Vent temperature trends at the Vulcano Fossa fumarole field: the role of permeability     

Andrew Harris  Salvatore Alparone  Alessandro Bonforte  Jonathan Dehn  Salvatore Gambino  Luigi Lodato  Letizia Spampinato 《Bulletin of Volcanology》2012,74(6):1293-1311

Between 1994 and 2010, we completed 16 thermal surveys of Vulcano’s Fossa fumarole field (Aeolian Islands, Italy). In each survey, between 400 and 1,200 vent temperatures were collected using a thermal infrared thermometer from distances of ～1?m. The results show a general decrease in average vent temperature during 1994–2003, with the average for the entire field falling from ～220°C in 1994 to ～150°C by 2003. However, between 2004 and 2010, we witnessed heating, with the average increasing to ～190°C by 2010. Alongside these annual-scale field-wide trends, we record a spatial re-organisation of the fumarole field, characterised by shut down of vent zones towards the crater floor, matched by rejuvenation of zones located towards the crater rim. Heating may be expected to be associated with deflation because increased amounts of vaporisation will remove volume from the hydrothermal system Gambino and Guglielmino (J Geophys Res 113:B07402, 2008). However, over the 2004–2010 heating period, no ground deformation was observed. Instead, the number of seismic events increased from a typical rate of 37 events per month during 1994–2000 to 195 events per month during 2004–2010. As part of this increase, we noticed a much greater number of high-frequency events associated with rock fracturing. We thus suggest that the heating event of 2004–2010 was the result of changed permeability conditions, rather than change in the heat supply from the deeper magmatic source. Within this scenario, cooling causes shut down of lower sectors and re-establishment of pathways located towards the crater rim, causing fracturing, increased seismicity and heat flow in these regions. This is consistent with the zone of rejuvenation (which lies towards and at the rim) being the most favourable location for fracturing given the stress field of the Fossa cone Sch?pa et al. (J Volcanol Geotherm Res 203:133–145, 2011); it is also the most established zone, having been active at least since the early twentieth century. Our data show the value of deploying multi-disciplinary geophysical campaigns at degassing (fumarolic) hydrothermal systems. This allows more complete and constrained understanding of the true heat loss dynamics of the system. In the case study presented here, it allows us to distinguish true heating from apparent heating phases. While the former are triggered from the bottom-up, i.e. they are driven by increases in heat supply from the magmatic source, the latter are triggered from the top-down, i.e. by changing permeability conditions in the uppermost portion of the system to allow more efficient heat flow over zones predisposed to fracturing.  相似文献   

Low damage seismic solutions for non-structural drywall partitions     

Ali Sahin Tasligedik  Stefano Pampanin  Alessandro Palermo 《Bulletin of Earthquake Engineering》2015,13(4):1029-1050

  相似文献   

Numerical and experimental evaluation of site effects at ridges characterized by complex geological setting     

Alessandro Pagliaroli  Alessandra Avalle  Emanuela Falcucci  Stefano Gori  Fabrizio Galadini 《Bulletin of Earthquake Engineering》2015,13(10):2841-2865

  相似文献   

Early Holocene transgressive palaeogeography in the Po coastal plain (northern Italy)          下载免费PDF全文

Luigi Bruno  Kevin M. Bohacs  Bruno Campo  Tina M. Drexler  Veronica Rossi  Irene Sammartino  Daniele Scarponi  Wan Hong  Alessandro Amorosi 《Sedimentology》2017,64(7):1792-1816

  相似文献   

Self‐centering structural systems with combination of hysteretic and viscous energy dissipations     

Weng Yuen Kam  Stefano Pampanin  Alessandro Palermo  Athol J. Carr 《地震工程与结构动力学》2010,39(10):1083-1108

