 0.9 m s^-1 to 3.1 m s^-1 just above the canopy.  相似文献   

Discharge of H2 from the Atotsugawa and Ushikubi Faults,Japan, and its relation to earthquakes     

Hiroshi Satake  Masahiko Ohashi  Yoshimitsu Hayashi 《Pure and Applied Geophysics》1984,122(2-4):185-193

The concentration of H₂ in soil gases has been measured weekly at five stations on the Atotsugawa and Ushikubi faults in northern central Main Island, Japan, since 1981 in search of possible relationship with earthquakes. The observed H₂ concentration varies from lower than 1 ppm to 7.8% in time and place. When a large earthquake (M: 7.7, epicenter distance: 486 km) occurred on 26 May 1983, an outstanding discharge of H₂ was observed at all five stations, preseismically at three of them, and coseismically at the other two. Simultaneous H₂ emission was also observed at some stations in seven other occasions. These periods of unusual H₂ discharge nearly coincided with occurrences of major earthquakes in Japan, but not of local minor earthquakes along the Atotsugawa fault. This fault, being a deep fracture zone, may be sensitive to large-scale crustal stress changes which incidentally cause the major earthquakes. Increased H₂ may be produced by rock fracture caused by the increased stresses on the fault and by the earthquakes themselves. Local minor earthquakes along Atotsugawa fault with magnitude lower than 3 may be unable to cause sufficient rock fracture to produce significant H₂.  相似文献   

High-Mg diorites derived from sanukitic HMA magmas, Kyushu Island, southwest Japan arc: evidence from clinopyroxene and whole rock compositions   总被引：21，自引：0，他引：21  

Atsushi Kamei  Masaaki Owada  Takashi Nagao  Keiichi Shiraki 《Lithos》2004,75(3-4):359-371

High-Mg diorites that have similar whole rock composition to high-Mg andesites (HMAs) should not be simply interpreted as rocks solidified from the HMA magmas, because the high-Mg diorites may be mafic cumulates derived from a different magma from the HMAs.

The HMAs contain unique clinopyroxenes with higher Mg# and Si than those of other sub-alkaline series igneous rocks. The Mg# and Si are controlled by the source magma composition rather than its crystallized conditions such as pressure and temperature. The chemical composition of clinopyroxenes would present important information for the investigation of the source of high-Mg diorites.

We considered the source of Early Cretaceous high-Mg diorites on Kyushu Island, southwest Japan arc, based on their clinopyroxene and whole rock compositions. The clinopyroxenes have similar chemical characteristics to those in HMAs rather than those in other sub-alkaline rocks. Moreover, the whole rock compositions are equivalent to the sanukitic HMA and do not show features of mafic cumulates. This indicates that the high-Mg diorites solidified from sanukitic HMA magmas. It is generally believed that the sanukitic HMA magmas involve the subduction of a young and/or hot oceanic slab was situated in their genesis. Therefore, the occurrence of the high-Mg diorites suggests that Kyushu was situated in the tectonic setting of young and/or hot slab subduction in the Early Cretaceous.  相似文献   

Role of Stress-controlled Flow Pathways in HDR Geothermal Reservoirs     

T. Ito  K. Hayashi 《Pure and Applied Geophysics》2003,160(5-6):1103-1124

— We addressed effects of in situ stress on the formation of flow pathways in fractured rocks in geothermal reservoirs, especially for HDR projects. Here we focused on fractures which are critically-stressed, causing shear slip in a current stress field. The sliding is likely to break sealing in the fractures and, as a result, to increase their permeability. Such a mechanism is possibly significant under high-temperature conditions at geothermal fields because of temperature enhancement on chemical reactions for the sealing. We present a procedure to estimate the orientation of the critically-stressed fractures relative to axes of in situ principal stress with the aid of the Mohr diagram. The procedure allows us to evaluate intuitively how the orientation changes with factors such as magnitude of in situ principal stresses and pore pressure. We applied the procedure to estimate possible orientations of the critically-stressed fractures in major HDR test sites. Results show that overall alignments of microseismicity during hydraulic stimulation are within predicted ranges for possible orientations of the critically-stressed fractures. Furthermore, it was found that if the state of in situ stress is not favorable to cause sliding of natural fractures, it tends to lead a high wellhead pressure at hydraulic stimulation and a high recovery rate at circulation. On the other hand, if the state of in situ stress is favorable for sliding, it tends vice versa to lead a low wellhead pressure at hydraulic stimulation and a low recovery rate at circulation.  相似文献   

