好氧颗粒污泥系统快速启动试验研究   总被引：2，自引：0，他引：2  

王琳  孙磊  林跃梅 《中国海洋大学学报(自然科学版)》2006,36(2):299-302

采用3组圆柱型SBR反应器进行活性污泥颗粒化培养,接种浓度分别为12 500mg.L-1,4 400mg.L-1和1 800mg.L-1。由于采用逐步缩短沉降时间这一有效措施,系统启动20d后,颗粒污泥初步形成,污泥浓度可达到6 000~8 000mg.L-1,高于普通活性污泥系统,且沉降性能良好,SVI值在50mL.g-1左右。颗粒污泥的平均粒径稳定在0.2~0.25mm。在活性污泥颗粒化的启动试验中,在生物化学条件相同的条件下,逐步缩短沉淀时间可以加快好氧污泥颗粒化系统的启动。  相似文献   

浮游植物叶绿素a含量简易测定方法的比较   总被引：17，自引：0，他引：17       下载免费PDF全文

杨彩根  宋学宏  孙丙耀 《海洋科学》2007,31(1):6-9

用乙醇、DMF(N,N-二甲基甲酰胺)、丙酮3种不同有机溶剂分别萃取苏州环城河水样中的浮游植物细胞叶绿素a,在分光光度计上测定其叶绿素a含量,试验数据经方差分析、Q检验,结果显示,乙醇法、DMF法的叶绿素a萃取率极显著高于丙酮(F=54.20＞F0.01(2,18)(6.01)).另用这3种萃取方法分别测定无常蓝纤维藻(Dactylococcopsis irregularis )纯培养液叶绿素a含量,通过直线回归,同样证明乙醇法、DMF法重复率较高,稳定性好,萃取率高.从安全、简便、重复性高等方面综合考虑,认为用乙醇萃取法是目前水域环境中浮游植物叶绿素a简易测定的最佳方法.  相似文献   

不同季节的企鹅珍珠贝游离珠植核效果比较   总被引：7，自引：1，他引：7  

毛勇  梁飞龙  余祥勇  叶富良 《海洋通报》2003,22(6):88-91

在雷州流沙港湛江海洋大学珍珠研究室实验基地分别于春、夏和秋季进行了企鹅珍珠贝游离珠植核实验。其中，春季插核的死亡率最低，为15.1％--16．2％，留核率最高，为10％左右：而夏季插核的死亡率最高，为63．56％，留核率也仅为2．22％：秋季插核的留核率最低，仅收珠1颗，留核率为0．35％，死亡率也较高，为54.4％。结果表明，春季是企鹅珍珠贝较适宜的插核季节。  相似文献   

应用遗传神经网格方法分析赤潮监测数据   总被引：1，自引：1，他引：1  

杨建强  高振会  孙培艳  石强  李钦亮 《海洋科学进展》2002,20(2):77-82

简要介绍了遗传神经网络方法的原理 ,探讨了应用遗传神经网络方法研究辽东湾海域丹麦细柱藻 (Leptocylindrusdanicus)赤潮与其环境因子之间的关系 ,计算了各环境因子对丹麦细柱藻赤潮的贡献。结果表明 ,温度、盐度、DIN的变化对研究海域丹麦细柱藻种群密度的增长有比较重要的影响 ,DIN是营养限制因子。遗传神经网络是分析赤潮监测数据的有效方法 ,值得进一步探索  相似文献   

水槽造流系统水力计算与泵机选择   总被引：1，自引：0，他引：1  

孙东昌  张亭健  辛海英 《海洋科学进展》2002,20(2):125-132

提供一种完整的用于试验水槽造流系统的水力计算和泵机选择方法 ,可用于其他类似工程设计。  相似文献   

仿鱼尾潜器推进系统的水动力分析   总被引：21，自引：3，他引：21  

苏玉民  黄胜等 《海洋工程》2002,20(2):54-59

以开发适用于小型潜器的仿生操纵与推进系统为研究背景 ,对金枪鱼的月牙形尾鳍进行水动力分析。文中将金枪鱼的尾鳍处理为在做横移和摇摆的耦合运动的同时 ,以某一匀速向前运动的月牙形刚性尾翼。计算中应用了双曲面元和压力库塔条件 ,利用面元法计算分析该三维尾翼的非定常水动力性能。探讨了前进速度、横荡和摇首的幅度、频率及其相位差对推进性能的影响  相似文献   