This paper presents an innovative set of high‐seismic‐resistant structural systems termed Advanced Flag‐Shaped (AFS) systems, where self‐centering elements are used with combinations of various alternative energy dissipation elements (hysteretic, viscous or visco‐elasto‐plastic) in series and/or in parallel. AFS systems is developed using the rationale of combining velocity‐dependent with displacement‐dependent energy dissipation for self‐centering systems, particularly to counteract near‐fault earthquakes. Non‐linear time‐history analyses (NLTHA) on a set of four single‐degree‐of‐freedom (SDOF) systems under a suite of 20 far‐field and 20 near‐fault ground motions are used to compare the seismic performance of AFS systems with the conventional systems. It is shown that AFS systems with a combination in parallel of hysteretic and viscous energy dissipations achieved greater performance in terms of the three performance indices. Furthermore, the use of friction slip in series of viscous energy dissipation is shown to limit the peak response acceleration and induced base‐shear. An extensive parametric analysis is carried out to investigate the influence of two design parameters, λ₁ and λ₂ on the response of SDOF AFS systems with initial periods ranging from 0.2 to 3.0 s and with various strength levels when subjected to far‐field and near‐fault earthquakes. For the design of self‐centering systems with combined hysteretic and viscous energy dissipation (AFS) systems, λ₁ is recommended to be in the range of 0.8–1.6 while λ₂ to be between 0.25 and 0.75 to ensure sufficient self‐centering and energy dissipation capacities, respectively. Copyright © 2010 John Wiley & Sons, Ltd.  相似文献   

Paleomagnetic dating of the most recent silicic eruptive activity at Pantelleria (Strait of Sicily)     

Fabio Speranza  Patrizia Landi  Francesca D’Ajello Caracciolo  Alessandro Pignatelli 《Bulletin of Volcanology》2010,72(7):847-858

We report on the paleomagnetism of ten sites in the products of the most recent silicic eruptive cycle of Pantelleria, Strait of Sicily. Previously radiometrically dated at 5–10 ka, our comparison with proxies for geomagnetic field directions allows us to narrow considerably the time window during which these eruptions occurred. The strongly peralkaline composition causes the magmas to have low viscosities, locally resulting in strong agglutination of proximal fall deposits. This allows successful extraction of paleomagnetic directions from the explosive phases of eruptions. One of our sites was located in the Serra della Fastuca fall deposit, produced by the first explosive event of the eruptive cycle. The other nine sites were located in the most recent explosive (pumice fall and agglutinate from Cuddia del Gallo and Cuddia Randazzo) and effusive (Khaggiar lava) products. The (very similar) paleomagnetic directions gathered from eight internally consistent sites were compared to reference geomagnetic field directions of the last 5–10 ka. Directions from Cuddia del Gallo agglutinate and Khaggiar flows translate into 5.9- to 6.2-ka ages, whereas the Fastuca pumices yield a slightly older age of 6.2–6.8 ka. Hence, the most recent silicic eruptive cycle lasted at most a millennium and as little as a few centuries around 6.0 ka. Paleomagnetically inferred ages are in good agreement with published (and calibrated by us) ¹⁴C dates from paleosols/charcoals sampled below the studied volcanic units, whereas K/Ar data are more scattered and yield ∼30% older ages. Our data show that the time elapsed since the most recent silicic eruptions at Pantelleria is comparable to the quiescence period separating the two latest volcanic cycles.  相似文献   

Alpine tectonic evolution and thermal water circulations of the Argentera Massif (South-Western Alps)     

Alessandro Baietto  P. Perello  P. Cadoppi  G. Martinotti 《Swiss Journal of Geoscience》2009,102(2):223-245

Three groups of thermal springs with temperatures close to 70 °C discharge both in the core (at Bagni di Vinadio and Terme di Valdieri) and on the external margin (at Berthemont-Les-Bains) of the Argentera Massif. Detailed structural field analysis carried out on the hydrothermal sites allows us to delineate both a model of Alpine tectonic evolution of the Argentera Massif and the patterns of hydrothermal circulation that were active during its final exhumation. The observed fault rock assemblages provide information relative to deformation that occurred in viscous, frictional-to-viscous and frictional crustal regimes. During the Early Miocene, the Bersezio Fault Zone and the Fremamorta Shear Zone, two main mylonitic shear zones, mainly accommodated regional transpression and provided pathways for fluid flow promoting mineral reactions in greenschist facies. During the Late Miocene–Early Pliocene, frictional-to-viscous deformation affected the massif, which underwent predominant transpression in the internal sectors and extension on the external margin. During the Plio-Pleistocene, deformation in frictional condition accompanied the final exhumation of the massif in a transpressive regime and resulted in the development of the NW–SE striking cataclastic zones. The hydraulic properties of these structures mainly influence the patterns of the active thermal circulations and the localization of the recharge and discharge zones. At Berthemont these faults represent conduits, whereas at Vinadio and Valdieri they form complex systems of conduits and barriers. In these two latter sites, the cataclastic faults compose flower structures that constrain laterally the thermal fluid flows while intensely fractured granites sited at depth constitute a highly-transmissive geothermal reservoir. Less permeable migmatitic gneisses overlaying the granites prevent a massive infiltration of the cold fluids at depth. This context favours within the high-permeability fractures granites the development of buoyancy-driven flows which combined with topographically-driven flows, provided the conditions for the upflow of the high-temperature waters.  相似文献   