Ore mineralogy,fluid inclusion,and stable isotopic characteristics of stratiform copper deposits in the coastal Cordillera of northern Chile     

Shoji Kojima  José Astudillo  Juan Rojo  Dania Tristá  Ken-ichiro Hayashi 《Mineralium Deposita》2003,38(2):208-216

  相似文献   

Guidelines for the good practice of surface wave analysis: a product of the InterPACIFIC project     

Sebastiano Foti  Fabrice Hollender  Flora Garofalo  Dario Albarello  Michael Asten  Pierre-Yves Bard  Cesare Comina  Cécile Cornou  Brady Cox  Giuseppe Di Giulio  Thomas Forbriger  Koichi Hayashi  Enrico Lunedei  Antony Martin  Diego Mercerat  Matthias Ohrnberger  Valerio Poggi  Florence Renalier  Deborah Sicilia  Valentina Socco 《Bulletin of Earthquake Engineering》2018,16(6):2367-2420

Surface wave methods gained in the past decades a primary role in many seismic projects. Specifically, they are often used to retrieve a 1D shear wave velocity model or to estimate the V_S,30 at a site. The complexity of the interpretation process and the variety of possible approaches to surface wave analysis make it very hard to set a fixed standard to assure quality and reliability of the results. The present guidelines provide practical information on the acquisition and analysis of surface wave data by giving some basic principles and specific suggestions related to the most common situations. They are primarily targeted to non-expert users approaching surface wave testing, but can be useful to specialists in the field as a general reference. The guidelines are based on the experience gained within the InterPACIFIC project and on the expertise of the participants in acquisition and analysis of surface wave data.  相似文献   

Application of the Spatial Auto-Correlation Method for Shear-Wave Velocity Studies Using Ambient Noise     

M. W. Asten  K. Hayashi 《Surveys in Geophysics》2018,39(4):633-659

Ambient seismic noise or microtremor observations used in spatial auto-correlation (SPAC) array methods consist of a wide frequency range of surface waves from the frequency of about 0.1 Hz to several tens of Hz. The wavelengths (and hence depth sensitivity of such surface waves) allow determination of the site S-wave velocity model from a depth of 1 or 2 m down to a maximum of several kilometres; it is a passive seismic method using only ambient noise as the energy source. Application usually uses a 2D seismic array with a small number of seismometers (generally between 2 and 15) to estimate the phase velocity dispersion curve and hence the S-wave velocity depth profile for the site. A large number of methods have been proposed and used to estimate the dispersion curve; SPAC is the one of the oldest and the most commonly used methods due to its versatility and minimal instrumentation requirements. We show that direct fitting of observed and model SPAC spectra generally gives a superior bandwidth of useable data than does the more common approach of inversion after the intermediate step of constructing an observed dispersion curve. Current case histories demonstrate the method with a range of array types including two-station arrays, L-shaped multi-station arrays, triangular and circular arrays. Array sizes from a few metres to several-km in diameter have been successfully deployed in sites ranging from downtown urban settings to rural and remote desert sites. A fundamental requirement of the method is the ability to average wave propagation over a range of azimuths; this can be achieved with either or both of the wave sources being widely distributed in azimuth, and the use of a 2D array sampling the wave field over a range of azimuths. Several variants of the method extend its applicability to under-sampled data from sparse arrays, the complexity of multiple-mode propagation of energy, and the problem of precise estimation where array geometry departs from an ideal regular array. We find that sparse nested triangular arrays are generally sufficient, and the use of high-density circular arrays is unlikely to be cost-effective in routine applications. We recommend that passive seismic arrays should be the method of first choice when characterizing average S-wave velocity to a depth of 30 m (V_s30) and deeper, with active seismic methods such as multichannel analysis of surface waves (MASW) being a complementary method for use if and when conditions so require. The use of computer inversion methodology allows estimation of not only the S-wave velocity profile but also parameter uncertainties in terms of layer thickness and velocity. The coupling of SPAC methods with horizontal/vertical particle motion spectral ratio analysis generally allows use of lower frequency data, with consequent resolution of deeper layers than is possible with SPAC alone. Considering its non-invasive methodology, logistical flexibility, simplicity, applicability, and stability, the SPAC method and its various modified extensions will play an increasingly important role in site effect evaluation. The paper summarizes the fundamental theory of the SPAC method, reviews recent developments, and offers recommendations for future blind studies.  相似文献   