水面皮层破坏-复原过程的实验室模拟研究     

吴永森  吴隆业 《海洋与湖沼》2001,32(6):605-611

依据水面红外发射和红外遥感测温原理，采用HDG－高灵敏度红外测温仪和常规测量仪器相结合的方法，在实验室空气稳定条件下，模拟测得了水面皮层破坏－复原（重建）的热力过程和气－水温差对水面皮层复原过程的影响，获得了大量的测量数据。数据分析表明，当气－水温差从3．0℃变为11．5℃时，水面皮层破坏可导致皮温增量从气－水温差3．0℃时的0．15℃变到11．5℃时的0．45℃，并发现恢复时间与气－水温差呈负线性关系。  相似文献   

A new efficient 3D non-hydrostatic free-surface flow model for simulating water wave motions     

Doo Yong Choi  Chin H. Wu   《Ocean Engineering》2006,33(5-6):587-609

A new three-dimensional, non-hydrostatic free surface flow model is presented. For simulating water wave motions over uneven bottoms, the model employs an explicit project method on a Cartesian the staggered gird system to solve the complete three-dimensional Navier–Stokes equations. A bi-conjugated gradient method with a pre-conditioning procedure is used to solve the resulting matrix system. The model is capable of resolving non-hydrostatic pressure by incorporating the integral method of the top-layer pressure treatment, and predicting wave propagation and interaction over irregular bottom by including a partial bottom-cell treatment. Four examples of surface wave propagation are used to demonstrate the capability of the model. Using a small of vertical layers (e.g. 2–3 layers), it is shown that the model could effectively and accurately resolve wave shoaling, non-linearity, dispersion, fission, refraction, and diffraction phenomena.  相似文献   

Wave interaction with a perforated wall breakwater with a submerged horizontal porous plate   总被引：1，自引：0，他引：1  

Yong Liu  Yu-cheng Li  Bin Teng 《Ocean Engineering》2007,34(17-18):2364-2373

This study examines the hydrodynamic performance of a new perforated-wall breakwater. The breakwater consists of a perforated front wall, a solid back wall and a submerged horizontal porous plate installed between them. The horizontal porous plate enhances the stability and wave-absorbing capacity of the structure. An analytical solution based on linear potential theory is developed for the interaction of water waves with the new proposed breakwater. According to the division of the structure, the whole fluid domain is divided into three sub-domains, and the velocity potential in each domain is obtained using the matched eigenfunction method. Then the reflection coefficient and the wave forces and moments on the perforated front wall and the submerged horizontal porous plate are calculated. The numerical results obtained for limiting cases are exactly the same as previous predictions for a perforated-wall breakwater with a submerged horizontal solid plate [Yip, T.L., Chwang, A.T., 2000. Perforated wall breakwater with internal horiontal plate. Journal of Engineering Mechanics ASCE 126 (5), 533–538] and a vertical wall with a submerged horizontal porous plate [Wu, J.H., Wan, Z.P., Fang, Y., 1998. Wave reflection by a vertical wall with a horizontal submerged porous plate. Ocean Engineering 25 (9), 767–779]. Numerical results show that with suitable geometric porosity of the front wall and horizontal plate, the reflection coefficient will be always rather small if the relative wave absorbing chamber width (distance between the front and back walls versus incident wavelength) exceeds a certain small value. In addition, the wave force and moment on the horizontal plate decrease significantly with the increase of the plate porosity.  相似文献   

The Working Mechanism and An Analytic Method of the Deep Embedded Large Cylinder Structure     

孙克俐  周锡礽钱荣 《中国海洋工程》2004,18(2):221-228

The large cylinder is a new-type structure that has been applied to harbor and offshore engineering. An analytic method of the relationship between loads and the structure displacement is developed based on the failure mode of deep embedded large cylinder structures. It can be used to calculate directly the soil resistance and the ultirnate bearing capacity of the structure under usage. A new criterion of the large cylinder structure, which discriminates the deep embedded cylinder from the shallow embedded cylinder, is defined. Model tests prove that the proposed method is feasible for the analysis of deep embedded large cylinder structures.  相似文献