Generalized plasticity state parameter‐based model for saturated and unsaturated soils. Part 1: Saturated state     

Diego Manzanal  José Antonio Fernández Merodo  Manuel Pastor 《国际地质力学数值与分析法杂志》2011,35(12):1347-1362

The behavior of granular materials is known to depend on its loose or dense nature, which in turns depends both on density and confining pressure. Many models developed in the past require the use of different sets of constitutive parameters for the same material under different confining pressures. The purpose of this paper is to extend a basic generalized plasticity model for sands proposed by Pastor, Zienkiewicz and Chan by modifying the main ingredients of the model flow—rule, loading–unloading discriminating direction and plastic modulus—to include a dependency on the state parameter. The proposed model is tested against the available experimental data on three different sands, using for each of them a single set of material parameters, finding a reasonably good agreement between experiments and predictions. Copyright © 2010 John Wiley & Sons, Ltd.  相似文献   

Generalized plasticity state parameter‐based model for saturated and unsaturated soils. Part II: Unsaturated soil modeling     

Diego Manzanal  Manuel Pastor  José Antonio Fernández Merodo 《国际地质力学数值与分析法杂志》2011,35(18):1899-1917

The aim of this paper is to extend the generalized plasticity state parameter‐based model presented in part 1 to reproduce the hydro‐mechanical behavior of unsaturated soils. The proposed model is based on two pairs of stress–strain variables and a suitable hardening law taking into account the bonding—debonding effect of suction and degree of saturation. A generalized state parameter for unsaturated state is proposed to reproduce soil behavior using a single set of material parameters. Generalized plasticity gives a suitable framework to reproduce not only monotonic stress path but also cyclic behavior. The hydraulic hysteresis during a drying—wetting cycle and the void ratio effect on the hydraulic behavior is introduced. Comparison between model simulations and a series of experimental data available, both cohesive and granular, are given to illustrate the accuracy of the enhanced generalized plasticity equation. Copyright © 2010 John Wiley & Sons, Ltd.  相似文献   

One-dimensional consolidation of soil under multistage load based on continuous drainage boundary     

Yi--> Tian  Wenbing Wu  Guosheng Jiang  M. Hesham El Naggar  Guoxiong Mei  Meijuan Xu  Rongzhu Liang 《国际地质力学数值与分析法杂志》2020,44(8):1170-1183

In engineering practice, a rapid loading rate can result in ground failure when the strength of soft soils is relatively low, and a multistage loading scheme is always utilized to deal with this situation. Firstly, under a multistage load and the continuous drainage boundary, an analytical solution of excess pore-water pressure and consolidation degree is obtained by virtue of the superposition formula of excess pore-water pressure, and a more general continuous drainage boundary under arbitrary time-dependent load is developed. Then, a comparison with existing analytical solutions is conducted to verify the present solution. A preliminary attempt on applying the continuous drainage boundary into the finite element model is made, and the feasibility of the numerical model for the one-dimensional consolidation under the continuous drainage boundary is verified by comparing the results calculated by FEM with that from present analytical solution. Finally, the consolidation behavior of soil is investigated in detail for different int erface parameters or loading scheme. The results show that, in land reclamation projects, a horizontal drain should be placed close to the boundary with a smaller interface parameter to improve the consolidation efficiency. The degree of consolidation is also related to the applied time-dependent load and interface parameters.  相似文献   

Enhancement of backtracking search algorithm for identifying soil parameters     

Yin-Fu Jin  Zhen-Yu Yin 《国际地质力学数值与分析法杂志》2020,44(9):1239-1261

In this paper, an enhanced backtracking search algorithm (so-called MBSA-LS) for parameter identification is proposed with two modifications: (a) modifying the mutation of original backtracking search algorithm (BSA) considering the contribution of current best individual for accelerating convergence speed and (b) novelly incorporating an efficient differential evolution (DE) as local search for improving the quality of population. The proposed MBSA-LS is first validated with better performance than the original BSA and some other typical state-of-the-art optimization algorithms on a benchmark of soil parameter identification in terms of effectiveness, efficiency, and robustness. Then, the efficiency of the MBSA-LS is further illustrated by two representative cases: identifying soil parameters from both laboratory tests and field measurements. All comparisons demonstrate that the proposed MBSA-LS algorithm can give accurate results in a short time. Finally, to conveniently solve the problems of parameter identification, a practical tool ErosOpt for parameter identification is developed by integrating the proposed MBSA-LS and some other efficient algorithms for readers to conduct the parameter identification using optimisation algorithms.  相似文献   

Sensitivity of soil parameters in unsaturated zone modelling and the relation between effective,laboratory and in situ estimates     