Geological,mineralogical, and oxygen isotope studies of the Chandmani Uul iron oxide–copper–gold deposit in Dornogobi Province,Southeastern Mongolia     

Luvsannyam Oyunjargal  Ken‐ichiro Hayashi  Teruyuki Maruoka 《Resource Geology》2020,70(3):233-253

The Chandmani Uul deposit is located in Dornogovi province, Southeastern Mongolia. Iron oxide ores are hosted in the andesitic rocks of the Shar Zeeg Formation of Neoproterozoic to Lower‐Cambrian age. Middle‐ to Upper‐Cambrian bodies of granitic rocks have intruded into the host rocks in the western and southern regions of the deposit. The wall rocks around the iron oxide ore bodies were hydrothermally altered to form potassic, epidote, and sericite–chlorite alteration zones, and calcite and quartz veinlets are ubiquitous in the late stage. Since granitic rocks also underwent potassic alteration, the activity of the granitic rocks must have a genetic relation to the ore deposit. The ore mineral assemblage is dominated by iron oxides such as mushketovite, euhedral magnetite with concentric and/or oscillatory zoning textures, and cauliflower magnetite. Lesser amounts of chalcopyrite and pyrite accompany the iron oxides. Among all these products, mushketovite is dominant and is distributed throughout the deposit. Meanwhile, euhedral magnetite appears in limited amounts at relatively shallow levels in the deposit. By contrast, cauliflower magnetite appears locally in the deeper parts of the deposit, and is associated with green‐colored garnet and calcite. Sulfide minerals are ubiquitously associated with these iron oxides. The oxygen isotope (δ¹⁸O) values of all types of magnetite, quartz, and epidote were found to be ?5.9 to ?2.8‰, 10.5 to 14.9‰, and 3.6 to 6.6‰, respectively. The δ¹⁸O values of quartz–magnetite pairs suggest an equilibrium isotopic temperature near 300°C. The calculated values of δ¹⁸O for the water responsible for magnetite ranged from 2 to 10‰. All the data obtained in this study suggest that the iron oxide deposit at the Chandmani Uul is a typical iron oxide–copper–gold deposit, and that this deposit was formed at an intermediate depth with potassic and sericite–chlorite alteration zones under the oxidized conditions of a hematite‐stable environment. The δ¹⁸O range estimated implies that the ore‐forming fluid was supplied by a crystallizing granodioritic magma exsolving fluids at depth with a significant contribution of meteoric water.  相似文献   

The build-up of the colour–magnitude relation as a function of environment     

Masayuki Tanaka  Tadayuki Kodama  Nobuo Arimoto  Sadanori Okamura  Keiichi Umetsu  Kazuhiro Shimasaku  Ichi Tanaka  Toru Yamada 《Monthly notices of the Royal Astronomical Society》2005,362(1):268-288

  相似文献   

Is there horizontal phase propagation of 5-min oscillations at high velocities?     

Franz-Ludwig Deubner  Nobukazu Hayashi 《Solar physics》1973,30(1):39-46

New observations of the photospheric 5-min oscillations are presented which prove that the physical reality of the very high horizontal phase propagation velocities observed in connection with the oscillations cannot be maintained. Instead, a statistical model is proposed to explain the observed phase relations.Mitteilungen aus dem Fraunhofer Institut Nr. 119.  相似文献