In order to make renewable energy technology deployment strategies politically acceptable, many countries are linking them to other socio-economic goals. A controversial industrial policy tool that is increasingly popular is the use of local content requirements (LCRs). These regulate the extent to which certain projects must use local products and are often justified on the basis of supporting local employment and private sector development. The LCR debate has centred on the rights and wrongs of protecting infant industry, with little progress being made in finding common ground. This article aims to move beyond this stalemate to understand conditions under which LCRs might be an effective tool for promoting local manufacturing. To do so, an effectiveness framework is applied to LCRs for solar photovoltaics in India's National Solar Mission. The article finds that for LCRs to be effective, they must be (1) limited in duration and incorporate planned evaluation phases, (2) focused on technologies and components for which technical expertise is available and global market entry barriers are manageable, and (3) linked to training and promotion of business linkages and linked to support for other stages of the value chain and wider services integral to success of renewable energy industries.
Policy relevance
It is widely appreciated that governments need to support renewable energy technology deployment in order to mitigate climate change. However, policy makers face increasing pressure to link such support with other socio-economic goals, such as job creation, economic development, and poverty reduction. One such policy support mechanism is the use of local content requirements (LCRs) linked to feed-in tariffs. Policy makers are faced with a difficult choice as manufacturing interest groups lobby for the establishment of protection measures such as LCRs whilst the international trade community led by the World Trade Organization (WTO) seeks to limit their use. This difficulty is amplified by the limited information on the impact of LCRs on job creation and economic development. In this context, this article documents the use of LCRs in India's National Solar Mission and seeks to understand the conditions under which LCRs are an effective policy tool for building a competitive local manufacturing industry. 相似文献
We provide a comprehensive overview of pseudorange biases and their dependency on receiver front-end bandwidth and correlator design. Differences in the chip shape distortions among GNSS satellites are the cause of individual pseudorange biases. The different biases must be corrected for in a number of applications, such as positioning with mixed signals or PPP with ambiguity resolution. Current state-of-the-art is to split the pseudorange bias into a receiver- and a satellite-dependent part. As soon as different receivers with different front-end bandwidths or correlator designs are involved, the satellite biases differ between the receivers and this separation is no longer practicable. A test with a special receiver firmware, which allows tracking a satellite with a range of different correlator spacings, has been conducted with live signals as well as a signal simulator. In addition, the variability of satellite biases is assessed through zero-baseline tests with different GNSS receivers using live satellite signals. The receivers are operated with different settings for multipath mitigation, and the changes in the satellite-dependent biases depending on the receivers’ configuration are observed. 相似文献
Fluid migration pathways in the subsurface are heavily influenced by pre‐existing faults. Although studies of active fluid‐escape structures can provide insights into the relationships between faults and fluid flow, they cannot fully constrain the geometry of and controls on the contemporaneous subsurface fluid flow pathways. We use 3D seismic reflection data from offshore NW Australia to map 121 ancient hydrothermal vents, likely related to magmatic activity, and a normal fault array considered to form fluid pathways. The buried vents consist of craters up to 264 m deep, which host a mound of disaggregated sedimentary material up to 518 m thick. There is a correlation between vent alignment and underlying fault traces. Seismic‐stratigraphic observations and fault kinematic analyses reveal that the vents were emplaced on an intra‐Tithonian seabed in response to the explosive release of fluids hosted within the fault array. We speculate that during the Late Jurassic the convex‐upwards morphology of the upper tip‐lines of individual faults acted to channelize ascending fluids and control where fluid expulsion and vent formation occurred. This contribution highlights the usefulness of 3D seismic reflection data to constraining normal fault‐controlled subsurface fluid flow. 相似文献
Dissolved gaseous mercury (DGM) was measured continuously using two newly developed techniques and a manual technique. The continuous techniques were based on the equilibrium between the aqueous and gaseous phase (DGM = Hgextr / H', Hgextr is the measured mercury concentration in the gas phase, H' is the Henry's Law coefficient at the desired temperature). In order to calculate the annual mercury evasion from the Mediterranean Sea, diurnal and seasonal measurements of DGM, total gaseous mercury in air (TGM), water temperature and wind speed were performed. During August 2003, March–April 2004 and October–November 2004 measurements of these parameters were conducted on board the RV Urania. The continuous measurements of DGM showed a diurnal variation in concentration, at both coastal and off shore sites, with higher concentrations during daytime than nighttime. The concentration difference could be as large as 130 fM between day and night. The degree of saturation was calculated directly from the measurements, S = Hgextr / TGM and was found to vary between the different seasons. The highest average degree of saturation (850%) and the largest variation in saturation (600–1150%) was observed during the summer. The spring showed the lowest variation (260–360%) and the lowest average degree of saturation (320%). The autumn also showed a large variation in saturation (500–1070%) but a lower average (740%) compared to the summer cruise. This might be explained by the temperature difference between the different seasons, since that parameter varied the most. The flux from the sea surface was calculated using the gas exchange model developed by Nightingale et al. [Nightingale, P.D., Malin, G., Law, C.S., Watson, A.J., Liss, P.S., Liddicoat, M.I., Boutin, J., Upstill-Goddard, R. C., 2000. In situ evaluation of air–sea gas exchange parameterization using novel conservative and volatile tracers. Global Biogeochemical Cycles, 14(1):373–387]. The evasion varied between the different seasons with the highest evasion during the autumn, 24.6 pmol m− 2 h− 1. The summer value was estimated to 22.3 pmol m− 2 h− 1 and the spring to 7.6 pmol m− 2 h− 1. Using this data the yearly evasion from the Mediterranean Sea surface was estimated to 77 tons. 相似文献
We describe the fabrication of organically modified sol–gel (ORMOSIL) planar optodes for mapping the two-dimensional oxygen distribution in sediments. All sensor foils were based on the use of ruthenium(II)-tris-(4,7-diphenyl-1,10-phenantrolin)-perchlorate, which is a fluorescent dye quenched dynamically by oxygen. Sensors made with different sol–gel immobilisation matrices, different concentrations of precursors and indicator dye, as well as different types of scattering particles co-immobilised in the sensor foil were investigated systematically. Optimal sensor performance was obtained with dye concentrations of 2–10 mmol/kg in an immobilisation matrix made of diphenyldiethoxy-silan and phenyltriethoxy-silan precursors with addition of organically coated TiO2 particles. The sensors exhibited a good mechanical stability and a high sensitivity from 0% to 100% oxygen, which remained constant over at least 36 days. The planar optodes were used with a fluorescent lifetime imaging system for direct mapping of the spatio-temporal variation in oxygen distribution within marine sediment inhabited by the polychaete Hediste diversicolor. The measurements demonstrated the spatio-temporal heterogeneity of the oxygen distribution in bioturbated sediments due to burrow structures and non-constant irrigation activity of the polychaete, which is difficult to resolve with microsensors or with traditional biogeochemical techniques. 相似文献
The transition from the Triassic to Jurassic is associated with dramatic changes in Earth's climate. Pangaea was breaking up as North America rifted away from Africa, the Central Atlantic Magmatic Province erupted, and the concentration of atmospheric carbon dioxide increased dramatically. This article summarises the changes in Earth's climate associated with this transition, including a discussion of the various impacts of the increased carbon dioxide on the Earth system, the question of whether the wet episode in the Carnian was a global or regional event, the formation of bauxite deposits, and how dinosaur distributions changed over time. Palaeoclimate model simulations reveal the spatial changes in climate between the Triassic and Jurassic, illustrating the subtropics becoming slightly cooler and wetter despite the warming trend for the Earth's average temperature. 相似文献