J. Mertens  H. Madsen  M. Kristensen  D. Jacques  J. Feyen 《水文研究》2005,19(8):1611-1633

Simulation of soil moisture content requires effective soil hydraulic parameters that are valid at the modelling scale. This study investigates how these parameters can be estimated by inverse modelling using soil moisture measurements at 25 locations at three different depths (at the surface, at 30 and 60 cm depth) on an 80 by 20 m hillslope. The study presents two global sensitivity analyses to investigate the sensitivity in simulated soil moisture content of the different hydraulic parameters used in a one‐dimensional unsaturated zone model based on Richards' equation. For estimation of the effective parameters the shuffled complex evolution algorithm is applied. These estimated parameters are compared to their measured laboratory and in situ equivalents. Soil hydraulic functions were estimated in the laboratory on 100 cm³ undisturbed soil cores collected at 115 locations situated in two horizons in three profile pits along the hillslope. Furthermore, in situ field saturated hydraulic conductivity was estimated at 120 locations using single‐ring pressure infiltrometer measurements. The sensitivity analysis of 13 soil physical parameters (saturated hydraulic conductivity (K_s), saturated moisture content (θ_s), residual moisture content (θ_r), inverse of the air‐entry value (α), van Genuchten shape parameter (n), Averjanov shape parameter (N) for both horizons, and depth (d) from surface to B horizon) in a two‐layer single column model showed that the parameter N is the least sensitive parameter. K_s of both horizons, θ_s of the A horizon and d were found to be the most sensitive parameters. Distributions over all locations of the effective parameters and the distributions of the estimated soil physical parameters from the undisturbed soil samples and the single‐ring pressure infiltrometer estimates were found significantly different at a 5% level for all parameters except for α of the A horizon and K_s and θ_s of the B horizon. Different reasons are discussed to explain these large differences. Copyright © 2004 John Wiley & Sons, Ltd.  相似文献   

PEIV模型参数估计新算法     

汪奇生  杨根新 《测绘科学技术学报》2016,(4):341-345

PEIV(Partial Errors-In-Variables)模型是EIV模型的扩展,它能解决系数矩阵含有非随机元素或存在结构特性的问题。针对常规PEIV模型算法的复杂性,提出了一种PEIV模型参数估计的新算法。该算法将系数矩阵含误差的元素看成是一类观测值,与平差模型原观测值构成两类观测值,将PEIV平差模型表示为类似于传统的最小二乘间接平差模型,再通过非线性最小二乘平差理论,推导出了算法的迭代公式和精度评定公式。算法迭代格式与间接平差类似,通过算例验证了算法的可行性和正确性。  相似文献   

求解GM(1,1)模型新总体最小二乘算法     

陶武勇  鲁铁定  吴飞 《测绘科学技术学报》2016,(5):476-479

在GM(1,1)模型中系数矩阵和观测向量都是由原始序列组成的。系数矩阵中同样是有误差的,与观测向量中的误差一样,亦来源于原始序列,即它们误差同源。不同位置的相同元素应该有相同的改正数,采用传统总体最小二乘求解则不能达到此目的。针对这一缺陷,推导了一种新的总体最小二乘算法;并且通过算例验证了新方法的可行性和有效性。  相似文献   

GNSS相应坐标系之间的关系及其影响     

曾安敏  杨元喜  明锋  景一帆 《测绘科学技术学报》2016,(6):551-556

不同的GNSS采用的坐标系定义几乎相近,但参考椭球及其坐标实现不同,这将影响多GNSS融合导航定位效果。根据各GNSS坐标系所采用参考椭球的基本常数,计算比较了不同坐标系参考椭球参数的差异;导出了相应的正常重力公式,比较了这些正常重力公式确定的正常重力值差异;最后分别从坐标系统的定义与实现两个方面分析了其对定位结果的影响。结果表明:1)GPS(BDS)与Galileo和GLONASS所使用的参考椭球引起正常重力差约为0.15和0.30 mgal;2)GPS与BDS,Galileo及GLONASS所使用参考椭球引起纬度分量最大差异约为0.1 mm,3 cm和3 cm,高程分量约为0.1 mm,0.5 m和1 m;3)各GNSS所使用坐标框架间转换参数引起的坐标变化达到厘米级。  相似文献   

An algebraic solution of maximum likelihood function in case of Gaussian mixture distribution     

J. L. Awange  B. Palancz  R. Lewis  T. Lovas  B. Heck  Y. Fukuda 《Australian Journal of Earth Sciences》2016,63(2):193-203

  相似文献   

IEC的风机选型参数估算方法在中国的适用性研究     

黄林宏  宋丽莉  李刚  王丙兰  张永山 《气象》2016,42(12):1522-1530

国际电工委员会编制的《风力发电机组设计要求》(IEC 61400-1)推荐了针对风电机组安全等级评估的极端风速和湍流强度特征值估算方法,因其简单便捷,在风电领域被广泛采用。利用全国风能资源专业观测网的193座测风塔观测数据,对IEC推荐的极端风速计算方法与我国规范推荐的基于极值I型概率分布方法进行比较,发现两种方法计算的193座塔70 m高度层50年一遇10 min平均最大风速,仅有7座测风塔较为一致,差异在±1%;IEC推荐方法的计算结果多数偏小,其中偏小10%以上的测风塔有121座,偏小30%以上的有44座测风塔,而偏大10%以上的只有9座测风塔;IEC方法计算的极值风速大幅度偏小的测风塔主要分布在台风影响的东南沿海地区,偏差较小的测风塔主要分布在西北和华北地形平缓区域,但同时偏大10%以上的测风塔也多分布在这一地区。以目前行业领域普遍采用的以15 m·s~(-1)风速的平均湍流强度作为风电机组选型指标,与严格按照规范,以15 m·s~(-1)风速段所有样本湍流强度的90%分位数处的值作为指标进行风电机组等级确定作对比,发现193座塔中有46座塔的选型是不安全的,甚至相差两个等级。  相似文献