Integrating airborne and multi‐temporal long‐range terrestrial laser scanning with total station measurements for mapping and monitoring a compound slow moving rock slide     

Alessandro Corsini  Cristina Castagnetti  Eleonora Bertacchini  Riccardo Rivola  Francesco Ronchetti  Alessandro Capra 《地球表面变化过程与地形》2013,38(11):1330-1338

A slow moving compound rock slide located in the northern Apennines of Italy was mapped and monitored through the integration of Airborne Laser Scanning (ALS), multi‐temporal long‐range Terrestrial Laser Scanning (TLS), and Automated Total Station (ATS) measurements. Landslide features were mapped using a High Resolution Digital Terrain Model (HR‐DTM) obtained by merging ALS and TLS data in an Iterative Closest Point (ICP) procedure. Slope movements in the order of centimeters to a few decimeters were quantified with Differential TLS (D‐TLS) based on a Surface Matching approach and supported by ATS data to define stable reference surfaces. The integrated approach allowed mapping of the composite geomorphic features of the rock slide under examination, revealing its complex dynamic nature and further proving that laser scanning is a versatile and widely applicable tool for slope process analysis. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   

Kinematics of active earthflows revealed by digital image correlation and DEM subtraction techniques applied to multi‐temporal LiDAR data     

Alexander Daehne  Alessandro Corsini 《地球表面变化过程与地形》2013,38(6):640-654

Earthflow‐type landslides are persistent natural hazards having deep socio‐economic and environmental consequences. They have significantly contributed to the geomorphic evolution of mountainous slopes in Europe since the Late Glacial. An understanding of their complex kinematics is crucial to better constrain the processes governing their occurrence and mobility. In this work we explored the possibility to quantify displacement vectors on a spatially distributed basis and to quantify volumetric transfer at the slope scale with regard to a large flow‐type landslide located in the northern Apennines of Italy. For this purpose we applied digital image correlation (DIC) and digital elevation model differencing (DEMoD) techniques to multi‐temporal airborne LiDAR surveys of 2006, 2007 and 2009. The DIC was applied to greyscale slope gradient maps retrieved after precise co‐registration of LiDAR surveys. Thereby, movement patterns over various sectors of the landslide were reconstructed and quantified, most notably up to 20 m in the head zone, up to 51 m in the lower main track, and up to about 27 m at the landslide toe. The DEMoD analysis revealed significant mass transfer from the source to the tracks and toe zone, with the upper flow tracks acting as temporal storage of large amounts of material. The mass balance indicated that significant amounts of advancing landslide debris were eroded by a local stream. An integrated analysis of DEMoD and DIC results allowed for a discussion of governing processes, such as the transition from slide to flow, the influence of underlying topography on earthflow mobility, and the role of undrained loading as a mechanism of toe zone reactivation. In conclusion, the successful application of DIC and DEMoD to the case study underlines the added value of high‐resolution DEMs in the analysis of earthflow kinematics toward a better understanding of their role in the geomorphic evolution of slopes. Copyright © 2012 John Wiley & Sons, Ltd.  相似文献   

Experimental Evidences of the Effect of Fibres in Reinforcing a Sandy Gravel     

Stefania Lirer  Alessandro Flora  Nilo Cesar Consoli 《Geotechnical and Geological Engineering》2012,30(1):75-83

Studies regarding fibre-reinforcement are restricted to clays, silty and sandy soils. No information is available on gravels. It is worth checking the effect of randomly oriented discrete fibres also on such soils to see if they can be beneficial and to get a better insight into the grain to soil interaction mechanism. In this paper, the effect of a small amount of fibres having high aspect ratio on a sandy gravel was analysed by means of tests carried out in a large triaxial apparatus. Specimens of both natural and fibre-reinforced sandy gravel were prepared by wet tamping at different relative densities, and were tested along monotonic and cyclic stress paths. The results show that the addition of a small amount of fibres causes a slight increase in peak strength and a larger increase in ultimate strength at small confining stress, with an overall more ductile behaviour. The cyclic tests at small confining stress and intermediate strain levels show that, for the lowest applied strain (of the order of 10⁻²%), the stiffness was larger for the reinforced specimens, with a much sharper decrease at larger strains and final values similar for the reinforced and non-reinforced materials.  相似文献